• Journal of Korea Society of Industrial Information Systems
• /
• v.25 no.2
• /
• pp.1-9
• /
• 2020

A smart factory is a key industrial application introduced by the 4^th industrial revolution. The automatic guided vehicle (AGV) is one of the technology realizing smart factory, but the development cost is high due to its early stage of technology. Although developing a low-cost AGV requires a lot of data, it has limited data acquisition capability because of the limited storage and the AGV movement. Hence, we propose a development environment using Bluetooth to collect data and design a lane detector. The proposed lane detector shows a high lane detection ratio regardless of light variation and a shade.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.3
• /
• pp.328-330
• /
• 2016

A lane departure warning system based on single lane mark detection is presented in this paper. The proposed system is focused on the robust detection of lane departure, even when one of the left or the right lane mark cannot be detected because of poor illumination or abrasion. Experimental results show that the proposed system warns lane departure, even if only a single lane is detected.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2010.07a
• /
• pp.70-73
• /
• 2010

최근 IT 기술이 융합된 지능형 자동차 기술에 대한 관심이 높아짐에 따라 이에 대한 연구가 활발히 진행되고 있다. 차선 검출은 지능형 자동차의 주요 과제인 첨단 안전자동차 기술의 핵심적인 부분으로 국내외에서 다양한 방법들에 대한 연구가 진행되었다. 차량의 안전을 향상시키기 위해서는 충분한 제동거리 확보가 가능한 거리까지 정확하고 빠른 차선 검출이 이루어져야 한다. 기존의 경계선 검출기반 차선 검출은 소실점 근처에서 경계선 검출이 이루어지지 않았다. 이는 차선과 도로의 색이 잘 구분되지 않는 채널을 사용하는 문제에서 기인한다. 따라서 본 논문에서는 선형 판별 분석 기법을 이용하여 차선과 도로 색을 가장 잘 구분할 수 있는 RGB 가중치를 계산하여 이로부터 projection 영상을 만들고, 변환한 영상에서 경계선 검출을 수행함으로써 보다 정확한 경계선 검출 결과를 얻는 방법을 제안한다. 제안한 방법으로 얻은 영상과 기존의 흑백 영상에 동일한 경계선 검출기를 적용하여 성능을 비교하고, 이를 적용한 차선검출 실험결과를 제시한다.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.18 no.6
• /
• pp.797-807
• /
• 2008

This paper proposes a new algorithm of extracting forward vehicle areas using the acquired lanes and road area information on road images with complex background to improve the efficiency of the vehicle detection. In the first stage, lanes are detected by taking into account the connectivity among the edges which are determined from a method of chain code. Once the lanes proceeding to the same direction with the running vehicle are detected, neighborhood roadways are found from the width and vanishing point of the acquired roadway of the running vehicle. And finally, vehicle areas, where forward vehicles are located on the road area including the center and neighborhood roadways, are extracted. Therefore, the proposed scheme of extracting forward vehicle area improves the rate of vehicle detection on the road images with complex background, and is highly efficient because of detecting vehicles within the confines of the acquired vehicle area. The superiority of the proposed algorithm is verified from experiments of the vehicle detection on road images with complex background.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.10 no.4
• /
• pp.304-310
• /
• 2017

In this paper, we propose the architecture of an IPM based lane detector for autonomous vehicles to detect and control the driving route along the curved lane. In the IPM image, we divide the area into two fields, Far/Near Field, and the lane candidate region is detected using the Hough transform to perform the matching for the curved lane. In autonomous vehicles, various algorithms must be embedded in the system. To reduce the system resources, we proposed a method to minimize the number of memory accesses to the image and various parameters on the external memory. The proposed circuit has 96% lane recognition rate and occupies 16% LUT, 5.9% FF and 29% BRAM in Xilinx XC7Z020. It processes Full-HD image at a rate of 42 fps at a 100 MHz operating clock.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.3
• /
• pp.464-470
• /
• 2021

Automobiles have been used as simple means of transportation, but recently, as automobiles are rapidly becoming intelligent and smart, and automobile preferences are increasing, research on IT technology convergence is underway, requiring basic high-performance functions such as driver's convenience and safety. As a result, autonomous driving and semi-autonomous vehicles are developed, and these technologies sometimes deviate from lanes due to environmental problems, situations that cannot be judged by autonomous vehicles, and lane detectors may not recognize lanes. In order to improve the performance of lane departure from the lane detection system of autonomous vehicles, which is such a problem, this paper uses fast recognition, which is a characteristic of YOLO(You only look once), and is affected by the surrounding environment using CSI-Camera. We propose a lane detection system that recognizes the situation and collects driving data to extract the region of interest.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.24 no.7
• /
• pp.834-841
• /
• 2020

Among the autonomous driving systems based on visual sensors, the control method using a vanishing point is the most general method for autonomous driving. However, if the lane is lost or does not exist, it is very difficult to detect this and estimate the vanishing point. In this paper, we predict the vanishing point of the road and the vanishing point lines on the left and right sides using CNN for the camera image and design the steering controller for autonomous driving from the predicted results. As a result of the simulation, it was confirmed that the proposed method well tracked the center of the road regardless of the presence or absence of a solid lane, and was superior to the control method using a general method using the vanishing point.

• The KIPS Transactions:PartB
• /
• v.15B no.6
• /
• pp.543-552
• /
• 2008

ATIS(Advanced Traveler Information System) is the system to offer a real-time traffic information or traffic situation for the benefit of the client. One of traffic information collection methods for ATIS research is the method of image analysis. The method is divided into two : one is the method to set two loop detectors at the area and the other is the method detecting the vehicle through an image analysis. In this paper, we propose a real-time traffic information collection system to mix two methods. The system installs multiple virtual detection lines and traces the location of the vehicle. Use of multiple virtual detection lines supplements the defect of the method of loop detectors. And we drew a representative pixels in the detecting area and used it for image analysis. This is to solve the problem of time delay which increases as the image size increases. We gathered traffic images and experimented using the system and got 92.32% of detection accuracy.

• Journal of Internet Computing and Services
• /
• v.16 no.2
• /
• pp.49-55
• /
• 2015

According to the statistics of traffic accidents over recent 5 years, traffic accidents during the night times happened more than the day times. There are various causes to occur traffic accidents and the one of the major causes is inappropriate or missing street lights that make driver's sight confused and causes the traffic accidents. In this paper, with smartphones, we designed and implemented a lane luminance measurement application which stores the information of driver's location, driving, and lane luminance into database in real time to figure out the inappropriate street light facilities and the area that does not have any street lights. This application is implemented under Native C/C++ environment using android NDK and it improves the operation speed than code written in Java or other languages. To measure the luminance of road, the input image with RGB color space is converted to image with YCbCr color space and Y value returns the luminance of road. The application detects the road lane and calculates the road lane luminance into the database sever. Also this application receives the road video image using smart phone's camera and improves the computational cost by allocating the ROI(Region of interest) of input images. The ROI of image is converted to Grayscale image and then applied the canny edge detector to extract the outline of lanes. After that, we applied hough line transform method to achieve the candidated lane group. The both sides of lane is selected by lane detection algorithm that utilizes the gradient of candidated lanes. When the both lanes of road are detected, we set up a triangle area with a height 20 pixels down from intersection of lanes and the luminance of road is estimated from this triangle area. Y value is calculated from the extracted each R, G, B value of pixels in the triangle. The average Y value of pixels is ranged between from 0 to 100 value to inform a luminance of road and each pixel values are represented with color between black and green. We store car location using smartphone's GPS sensor into the database server after analyzing the road lane video image with luminance of road about 60 meters ahead by wireless communication every 10 minutes. We expect that those collected road luminance information can warn drivers about safe driving or effectively improve the renovation plans of road luminance management.

• Korean Journal of Digital Imaging in Medicine
• /
• v.9 no.1
• /
• pp.7-15
• /
• 2007

This study aim to investigate image characteristics due to focus-grid and head phantom decentering from the armorphos silicon thin film transistor detector the fixed focus-grid is applied, wish to propose right use method of digital medical equipment. Acquired image according to focus-grid and head phantom position decentering using head phantom on armorphos silicon thin film transistor detector the fixed focus-grid is applied. acquired image evaluate pixel value, histogram, plot profile, surface plot using NIB (Image J) image analysis program and compared decentering image with standard image. Mean value and standard deviation value of focus-grid lateral decentering and duplex decentering of focus-grid and head phantom decreased by ratio, consequently increase of horizontality, diagonal decentering. also, deteriorated contrast of image because frequency of high pixel value decreases fairly. according increases decentering, image distortion phenomenon was increase, by next time, pixel mean value of head phantom decentering was no big change but horizontality, diagonal, mean value and standard deviation value of pixel decreased by ratio. Even if increase pixel noise of image because wide latitude and post processing ability of digital detector, radiotechnologist can not recognize. Therefore, radiotechnologist must recognize correctly the photographing factors which increases pixel noise on the grid system installation digital detector and should exam.