• Geophysics and Geophysical Exploration
• /
• v.24 no.3
• /
• pp.73-77
• /
• 2021

Induced polarization (IP) is useful for mineral exploration and hydrogeological studies by visualizing the electrochemical reactions at the interface between polarized minerals and groundwater. Frequency-domain IP (FDIP) is not actively applied to field surveys because it takes longer to acquire data, despite its higher data quality than conventional time-domain IP. However, data quality is more important in current mineral exploration as the targets gradually shift to deep or low-grade ore bodies. In addition, the measurement time reduced by automated instrumentation increases the potential for FDIP field applications. Therefore, we demonstrate that FDIP can detect mineral exploration targets by performing geophysical logging in the boreholes of a skarn deposit, in South Korea. Alternating current (AC) resistivity, percent frequency effect (PFE) and metal factor (MF) were calculated from impedance values obtained at two different frequencies. Skarn zones containing magnetite or pyrite showed relatively low AC resistivity, high PFE, and high MF compared to other zones. Therefore, FDIP surveys are considered to be useful for mineral exploration.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.34 no.7
• /
• pp.729-738
• /
• 2010

The characteristics of lifted butane flames diluted with nitrogen have been investigated experimentally in order to elucidate the mechanism of individual flame oscillation modes. Flame oscillations in laminar free-jet lift-off flames are classified into the following five regimes: a stabilized lift-off regime (I), a heat-loss-induced oscillation (II), a buoyancy-induced oscillation along with a heat-loss-induced oscillation (III), a combined form of an oscillation prior to blow-out and a heat-loss-induced oscillation (IV), and a combination of an oscillation prior to blow-out and a buoyancy-induced oscillation along with a heat-loss-induced oscillation (V). The characterization of the individual flame oscillations modes are presented and discussed using Strouhal numbers and their relevant parameters by the analysis of the power spectrum for temporal variation of the lift-off height.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.14 no.3
• /
• pp.473-485
• /
• 1994

Vibration control of concrete slab mounting precision instrument is needed to make the working vibration environments in frequency domain as well as time domain. In order to take the vibration control countermeasures, signal and system analyses of the concrete slab are processed. Through them the dynamic responses of concrete slab are obtained in frequency domain, and frequency response functions are acquired by exciting the concrete slab and measuring dynamic responses at various points across its surface. The dynamic characteristics of concrete slab are determined by experimental modal analysis. Based on modal parameters from a set of frequency response function measured, it is possible to investigate the effects of potential design modifications and reduce the dynamic response of concerned point by moving or suppressing an objectionable modal resonance conditions through structural dynamics modification.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.3 no.1
• /
• pp.103-112
• /
• 1999

This is study to estimate the pump induced vibration in time and frequency domain by frequency response function between two points in case of 20Hp and 50Hp centrifugal pumps. The frequency response function has real and imaginary information of signals, and response function has also real and imaginary information. So the vibration force can be obtained from the response function and frequency response function by complex calculation. And it is compared with the theoretically estimated values and it is suggested that the amplitude of vibration with main frequency is about 10~25% of pump and motor weight, and the magnitude of unbalanced mass is about 30~60% of pump and motor weight to estimated vibration force in time domain. There are the other kinds of vibration components with different frequency values of 2~3 times of its main frequency, and these kinds of information are used to control the tuning ratio between operating frequency of pump and structural frequency of concrete slab.

• Journal of the Mineralogical Society of Korea
• /
• v.13 no.1
• /
• pp.37-43
• /
• 2000

Fourier transform 적외선 분광기를 사용하여 원적외선 (<200 cm-1) 영역과 중간적외선 (400-4000 cm-1) 영역에서 열수기원 일라이트의 층간 결합상태와 화학조성간의 관계를 해석하였다. 중간 적외선 영역에서는 2M1 다형의 Al-O-Al 및 Al-O-Si 결합이 1Md 형의 것보다 강한 것으로 나타났다. 원적외선 영역에서는 세 종류의 K-O 결합이 111-114, 135-143 및 167-168 cm-1에서 인지되었다. 2M1과 1Md 다형간의 가장 큰 차이는 2M1형의 층간결합이 1Md형보다 상대적으로 강하여 K가 층간에 보다 강하게 결합되어 있다는 점이며, 두 다형의 층간결합의 상태는 서로 상이하다. K-Oinner band는 (OH) stretching band의 진동수가 높을수록 커지며, (OH) stretching band는 팔면체의 양이온 (Fe+Mg)의 함량에도 영향을 받는 것으로 나타났다.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.12 no.4
• /
• pp.649-659
• /
• 1999

본 연구에서는 점탄성감쇠기가 설치된 비비례 감쇠 구조물의 바람에 대한 확률적 응답을 진동수영역에서 구하였다. 복소수 고유치 및 고유백터를 바탕으로 모드중첩법을 이용하여 응답의 RMS 값을 구하고 그것을 근사적인 방법인 모드 변형에너지법에서 얻은 결과와 비교하였다. 또한, 가력 진동수에 따라서 변하는 점탄성감쇠기의 강성 및 감쇠 계수를 상수로 모형화하였을 때의 풍응답 해석 결과의 정확성을 진동수영역에서 검증하였다. 해석결과에 의하면 감쇠기의 진동수 의존 특성은 구조물의 1차 고유 진동수에 의해서 비교적 정확하게 표현되었고, 모드 변형에너지법은 대체로 정확한 결과를 도출하였지만, 가속도 응답을 구할 때에는 다소 큰 오차를 유발하였다.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.11a
• /
• pp.696-701
• /
• 2005

조화가진력이 작용하는 고정경계를 가진 완전원판의 비선형 진동에 대한 응답특성을 연구하였다. 원판의 비대칭모드의 고유진동수 근처에 가진주파수가 작용하는 주공진에서의 응답은 정상파(standing wave)뿐만 아니라 진행파(traveling wave)가 존재 한다고 알려져 있다. 주공진 근처의 정상상태 응답곡선에서 최대한 5개의 안정한 응답이 존재하는 것으로 밝혀졌으며, 이들은 1개의 정상파와 4개의 진행파로 나타난다. 이 진행파 중 2개는 가진진동수가 변화함에 따라 Hope분기에 의해 안정성을 잃은 후 주기배가운동을 거쳐 흔돈운동에 이르게 된다. 초기조건에 의해 각각의 끌개(attractor)에 흡인되는 흡인영역의 경계를 주평면의 개념을 통하여 구하였으며, 가진진동수가 변화함에 따라 안정한 해가 혼돈운동에 이르는 과정에 대해 흡인영역의 경계가 변화되는 특성을 관찰하였으며, 흡인영역 경계에 대한 프랙털 차원(fractal dimension)을 계산하였다.

• Journal of Korean Ophthalmic Optics Society
• /
• v.6 no.1
• /
• pp.13-29
• /
• 2001

A mathematical model was proposed to analyze the vibration of diaphragm, such as the contact lenses fitted on the eyes, being subjected to the external sinusoidal pressure. The model incorporates the differential equations and their numerical solution program, based on the wave equations. Turbo-C and graphic software, formulated to describe the dependence of the various parameters involved in the vibration. The model predicts the radial distribution of amplitude, frequency dependence of both average displacement amplitude and the power of diaphragm whose edge is being either simply supported or rigidly clamped in vibration. The effect of variables such as thickness, radius, damping coefficients on the vibration characteristics was illustrated by the computer simulation of the derived program. As the frequency of driving pressure increases above the certain value determined by the boundary conditions and parameters the wave shape or pattern changes from simple arc to belly or loops having double antinode. It seems that the effect of outer antinode progressively increases as the frequency increases. If this kind of phenomena occurs to the contact lens on the cornea in vivo, it may cause an abnormal correction power in the lenses or pull off the eye due the increased rise of outer part of the lens.

• Journal of KSNVE
• /
• v.6 no.3
• /
• pp.341-347
• /
• 1996

Vibration analysis is one of the most powerful tools available for the detection and isolation of incipient faults in mechanical systems. The methods of vibration analysis in use today and under continuous study are broad band vibration monitoring, time domain analysis, and frequency domain analysis. In recent years, great interest has been generated concerning the use of time- frequency repesentation and its application for a machinery diagnostics and condition monitoring system. The objective of the study described in this paper was to develop a new diagnostic tool for the rotating machinery. This paper introduces a new time frequency representation. Directional Winger-Ville Distribution, which analyese the time-frequency structure of the rotating machinery vibration.

• International Area Studies Review
• /
• v.21 no.2
• /
• pp.3-20
• /
• 2017

Traditional co-integration analysis method is known to be difficult to clearly determine the relationship between the cointegrated variables. This study utilizes a fractional cointegation method and a causal analysis of time and frequency domain among the exchange rates of Korea, China and Japan. The results show that even though traditional cointegration methods did not clarify the existence of cointegration, exchange rates were fractionally cointegrated. Causal analysis of time domain and frequency domain provided somewhat different results, but the yen/dollar was useful for forecasting won/dollar and yuan/dollar. Proper use of causal analysis of frequency domain and fractional cointegration emthods may provide useful information that can not be explained from the traditional method.