• The Bulletin of The Korean Astronomical Society
• /
• v.3
• /
• pp.11-17
• /
• 1978

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2014.10a
• /
• pp.299-301
• /
• 2014

본 논문에서는 직류 오프셋 (DC-offset) 제거 기능을 가진 저 전력 자동 이득 조절 증폭기 (PGA, Programmable Gain Amplifier)를 제안한다. 이러한 회로는 직류 오프셋 문제점을 해결하기 위해 기존의 gm-boosting 증폭기를 변형한 디지털 이득 제어 방식으로 설계되어 있기 때문에 우수한 선형성을 가진다. 또한 특수 목적에 맞도록 그 이득을 6dB에서 60dB까지 7단계로 조절 가능하며, 밀러효과를 이용한 AC-coupling 방식으로 큰 값의 유동적인 커패시터와 저항을 구현하여 직류 오프셋을 제거한다. 제안한 PGA는 기존 회로에 비해 0.2dB 보다 작은 이득오차와 0.47mW의 낮은 소비전력 특성을 보였다.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.4 no.4
• /
• pp.2-12
• /
• 1967

A pair of insulated-gate metal-oxide-semiconductor field-effect transistor has been used to measure the direct current produced from the ionization chamber in the range of to A. An analisis of direct-current differential amplifier giving the expressions of the common-mode rejection ratio and the rralization of the constant-current generator to give very large effective source resistance has been presented. Voltage gain is 6.6, drift at the room temperature is 1.5mv per day. The common-mode rejection ratio is obtained maximum 84db. These facts give the feasibility of small direct-current measurements by utilizing this type transistors.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1998.06e
• /
• pp.177-180
• /
• 1998

높은 Q가 요구되는 고주파 신호 처리용 필터 설계에서는 흔히 SC 필터를 사용하고 있다. 처리하고자 하는 신호가 고주파수이고, 선택도 Q 값이 매우 높은 경우에는, SC 필터에 사용하는 증폭기의 성능이 빠르고, 직류 성분 이득이 커야만 한다. 이와 같은 속도와 이득이 요구됨에 따라 일반적인 범용 증폭기는 이득이 충분치 못하여 사용이 제한되고, 설사 범용 증폭기를 이용하여 필터를 구성하였다 해도 그 특성에 많은 제한을 줄 수밖에 없다. 또한 GaAS MESFET op amp의 경우, 최근의 논문에서도 60[dB] 이상의 이득이 제안된 바 없으므로, 필터 구성시 또 다른 설계 기술이 요구된다. 따라서 본 논문에서는 GaAS MESFET 능동 SC 적분기의 유한한 이득과 offset 전압을 보정한 새로운 구조의 적분기를 제안한다.

• Proceedings of the KIPE Conference
• /
• 2012.11a
• /
• pp.1-2
• /
• 2012

본 논문에서는 직류배전의 보호를 위한 고장전류제한기술을 제안한다. 제안된 전류제한기는 PWM스위칭 방식으로 동작하며 차동증폭기, 비교기, MOSFET스위치와 게이트드라이버로 구성되어 있다. 전류제한기는 부하 측의 단락사고나 돌입전류를 제어하기 위한 목적으로 직류리액터 $L_f$에 흐르는 전류를 센싱하여 기준전류 $L_{ref}$보다 높게 흐르려는 경우 MOSFET은 ON/OFF스위칭 하여 기준전류 $L_{ref}$이상으로 흐르지 못하게 함으로써 과전류가 흐르는 것을 방지한다. 제안된 전류제한기의 성능을 실험을 통하여 검증 한다.

• Journal of the Korean Society of Radiology
• /
• v.11 no.3
• /
• pp.101-108
• /
• 2017

DC/DC switching power converters are commonly used to generate a regulated DC output voltage with high efficiency. The advanced DC/DC converter uses a PWM-IC with OP-Amp. (Operational Amplifier) to control a MOSFET (metal-oxide semiconductor field effect transistor), which is a switching component, efficiently. In this paper, it is shown that the electrical characteristics of OP-Amp. are affected by radiations of ${\gamma}$ rays using $^{60}Co$ for TID (Total Ionizing Dose) testing and 5 heavy ions for SEL (Single Event Latch-up) testing. TID testing on OP-Amp. is accomplished up to the total dose of 30 krad, and the cross section($cm^2$) versus LET($MeV/mg/cm^2$) in the OP-Amp. operation is evaluated SEL testing after implementation of the controller board.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.10 no.2
• /
• pp.23-35
• /
• 1973

To deal with electronic circuits analysis, the matrix-topological formulation is described. In addition to the classical mesh, node and outset method, a mixed analysis is described, and it is presented that any electronic circuits problem, including dc, ac, transient anatysis, can be analysed by the electronic circuit analysis program. In this paper a model of two stage transistor audio amplifier is made and frequency characteristics for the cicuits are analysed by ECAP. The measured results give good agreement with the ECAP analysis.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.3 s.345
• /
• pp.68-77
• /
• 2006

This paper presents a new Design-for-Testability (DfT) circuit for 4.5-5.5GHz low noise amplifiers (LNAs). The DfT circuit measures gain, noise figure, input impedance, input return loss, and output signal-to-noise ratio for the LNA without external expensive equipment. The DfT circuit is designed using 0.18m SiGe technology. The circuit utilizes input impedance matching and DC output voltage measurements. The technique is simple and inexpensive.

• 제어로봇시스템학회:학술대회논문집
• /
• 1996.10b
• /
• pp.52-55
• /
• 1996

In order to establish the robust current controller design technique of series wound motor driver system. This paper proposes a method of compensated Bang-Bang current control using a series wound motor driver system under improperly variable load. To get minimum time torque control. A compensated Bang-Bang current controller structure is simpler than the structure of PID plus Bang-Bang controller. This paper shows that a general 8 bits microprocessor be used efficiently implementing such an algorithm. The calculation time of software is extremely small when compared with conventional PID plus Bang-Bang a controller. Both nonlinear operating characteristics of Digital switching elements and Describing Function methods are used for the analysis and synthesis. Real time implementation of compensated Bang-Bang current is achieved. Concept design strategy of the control and PWM waveform generation algorithms are presented in the paper.

• Journal of the Korea Convergence Society
• /
• v.7 no.3
• /
• pp.77-85
• /
• 2016

We propose a digital signal processing technic that can compensate the non-linearity inherent in audio amplifiers, and present the result of the simulation. The inherent non-linearity of the audio power amplifier arising from analog devices is compensated via a digital signal processing technic consisting of indirect learning architecture and an adaptive filter. The simulation results show that the compensator can be realized using a third-order polynomial and compensates odd-order non-linearity efficiently. The even-oder non-linearity is mainly due to the dc offset at the output, which is difficult to eliminate with the proposed method. Care must be taken in designing the bias circuit to avoid the DC offset at the output. The proposed technic has significance in that digital signal processing technic can compensate for the impairment that is an inherent characteristic of an analog system.