• Journal of the Korean Geotechnical Society
• /
• v.30 no.10
• /
• pp.19-31
• /
• 2014

In order to investigate ground state change visually in physical model during centrifuge testing, electrical resistivity survey was adopted. Commercial resistivity survey equipment verified at various in-situ sites was utilized. The resistivity survey equipment installed in centrifuge facility was remotely controlled through intranet and electrical resistivity images obtained while centrifuge testing was being checked by real-time inversion. To verify the stable operation of the developed resistivity survey system, preliminary tests were conducted. Model ground was uniformly constructed using unsaturated soil and saline water was dropped on the ground surface to simulate contaminant flow situation. During the 10 g centrifuge tests, electrical resistivity was continuously detected and the testing results were compared with those of identically carried out 1 g centrifuge tests. In addition, the electrical resistivity was directly measured immediately after the centrifuge test by open cutting the model. Finally, reliability of electrical resistivity survey in the centrifuge test was verified by comparing those testing results.

• Journal of Soil and Groundwater Environment
• /
• v.12 no.5
• /
• pp.9-18
• /
• 2007

Soil vapor extraction (SVE) is an effective and cost efficient method of removing volatile organic compounds (VOCs) and petroleum hydrocarbons from unsaturated soils. However, soil vapor extraction becomes ineffective in soils with low gas permeability, for example soils with air permeabilities less than 1 Darcy. Incorporating PVDs in an SVE system can extend the effectiveness of SVE to lower permeability soils by shortening the air flow-paths and ultimately expediting contaminant removal. The objective of the research described herein was to effectively incorporate PVDs into a SVE remediation system. The test results show that the gas permeability was evaluated for four different equivalent diameters, increasing the equivalent diameter results in a decrease in the calculated gas permeability. It was found that the porosity for the dry condition was greater than that of the wet condition and will allow flow rate for the same vacuum flow, offering a low resistance to the air flow.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.8
• /
• pp.117-127
• /
• 2007

Slope stability analysis is a geotechnical engineering problem characterized by many sources of uncertainty. Some of them are connected to the uncertainties of soil properties involved in the analysis. In this paper, a numerical procedure for integrating commercial finite difference method into probabilistic analysis of slope stability is presented. Since the limit-state function cannot be expressed in an explicit form, the ANN-based response surface method is adopted to approximate the limit-state function and the first-, second-order reliability method and the Monte Carlo simulation technique are used to calculate the probability of failure. Probabilistic stability assessments for a hypothetical two-layer slope and the Sugar Creek embankment were performed to verify the application potential to the slope stability problems. The examples show the successful implementation and the possibility of the extension of the proposed procedure to the variety of geotechnical engineering problems.

• Geotechnical Engineering
• /
• v.9 no.4
• /
• pp.27-36
• /
• 1993

The drained and undrained behavior of pure silt was investigated experimentally. Special attention was given to the stress-strain behavior of silt prior to failure and behavior at failure under monotonic and cyclic loading. A pure silica flour was chosen to form samples with two different densities of D,=80%, eo=0.68 and D,=35%, eo=0.9. The isotropically consolidated samples were tested in the triaxial testing device under monotonic undrained, drained compression and extension conditions. Also samples were tested under cyclic undrained condition. Based on the experimental results. it was qualitively identified that the overall behavior of silt is similar to that of sand. When compared with clay, silt shows a significantly different behavior due to its dilatant nature under both the monotonic and cyclic shear loadings.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.02a
• /
• pp.42-58
• /
• 2000

본 연구의 목적은 연약지반의 압밀계수 측정에 있어 Piezocone 관입시험을 이용할 때 관입시험자체의 정확성과 시험결과들에 미치는 여러 가지 지반공학적 영향요소들을 고려하려는데 있다. 본 연구의 연구실험방법으로는, Piezocone 관입을 위한 연약모형지반 조성을 위하여 초대형 Slurry Consolidometer에 Free Stress 상태의 Slurry를 45일간 압밀시킨 후 Automatic Computer Control Calibration Chamber (LSU/CALCHAS; Louisiana State University Calibration Chamber System)에 옮긴후 다시한번 압밀시키는 Two-Stage Consolidation Method를 사용하였다 동시에 연약모형지반내에 8개의 Piezometer를 설치하여 Piezocone 관입시 유발되는 지반 내에서의 과잉간극수압의 변환을 측정하였다. 총 25개의 Piezocone 시험중 4개는 Standard 10$\textrm{cm}^2$ Piezocone이고, 나머지 21개는 Miniature Piezocone이 사용되었다. 모형지반은 여러 가지 Boundary Condition들과 Stress Condition 그리고 Stress History등을 고려하여 조성되었다. 또한 Dissipation Test직후의 압밀특성을 확인하기 위하여 0.01초당 한 개이상의 실측점을 측정할 수 있는 Digital-Oscilloscope를 이용하였다. 특히 Dissipation Test, 즉시 Piezocone의 Filter Element에 잡히지 않는 과잉간극수압의 Initial Drop 존재에 관한 기존의 추측을 실제 실험치로 확인할 수 있었다.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.5
• /
• pp.67-77
• /
• 2006

Bearing capacity of soil can be improved by several conventional ground improvement techniques like stabilization and compaction. Recently, the necessity on the reseaches for the bearing capacity of footing reinforced by Geotextile is being significantly increased. In this paper, a series of model tests on sandy ground reinforced by a layer of Geotextile were performed under plane strain condition, and the effects of bearing capacity improvement and behaviour of sandy ground were observed through tests for position and horizontal length, material strength of reinforcement.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1992.10a
• /
• pp.131-136
• /
• 1992

발파공법은 비 점토성 지반의 심층 개량처리에 있어서 경제적이며 실용성 있는 방법이다. 발파에 의한 흙의 다짐효과는 복잡한 과정을 통하여 이루어지며 좋은 결과를 얻기 위해서는 발파 계획에 있어서 동 공법의 작용원리를 잘 이해하고 적용하여야 한다. 본 연구에서는 발파공법에 의한 흙의 다짐효과에 관한 과거의 연구자료를 광범위하게 조사하였다. 지반개량 작용원리에 관련하여 특별한 현상과 증거를 제시하는 실제 사례 자료를 기초로 하여 현재까지 흙의 밀도증가 요인을 설명해 온 개념은 발파에 수반되어 주변 주반에 발생하는 지반거동현상을 설명하기에 부족함이 있음을 지적하였다. 또한 발파지점 부근에 형성되는 액상화 영역과 그 외부 영역에서 각각 발생되는 과인간극수압 및 지반응력상태, 이에 따른 지반침하 형태 그리고 개량지반의 강성 및 강도특성에 관하여 고찰하였다.

• Journal of the Korean GEO-environmental Society
• /
• v.22 no.11
• /
• pp.31-37
• /
• 2021

To prevent accidents due to the cavities and loosened layers formed due to water leakage from the deteriorated buried pipes, evaluation of the changes in water contents around the buried pipes is required. As a method to evaluate the water contents of the soils, time domain reflectometry (TDR) system can be adopted. However, slender electrodes used in standard TDR probe may be damaged when buried in the ground. Thus, in this study, buried type TDR module was developed for the evaluation of the water contents with maintaining required shape of the electrodes in the ground. The TDR module is composed of three electrodes connected to the core conductor and outer conductor and a casing to prevent deformation and maintain alignment of the electrodes in the ground. For the verification of TDR waveforms measured using the TDR module, comparative analysis was conducted with the TDR waveforms measured using the standard TDR probe, and the relationship between the volumetric water content of the soils and the travel time of the guided electromagnetic wave was constructed. In addition, a model test was conducted to test the applicability of the buried type TDR module, and the experimental result shows that the TDR module clearly evaluates the changes in volumetric water contents due to the leakage from the modeled buried pipe. Therefore, the buried type TDR module may be effectively used for the health monitoring of the buried pipe and the evaluation of the water contents around the pipes buried in the urban pavements.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.03a
• /
• pp.973-976
• /
• 2009

This paper shows that the method of validation on performance-based design is studied on geotechnical conditions. In the design of structure foundation are studied the evaluation items on this matter.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1995.10a
• /
• pp.25.1-33
• /
• 1995

지반공학 및 지반환경분야에서 문제의 관건은 표층과 흙의 성질에 대한 정보를 정확히 파악하는 것이다. 표층의 상황은 어느 현장이나 공간적으로 그 성질을 달리하므로 기술자의 경험이나 지구통계학을 이용하여 적절한 현장의 상태를 분석하게 된다. 휴스톤대학에 위치한 미국국립시험현장에서 수행한 28개의 콘관입시험을 통해 얻은 자료를 가지고 지구통계학적분석을 하여 비배수 전단강도의 3차원적 형태를 파악하였다. 본 연구를 통하여 지구통계학의 유용함과 현장의 변화가 상당함을 쉽게 이해하게 된다.