• Geotechnical Engineering
• /
• v.4 no.2
• /
• pp.15-24
• /
• 1988

To identify the stability of cantilever retaining wall in safe state by the deterministic method, these potential modes of such geotechnical failures as bearing capacity, horizontal sliding and overturning are analysed using Advanced First Order Second Moment (AFOSM) method. All design variables are assumed of the normal distribution and to be statistically independent. Considering the correlations between the single modes, structural system reliability index is 2. 05. Even if the safety factors are larger than the required value in the codes' by the conventional deterministic method, the system reliability of this structure may not be Judged to be safe state since the system reliability index is much lower than general value of 3.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.5
• /
• pp.5-16
• /
• 2001

소일네일링 구조물의 설계 및 안정해석에 관한 지금까지의 연구는 대부분 굴착 배면지반의 자중만을 고려하여 연구 개발된 굴착사면에 인접하여 하중이 재하되는 경우, 그의 거동에 관한 연구는 미비한 실정이다. 따라서 본 연구에서는 원심모형시험기를 사용하여 하중재하시 소일네일링 구조물의 거동과 파괴 메카니즘에 관한 매개변수적 실험을 실시하였다. 매개변수적 실험에서는 네일의 길이 및 간격, 네일의 설치각, 하중재하위치 등을 다양하게 변화시키면서 1g 상태에서 축소모형실험을 실시하는 한편, 30g 및 50g까지 중력수준을 증가시킨 상태에서 상재하중실험을 실시하였다. 실험으로부터 얻어진 결과를 바탕으로 하중-침하 특성, 매개변수의 변화에 따른 영향, 중력수준의 증가에 따른 영향, 파괴메카니즘 등을 비교 분석하였다.

• Journal of the Korean Geotechnical Society
• /
• v.16 no.5
• /
• pp.193-201
• /
• 2000

교란상태개념(Disturbed State Concept;DSA)모델릉 이용하여 포화사질토의 동역학적 거동을 모사하는 예측기법을 개발하였다. 실내진동전단시험 자료로부터 DSC모델 매개변수를 찾고, DSC 모델을 이용하여 전개한 응력중분과 변형률중분의 관계를 표현하는 탄소성구성방정식으로부터 진동하중을 받는 지반재료의 간극수압 및 유효응력 변화, 그리고 축자응력-축방향변형률 거동을 예측하였다. 압축 및 인장 재하시에는 DSC모델을 사용하여 변형률 경화(strain-hardening)및 진동하중에 의한 변형률 연화(cyclic-softening)현상을 모사하고, 제하(unloading)시에는 선형탄성모델을 사용하여 근사화하였다. 예측 결과를 실내전단시럼 결과와 비교하여 예측기법을 검증하였다.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.6
• /
• pp.73-81
• /
• 2002

Various CPT-based prediction models far profiling stress history of marine clay at the southern part of the Korean peninsula were investigated by using both statistical analysis and case history study. Preconsolidation pressures($\sigma'$p) and overconsolidation ratio(OCR) estimated by empirical correlations and cone penetration tests were compared with those of laboratory odometer test results. Stress history of marine clay determined by odometer test results was in general overconsolidated at below 10m depth from the mudline, whereas marine clay at below l0m depth from the mudline which has an around 0.3 overconsolidation ratio showed variable stresses and unstable states. Preconsolidation pressures were computed by both empirical methods of the Chen and Mayne(1996) and theoretical method of Konrad and Law(1987). It is estimated that Chen and Mayne(1996)'s prediction method based on pore water pressure is more reliable than any other prediction methods, and their method proved to be the most reliable for overconsolidation ratio estimation. However, it is recommended that Mayne & Holtz(1988) and Mayne & Bachus(1988) methods are more suitable than any other methods for predicting the overconsolidation ratio at an underconsolidated (OCR<1) clay. For these reasons, rather than making use of existing prediction models, development of site specific empirical correlations which considers local characteristics and site conditions may be required due to different local stress history and variable soil properties.

• Journal of the Korean Geotechnical Society
• /
• v.15 no.2
• /
• pp.165-180
• /
• 1999

Static load tests were performed for open-ended piles, closed-ended piles, piles with grouted toe, and base-grouted piles by using calibration chamber. Then vertical bearing capacities determined from load tests were compared with each other. The stability of base-grouted pile during a simulated seaquake was investigated by changing the penetration depth. Also, static load tests and seaquake tests for 2-piles and 4-piles group were performed. The bearing capacity of the pile grouted inside the toe was 11.2~30.8% less than that of open-ended pile because of reduction of base resistance due to disturbance of base soil under pile toe. The bearing capacity of a base-grouted pile was 23.8~33.9% more than that of an open-ended pile and was similar to that of a closed-ended pile. The bearing capacity of base-grouted group pile was increased ; the bearing capacity of base-grouted 2-piles group increased 14.6~31.8% compared to that of open-ended 2-piles group, and that of base-grouted 4-piles group increased 15.3~22.4% compared to that of open-ended 4-piles group. During the simulated seaquake in deep sea, stability of base-grouted pile was found to be dependent on the pile penetration depth. During seaquake motion, single long base-grouted pile longer than 20m was stable and short base-grouted pile shorter than 12m failed. But relatively long base-grouted pile longer than 12m kept mobility state. Bearing capacity of base-grouted group pile with penetration depth less than 7m was degraded a little bit ; so, base-grouted group pile could maintain mobility condition.

• The Journal of Engineering Geology
• /
• v.31 no.2
• /
• pp.135-148
• /
• 2021

Ground subsidence risk ratings obtained from the site investigation during pre-excavation stages could be changed depending on the parameters revealed during construction activities. A method of correcting the pre-excavation ground subsidence risk ratings based on the site conditions observed in the field is suggested in this study. The elevation of groundwater table during the excavation may be different from the predicted value depending on the application of waterproofing methods and construction conditions. The drastic drawdown of groundwater table during the excavation could cause ground subsidence due to soil volume decrease related to consolidation or compression of the ground, whereas the rising of groundwater table caused by the intense rainfall may result in a high potential for ground subsidence due to heaving or boiling of the excavation bottom. Excessive displacements of retaining walls or ground settlements may cause ground subsidence, which also results in a high risk of ground subsidence caused by the destruction of buried pipelines. Reevaluation of ground subsidence risk ratings is suggested considering the fluctuation of groundwater table, condition of groundwater leakage, measured ground displacements, and soil types. Finally, the ground subsidence risk rating system is improved for better evaluation by using 12 factors in 5 categories.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.5
• /
• pp.27-35
• /
• 2004

The goal of this study is to investigate the feasibility of the reference state approach in determining the generalized soil-water characteristic curve that is essential fur characterization of unsaturated soil behavior. The soil-water characteristic curves are obtained from a number of specimens of fine-grained residual soils compacted with different void ratios. Based on the experimental test results, the feasibility of using the liquid limit state as the reference state for predicting the soil-water characteristic curve is verified. Finally, through the regression analysis of experimental data using the equation of Fredlund and Xing (1994), a reliable method is proposed to predict the generalized soil-water characteristic curve of fine-grained residual soils using the liquid limit state as the reference state.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.17 no.5
• /
• pp.553-561
• /
• 2015

In this study, the performance assessment criterion for reasonable maintenance of shield TBM tunnel was presented. The performance assessment items such as crack, leakage, breakage, spalling, exfoliation/detachment, efflorescence, quality condition, exposure of steel, carbonation, faulting step, bolts condition, drainage condition, ground condition, contact section condition and conduit condition were selected by analyzing domestic and foreign performance assessment criterions and investigating segment lining deterioration cases through the site investigation and in-depth inspection analysis result on the shield TBM tunnel. In addition, the reasonable weight using AHP (Analytic Hierarchy Process) were estimated.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.1
• /
• pp.77-92
• /
• 2003

A set of standard triaxial testing was performed to identify underlying physical processes and inherent limitations in the determination of critical state parameters in sandy soils. The experimental test results showed that the critical state friction angle for a given soil is constant regardless of drainage condition while the critical state line on the e-log p'space is significantly affected by drainage condition mainly because of insufficient strain attained in standard triaxial tests and strain localization effects in udrained tests. It appeared that the best method to determine critical state parameters in laboratory testing is to use homogeneous loose specimens under drained shear condition. In addition, a reference state parameter was suggested to design tests that will avoid dilatancy or strain localization effects in drained tests.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.4
• /
• pp.57-70
• /
• 2001

한계상태이론은 정규압밀 및 과압밀시료에 대한 비배수 전단강도와 간극수압계수에 관한 식을 제안하고 있는데, 이 식은 3가지 상수를 포함하고 있다. 한계상태상수(M), 한계상태 간격비(${\gamma}$), 한계상태 간극수압계수(Λ)가 바로 그것이며, 이러한 상수는 각 모델 및 구하는 방법에 따라 그 차이가 발생함으로서, 전단강도 및 간극수압계수의 예측시 적지 않은 영향을 미치게 된다. 본 논문에서는 재 성형된 이암풍화토를 이용하여 등방삼축압축시험을 정규압밀과 과압밀로 나누어 실시하고 그 결과를 분석하였으며 이를 토대로 각 모델 및 방법에 따른 상수를 도출하였다. 그리고 이러한 상수의 차이가 비배수 전단강도 및 간극수압계수의 예측에 미치는 영향을 살펴보았다. 시험결과 정규압밀시료의 경우 각 상수의 변화에 따른 비배수 전단강도 및 간극수압계수는 상당한 차이를 보였으며, 한계상태간격비와 Λ값을 강도비로부터 얻어진 값을 사용한 경우가 결과치에 가장 잘 근접함을 알 수 있었다. 과압밀시료의 경우 역시 이들 상수에 따라 전단강도의 변화폭이 크게 나타났으며 정규압밀과 마찬가지로 강도비에서부터 도출된 상수를 적요한 경우 실측치에 가장 근접하였다. 반면 간극수압계수의 예측시에는 상수에 따른 변화폭이 크지 않았으며, 특히 과압밀비가 증가할수록 각 상수에 대한 영향이 작게 나타났다.