• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.10 no.6
• /
• pp.389-393
• /
• 2000

High-quality $Er^{3+}$ doped Mg : $LiNbO_3$single crystal fibers were grown by a micro-pulling down ($\mu$-PD) method. Single crystal fibers were pulled down through the nozzle, at a pulling down rate of 0.5 mm/min and using a Pt crucible with a nozzle 1 mm in diameter in air atmosphere. Defects such as bubbles, cracks and inclusions were not detected in any of the grown crystals. The optical transmission of Er : Mg : $LiNbO_3$crystal was measured and the energy levels of $Er_2O_3$ ion could be calculated. The photoluminescence spectrum of crystal fibers showed an energy band emission with the strongest line corresponding to the $^4I_{3/2}{\to}^4I_{15/2}$transition. The concentration dependence of the entire wavelength region emission intensity upon excitation intensity measured emission intensity for the 3 mol% MgO doped fibers was larger than that for the 1, 5 mol% MgO doped fibers.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.198.1-198.1
• /
• 2012

저궤도 위성이 발사체에서 분리된 후 탑재 소프트웨어에 의한 초기 동작이 수행되고 나면 초기 운용이 시작된다. 초기 운용 기간에 수행할 모든 절차와 대처 가능한 긴급 상황이 발생할 경우 수행할 절차는 발사 전에 미리 준비된다. 위성의 각 부분의 설계 마진은 최악 조건을 기준으로 반영되어 있기 때문에 발사 이후의 버스 시스템 관점에서의 위성 특성은 요구 사항을 만족하는 범위가 될 것으로 예상이 가능하다. 실제로 발사 후 위성 텔레메트리 분석을 통해 대부분의 항목에서 요구 조건을 만족하는 것으로 확인되었다. 또한 텔레메트리 분석을 통해 설계 단계에서 예상했던 것 보다 정확한 궤도 특성이 반영된 위성 특성을 파악하였다. 이러한 특성은 설계 시 고려했던 상황과 다르더라도 실제 궤도 특성이 반영된 특성이므로 초기 운용 및 정상 운용 시에 정상적인 상황인 것으로 고려해야 한다. 첫째, 지구 알베도 특성에 따라 태양센서 값이 궤도에 따라 변화한다. 위성의 자세가 정확히 태양을 지향하고 있더라도 태양센서에 지구에서 반사된 빛이 입사되어 자세 제어에 영향을 주게 된다. 알베도의 영향은 적도에서 극지방으로 갈수록 커지며, 계절에 따라 다른 특성을 보인다. 알베도의 영향을 최소화하기 위해 자세 제어 모델에 알베도 효과를 고려하거나 알베도 효과를 무시할 수 있을 정도로 자세 제어 오차 한계를 조정할 수 있다. 둘째, 위성의 지구 회피 회전에 의해 태양 전지판의 온도가 궤도에 따라 변화한다. 위성체는 위성체에 장착된 두 개의 별센서의 가시성 확보를 위해 태양 지향 자세에서 요축으로 일정 속도로 회전한다. 남극 부근에서는 두 태양 센서가 모두 지구의 반대편인 남쪽을 지향하도록 하며, 북극 부근에서는 북쪽을 지향하도록 한다. 이 때 두 태양 센서의 방향에 장착된 태양 전지판은 극지방에서 지구 반대편에 위치하므로 다른 태양 전지판에 비해 낮은 온도를 갖게 된다. 이 논문에서는 위성의 궤도 특성에 따른 고려 사항에 대해 설명하였다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.11
• /
• pp.2534-2539
• /
• 2015

Method for regulating voltage using a generator voltage regulating device (AVR) is divided in an existing analog system and a digital replacement. Typically, to adjust the voltage by using a brushless excitation system of the type to be reduced for a voltage change under all. The control method of the AVR as a PID (proportional-integral-differential) control method is widely used. However, the control scheme is to reduce the transient response of the control parameters of the controller to the control object. Therefore, if the control target should change, there is a problem, reset the parameters of the controller again. In this study, without having to reset the parameters of the controller for the parameter variations to be controlled iPID (intelligent PID) using a controller designed to obtain a generator AVR system voltage variation is small in response to full load is applied to and through simulations and experiments improved transient response.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2010.05a
• /
• pp.959-962
• /
• 2010

There are a lot of methods available in designing PID(Proportional-Integral-Derivative) and Lead/Lag controllers in the industrial field of technology because of their useful advantages such as simplicity and robustness. In an early stage of development process, a computational simulation approach is a very efficient tool for the designs of the controllers. Thus, in this paper we propose a cost-effective, and practically efficient. The PID and Lead/Lag controllers. To show the effectiveness of the proposed Lead/Lag controller, we compare and contrast of the simulation results of each controller with the Matlab simulator. Although we have only considered the DC motors for the controllers, but it could be extended in future developments to more complex plants. As a result, the proposed frameworks could be used to solve industrial problems such as a reduction in development cycle time and minimizing system errors.

• Journal of the Institute of Convergence Signal Processing
• /
• v.4 no.3
• /
• pp.49-54
• /
• 2003

In this paper, we propose a controller with the self-organizing neural network compensator for compensating PID controller's response. PID controller has simple design method but needs a lot of trials and errors to determine coefficients. A neural network control method does not have optimal structure as the parameters are pre-specified by designers. In this paper, to solve this problem, we use a self-organizing neural network which has Back Propagation Network algorithm using a Gaussian Potential Function as an activation function of hidden layer nodes for compensating PID controller's output. Self-Organizing Neural Network's learning is proceeded by Gaussian Function's Mean, Variance and number which are automatically adjusted. As the results of simulation through the second order plant, we confirmed that the proposed controller get a good response compare with a PID controller. And we implemented the of controller performance hydraulic servo motor system using the DSP processor. Then we observed an experimental results.

• Korean Journal of Food Science and Technology
• /
• v.30 no.4
• /
• pp.733-738
• /
• 1998

Tannic acid (TA), chlorogenic acid (GA) and caffeic acid (CA) as copigments were added in anthocyanin solutions (pH 3.0) to test their effects on the stability against temperatures, metal ions, and light. Absorbance of anthocyanins increased with the increase of copigment concentrations. Tannic acid showed the highest absorbance increase with bathochromic shift of 14 nm (from 514 nm to 528 nm). Copigmentation resulted in higher storage stability of anthocyanins for 21 days at room temperature $925^{\circ}C)$ but lower thermal stability at higher temperatures more than $70^{\circ}C. Addition of metal ions to TA caused the enhanced stability as well as increased absorbance of anthocyanins. Copigmentation also caused a significant increase of light stablilty of anthocyanins at room temperature, so that addition of TA showed 2.3 times showed photodegradation of anthocyanins under 20,000 lux-light dosage in pH 3.0 solution at $25^{\circ}C$.

• Smart Media Journal
• /
• v.6 no.2
• /
• pp.26-32
• /
• 2017

In this paper, we implement a signal-detecting electric circuit based LED lighting control system which is essential in NUI technology using EPIC converting surrounding earth electric field disturbance signals to electric potential signals. We used signal-detecting electric circuits which was developed to extract individual signal for each EPIC sensor while conventional EPIC-based development equipments provide limited forms of signals. The signals extracted from our developed circuit contributed to better performance as well as flexiblity in processes of feature extracting stage and pattern recognition stage. We designed a system which can control the brightness and on/off of LED lights with four hand gestures in order to justify its applicability to real application systems. We obtained faster pattern classification speed not only by developing an instruction system, but also by using interface control signals.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.26 no.6
• /
• pp.485-492
• /
• 2016

A role of the binarization is very important in separating the foreground and the background in the field of the computer vision. In this study, an adaptive fuzzy binarization is proposed. An ${\alpha}$-cut control ratio is obtained by the distribution of grey level of pixels in a sliding window, and binarization is performed using the value. To obtain the ${\alpha}$-cut, existing thresholding methods which execution speed is fast are used. The threshold values are set as the center of each membership function and the fuzzy intervals of the functions are specified with the distribution of grey level of the pixel. Then ${\alpha}$-control ratio is calculated using the specified function and binarization is performed according to the membership degree of the pixels. The experimental results show the proposed method can segment the foreground and the background well than existing binarization methods and decrease loss of the foreground.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.11
• /
• pp.137-146
• /
• 2015

In this paper, we propose a pothole detection method using various features of intensity and motion. Segmentation, decision steps of pothole detection are processed according to the values which are derived from feature characteristics. For segmentation using intensity, we use a binarization method using histogram to separate pothole region from background. For segmentation using motion, we filter using high pass filter and get standard deviation value. This value is divided by regression value according to camera environment such as photographing angle, height, velocity, etc. We get binary image by histogram based binarization. For decision, candidate regions are decided whether pothole or not using comparison of candidate and background's features. Experimental results show that our proposed pothole detection method has better results than existing methods and good performance in discrimination between pothole and similar patterns.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2018.05a
• /
• pp.278-278
• /
• 2018

현재 우리나라에서는 행정안전부의 풍수해저감종합계획, 사전재해영향성검토협의, 재해위험지구개선사업 등에 해외에서 개발된 상용프로그램이 사용돼 접근성 저하로 인해 지자체 방재담당자의 실무나 대학에서 연구용으로 다루기에는 한계가 있다. 이에 본 연구에서는 내수침수, 외수침수, 2차원 침수해석으로 구성하여 GUI 기능을 강화한 통합침수재해지도 작성시스템(i-FIM, Integrated Flood Inundation Modeling system)을 개발하여 입력자료의 구성 및 매개변수의 수정이 용이하게 함으로써 하수관망 등에 부분적인 설계 변경이 있는 경우 지자체 방재담당자가 간단한 작업을 통해 침수영향 변화를 쉽게 파악할 수 있도록 하였다. 또한, 상세한 지형의 반영이 필요한 도시지역의 2차원 침수해석의 경우 계산격자 망의 크기가 작아질수록 소요되는 계산시간이 기하급수적으로 증가하는 한계가 있어 i-FIM에서는 계산격자를 $2{\times}2$, $3{\times}3$, $5{\times}5$ Subgrid 형태의 격자를 적용하고, 병렬프로그래밍과 계산시간조정 기능을 추가하여 2차원 침수해석 모형의 계산 속도를 향상시켰다. 이를 실무에 적용하기 앞서 2006년 집중호우로 인해 안성시에서 발생한 제방 붕괴사상, 2016년 태풍 차바로 인해 울산시에서 발생한 제방 월류 사상을 통해 침수흔적도와 비교하여 검증을 실시하였다. i-FIM에서 최종적인 2차원 침수해석 결과는 2017년에 개정된 '재해지도 작성 기준 등에 관한 지침'의 침수심 등급 구분의 색채 설정에 따라 각 격자별 침수심을 표출함으로써 표준화된 재해지도 작성이 가능하도록 하였다. 또한, 포털사이트의 지도 및 위성지도에 표출함으로써 침수 위험이 발생할 수 있는 지역의 현재 이용 용도를 파악하여 침수재해에 대한 상세한 대책을 마련할 수 있을 것으로 판단된다.