• Journal of the Korean Ceramic Society
• /
• v.39 no.4
• /
• pp.346-351
• /
• 2002

The electrical conductivity and phase stability of $ZrO_2$ doped with $Sc_2O_3$ and $CeO_2$ were investigated in order to search for better solid electrolyte material for solid oxide fuel cell. Present study showed that $ZrO_2$ doped with $Sc_2O_3$ and $CeO_2$ exhibited no phase transition during the heat treatment up to $1350^{Circ}C∼1550^{Circ}C$ and was stable as a cubic phase in whole temperature ranges. The $ZrO_2$ doped with $Sc_2O_3$ and $CeO_2$ showed much higher electrical conductivity than YSZ in the temperature range of $300∼^{Circ}C$ and better long term stability than other sc-$ZrO_2$ based electrolyte that showed the possibility as a strong candidate electrolyte material for intermediate-or low-temperature SOFC.

• Analytical Science and Technology
• /
• v.17 no.6
• /
• pp.470-475
• /
• 2004

The mercury film thin layer flow cell (MFTLFC) which yielded the highest sensitivity for the electrochemical reduction of doxorubicin was constructed by coating the glassy carbon working electrode (GCE; $A=0.208cm^2$) with $5{\mu}L$ of HgO coating solution (0.5% HgO + 0.25% polystyrene/cyclohexanone) and subsequently followed by applying a potential of -0.40 V for 300 sec in the flow stream of an acetate buffer of pH 4.5. The voltammogram of doxorubicin reached the diffusion current plateau at -0.53 V vs. a Ag/AgCl (3 M NaCl) in the MFTLFC. The diffusion current (Id) of doxorubicin at the MFTLFC was 1.7 times greater than the Id obtained at the TLFC employing a bare glassy carbon working electrode. When the peak areas (electric charge) were plotted vs. concentrations of standard anthracyclines, the calibration factors of doxorubicin and daunorubicin were $1.12{\times}10^8{\mu}C/M$ (coefficient of determination; $R^2$: 0.969) and $0.98{\times}10^8{\mu}C/M$> ($R^2$: 0.999), respectively in the concentration range between $1.0{\times}10^{-8}M$ and $1.0{\times}10^{-6}M$.

• Nuclear Engineering and Technology
• /
• v.27 no.4
• /
• pp.453-462
• /
• 1995

In connection with the safe storage of high level nuclear waste, effect of $H_2O$$_2$ on the corrosion behavior of 304L stainless steel was examined. Open circuit potentials and polarization curves were measured with and without $H_2O$$_2$. The experimental results show that $H_2O$$_2$ increased corrosion potential and decreased pitting potential. The passive range, therefore, decreased as $H_2O$$_2$ concentration increased, indicating that pitting resistance was decreased by the existence of $H_2O$$_2$ in the electrolyte. These effect of $H_2O$$_2$ on corrosion of 304L stainless steel are considered to be similar to those of ${\gamma}$-irradiation. To compare the effects of $H_2O$$_2$ with those of $O_2$, cathodic and anodic polarization curves ore made in three types of electrolyte such as aerated, deaerated, and stirred electrolyte. The experimental results show that the effects of $H_2O$$_2$ on the corrosion behavior were tory similar to those of $O_2$ such as increase of corrosion potential, decrease of pitting resistance, and increase of repassivation potential. In acid and alkaline media, the corrosion potential shifts by $H_2O$$_2$ were restricted by the large current density of proton reduction and by the le Chatelier's principle respectively.y.

• Membrane Journal
• /
• v.16 no.4
• /
• pp.268-275
• /
• 2006

Novel SILEMs were prepared by multi-stage phase separation process combined by the low temperature phase separation (LTPS) and the high temperature phase separation (HTPS) using room temperature ionic liquids (RTILs) which have a high ionic conductivity. PVDF and imidazolium series ionic liquids were used as membrane material and electrolyte, respectively. To study the ion conducting properties, the SILEMs were tested using LCR meter at temperature controlled from 30 to $130^{\circ}C$. Under humid conditions, with increasing temperature from 30 to $100^{\circ}C$, the ion conductivity of the cast $Nafion^{(R)}$ membrane increased linearly, but then started to decrease after $100^{\circ}C$. However, in the case of the SILEMs, with increasing operating temperature, the ion conductivity increased. Also, the ion conductivity behaviors of the SILEMs were almost same, regardless of humidity. The ion conductivity of the SILEMs was $2.7{\times}10^{-3}S/cm$ and increased almost linearly up to $2.2{\times}10^{-2}S/cm$ with increasing temperature to $130^{\circ}C$. The effects of an inorganic filler on the physical properties of the SILEMs were studied using the $SiO_2$. The addition of $SiO_2$ could improve the mechanical strength of the SILEMs, though the ionic conductivity was decreased slightly.

• Applied Chemistry for Engineering
• /
• v.9 no.5
• /
• pp.734-741
• /
• 1998

Electrode characteristics were studied in the interface between sample solutions and $K^+$ ion selective PVC membrane electrodes containing neutral carriers, dibenzo-18-crown-6(D18Cr6) and valinomycin(Val). The effect of doping of base electrolytes, the chemical structure and the content of carrier, variation of plasticizer, membrane thickness, and concentration variation of sample solution on the response characteristics of electrode such as the measured Nernstian slope, the detection limit, the linear response range, and potentiometric selectivity coefficients, were studied. In order to synthesize the membrane D18Cr6 and Val as neutral carriers were used, and complex between the carrier and $K^+$ ions were used as active materials. PVC membrane electrodes were made of plasticizers (DBP, DOS, and DBS), the base electrolyte[potassium tetraphenylborate(KTPB)], and solvent(THF). The chemical structure of carrier D18Cr6 was best for electrode and ideal electrode characteristics were appeared especially in case of doping of TPB. The optimum carrier content was about 3.23 wt % in case of D18Cr6 and Val. DBP was best as a plasticizer. As membrane thickness decreased the electrode characteristics was improved. But its characteristics were lowered below the optimum membrane thickness because of the elution of carrier, deterioration of membrane strength, etc. In the case of D18Cr6, the selectivity coefficients by the mixed solution method for the $K^+$ ion were in the order of $NH_4{^+}>Ca^{2+}>Mg^{2+}>Na^+$.

• Korean Journal of Food Science and Technology
• /
• v.34 no.6
• /
• pp.998-1001
• /
• 2002

Micro-LC method for the quantitative determination of hydrogen peroxide in foods has been established. This method was carried out on cation-exchange resin gel column using distilled water as mobile phase with 50 mM sodium sulfate as electrolyte. The detection was performed with an electrochemical detector (ECD) at 0.6 voltage. Under this analytical condition, the recovery rates of hydrogen peroxide in tomato and lemon were 98.3 and 97.4%, respectively. Among 28 food types, hydrogen peroxide concentrations were 0.6, 0.5, 1.9, 0.9, 0.5, 0.6, 0.9, 0.8, and 0.4 ppm in banana, peach, orange, strawberry, pepper, onion, cucumber, burdock, and egg plant, respectively, Whereas none was detected in remaing 19 samples.

• Journal of the Korean Electrochemical Society
• /
• v.22 no.4
• /
• pp.139-147
• /
• 2019

Lithium-ion battery (LiB) with high energy density and efficiency has been utilized for the electric vehicle (EV) and energy storage system (ESS) as well as portable devices. However, as explosion accidents have frequently happened till lately, all-solid-state lithium secondary battery (ALSB) began to get in a spotlight because it can secure a very high safety and energy density by substituting flammable organic liquid electrolyte to nonflammable inorganic solid electrolyte. In spite of ALSB's certain merits, it has shown much poorer performance of cells than one of LiB due to some challenges, which have been small or never dealt with in the LiB system. Hence, although plenty of studies made progress to solve them, an approach about design of all-solid-state electrode (ASSE) has been limited on account of difficulty of ALSB's experiments. That is why the virtual 3D structure of an all-solid-state electrode has to be built and used for the prediction of cell performance. In this study, we elucidate how to form the 3D ASSE structure and what to be needed for the simulation of characteristics on ALSB. Furthermore, the ultimate orientation of 3D modeling and simulation for the study of ALSB are briefly suggested.

• Journal of Christian Education in Korea
• /
• v.65
• /
• pp.163-187
• /
• 2021

The purpose of this study is to find the implications of Christian education on the relationship between the formation of faith and digital literacy in the Korean society, which is rapidly changing within the fourth Industrial Revolution today through critical conversations on educational contexts. Over the past decade, Korean society has lived in an era of rapid and radical change more than any other time through a new way of life called the Fourth Industrial Revolution. The Korean church is also facing the reality that it must fulfill its urgent mission to deliver the unchanging truth in an ever-changing era. With this in mind, this study (1) identifies digital literacy as an essential competency requested in the era of the fourth industrial revolution by examining the relationship with congregation's life as well as its definition and contents, (2) discovers educational rationale for the relationship between faith formation and digital literacy by applying educational context of Christian education with attention to the educational efficiency of digital literacy, and (3) finds educational implications of digital literacy by re-conceptualizing the contents, context, role of teachers and students, and evaluation in the context of Christian education. I hope that this study will help Christian education serve for the spread of the Gospel of Christ and the realization of the kingdom of God on this earth through digital media in the future more time-responsively and mission-practically.

• Journal of the Korean Chemical Society
• /
• v.63 no.4
• /
• pp.289-306
• /
• 2019

The purpose of this study is to compare the contents of chemistry textbooks developed according to the 2015 revised curriculum with the contents of the 2009 revised curriculum to research the change in "the development and use of models". To do this, we analyzed 8 kinds of Chemistry I textbooks and 6 kinds of Chemistry II textbooks from the 2015 revised curriculum and compared them with 4 kinds of Chemistry I textbooks and 4 kinds of Chemistry II textbooks from the 2009 revised curriculum. The scope of the analysis was the explanations of the textbooks related to aqueous electrolysis experiments. In order to compare the contents regarding electrolytes when the same experiments are interpreted with different models, we analyzed contents of 4 kinds of middle school science textbooks from the 2015 revised curriculum and 9 kinds of middle school science textbooks from the 2009 revised curriculum. As a result of the analysis, the same experiment was explained by different models according to the grade level and unit, and all explanations were limited to a single model. Also, the tendency to limit the kinds of electrolytes for controlled experimental results is more pronounced in the 2015 revised curriculum than in the 2009 revised curriculum. From this results, we suggest that efforts are needed to reflect the "development and use of models" in chemistry textbooks developed according to the 2015 revised curriculum.

• Membrane Journal
• /
• v.29 no.3
• /
• pp.173-182
• /
• 2019

Much research has been made for finding new and eco-friendly alternative sources of energy to solve the problems related with the pollution caused by emissions of greenhouse gases such as carbon dioxide as the use of fossil fuels increases worldwide. Among them, fuel cells draws particular interests as an eco-friendly energy generator because only water is obtained as a by-product. Anion exchange membrane-based alkaline fuel cell (AEMFC) that uses anion exchange membrane as an electrolyte is of increased interest recently because of its advantages in using low-cost metal catalyst unlike the PEMFC (potton exchange membrane fuel cell) due to the high-catalyst activity in alkaline conditions. The main properties required as an anion exchange membrane are high hydroxide conductivity and chemical stability at high pH. Recently we reported a chemically crosslinked poly(2-dimethyl-1,4-phenylene oxide) (PPO) by reacting PPO with N,N,N',N'-tetramethyl-1,6-hexanediamine as novel anion exchange membranes. In the current work, we further developed the same crosslinked polymer but having enhanced physicochemical properties, including higher conductivity, increased mechanical and dimensional stabilities by using the PPO with a higher molecular weight and also by increasing the crosslinking density. The obtained polymer membrane also showed a good cell performance.