• Progress in Medical Physics
• /
• v.25 no.4
• /
• pp.255-263
• /
• 2014

The dosimetry of very small fields is challenging for several reasons including a lack of lateral electronic equilibrium, large dose gradients, and the size of detector in respect to the field size. The objective of this work was to evaluate the suitability of a new commercial synthetic diamond detector, namely, the PTW 60019 microDiamond, for the small field dosimetry in cyberknife photon beams of 6 different collimator size (from 5 mm to 30 mm). Measurements included dose linearity, dose rate dependence, output factors (OF), percentage depth doses (PDD) and off center ratio (OCR). The results were compared to those of pinpoint ionization chamber, diamond detector, microLion liquid Ionization chamber and diode detector. The dose linearity results for the microDiamond detector showed good linearly proportional to dose. The microDiamond detector showed little dose rate dependency throughout the range of 100~600 MU/min, while microLion liquid Ionization chamber showed a significant discrepancy of approximately 5.8%. The OF measured with microDiamond detector agreed within 3.8% with those measured with diode. PDD curves measured with silicon diode and diamond detector agreed well for all the field sizes. In particular, slightly sharper penumbras are obtained by the microDiamond detector, indicating a good spatial resolution. The results obtained confirm that the new PTW 60019 microDiamond detector is suitable candidate for application in small radiation fields dosimetry.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.7 no.4
• /
• pp.366-376
• /
• 2002

A sensor fault detection and isolation scheme(SFDIS) is adopted to improve the reliability of direct torque controlled induction motor drives and the experimental results are discussed. Major contributions include: experimental analysis of a few important sensor faults. design and implementation of the proposed SFDIS, and the fault tolerant control system(FTCS). Although the adopted SFDIS employs only one observer for residual generation, the system has the function of fault isolation that only multiple observer schemes can have. To verify the performance of the proposed scheme, the speed control system is designed for the 2.2kW direct torque controlled Induction motor. Hardware of the control system consists of a control board using TMS320OVC33 and a power stack using IPM. Experimental results for various type of sensor faults show the effectiveness of the SFDIS and the FTCS.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.3
• /
• pp.37-46
• /
• 2012

In RADAR and SONAR detection systems, noise environment can be classified into homogeneous and heterogeneous environment. Especially heterogeneous environments are modelled as target masking and clutter edge. Since the variability-index (VI) CFAR, a composed CFAR algorithm, dynamically selects one of the mean-level algorithms based on the VI and the MR (mean ratio) test, it is robust to various environments. However, the VI CFAR still suffers from lowered detection probabilities in heterogeneous environments. To overcome these problems, we propose an improved VI CFAR processor where TM (trimmed mean) CFAR and a sub-windowing technique are introduced to minimize the degradation of the detection probabilities appeared in heterogeneous environments. Computer simulation results show that the proposed method has the better performance in terms of detection probability and false alarm probability compared to the VI CFAR and single CFAR algorithms.

• Proceedings of the KIPE Conference
• /
• 2012.07a
• /
• pp.262-263
• /
• 2012

3상 새그 보상기는 계통 새그나 사고 발생 시 빠르게 이상상태를 검출하여 계통을 분리하고 수퍼커패시터에 충전된 에너지를 부하에 안정하고 연속적인 정격 전압을 공급하는 장치이다. 그러나 비선형 부하일 때, 3상 새그 보상기의 출력전압에 저차 고조파가 포함된 왜곡이 발생한다. 본 논문에서는 비선형 부하에서도 안정적인 정현파 전압을 공급하기 위해 선택적 고조파 제거 방식을 도입한 전압제어기를 제안 하였다. 새그 보상기 시작품을 제작하였으며, 제안한 선택적 고조파 제거 전압제어기의 타당성을 실험을 통하여 THD가 12.7%에서 4.3%로 개선되는 것을 확인하였다.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.3 no.1
• /
• pp.18-23
• /
• 1966

An experimental study of a steel plate thickness gauge by means of the measurements of backscatered gamma-rays has been carried out. The difference between this and other methods is that this method does not include any shilding matterials in the detecting probe, because the primary radiations and the backscattered radiations are detected simultaneously by an NaI (TI) scintillating crystal, and the activity of the Co-60 source used is low enough. In this thickness gauge, the thickness of the steel plates can be read directly on the counting ratemeter scale. The optimum conditions in the source-to-detector distance, window width of the analyzer, energy and strength of the gamma-ray source were found experimentally. The results have shown that the accuracy of the gauge was about $\pm$3% in the range of 3 to 8mm thickness. This gauge can be used to detect the pits or corrosions on the inner walls of the steel pipes.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.3
• /
• pp.41-50
• /
• 2010

In this paper, an area-efficient symbol detector is proposed for MIMO communication systems with two transmit and two receive antennas. The proposed symbol detector can support both the spatial multiplexing mode and spatial diversity mode for MIMO transmission technique, and shows the optimal maximum likelihood (ML) performance. Also, by sharing the hardware block with multi-stage pipeline structure and using the complex multiplier based on polar-coordinate，the complexity of the proposed architecture is dramatically decreased. The proposed symbol detector was designed in hardware description language (HDL) and implemented with Xilinx Virtex-5 FPGA. With the proposed architecture, the number of logic slices for the proposed symbol detection is 52490 and the number of DSP48s (dedicated multiplier) is 52, which are reduced by 35.3% and 85.3%, respectively, compared with the conventional architecture.

• The Korean Journal of Pesticide Science
• /
• v.2 no.3
• /
• pp.79-84
• /
• 1998

Tandem HPLC and atmospheric pressure chemical ionization(APcI) LC/MS method was used for the determination and confirmation of carbendazim residues in soybean sprout. Fluorescence(FL) detector was connected in tandem with the ultraviolet(UV) detector for dual detection of the carbendazim residue at the excitation and emission wavelength of 280 nm and 310 nm, respectively. The limit of detection for carbendazim was $0.1{\mu}g/kg$ sample. Recoveries of carbendazim from fortified soybean sprout at 0.5, 1.0 and 2.0 ppm were averaged 89.1%. Mass spectrometry using a APcI source confirmed the carbendazim residue in the soybean sprout sample. Fragmentation pattern on the APcI LC/MS spectrum of carbendazim was simpler than that from electron impact(EI) mass spectrum. Carbendazim produced 3 major ions including m/z 133, m/z 159 and m/z 191($M^{+}$). This method was sensitive enough to provide reliable and reproducible results for practical applications.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.6
• /
• pp.132-142
• /
• 2014

In this paper, we propose a traffic lights detection method using visual attention and spot-lights detection. To detect traffic lights in city streets at day and night time, the proposed method is used the structural form of a traffic lights such as colors, intensity, shape, textures. In general, traffic lights are installed at a position to increase the visibility of the drivers. The proposed method detects the candidate traffic lights regions using the top-down visual saliency model and spot-lights detect models. The visual saliency and spot-lights regions are positions of its difference from the neighboring locations in multiple features and multiple scales. For detecting traffic lights, by not using a color thresholding method, the proposed method can be applied to urban environments of variety changes in illumination and night times.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.2 no.4
• /
• pp.53-58
• /
• 2009

In recently years, the research and application for sensor has increased in each field. In this paper, the system which can perceive and detect using 3-axis accelerometer sensor and serial communication is proposed. Also, the user has GUI environment for monitor in real-time. In order to reduce unstable data and error defect of electronic rechargeable liquid tilt sensor used digital 3-axis accelerometer sensor which has AD convertor. Therefore, this system provide exact data and a problem of objects for user more easier.

• Journal of the Korean Society of Radiology
• /
• v.18 no.2
• /
• pp.65-71
• /
• 2024

To achieve high resolution and sensitivity of positron emission tomography (PET) for small animals, the detector is constructed using very thin and long scintillation pixels. Due to the structure of these scintillation pixels, spatial resolution deterioration occurs outside the system's field of view. To solve this problem, we designed a detector that could improve spatial resolution by measuring the interaction depth and improve sensitivity by using a quasi-block scintillator. A quasi-block scintillator size of 12.6 mm x 12.6 mm x 3 mm was arranged in four layers, and optical sensors were placed on all sides to collect light generated by the interaction between gamma rays and the scintillator. DETECT2000 simulation was performed to evaluate the performance of the designed detector. Flood images were acquired by generating gamma-ray events at 1 mm intervals from 1.3 mm to 11.3 mm within the scintillator of each layer. The spatial resolution and peak-to-peak distance for each location were measured in an 11 x 11 array of flood images. The average measured spatial resolution was 0.25 mm, and the average distance between peaks was 1.0 mm. Through this, it was confirmed that all locations were separated from each other. In addition, because the light signals of all layers were measured separately from each other, the layer of the scintillator that interacted with the gamma rays could be completely separated. When the designed detector is used as a detector in a PET system for small animals, it is considered that excellent spatial resolution and sensitivity can be achieved and image quality can be improved.