• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.8A
• /
• pp.752-759
• /
• 2010

The low power consumption is the most important design factor for the In-Body communication system of WBAN. The conventional PSSK (Phase-Silence-Shift-keying) modulation technique can be regarded as an extension from PSK modulation. And this PSSK has better power efficiency than PSK modulation, and higher spectral efficiency than FSK modulation. PSSK modulation is to transmit two orthogonal symbols. The transmission power can be lowered because the symbol rate in signal period becomes half. BER performance is improved because transmission power is lower and the modulation symbol distance is widened. In addition, PSSK preserve the low-power and increase the data rate than FSK. In this paper, we analyzed existing PSSK and like to propose a new PSPM (Phase-Shift-Position-Modulation) modulation scheme. This PSPM is evaluated in terms of considered bandwidth efficiency and BER performance, compared with the PSSK. This PSPM modulation method transmits the information data by both PSK symbol data and symbol position data, so that we can significantly improve the power efficiency. New proposed PSPM method could be very useful for the In-body communication that requires the most power efficient system.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.6
• /
• pp.43-49
• /
• 2015

In this paper, we propose enhanced wireless power transfer system based on magnetic resonance for portable electronic device charging. Resonators were designed and fabricated for efficiency improvement and miniaturization through electromagnetism simulation using HFSS(High Frequency Structure Simulator). Impedance matching network is employed to minimize reflections that is caused by difference between input impedance and output impedance. Receiver IC that consist of rectifier and Low Drop Out(LDO) regulator were designed and fabricated to reduce power loss. This chip is implemented in $0.35{\mu}m$ BCD technology. A maximum overall efficiency of 73.8% is determined for the system through experimental verification.

• Journal of Korea Society of Industrial Information Systems
• /
• v.16 no.4
• /
• pp.1-7
• /
• 2011

In this paper, we design rectifing circuits at 910MHz, which is used for passive RFID system, for wireless power transmission system by using two types of schottkey diodes HSMS_2822 and HSMS 2852, and the RF-DC conversion efficiencies for the curcuits are compared and analyzed in terms of input power and load resistance. When the input power is -20 to 17dBm, the conversion efficiency for HSMS_2852 is larger than in case of HSMS_2822. The output voltage and current at the load of the fabricated rectifying circuit are measured through a dipole antenna when input power is transmitted by a RFID reader and the diatance varies. The measured ouput volatge and current for the distance of 50cm are 2.5V and 5.75mA.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.6
• /
• pp.43-48
• /
• 2006

In this paper, the rectenna converting 2.45[GHz] microwave into DC power is designed and fabricated for wireless power transmission using microwave and the methode for impedance matching and tuning are proposed in order to maximize RF-DC conversion efficiency. The fabricated rectenna can be easily tuned by using a broad open stub and has the RF-DC conversion efficiency up to 59[%] when the 5[dBm] input power is applied. The 2.2[V], 1.5[mW] DC level, in the 1[m] distance between the transmitter and the receiver can be obtained and this value is avaliable in the small power digital system.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.2
• /
• pp.85-89
• /
• 2011

In this paper, a novel Class-E power amplifier using metamaterials has been realized with one RF LDMOS diffusion metal-oxide-semiconductor field effect transistor. The CRLH structure can lead to metamaterial transmission line with the Class-E power amplifier tuning capability. The CRLH TL is achieved by the frequency offset and the nonlinear phase slope of the CRLH TL for the matching network of the power amplifier. Also, the proposed power amplifier has been realized by using the CRLH structure in the output matching network for better efficiency. Operating frequencies are chosen at 13.56 MHz in this work. The measured results show that the output power of 39.83 dBm and the gain of 11.83dB was obtained. At this point, we have obtained the power-added efficiency (PAE) of 73 % at operation frequency.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.4B
• /
• pp.520-527
• /
• 2001

육상이동위성 채널에서 고속 광대역의 정보를 효율적으로 전송하기 위한 최적 방안으로 OFDM(Orthogonal Frequency Division Multiplexing) M-ary PSK를 들 수 있다. 그러나 가입자 단말기 또는 위성중계기의 송신단 고출력 증폭기(HPA : High Power Amplifier)를 전력효율적인 비선형 mode에서 동작할 때, OFDM M-ary PSK 시스템의 최대 전력 대 평균전력의 비(PAPR : Peak-to-Average Power Ratio)가 부바송파 개수만큼 선형적으로 커져 단일 반송파 변조방식에 비해 비선형 왜곡에 의한 성능 열화가 심각하다. 본 논문에서는 이와 같은 성능 열화를 개선하기 위하여 전송채널에서 대역효율과 BER(Bit Error Rate) 성능이 우수한 PC(Parallel Combinatory) OFDM 방식과 개선된 PAPR을 가지는 PTS(Partial Transmit Sequence) OFDM 방식을 결합한 Combined PC & PTS OFDM 방식을 제안하고 그 성능을 분석하였다.

• 한국정보통신설비학회:학술대회논문집
• /
• 2005.08a
• /
• pp.358-363
• /
• 2005

본 논문에서는 전력 제어를 통해 에너지 소비를 최소화하여 네트워크 수명을 극대화 시킬 수 있는 효율적인 라우팅 방안을 제안하였다. 제안한 프로토콜에서 센서 노드들은 여러 개의 단위 전력을 가지고 있어 독립적인 라우팅 테이블을 형성하게 된다. 이를 토대로 가장 에너지 소비가 적은 경로를 설정하여 데이터를 전송하게 된다. 또한 특정 노드가 더 이상 기능을 하지 못하는 경우에도 적응적으로 경로를 재설정하여 데이터를 전송할 수 있도록 설계하였다. 이렇게 제안한 프로토콜과 기존의 방식과의 비교 실험을 통해 제안한 라우팅 방식의 성능을 효율적 에너지 소비 측면에서 분석하였다. 그 결과 논문에서 제안한 프로토콜의 성능이 기존의 방식과 비교하여 향상되었음을 확인하였다.

• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.15-15
• /
• 2015

본 논문은 무선전력전송을 위한 자기공진코일의 최적 설계에 관한 내용이다. 공진코일의 턴수, 공진코일 사이의 거리, 코일을 형성하는 도선의 두께, 공진코일의 구조에 따라 공진시스템의 공진주파수와 전송효율 등의 공진특성에 영향을 준다. 이때 소스코일과 수신코일은 턴수가 1인 단일원형루프코일을 사용한다. 공진시스템의 공진특성은 상용툴인 HFSS를 이용한 시뮬레이션으로 분석하였고, 측정을 통해 성능을 검중하였다.

• The Journal of the Korea Contents Association
• /
• v.8 no.1
• /
• pp.177-185
• /
• 2008

Research on media access control (MAC) scheme for Wireless Sensor Network (WSN) has been mainly focused on energy efficiency improvement, while interest on latency is relatively weak. However, end-to-end latency could be a critical limitation specifically in the multi-hop network such as wireless multimedia sensor networks. In this paper we propose a media access control scheme with distributed transmission power control to Improve end-to-end transmission latency as well as reduce power consumption in multi-hop wireless sensor networks. According to the simulation results, the proposed scheme is turned out to be an energy efficient scheme with improved end-to-end transmission latency.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.54 no.4
• /
• pp.3-9
• /
• 2017

Due to difficulties of continuous electric power provision to underwater communication nodes, the efficient power usage is highly required in underwater network protocol. In this paper, we studied the energy efficient MAC(Medium Access Control) protocol for underwater network supporting mobile nodes such as UUV(Unmanned Underwater Vehicle) and AUV(Autonomous Underwater Vehicle). The mobile nodes could waste the electric power in vain when the receiver moves out of the radio propagation coverage during the data exchange and thus the transmitted data fails in reaching the receiver. Expecially, such a failure is much more obvious in underwater acoustic channels since the propagation delay is about $10^5$ times slower than in terrestrial radio channels. This proposed mobility-MAC controls the data dropping stochastically in the Dropping Zone by considering the receiver's location and moving velocity. In conclusion, this selective dropping method not only improves latency and throughput by reducing invalid droppings but also boosts power efficiency by valid droppings.