• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2009.11a
• /
• pp.149-152
• /
• 2009

A pyrostarter is a sort of gas generator, which supplies the energy to drive turbines by the combustion gas of a solid propellant charged internally. The igniter of the pyrostarter should guarantee the ignition reliability expecially for the solid propellant with a low fame temperature. For the development of the igniter, several closed bomb testes have been performed to decide several design parameters to get a sufficient chamber pressure build-up for the ignition. Moreover, as a result of the firing testes with pyrostarters, the ignition reliability have been verified and the amount of igniter propellants has been reviewed.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2009.05a
• /
• pp.219-222
• /
• 2009

Pyrostarters play a role as a turbopump starter in liquid propellant propulsion systems by supplying pressurized gas to power turbines for engine start. A rupture disk in pyrostarters, which is usually installed behind a nozzle throat, not only isolates the charged solid propellants from the external environment but also improves the ignitability of the solid propellants by increasing a chamber pressure at the beginning of combustion. Experimental tests have been performed to study the effects of rupture disk thickness, depth and shape of scores, and pressure build-up rates on burst pressures and burst diameters. The experimental results show that the developed rupture disk fulfills the performance requirements expected in a real operational condition.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.11a
• /
• pp.781-784
• /
• 2008

In this paper, insulating effect and strength development of concrete under low temperature are reported varying curing sheets. According to test results, in temperature -5$^{\circ}$C concrete subject to exposure and air cap condition, result in a frost damage at early age by a fall of below zero temperature. Mean while, the combination of PE film and non-woven fabric maintained around 3 $^{\circ}$C within first 24 hours since placement. For double bubble sheets, concrete temperature maintained above 7$^{\circ}$C due to its excellent heat insulating capability. As a result of core strength test, strength of specimens cured with viny + non-woven fabric and double bubble sheets had higher strength than strength of other specimens due to good heat insulation effect at early age.

• Journal of Sericultural and Entomological Science
• /
• v.36 no.2
• /
• pp.110-114
• /
• 1994

Abnormally cool and wet weather conditions during the summer of 1993 offered an opportunity to evaluate the effects of abnormal weather conditions on mulberry growth and to develop cultivation practicies to reduce leaf yield loss under the similar abnormal weather conditions. Different methods of nutrient supplementation were evaluated in Suwon and Kongju. Nitrogen was supplemented by foliar spray of urea(1.7%) or composite chemical fertilizer Jamsibiryo #8, or by the application of ammonium sulfate(60kg/ha) to the soil. During the period between the late June and the early September which corresponds to the mulberry growing season after summer pruning, mean temperature was 1.4$^{\circ}C$ lower and precipitation 83mm higher than normal year. This weather condition in 1993 caused reduction in leaf yield by 16.4% than common year. Soil nitrogen content decreased due to higher precipitation. Leaf yield loss was reduced by the supplementation of nitrogen to the soil. Leaf nitrogen content increased with the foliar urea spray and nitrogen supplementation to the soil.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.9
• /
• pp.4197-4203
• /
• 2013

In order to investigate the heating performance of multi-heat pump applying an inverter compressor, the experiment on heat pump with 3 indoor units was performed under the heating standard and heating low-temperature conditions. The performance data of heat pump with 3 indoor units were measured by the multi-psychrometric calorimeter. The operation characteristics and the behavior of the refrigerant cycle of the heat pump with 3 indoor units were understood from the heating capacity, heating COP, and P-h diagram by indoor-unit combination. The present experimental results show that the operating load and performance of the multi-heat pump depends on the indoor-unit combination. The heating capacity and heating COP of the low temperature condition were smaller than those of the standard one. Also the refrigerant cycles on indoor-unit combination were analyzed by using P-h diagram.

• Journal of Aerospace System Engineering
• /
• v.17 no.6
• /
• pp.144-148
• /
• 2023

Aircraft battery is the core equipment of an aircraft that supplies engine starting power and emergency power, and it must be charged to ensure sufficient capacity at all times and maintain high reliability to ensure stable power supply. The battery of the T-50 series aircraft is designed to enable the engine to start up to two times in temperatures as low as -18℃ and above. However, intermittent failures in engine starting have been observed during winter. In this paper, we analyze the failure phenomena occurring during low-temperature charging of the battery and improve the charging algorithm based on the analysis and test. Additionally, the results of start simulation tests show that the battery charging defects at low temperatures are resolved, and an improvement in the charging performance is confirmed; thus, validating the effectiveness of the new algorithm.

• The Korean Journal of Mycology
• /
• v.30 no.2
• /
• pp.99-103
• /
• 2002

The suitable sterilization conditions in pot cultivation of varieties of Chunchunutari-2-ho and Suhannutari-1-ho Pleurotus ostreatus were investigated. The substrate formulations for the cultivation consisted of 40% poplar sawdust, 40% waste cotton and 20% beet pulp (PWB), and 40% poplar sawdust, 40% cotton seed hull and 20% beet pulp (PCB). The increase in the sterilization temperature caused decrease in the pH of the substrate. The moisture content of PWB substrate increased by 1.8%, but that of PCB substrate decreased by 4.1 % after low temperature sterilization ($12hr\;at\;60^{\circ}C$). However, a little change in the sterilization at higher temperature ($6hr\;at\;100^{\circ}C\;and\;90min\;at\;121^{\circ}C$) did not alter the moisture content of both substrate appreciably. The duration of mycelial growth was longest and its density was lowest in low temperature sterilization ($12hr\;at\;60^{\circ}C$). The high pressure sterilization ($90min\;at\;121^{\circ}C$) of PCB substrate produced high yield (236.6 g/pot) and the highest biological efficiency (96.6%) for Chunchunutari-2-ho. On the contrary the high temperatures sterilization ($6hr\;at\;100^{\circ}C$) of PCB substrate resulted in the yield of 259.1 g/pot with the biological efficiency 94.9% for Suhannutari-2-ho.

• Food Science and Preservation
• /
• v.10 no.1
• /
• pp.28-31
• /
• 2003

For safe storage of agricultural products in the cold storage house, accurate monitoring of temperature, humidity and gas conditions is necessary. This study was conducted to develop an environmental monitoring and warning system for the cold storage house to improve safety of storage. The system developed in this study is able to monitor temperature, humidity and $CO_2$concentration in the storage house and to send alarm signal to the farmer by telephone and beeper when abnormal conditions have been occurred in the storage house. And the developed system use internet network so we can supervise storage conditions in the home. From the results of the performance test, it was found that the temperature and relative humidity can be controlled within the range of 0.5$^{\circ}C$ and $\pm$2 percent. And farmer's response was fair.

• Korean Journal of Plant Resources
• /
• v.10 no.1
• /
• pp.58-63
• /
• 1997

The experiment was done to clarify the effect of keeping material and storage temperature on weight and quality of Chinese yam (Dioscorea opposita) tuber. After the yam tubers were placed into the plastic boxes filled with different keeping materials [polyethylene (PE) film, hull, soil, sand, vermiculite], they were stored under different storage temperature(room, cold) from Oct. 15 to Mar. 15 when all the characters related to the tubers were measured. Soil or PE film as keeping materials was the lowest sound tuber rate when stored at room or cold temperature, respectively, while vermiculite was the highest in both storage temperature. When PE film and vermiculite in both storage temperatures were used as keeping materials, tuber weight were less reduced than the others. Brightness of chromaticity and moisture content were lower in room temperature storage than in cold temperature storage although the characteristics related to marketability were not affected by storage temperature. PE film had greater brightness and value 'a' of chromaticity but lower its 'b' value in the latter temperature than in the former temperature. Vermiculite, however, did the reverse result in comparison with PE film.

• International Journal of Highway Engineering
• /
• v.6 no.4 s.22
• /
• pp.1-12
• /
• 2004

This study evaluated the asphalt binder characteristics for the hot-recycled asphalt mixture in which RAP was added in ambient temperature for surface course as well as for base course. RAPs were collected from four sources and their physical properties were evaluated. Mix designs were performed using 10 and 20% RAP contents for surface courses and 10, 20 and 30% for base courses. A virgin asphalt with the penetration grade of 60-80 was used for mixing recycled mixtures. Physical properties of recycled binders, including penetration, absolute viscosity, GPC, BBR and penetration after TFO were measured. From the results, regression analysis of absolute viscosity versus LMS in GPC showed $R^2$ being over 0.95, showing that GPC results estimate the absolute viscosity with relative accuracy. In BBR test, the resistance of recycled mixtures at low service temperature was inferior to the control, because the low temperature PG of recycled binder was one grade higher than that of the control binder.