• Journal of the Korea institute for structural maintenance and inspection
• /
• v.18 no.2
• /
• pp.117-125
• /
• 2014

This paper examines the fundamental properties of alkali-activated slag cement (AASC) activated by sodium hydroxide (NaOH). The water to binder (W/B) ratio was 0.4 and 0.5. And concentration of activator were 2M and 4M. Five mix design of each W/B ratios was considered. The N0 mixture was KS L 5109 method and N1~N4 were varied in different mixing time, mix step and entering points of fine aggregate. Test results clearly showed that the flow value, strength and drying shrinkage development of AASC were significantly dependent on the entering point of fine aggregate. The flow value tended to decreases with delaying entering point of fine aggregate. The compressive strength and flexural strength increases with delaying entering point. Moreover, the XRD analysis confirmed that there were sustain these results. The drying shrinkage increases with delaying entering point of fine aggregate. Futhermore, a modified mixing method incorporating all hereby experimentally derived parameters, is proposed to improvement the physical properties of AASC.

• International Commerce and Information Review
• /
• v.14 no.2
• /
• pp.271-293
• /
• 2012

As service industry became more important, many of studies have been done on the role of service. Such studies has been researched focusing on the relationship between the service intensity in the economy and a country's productivity. Baumal(1967) suggested that service growth in economy would bring about decrease in productivity. However, the economy of developed countries encounter with the productivity growth as their economy grows, which phenomenon called Baumol's paradox. Oulton (1999, 2001) find out the reason of Baumol's paradox in a forward and backward chain effects. So, this paper is aimed at verifying the theory of Oulton (1999, 2001) for 13 OECD countries using panel data analysis. We find out that the intermediate knowledge-intensive service inputs cause a multifactor productivity growth.

• Journal of the Korean Vacuum Society
• /
• v.4 no.2
• /
• pp.183-188
• /
• 1995

고에너지(50-200KeV)로 가속된 이온을 모재표면에 물리적으로 투입하므로써 표면의 조성 및 조직을 변화시키는 공정인 이온주입기술을 이용하여 경량고강도소재로 각광받고 있는 AI2218 합금의 재식성 향상을 연구하였다. 질소이온주입은 DuoPIGatron 이온원을 사용하여 가속전압 100KeV, 조사량 $1{\times}10^{17}ions/\textrm{cm}^2$~$5{\times}10^{17}ions/\textrm{cm}^2$의 조건으로 행하였으며 AI합금의 열화를 방지하기 위하여 시편온도를 $60^{\circ}C$이하로 유지하였다. 질소이온 주입재의 재식성 평가를 위하여 3.5% NaCI 용액에서 양극분극시험 및 5% NaCI 용액에서 염수분무시험을 행하였다. Auger Electron Spectroscopy와 Transmission Electron Microscopy을 이용하여 표면의 질화물형성 여부를 조사하였으며, Scanning Electron Microscopy을 이용하여 부식된 표면을 관찰하였다. AI2218합금에 질소이온을 주입한 결과 표면에 미세한 AIN 석출물을 형성하였으며 이러한 질화물형성에 의해 공식(pitting)발생을 억제하고 부식전류밀도를 감소시켜 내식성이 향상되었다.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.23 no.1
• /
• pp.111-119
• /
• 1999

가수분해된 네 개의 반응성 염료를 이용하여 견, 양모 나일론 섬유를 염색할 때 영향을 미치는 여러 인자들에 대하여 연구하였다 염의 투입을 가수분해 전과 후로 달리하였을 때 염색된 직물의 K/S 값에 미치는 영향은 염료와 직물의 종류에 따라 각기 달랐으며 염의 영향은 염료의 분자 크기가 클 때 더 크게 나타났다. 이는 염 노동의 증가시 염욕 안에서의염료 용해도가 염료 분자가 클 때 더많은 영향을 받기 때문인 것으로 생각된다. 욕비 증가시에는 염색된 직물의 K/S값은 초기에 감소를 보이다가 높은 욕비에서 K/S값이 증가되었는데 이는 염의 농도의 감소로 인한 영향으로 사료된다. 가수분해된 반응성 염료로 염색된 직물의 수세 견뢰도는 염료의 분자 크기에 의해 영향을 받았으며 직물의 마찰 땀 견괴도는 Gray scale에서 3보다 높았다 본 연구의 결과는 면섬유 염색에 사용한 가수분해된 반응성 염료를 이용하여 견, 양모, 또는 나일론섬유의 염색에 재 사용할 수 있는 가능성을 제시하여 준다.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1994.10a
• /
• pp.68-68
• /
• 1994

현재의 도금폐수처리는 침전옹집법에 의해 슬러지화 하여 매립되고 있으나, 이 매립물은 침출수를 방출하여 수질오염에 문제가 되고 있다. 특히 크롬폐수는 환원 침전시키고 있으나, 공기에 의한 산화로 재용출 가능성이 비교적 높다. 따라서 크롬 고금폐수를 역삼투압법에 의해 크롬이온을 농축 회수하고, 생성되는 투과수는 도금공정에 재투입하여 공해물질이 발생되지 않는 무배출 공정 (Zero-Discharge System)을 개발하는데 본 연구의 목적이 있다. 본 실험에서는 유가금속 중 크롬을 회수하기 위하여 크롬 모델폐수의 농도, pH등을 변화시키면서 연속공정으로 R.O. Cell에 의한 투과수와 막의 상태 변화등을 살펴보았으며, 크롬 실폐수를 R.O. Cell 테스트와 역삼투기기 (1-2ton/day)를 이용하여 농축수 및 투과수의 재이용에 관하여 실험하였다.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.41 no.1
• /
• pp.115-122
• /
• 1996

One of the most laborious work in rice farming is transplanting of rice seedling which has been required preparation of nursery bed and care of seedling during one month period. In this research, direct seeding in dry paddy(DS) and direct seeding in wet paddy(WS) were practiced to compare with traditional transplanting(TP) in Suwon. Growth stages in direct seeding were delayed as its planting time was about 21 days later than those of TP. Heading stage of direct seeding at Suwon was delayed about 9 days as compared to transplanting culture. Rice yield was not different between the seeding practises. Working-hour saving was about 17％(DS) and 28％(WS). Production cost of direct seeding was decreased 20％(DS) and 32％(WS), respectively. Amount of rice production per a unit working-hour in direct seeding could increase 14％(DS) and 39％(WS) compared to that of TP, respectively. Therefore, direct seeding could save significantly working hour and production cost without reducing rice yield. WS was more effective than DS in saving labor and production cost. Direct seeding was not efficient method in input of farming energy and agricultural chemicals.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.9
• /
• pp.71-78
• /
• 2011

Cement treating technique, such as deep mixing method, has been used widely to stabilize the dredged clayey soil for many years. Despite of its effectiveness in treating soil by cement, several efforts have also been made to try to reduce the side effect of the cement that used to stabilize the dredged clay. However, authors considered that more detailed study on the physical and mechanical properties of lean-mixed soil-cement has been required to establish the design procedure to apply the practical problems. Therefore, in this study, the curing time and mixing ratio was used as key parameters to estimate the physical and mechanical properties including long-term behavior. The unconfined strength of lean-mixed soil-cement increase continuously during curing period, 270 days, while increasing rate becomes low in ordinary cement-treated dredged clay. We also concluded that cement-treated dredging clay shows apparent quasi overconsolidation behavior even in low cement proportion. By this study, fundamental approach was carried out for effective reuse of very soft dredged clayey soil both in mechanical and environmental aspect. It can be also expected that this study can propose a basic design data to use the lean-mixed soil cement.

• Journal of the Korea Institute of Building Construction
• /
• v.22 no.1
• /
• pp.45-55
• /
• 2022

Ultra-low shrinkage concrete is very effective for securing the quality and appearance of a concrete structure because it can control the drying shrinkage cracks of the concrete structure to within a certain limit. In this study, with the purpose of commercializing ultra-low shrinkage concrete, the optimal amount of expansive agent and shrinkage reducing agent was determined through a lab test, and a concrete wall mock-up test was conducted to examine the shrinkage properties and crack control effects of ultra-low shrinkage concrete. As a result, it was confirmed that there was little drying shrinkage deformation in the wall specimen, and furthermore that no cracks were generated.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.10
• /
• pp.574-579
• /
• 2016

This study assessed feasibility of making granular fertilizer with fly ash from a sewage sludge incinerator in Korea. Composition, characteristics, strength, and heavy metal contents of the granular fertilizers were investigated. Due to its high contents of phosphorus, fly ash from a sewage sludge incinerator could be used to make fertilizers. Granulation rates (2-4 mm granules) over 80% could be achieved as the fly ash contents were 15% or less of the fertilizer. Leaching tests of the fertilizers, based upon the Korean Standard Methods for Solid Wastes, showed the concentrations of heavy metals less than the risk limits. However, contents analysis of the fertilizers, based upon the Korean Standard Methods for Soils, experienced higher levels of heavy metals than the risk limits as the fly ash content exceeded 7% of the fertilizer. Thus, the fly ash needs to be added less than 7% of the fertilizer if there is no pretreatment to remove heavy metals.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.26 no.3
• /
• pp.32-42
• /
• 2022

The strategy to develop a launch vehicle family by bundling multiple rocket engines of a single type has been proven by SpaceX and their reusable fleet comprised of Falcon 9 and Falcon Heavy. In this study, we revisit a potential launch vehicle family out of a 35 tonf-class methalox staged combustion cycle engine and evaluate their utility and performance in various space missions. For example, a Korean version of Falcon 9 can deliver 4.7 tons of payload into 500 km SSO in an expendable mode while the payload is reduced to 2.16 tons in a sea-landing reusable mode. A Korean version of Falcon Heavy can deliver 4.4 tons into GTO when launched from the Naro Space Center, indicating that this common booster core configuration can handle Cheollian 2 albeit the high inclination. Once developed, the same methaloax engine can power the first-stage of smallsat launch vehicles and air launch vehicles.