• Proceedings of the Korea Water Resources Association Conference
• /
• 2004.05b
• /
• pp.1032-1036
• /
• 2004

수자원계획수립시 가장 큰 문제점 중의 하나는 관심대상유역의 관측자료가 없는 경우이다. 이와 같은 미계측유역의 경우 통상 단순히 인근관측소 자료를 면적비로 전이시켜 사용하거나, 인근 계측유역에서 유출모형의 매개변수를 추정하여 매개변수를 전이시키는 방법을 사용하고 있다. 본 연구에서는 계측유역에서 추정한 장기유출모형의 매개변수를 미계측유역으로 전이시킬 때 유역별 토양수분보유능을 이용하여 보다 객관적으로 매개변수를 전이하는 방법을 제시하였다. 방법으로는 정교한 토양수분모의가 가능한 PRMS 모형을 이용하여 자료의 정도가 높은 5개 댐지점에서 매개변수를 검${\cdot}$보정한 다음, 소양강댐과 충주댐유역을 미계측유역으로 가정하여 계측유역의 토양수분보유능과 가장 유사한 유역에 매개변수를 전이하여 결과를 분석하였다.

• Proceedings of the Korean Society of Disaster Information Conference
• /
• 2022.10a
• /
• pp.427-428
• /
• 2022

최근 대규모 항만 건설 및 기존 부두 리모델링과 같은 해안 공간 구조물 확충사업이 활발하게 진행되고 있으며 항만 구조물 거동 장기계측을 위한 센서에 대한 관심도 높아지고 있다. 기존의 항만에 적용한 전기식 센서들은 수개월 정도 단기간의 구조물 거동 측정은 가능하지만 수년 이상의 장기계측 시 염수분에 의한 부식 및 내구성에 취약하기 때문에 원활한 측정에 한계점이 있고 센서 설치를 위한 항만 외곽지역 구조물과 육상전원공급설비 배전반 사이의 거리로 인하여 긴 연장의 횡단로 가설전선 보호대 등을 설치해야 하는 어려움이 있다. 따라서, 본 연구에서는 항만 구조물 거동 장기계측을 위해 기존 전기식 센서들의 부식문제점을 파악하여 해수용 4종 센서 IoT 모듈 패키징을 설계하고 외부 전원공급 방해 영향을 최소화한 태양광 발전을 적용한 항만 구조물 거동 계측 시스템을 제안하였다.

• Journal of the Korea Concrete Institute
• /
• v.26 no.5
• /
• pp.615-625
• /
• 2014

Excessive long-term slab deflection caused by construction load is a critical issue for the design of concrete slabs, as long span flat plates become popular for tall buildings. In the present study, the effect of construction load causing early slab cracking on the long-term deflection was theoretically studied. On the basis of the result, a numerical analysis method was developed to predict the long-term deflection of flat plates. In the proposed method, immediate deflection due to slab cracking and long-term effect of creep and shrinkage were considered. To verify the construction load effect, long-term slab deflections were measured in actual flat plate buildings under construction. The results showed that the immediate deflection due to the construction load increased significantly the long-term deflection. The proposed method was used to predict the deflections of the buildings. The results were compared with the measurement results. The predictions agree well with the long-term deflections of flat plate affected by construction load.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.349-352
• /
• 2008

IPC girder is more prestressed and has smaller sectional area than the conventional PSC-I type girder due to incremental prestressing along the construction process. The continuous IPC girder bridge may have problems in serviceability and stresses at internal supports because it is very flexible. In this paper, The long-term behavior of the continuous IPC girder bridge is studied through long-term structural analysis and monitoring the deflections. The long-term behavior is monitored right before the introduction of 2nd prestressing that is the construction process different from the conventional PSC-I type girder bridge. The total station of high-precision was used in measuring the deflections. According to the monitoring result so far, the continuous IPC girder bridges does not show remarkable long-term behavior like severe camber or deflection and the measured deflections are very similar to the results of long-term structural analysis.

• Journal of the Korean GEO-environmental Society
• /
• v.11 no.12
• /
• pp.27-35
• /
• 2010

The structures built under the groundwater level are affected by the buoyancy force, which is hydrostatic pressure in the up direction. Recently, buoyancy-resistant anchor method has been applied in many cases of the construction of the important structure of large size, which is built under the groundwater level so that it takes high uplift pressure. Even if the construction cost of the method is very high, it surely increases the safety rate. However, the diagnosis of the performance of the buoyancy-resistant permanent anchor and the investigation of resistance mechanism are still insufficient. Especially, the long-term behavior of the anchor has not been studied well due to the difficulty in observation procedure. The contribution of this paper is the establishment of reasonable design methodology. We have measured anchor axial forces for 10 years after the construction, by using an automated measurement and a manual measurement by establishing a load cell in anchor head. Through the data collected from the measurements, we analyze the construction-step behavior of the anchor according to the self-weight variation of the building and the long-term behavior (i.e. movement within 10 years after the construction) of the anchor according to the passage of time.

• Journal of the Korean GEO-environmental Society
• /
• v.6 no.1
• /
• pp.53-62
• /
• 2005

This paper estimates the long-term settlement of Kimpo metropolitan landfill based on measured settlement data from 180 landfill monitors accumulated over a period of 12 years. Comparison of domestic and international settlement records indicate that the domestic compression rate is slightly lower due to greater portion of organic component. Several existing settlement models are used to compare with the observed behavior and also to estimate long-term settlement. The hyperbolic, Gibson & Lo, Bjarngard & Edgers and Power Creep Law models compare well with the measured settlement of the Kimpo metropolitan landfill. The settlement models are further used to estimate long-term settlement. Bjarngard & Edgers and Power Creep Law models result in higher estimates of the long-term settlement compared to the hyperbolic and Gibson & Lo models. Further comparisons indicate that other models, including Sowers and log models, are inapproriate for predicting the long-term settlement of the Kimpo metropolitan landfill.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.27 no.4
• /
• pp.86-93
• /
• 2023

A bridge health monitoring technology is under development for the safety management of aged bridges. The bridge health monitoring technology has been developed mainly for single bridge management at a large scale, so it uses wire-based systems for power supply and data transfer. However, the wire-based systems need to be improved for the sporadically distributed small-sized bridges on local roads. This study proposed a wireless structural health monitoring system for small-sized bridges. The proposed monitoring system overcomes the limitations of wired systems by providing wireless power through solar power and utilizing LTE technology to transmit measurement data. In addition, a remote control system and power management plan were proposed to ensure the stability of the bridge measurement system. The proposed measurement system was installed on 32 bridges on fields and verified the operability by collecting 80.6% of measurement data for one year. The proposed system can support the health monitoring of aged bridges on local roads.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.6A
• /
• pp.389-398
• /
• 2012

In this study, structural strain responses of the jacket-type Uldolmok tidal current power plant structure under severe tidal environments were measured and analyzed using long-term measurement system during construction and also operation. It was observed that there were significant changes in strain responses at the steps of jacket lifting, block loading, pile ejection and insertion. Strains due to dead loads and tidal loads were analyzed before and after removal of a jacket leg, and it was also found that the strains due to dead load were much significantly changed after jacket leg removal. From the measurement data during operation, it was found that strain responses were fluctuated with M2 and M4 tidal periods and also relatively short period of about 10 min due to the peculiar tidal characteristics in the Uldolmok strait. Finally, the neural network-based non-parametric estimation models were investigated to build up the signal-based structural damage monitoring system.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.29 no.3
• /
• pp.219-227
• /
• 2016

In this study, we have proposed a method of monitoring of bridges under construction in view of the long-term behavior of the prestress concrete bridge of which the Free Cantilever Method is applied. As a method to confirm the ability of the long-term behavior of the concrete box girder, temperature sensors and strain gauges were installed, and the measured data was used to calculate creep coefficient. Moreover, we have measured the stress of the concrete box girder during construction which was applied with creep coefficient and compared with the changes in temperature to analyze the vertical displacement along the segment. In conclusion, monitoring of the FCM bridge during construction in consideration of the long-term behavior can be analyzed efficiently by suing temperature and displacement data without the use of laser displacement meter or laser delfectometer.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.39 no.4
• /
• pp.469-475
• /
• 2019

A long-term bridge monitoring system has been introduced and is under operation for long-term safety management of the structure. However, it is difficult to assess the condition of the quantitative structural system as it only measures responses and does not measure input loads. To overcome these shortcomings, FBG (Fiber Bragg Grating)-based input load measurement sensors were developed in this paper for measuring highway bridge input loads and their validity was verified through laboratory tests.