• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.10
• /
• pp.72-79
• /
• 2014

This paper presents a method for constructing a pipeline-aware quasi-cyclic irregular repeat accumulate low-density parity-check (PA-QC-IRA-LDPC) codes and efficient rate-1/2 (2016, 1008) PA-QC-IRA-LDPC decoder architecture. A novel pipeline scheduling method is proposed. The proposed methods efficiently reduce the critical path using pipeline without any bit error rate (BER) degradation. The proposed pipeline-aware LDPC decoder provides a significant improvement in terms of throughput, hardware efficiency, and energy efficiency. Synthesis and layout of the proposed architecture is performed using 90-nm CMOS standard cell technology. The proposed architecture shows more than 53% improvement of area efficiency and much better energy efficiency compared to the previously reported architectures.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.15 no.4
• /
• pp.157-161
• /
• 2005

Spectroscopic ellipsomerty measurements of the complex dielectric function of the CdTe thin films grown on GaAs(100) substrates by hot wall epitaxy have been performed in 1.5${\~}$5.5 eV photon energy range at room temperature. The spectroscopic ellipsometer spectra revealed distinct structures at energies of the $E_l,\;E_1+{\Delta}_1$, and $E_2$ critical points. These energies were decreased with increasing thickness of CdTe thin films.

• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.14 no.2
• /
• pp.8-14
• /
• 2018

A boiling heat transfer is used in various industry such as power generation systems, heat exchangers, air-conditioning and refrigerations. In the boiling heat transfer system, the critical heat flux (CHF) is the important factor, and it indicated safety of the system. It has kept up studies on the CHF enhancement. Recently, it is reported the CHF enhancement, when working fluid used the nanofluid with excellent thermal properties. Therefore, in this study, we investigated the influence of nano particles coated surface for heat transfer enhancement in pure water, oxidized multi-wall carbon nanotube nanofluid (OMWCNT), and oxidized graphene nanofluid (OGraphene). Nanoparticles were coated for 120 sec on the surface, and we measured the CHF at the flow velocities of 0.5, 1.0, and 1.5 m/sec, respectively. As the results, both of the OMWCNT and OGraphene nanofluids increased up to about 34.0 and 40.0%.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.11a
• /
• pp.76.1-76.1
• /
• 2011

석탄 가스화기 내에서 슬래그의 축적에 의한 막힘 현상 등으로 발생 가능한 조업중단을 예방하기 위해 탄의 종류에 따른 슬래그의 유동을 정확히 예측하는 것은 중요하다. 슬래그의 유동은 원료인 석탄의 회 성분 조성 그리고 가스화기 온도의 영향을 크게 받는다. 회가 용융된 형태인 슬래그의 융점 특성을 파악하여 슬래그 거동을 예측하기 위해서는 회를 조성하고 있는 주성분의 비율 뿐 아니라 소량의 성분들도 고려하여야 한다. 또한, 가스화기 조업 조건 중 수증기 분압이 슬래그 점도에 미치는 변화를 파악하여 공정 조건 확립 및 슬래그 계통 제어 로직에 반영 할 수 있다. 따라서, 대표적 열화학 평형계산 프로그램인 Factsage를 이용하여 슬래그 성분의 액상선 온도를 예측해보았다. 슬래그는 회 성분의 조성에 따라 결정 슬래그와 유리 슬래그로 나눌 수 있다. 본 연구에서는 결정 슬래그로는 Alaska Usibelli 탄을, 유리 슬래그로는 Kideco 탄의 조성을 사용하여, 가스화기 조업 조건 중 수증기의 분압에 따라 석탄 슬래그의 형성 및 점도 변화에 직접적인 영향을 미치는 결정 형성에 대한 상관관계를 예측해 보았다. 또한, 슬래그 유동에 영향을 줄 수 있는 요인으로써, 석탄의 품질을 결정하는 인자인 Base/Acid Ratio, Iron in Ash, Calcium in Ash, Silica-to-Alumina Ratio, Inron-to-Calcium Ratio를 달리 변화시켜가며 슬래그 점도 변화에 직접적인 영향을 미치는 결정 형성을 예측하였다. 이 예측결과는 향후 실험 데이터와 비교하여, 슬래그 처리 부분의 모니터링에 기초 자료로 활용될 뿐 아니라, 슬래그점도 측정 시스템의 운전 파라미터를 도출하는데 이용 가능할 것이다.

• 한국신재생에너지학회:학술대회논문집
• /
• 2008.10a
• /
• pp.254-257
• /
• 2008

For crystalline slags, of which the viscosity rapidly increases at $T_{cv}$ due to the formation of crystalline phases, the Tcv is affected by measurement conditions. In this study, we investigated the effect of cooling rate, and alumina dissolution on the determination of $T_{cv}$. Using synthetic slag samples based on the composition of Alaska Usibelli slag, $T_{cv}$ were determined under a constant cooling rate of $2^{\circ}C$/min, and under rapid cooling with holding time to allow the slag to reach thermal and rheological equilibrium. The effect of alumina dissolution was investigated using platinum lined crucibles. The constant cooling resulted in lower $T_{cv}$ by $33^{\circ}C$ as compared to the equilibrium measurements. Under $2^{\circ}C$/min cooling, the blocking alumina dissolution resulted in lower $T_{cv}$ by $23^{\circ}C$. When the $T_{cv}$ was measured under $2^{\circ}C$/min cooling using an alumina crucible, therefore, the effects of a constant cooling is somewhat offset by the alumina dissolution effect, and bring the measured value closer to the true value.

• Journal of Energy Engineering
• /
• v.26 no.4
• /
• pp.1-6
• /
• 2017

This study evaluated hydrogen effect of metal and non-metallic materials used in the hydrogen blended natural gas vehicle. Hydrogen penetrated concentration of 34Cr-Mo steel(850MPa tensile strength) for winter driving conditions was measured 0.0018ppm and summer driving conditions was 5.3ppm. The critical hydrogen concentration of high strength metal used in this study was measured 1.03ppm by CLT. Therefore, 34CrMo steel cas cause problems in the 30% HCNG(25MPa) environment. In case of the test for non-metallic materials, all materials met the criteria of the gas resistance test, but Fluorocarbon Rubber material had a significant change in the volume. So if it is used, extra care is needed.

• Journal of Hydrogen and New Energy
• /
• v.18 no.2
• /
• pp.189-196
• /
• 2007

The evaporation heat transfer coefficient and pressure drop of $CO_2$(R-744) in a horizontal tube was investigated experimentally. The main components of the experimental apparatus are a receiver, a variable-speed pump, a mass flow meter, a pre-heater and an evaporator(test section). The test section consists of a horizontal stainless steel tube of 4.57 mm inner diameter. The experiments were conducted at mass flux of $200{\sim}1000\;kg/m^2s$ saturation temperature of $0{\sim}20^{\circ}C$, and heat flux of $10{\sim}40\;kW/m^2$. The test results showed that the heat transfer coefficient of $CO_2$ has a greater effect on nucleate boiling more than convective boiling. Mass flux of $CO_2$ does not affect nucleate boiling too much. In comparison with test data and existing correlations, All of the existing correlations for the heat transfer coefficient underestimated the experimental data. However lung et al.'s correlation showed a good agreement with the experimental data. The evaporation pressure drop of $CO_2$ increases with increasing mass flux and decreasing saturation temperature. When comparison between the experimental pressure drop and existing correlations. Existing correlations failed to predict the evaporation pressure drop of $CO_2$.

• Journal of the Korea Society of Computer and Information
• /
• v.4 no.4
• /
• pp.77-85
• /
• 1999

In this paper. improved the formula of Kass. First of all, improved initial guess inside and outside of an object. So, prevent the of shrink, find more easily and faster the contour of object. Secondly, proposed the algorithm which moved to local minimum with the improvement of formula of the internal energy and $3{times}3$ matrix. Process the noise of local minimum with use of medial filtering. In third, process the phenomenon which edge points gather one point with imposing energy to the energy term. Improve the algorithm to find the contour precisely with the use of threshold. The result of these improvements, make an initial guess easily and find the contour of objects which have higher curvature. Improve the speed of process by reducing the repetition of feedback system.

• Journal of the Korean Solar Energy Society
• /
• v.36 no.3
• /
• pp.63-74
• /
• 2016

The nanofluids are the fluids with excellent thermal property, it is expected as a working fluid of the next generation. The nanofluids are well known that if it is used in the boiling heat transfer system, the critical heat flux is enhanced up to 200%, and the thermal conductivity is increased up to from 10 to 160%. However, the fouling phenomenon can be occurred that nanoparticles of nanofluids are deposited on the heat transfer surface. Therefore, to investigate relation between nanofluid and fouling, this study is carried out using oxidized graphene nanofluid. Also it compared and analyzed the critical heat flux and the boiling heat transfer coefficient. As the result, in case of oxidized graphene deposition for fouling, the critical heat flux is increased up to 20% more than oxdized graphene nanofluid. However, the boiling heat transfer coefficient is decreased down to about $6kW/m^2K$ at $1,000kW/m^2$ more than pure water.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.1
• /
• pp.37-43
• /
• 2012

In this paper, we analysis wideband spectrum sensing with distance based weight combining for Cognitive Radio (CR) systems. CR systems is implemented the spectrum of the Primary User(PU) by using a energy detection method. Threshold is determined in accordance with the constant false alarm rate (CFAR) algorithm for energy detection. The signal of PU is BPSK signal and the wireless channel between a PU and CR systems is modeled as Gaussian channel. From the simulation results, the wideband sensing with distance based and Distance based weight Combing (DWC) methods shows higher spectrum sensing performance than single CR user spectrum sensing.