• 한국항공우주학회지
• /
• 제41권10호
• /
• pp.761-769
• /
• 2013

헬리콥터의 후류가 공기력에 미치는 영향은 매우 크다. 하지만 후류의 형상은 매우 복잡하며 예상하기 힘들다. 본 연구에서는 수치적인 방법을 통하여 후류를 자세히 관찰할 것이다. 후류에서의 와류를 자세히 관찰하기 위한 수치적 방법으로는 와류격자법과 자유후류법을 사용하였다. 본 연구에서 제자리 비행에서의 후류 형상을 관찰하였다. 적절한 추력계수를 갖는 제자리 비행에서는 익단 와류 뿐 아니라 블레이드의 안쪽에서 발생하는 counter-rotating vortex도 관찰할 수 있다. 이러한 와류들이 아래로 내려가면서 익단 와류와 counter-rotating vortex가 서로 가까워지며 서로에게 영향을 끼치게 된다. 이에 따라 와류들은 자체적인 불안정성으로 인해 형상이 변한다.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2008년도 제31회 추계학술대회논문집
• /
• pp.157-160
• /
• 2008

터빈의 익단 간극은 블레이드와 케이싱간 마찰을 줄이기 위한 중요한 부분이다. 수치 해석을 통해 익단 간극이 직접적으로 터빈에 미치는 영향을 판단하기 위하여 UTRC 터빈을 익단 간극이 있는 경우와 없는 경우로 나눠 계산을 수행하였다. CFX를 통해 도출된 해석결과는, 익단 간극이 있는 경우 생성된 와류가 터빈 전반에 걸친 손실을 일으키고 그 결과 익단 간극이 없는 터빈에 비해 더 낮은 전압효율을 보인다.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2003년도 유체기계 연구개발 발표회 논문집
• /
• pp.496-501
• /
• 2003

Reynolds averaged Wavier-Stokes simulations based on the Reynolds stress model was performed to investigated the effect of inlet flow angle on the distributions of the Reynolds stress tensor inside tip leakage vortex of a linear compressor cascade. Two different inlet flow angles ${\beta}=29.3^{\circ}$(design condition) and $36.5^{\circ}$(off-design condition) were considered. Stress tensor analysis, which transforms the Reynolds stress into the principal direction, was applied to show an anisotropy of the normal stresses. Whereas the anisotropy was highest in the region where the tip leakage vortex collides the suction side of the blade and tip leakage flow enters between blade tip of the pressure side and the endwall, it had the lowest value at the center of tip leakage vortex. It was also found that the magnitude of maximum shear stress at design condition was greater than that of off-design condition.

• 한국항공우주학회지
• /
• 제37권4호
• /
• pp.329-335
• /
• 2009

비정상 패널법과 시간 전진 자유 후류법을 연계하여 제자리 및 수직 비행 하는 헬리콥터 로터의 공력 및 익단와류를 검증하였다. 검증된 수치 방법을 이용하여 저속 하강 비행하는 로터에서 발생하는 BVI(Blade Vortex Interaction)의 비정상 공력을 해석 하고 이때 나타나는 익단 와류에 의한 공력의 변화를 고찰하였다.

• 한국유체기계학회 논문집
• /
• 제7권5호
• /
• pp.50-57
• /
• 2004

• 대한기계학회논문집B
• /
• 제28권8호
• /
• pp.902-909
• /
• 2004

A steady-state Reynolds averaged Navier-Stokes simulation was conducted to investigate the distribution of the Reynolds stress tensor inside tip leakage vortex of a linear compressor cascade. Two different inlet flow angles ${\beta}=29.3^{\circ}$(design condition) and $36.5^{\circ}$(off-design condition) at a constant tip clearance size of $1\%$ blade span were considered. Classical methods of solid mechanics, applied to view the Reynolds stress tensor in the principal direction system, clearly showed that the high anisotropic feature of turbulent flow field was dominant at the outer part of tip leakage vortex near the suction side of the blade and endwall flow separation region, whereas a nearly isotropic turbulence was found at the center of tip leakage vortex. There was no significant difference in the anisotropy of the Reynolds normal stresses inside tip leakage vortex between the design and off-design condition.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2003년도 추계학술대회
• /
• pp.845-850
• /
• 2003

Unsteady nature of a tip leakage vortex in an axial flow fan operating at a design and off-design operating conditions has been investigated by measuring the velocity fluctuation in a blade passage with a rotating hotwire probe sensor. Two hot-wire probe sensors rotating with the fan rotor were also introduced to obtain the cross-correlation coefficient between the two sensors located in the vortical flow as well as the fluctuating velocity. The results show that the vortical flow structure near the rotor tip can be clearly observed at the quasi-orthogonal planes to a tip leakage vortex. The leakage vortex is enlarged as the flow rate is decreased, thus resulting in the high blockage to main flow. The spectral peaks due to the fluctuating velocity near the rotor tip are mainly observed in the reverse flow region at higher flow rates than the peak pressure operating condition. However, no peak frequency presents near the rotor tip for near stall condition.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2003년도 유체기계 연구개발 발표회 논문집
• /
• pp.404-411
• /
• 2003

Three-dimensional vortical flow and separated flow topology near the casing wall in an axial flow fan having two different tip clearances have been investigated by a Reynolds-averaged Wavier-Stokes (RANS) flow simulation. The simulation shows that the tip leakage vortex formed close to the leading edge of the blade tip on suction side grows in the streamwise direction. On the casing wall, a separation line is formed upstream of the leakage vortex center due to the interference between the leakage vortex and main flow. The reverse flow is observed between the separation line and the attachment line generated downstream of the trailing edge, and increased with enlarging tip clearance. The patterns of a leakage velocity vector including a leakage flow rate are also analyzed according to two tip clearances. It is noted that the understanding of the distribution of a limiting streamline on the casing wall is very important to grasp the characteristics of the vortical flow in the axial flow fan.

• 한국항공우주학회지
• /
• 제30권3호
• /
• pp.57-63
• /
• 2002

지면효과를 받는 와류면의 2차원 비정상 전개를 이산와류법을 사용하여 연구하였다. 와류면이 말리는 정확한 형상을 얻기 위하여, 두 개의 평활기법을 비교하였다. 타원형 하중분포를 가지는 지면가까이에 있는 날개의 후류말림에 대하여 본 연구 방법을 적용하였다. 날개가 지면가까이 비행할 때, 지면효과로 인하여 와류가 날개길이방향으로 이동하였으며 날개익단부근에서 와류면의 늘림운동이 발생하였다.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 추계학술대회
• /
• pp.1383-1388
• /
• 2004

The flow characteristics in the blade passage of a low speed axial flow fan have been investigated by experimental analysis using a rotating hot-wire sensor for design and off-design operating conditions. The results show that the tip leakage vortex is moved upstream when flow rate is decreased, thus disturbing the formation of wake flow near the rotor tip. The tip leakage vortex interfaces with blade pressure surface, and results in high velocity fluctuation near the pressure surface. From the relative velocity distributions near the rotor tip, large axial velocity decay is observed at near stall condition, which results in large blockage compared to that at the design condition. Througout the flow measurements using a quasi-orthogonal measuring points to the tip leakage vortex, it is noted that the radial position of the tip leakage vortex is distributed between 94 and 96 percent span for all flow conditions. High spectrum density due to the large fluctuation of the tip leakage vortex is observed near the blade suction surface below the frequency of 1000 Hz at near stall condition.