• 한국가스학회:학술대회논문집
• /
• 2007.04a
• /
• pp.33-36
• /
• 2007

합성가스는 C1화학을 시작하는 반응원료 물질로 최근 DME(dimethyl-ether), 메탄올, GTL(gas to liquid), CTL(coal to liquid), 암모니아 생성 공정 등 많은 화학공정에 사용되고 있다. 합성가스를 생산하는 방법은 천연가스 개질반응과 석탄의 가스화반응, 그리고 원유의 정제 등을 통해 얻을 수 있다. 삼중개질반응은 천연가스와 산소, 수증기, 이산화탄소를 원료로 $1000^{\circ}C$ 이상의 고온에서 반응시켜 합성가스를 생산하며, 균일반응계와 불균일반응계로 이루어져 있다. 균일반응계에서는 천연가스와 산소가 주로 반응하며, 원료로 투입된 대부분의 산소는 균일반응계에서 소모되어 일산화탄소와 이산화탄소를 생성한다. 삼중개질반응의 균일반응계에서는 산소와 천연가스와의 반응으로 많은 발열이 발생하여 전체 반응계의 온도를 유지할 수 있도록 해준다. 본 연구에서는 산소로 인한 삼중개질반응의 온도 조절과 균일반응계의 온도 분포를 위치에 따라 관찰해 보았으며, 실험과 모사를 통해 비교해 보았다.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.2
• /
• pp.139-146
• /
• 2014

Sodium borohydride ($NaBH_4$) is considered as a secure metal hydride for hydrogen storage and supply. In this study, the interfacial friction of two-phase flow in the dehydrogenation of aqueous $NaBH_4$ solution in a microchannel with a hydraulic diameter of $461{\mu}m$ is investigated for designing a dehydrogenation chemical reactor flow passage. Because hydrogen gas is generated by the hydrolysis of $NaBH_4$ in the presence of a ruthenium catalyst, two different flow phases (aqueous $NaBH_4$ solution and hydrogen gas) exist in the channel. For experimental studies, a microchannel was fabricated on a silicon wafer substrate, and 100-nm ruthenium catalyst was deposited on three sides of the channel surface. A bubbly flow pattern was observed. The experimental results indicate that the two-phase multiplier increases linearly with the void fraction, which depends on the initial concentration, reaction rate, and flow residence time.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.11
• /
• pp.2077-2083
• /
• 2000

For the application of wet air oxidation(WAO) process reactive dyes, remazol blacks has been selected as the subject for this study. The rate of decomposition relating to the reaction temperature and catalyst has been summarized during the catalytic wet air oxidation reaction. When 1.5 gram per liter of platinum is added titanium-dioxide and the partial pressure is adjusted to 6 atmosphere at the reaction temperature exceeding $200^{\circ}C$, more than 95% of the remazol blacks dyes were decomposed. When the reaction temperature was raised to $200^{\circ}C$, $220^{\circ}C$ and $250^{\circ}C$, respectively, for 240 minutes after adding the catalyst, the remaining rate of ultraviolet absorbance had dropped significantly to 18%, 12%, and 4%. At the reaction temperature of $250^{\circ}C$, color removal efficiency was approximately 95% or more after 120 minutes from the beginning of the reaction.

• Membrane Journal
• /
• v.15 no.4
• /
• pp.330-337
• /
• 2005

Water selective silica membranes were prepared fur use as membrane reactor for synthesis of dimethyl ether (DME) by methanol dehydration. Silica membranes formed on a Porous SUS tube by ultrasonic spray Pyrolysis (USP) and chemical vapor deposition (CVD) using tetraethoxysilane (TEOS) as precursor. The CVD-derived membranes formed higher level of trade-off line between water permeance and water/methanol selectivity than that of the USP-derived membranes. The membrane reactor possessing water permeance of $1.2\times10^{-7}\;mol\;{\cdot}\;m^{-2}\;{\cdot}\;S^{-1}\;{\cdot}\;Pa^{-1}$ and water/methanol selectivity of 10 exhibited increase in methanol conversion of about $20\%$ comparing to conventional reactor system. These findings led us to conclude that the dehydration membrane reactor simultaneously separating the water vapour produced in the reaction zone was effective in increasing the reaction conversion.

• Journal of the Korean Chemical Society
• /
• v.24 no.4
• /
• pp.329-336
• /
• 1980

A domestic phosphogypsum was calcined in a batch type fluidized bed reactor at various reaction temperatures ranging 90∼180$^{\circ}$ without and with an alkaline additive amounting up to 5% of gypsum, and physical properties of the resultant products were compared following their characterization by X-ray diffraction pattern and DTA. It has been found that dehydration reactions were uniformly carried out in the fluidized bed reactor and only hemihydrate was obtained at 90$^{\circ}$ whereas at higher temperatures dehydration reaction progressed further. When gypsum was charged to the reactor preheated at over 140$^{\circ}$, a considerable degree of dehydration occurred before the reactant reached the initially set reactor temperature and in particular, at over 160$^{\circ}$ most of dehydration reaction was performed prior to the present reactor temperature. However, it has been found that gypsum mostly transforms into hemihydrate around the reactant temperature of 140$^{\circ}$ while transformation into anhydrite mostly occurs around $160^{\circ}C.$ When calcium hydroxide was added to gypsum in the reactor, the optimum physical properties of the calcined product were obtained at the weight ratio of $Ca(OH_2)/P_2O_5$ = 3.2.

• Applied Chemistry for Engineering
• /
• v.24 no.4
• /
• pp.412-415
• /
• 2013

Palladium on carbon powder was prepared using 1-hexyl-3-methylimidazolium tetrafluoroborate, one of room temperature ionic liquids. The synthesized particles were tested as a hexafluoropropylene hydrogenation catalyst. Moreover, the hydrogenation was performed under various reaction conditions to develop an optimum reaction process. The catalyst prepared by more than 3 wt% of palladium and the unity mole ratio of ionic liquid to palladium precursor showed higher catalytic activity. For reaction conditions, the complete hexafluoropropylene (HFP) conversion was achieved at these conditions; the volume flow ratio of hydrogen to HFP was higher than 1.25 and $GHSV_{HFP}$ was lower than 50000 mL/g-h.

• Journal of Energy Engineering
• /
• v.11 no.3
• /
• pp.247-253
• /
• 2002

Natural manganese ore was selected as main active component for a non-zinc desulfurization sorbent used in the gas clean-up process of the integrated gasification combined cycle (IGCC) because of excellent H$_2$S removal efficiency and economical aspect . In this study, the regeneration characteristics of sorbent after desulfurization reaction were determined in a thermobalance reactor and a fixed bed reactor in the temperature range of 350~55$0^{\circ}C$. The mixed gases of oxygen and nitrogen are used as the regeneration reaction gases for manganese sorbent. According to Mn-S-O phase diagram, the manganese sorbent has a low regeneration efficiency in medium temperature due to formation of MnSO$_4$ and the regeneration temperature must be over 85$0^{\circ}C$. To improve that problem, ammonia and steam was added in regeneration mixed gases. Effect of new regeneration method was determined by XRD and difference of desulfurization through multicycle tests.

• Journal of the Korean Chemical Society
• /
• v.22 no.3
• /
• pp.150-157
• /
• 1978

The rate constants for the hydrolysis of the derivatives of N-(p-nitrophenyl)-benzohydrazonyl azide (p-$CH_3,\;p-CH_3O,\;p-NO_2$, p-Cl, p-Br) have been determined by UV spectrophotometry in 50% dioxane-water at $25^{\cicr}C$ and a rate equation which can be applied over wide pH range was obtained. Below pH 5, the rate of hydrolysis of hydrazonyl azides is accelerated by electron-donating group ($\rho$ = -0.47), whereas at the pH values greater than 7, the $\rho$-value is 0.68. The effect of salt, solvent, substituent and azide ion on the rate of hydrolysis are rationalized in terms of $S_N1$ and $S_N2$ mechanism; below pH 5, the hydrolysis proceed through $S_N1$, however, above pH 7, the hydrolysis is started by the attack of hydroxide ion and in the range of pH 5∼7, these two reactions occur competitively.

• Journal of the Mineralogical Society of Korea
• /
• v.17 no.3
• /
• pp.277-288
• /
• 2004

Alkali-silica reaction (ASR) is a chemical reaction between alkalies in cement and chemically unstable aggregates and causes expansion and cracking of concrete. In the Present study, we studied the effects of metakaolin, which is a newly introduced mineral admixture showing excellent pozzolainc reaction property, on the inhibition of ASR. We prepared mortar-bars of various replacement ratios of metakaolin and conducted alkali-silica reactivity test (ASTM C 1260), compressive strength test and flow test. We also carefully analyzed the mineralogical changes in hydrate cement paste by XRD qualitative analysis. The admixing of metakaolin caused quick pozzolanic reaction and hydration reaction that resulted in a rapid decrease in portlandite content of hydrated cement paste. The expansion by ASR was reduced effectively as metakaolin replaced cement greater than 15%. This resulted in that the amounts of available portlandite decreased to less than 10% in cement paste. It is considered that the inhibition of ASR expansion by admixing of metakaolin was resulted by the combined processes that the formation of deleterious alkali-calcium-silicate gel was inhibited and the penetration of alkali solution into concrete was retarded due to the formation of denser, more homogeneous cement paste caused by pozzolanic effect. Higher early strength (7 days) than normal concrete was developed when the replacement ratios of metakaolin were greater than 15%. And also, late strength (28 days) was far higher than normal concrete for the all the replacement ratios of metakaolin. The development patterns of mechanical strength for metakaolin admixed concretes reflect the rapid pozzolanic reaction and hydration properties of metakaolin.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1997.10a
• /
• pp.53-60
• /
• 1997

1. 서론 : 촉매막기술은 반응과 분리공정을 동시에 하나의 장치에서 수행할 수 있기 때문에 한 개의 공정을 줄일 수 있는 효과적인 에너지 절약형 기술이다. 생성물중의 적어도 하나가 선택적으로 막을 통해 투과되기 때문에 가역반응의 경우에는 비가역반응에 가까운 거동을 보이게 된다[1-5]. 본 연구는 12-텅스토인산($H_3PW_{12}O_{40}$)를 촉매로 사용하고 막반응시를 비활성촉매막반응기(IMRCF, Inert membrane reactor with catalyst in the feed side)형태, 막으로는 PSF(Polysulfone), PPO(Polyphenylene Oxide)를 사용하여 MTBE(Methyl tert-butyl ether)분해반응을 모사하였다. 막반응기에서 생성된 생성물을 선택적으로 분리해냄으로 인하여 전환율은 고정층보다 증가하였는데 반응온도가 증가할수록, 반응물의 분압은 낮을수록 증가하였다. 반응온도가 높아짐에 따라 막반응기에서의 전환율은 고정층반응에서 나타나는 전환율과의 차이가 줄어드는 것을 볼 수 있었다. 위와같은 결과에 따라서 MTBE 반응물의 분해로 생성되는Isobutene의 수율이 90$\circ$C 이상의 반응온도에서 촉매/반응물비에 대한 최적조건이 나타나는 것을 알 수 있었다.