• Journal of the Mineralogical Society of Korea
• /
• v.28 no.2
• /
• pp.165-171
• /
• 2015

Dust samples collected from air in metropolitan areas of Busan and Ulsan were analyzed by phase contrast microscopy, phase contrast dispersion microscopy and SEM. Asbestos concentration in dust samples was lower than detection limit. Many fibrous materials were observed in dust samples, but most of them were organic fibers. Inorganic fibers such as rock fiber, ceramic fiber and gypsum were contained in the samples and non-fibrous minerals such as quartz, calcite and feldspar were also occasionally observed. Domestic law requires that asbestos in air dust is mainly analyzed by phase contrast microscopy. From this study, however, precise analysis of asbestos was almost impossible by this method only. As indicated in JIS method of Japan, therefore, count and identification of asbestos were more efficient by dispersion staining method after removing organic materials in samples by low temperature incinerator.

• Journal of the Korean Society of Visualization
• /
• v.13 no.3
• /
• pp.15-19
• /
• 2015

We developed a high-throughput microscopy (HTM) method which enabled us to replace a conventional phase contrast microscopy (PCM) method that has been used as a standard analytical method for airborne asbestos. We could obtain the concentration of airborne asbestos fibers under detection limit by automated image processing and analysis using HTM method. Here we propose an improved image processing algorithm with variable parameters to enhance the accuracy of the HTM analysis. Since the variable parameters that compensate the difference of the brightness are applied to the individual images in our new image processing method, it is possible to enhance the accuracy of the automatic image analysis method for sample slides with low asbestos concentration that caused errors in binary image processing. We demonstrated that enumeration of fibers by improved image processing algorithm remarkably enhanced the accuracy of HTM analysis in comparison with PCM. The improved HTM method can be a potential alternative to conventional PCM.

• Journal of the Institute of Convergence Signal Processing
• /
• v.12 no.3
• /
• pp.181-187
• /
• 2011

In this thesis, digital in-line holographic microscopy has been implemented with enhanced phase shifting technique. It was demonstrated that the zero-order diffraction noise and the twin image can be eliminated by phase-shifting interferometry very effectively. Also the experimental and numerical reconstruction has been incorporated into one set-up operating in real time. Experimental results and the analysis of the phase map indicate that the proposed system can be very useful for the measurement of microscopic objects and 3-D microscopy.

• The Journal of Korean Academy of Prosthodontics
• /
• v.49 no.2
• /
• pp.138-144
• /
• 2011

Purpose: The purpose of this study was to evaluate the cleansing effect of recently developed alkaline ionized water, e-WASH, on microorganisms of the denture surface. Materials and methods: Removable partial and complete dentures were randomly assigned to the experimental group of 41 dentures, and the control group of 26. The denture was immersed in the e-WASH solution (experimental group), or tap water (control group) for 5 minutes. The plaque was collected from the denture surface before and after immersion, and smeared on the slide glass. Amount and motility of microorganisms were compared according to the morphology and strain of microorganisms, using the phase contrast microscope. Statistical analysis was accomplished with paired t-test and independent t-test at 95% confidence level (P<.05). Results: 1. The amount of cocci, bacilli, filamentous, spiral/comma, and the motility of bacilli, filamentous, and spiral/comma were decreased after denture cleansing with the alkaline ionized water, e-WASH (P<.05). But in the control group, only the amount of cocci showed a significant difference (P<.05), but no difference from the others. There were no differences in other analysis. 2. In the experimental group, the amount of cocci, bacilli, filamentous, spiral/comma, and the motility of bacilli, filamentous, and spiral/comma were smaller and more inactive compared to the control group (P<.05). Conclusion: These results indicated that the alkaline ionized water, e-WASH could effectively reduce the amount and motility of the experimented microorganisms on the denture surface, and that e-WASH could be recommended as an effective denture cleanser.

• Korean journal of applied entomology
• /
• v.34 no.4
• /
• pp.368-372
• /
• 1995

To develop a microbial pesticide for the control of pine gall midges. Thecodiplosis japonensis, entomopathogenc fungi were isolated from 233 soil samples in the damaged region of Thecodiplosis japonenesis, and identified with Beauveria spp. 29 strains and Paecilomyces spp. 2 strains. The morphology of entomopathogenic fungi was observed by scanning electron miroscope. In addition, the toxicity of entomopathogenic fungi was observed by scanning electron microscope. In addition, the toxicity of entomopathogenic fungi isolated from soil samples was determined by bioassay against Thecodiplosis japonensis larvae. The result showed that toxicity of relatively pathogenic strains, Beauveria spp. SFB-168-2 was 82.9%, suggesting that Beauveria spp. SFB-168-2 is effective entomopathogenic fungi for the control of pine gall midges.

• Applied Microscopy
• /
• v.29 no.3
• /
• pp.331-341
• /
• 1999

Examination of the morphology of red blood cells in the urine has been shown to be a promising adjunct in determining whether hematuria represents glomerular or nonglomerular bleeding. This is due to distortion of RBCs as they Pass across the basement membrane of the glomerular capillaries. It is concluded that is method can greatly help the clinician in distinguishing between glomerular and nonglomerular bleeding in patients with hematuria and channeling such patients toward the most appropriate investigations. We have experimented dysmorphic red blood cells that 5 patients of the hematuria are distorted with irregular outlines and often have small blobs extruding from the red cell membrane. Tried urinary sediments were seen with phase contrast microscope and confirmed scanning electron microscope. There are seen acanthocytes, anulocytes, ghost cells and sphero-echinocytes in dysmorphic erythrocytes. Clinical diagnosis was referred from the result of the biopsy-proven. Scanning electron microscopic findings of the hematuria are good diagnostic tool that disclose in distorted red blood cells from patients with glomerular disorders.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.1 no.2
• /
• pp.221-237
• /
• 1991

This study was conducted to evaluate the accuracy and the precision of asbestos counting data produced by the Division of Industrial Health, School of Public Health, Seoul National Universitys (SNU). The study was performed from July 18 to October 4, 1991, and the results are summarized as follows. 1. Intracounter Relative Standard Deviations (Sr) in the category of 5-50.5 fibers as total fibers counted ranged from 0.27 to 0.37, which were greater than 0.10-0.17 which were reported by the NIOSH. The reasons are supposed to be as follows. First, inexperience of counters in asbestos fiber counting was considered to be a main reason. Second, poor quality of samples due to sampling and mounting error increased variation of counting. Third, fiber density of many samples were less than $100fibers/mm^2$. But Intracounter Relative Standard Deviations (Sr) in samples with >50.5 fibers ranged from 0.l6 to 0.20, approaching the value 01 NIOSH. 2. Intralaboratory Relative Standard Deviations (Sr) in categories of 5-20.5, >20.5-50.5 and >50.5 fibers were 0.54, 0.37 and 0.26, respectively. Intralaboratory Sr in samples with fiber density greater than $100fibers/mm^2$ was 0.26. This was similar to the values reported by other foreign experienced laboratories. 3. Comparing results of three counters, Counter C, a beginner, overestimated asbestos fiber concentrations. 4. Since our SNU laboratory has participated in two quality control programs, IOMA-F.R.I.C.A., U.K. and NIOSH PAT Program, U.S.A., this laboratory has been evaluated as " Rating 1" and "Proficient" laboratory, by IOM and NIOSH, respectively.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.22 no.2
• /
• pp.134-139
• /
• 2012

Objectives: This study was conducted to study the analytical variability of A & B counting rules in counting using a phase contrast microscope airborne fibers collected on filters in man-made mineral or vitreous fibers (MMMFs) industries. Methods: Fibers in filters were counted using A & B rules of NIOSH Method 7400. Intra-counter and inter-counter variations by fiber type and density were obtained. The types of MMMFs analyzed were glass wool fiber, rock wool fiber, slag wool fiber, and refractory ceramic fibers. The densities of fibers classified were <20 $fibers/mm^2,$ 20 - <50 $fibers/mm^2$, 50 - <100 $fibers/mm^2,$ and ${\geq}100$ $fibers/mm^2,$ respectively. Results: Intra-counter relative standard deviations by rule A were 0.084, 0.102, 0.071 for glass wool fibers, rock wool fibers and refractory ceramic fibers, and those by rule B were 0.139, 0.120 and 0.142, respectively. Inter-counter relative standard deviations by rule A were 0.281, 0.296, 0.180 for glass wool fibers, rock wool fibers and refractory ceramic fibers, and those by rule B were 0.396, 0.337 and 0.238, respectively. Conclusions: Intra-counter variation was not different significantly among fiber types (p>0.05), but B rule variation for ceramic fibers approximately 2 times greater than corresponding A rule estimates, and intra-counter and inter-counter variations were higher in the low fiber density.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.27 no.1
• /
• pp.103-108
• /
• 2023

In this study, basic research was conducted to secure microbial resources applicable to autonomous crack healing concrete. To this end, in this experiment, biomineral-forming microorganisms were separated from natural sources, and the ability of survival in cement and calcium carbonate precipitation were compared to secure suitable microbial resources. Bacillus-type bacteria forming endospores were isolated from the sample, and the amount of calcium carbonate produced by the six microorganisms identified by 16S rRNA sequencing was compared. Two types of microorganisms, Bacillus velezensis and Bacillus subtilis, with the highest calcium carbonate precipitation were selected, and the survival of the microorganisms was confirmed through phase contrast microscopy after being cured after being added to the mortar. In addition, it was confirmed that the autonomous crack healing capability by the crack healing material produced by microorganisms was confirmed by artificially generating cracks in the mortar.

• Journal of the Microelectronics and Packaging Society
• /
• v.24 no.2
• /
• pp.23-27
• /
• 2017

This paper proposes an approach to predict the reliability of high temperature heaters by identifying their primary failure modes and mechanisms in the field. Test specimens were designed to have the equivalent stress conditions with the high temperature heaters in the field in order to examine the effect of stress conditions on the solder joint failures. There failures often result from cracking due to intermetallic compound (IMC) or void formation within a solder joint. Aging tests have been performed by exposing the test specimens to a temperature of $170^{\circ}C$ in order to reproduce solder joint failures in the field. During the test, changes in IMC formation were investigated by scanning electron microscopy (SEM) on the cross-sections of the test specimens, while changes in void formation were monitored both by resistance spectroscopy and by micro-computed tomography (microCT), alternately. The test results demonstrated the void volume within the solder increased as the time at the high temperature increased. Also, the phase shift of high frequency resistance was found to have high correlation with the void volume. These results implied the failure of high temperature heaters can be non-destructively predicted based on the correlation.