• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.8
• /
• pp.809-815
• /
• 2003

It is very important to get very high switching speed as well as low phase noise of frequency synthesizer in the OFDM/FH communication system. In this paper we compare the phase noises and switching speeds of the conventional PLL and digital hybrid PLL(DH-PLL) frequency synthesizer, also, we investigate the effect of phase noise on the performance of OFDM/FH communication system. DH-PLL has high switching speed property at the cost of circuit complexity and more power consumption. Unlike the conventional PLL in which the phase noise and switching speed have the trade off relationship in respect of loop filter bandwidth, DH-PLL frequency synthesizer can perform fast switching speed and low phase noise simultaneously. Under the condition of same hopping speed requirement, DH-PLL can achieve faster switching speed and lower SNR penalty compared with conventional PLL in the OFDM/FH communication system.

• Journal of Power System Engineering
• /
• v.4 no.4
• /
• pp.16-24
• /
• 2000

고체내의 열에너지의 전달을 분석하기 위하여 고전적인 Fourier 열전도 법칙과 에너지 보존식에서 유도되는 열전도 방정식을 사용해 왔다. 이러한 열전도 방정식은 열전도가 무한한 속도로 진행된다는 것을 의미하고 있다. 그러나 극저온상태에서나 매우 급속한 열전도과정 중 매우 짧은 시간의 상태에서 non-Fourier 모델에 기초를 둔 쌍곡선형 열전도 방정식이 도입되었다. 최근의 이에 관한 연구에서 열전도가 파장의 형태로 유한한 전파속도를 갖는다는 것이 실험적으로 증명되었고 이로부터 여러 가지 실험적인 해석과 이론 해석이 전개되었다. 본 논문에서는 열전파 속도의 유한한 성질을 나타내는 수정된 열전도 법칙을 이용하여 1차원 평판에 대하여 공간에 대한 finite Fourier 변환 방법과 Green 함수 방법으로 해석하여 열전도파의 파동 성질, 공진 현상 및 위상차를 고찰하고자 한다. 열전도파가 갖는 모달 주파수에 대해 임계값을 갖으며 이 임계값을 초과할 때 공진 현상과 위상차를 고찰할 수 있었다.

• Journal of Astronomy and Space Sciences
• /
• v.9 no.1
• /
• pp.120-125
• /
• 1992

The normalized line profiles of VV Cep have been calculated by integrating the equation of transfer. The Sobolev theory was adopted and the wind velocity distribution was assumed to be V(r) = V$\infty(1-R_c/r)^{1/2}$. The peaks of the line profiles for the phase 0.06 and 0.80 appear at near half maximum and zero velocity surface of the wind, respectively.

• The Journal of Engineering Geology
• /
• v.16 no.4 s.50
• /
• pp.381-392
• /
• 2006

The passive surface wave survey using microtremor is conducted in areas of crystalline rock basements to obtain average shear-wave velocity structures to 30 m deep (Vs30), on which the earthquake-resistant design standard is based. Test data were recorded at two sites with triangular and L-shaped arrays for 4 seconds with an sampling interval of 2 ms. The microtremor recorded at a site were analysed using the spatial autocorrelation method to obtain phase-velocity spectra and effects of major factors such as size and shape of away and number of record and receiver were examined. At the other site, shear-wave velocities were derived from VSP and microtremor data separately. The results from these two methods agree to each other reasonably well, indicating that the microtremor method can be an effective geophysical tool to measure Vs30.

• 한국방재학회:학술대회논문집
• /
• 2009.02b
• /
• pp.61.2-61.2
• /
• 2009

• Geotechnical Engineering
• /
• v.13 no.1
• /
• pp.111-122
• /
• 1997

The calculation of phase velocities in Spectral-Analysis -of-Surface -Waves (SASW) meas urements requires unwrapping phase angles. In case of layered systems with strong stiffness contrast like a pavement system, conventional phase unwrapping algorithm to add in teger multiples of 2n to the principal value of a phase angle may lead to wrong phase volocities. This is because there is difficulty in counting the number of jumps in the phase spectrum especially at the receiver spacing where the measurements are in the transition Bone of defferent modes. A new phase interpretation scheme, called "Impulse Response Fil traction ( IRF) Technique," is proposed, which is based on the separation of wave groups by the filtration of the impulse response determinded between two receivers. The separation of a wave group is based on the impulse response filtered by using information from Gabor spectrogram, which visualizes the propagation of wave groups at the frequency -time space. The filtered impulse response leads to clear interpretation of phase spectrum, which eliminates difficulty in counting number of jumps in the phase spectrum. Verification of the IRF technique was performed by theoretical simulation of the SASW measurement on a pavement system which complicates wave propagation.opagation.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.30 no.5
• /
• pp.217-222
• /
• 2018

An analytical method for determining the degree of wave refraction is investigated. The ray tracing method previously used to calculate wave propagating cannot explain the degree of refraction caused by different kinds of conditions. In this study, we suggest the index of refraction degree using the principle that refraction is caused by the difference of phase velocities along the crest line.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.6
• /
• pp.2181-2188
• /
• 1991

The ultrasonic longitudinal wave velocities propagating normal to the surface in thin plates were measured with the amplitude spectrum method. The accuracy of the velocity measurement in o.5mm thick plates was 0.1%. In 4.239mm thick plate the phase velocities at the frequency band of 5MHz-15MHz were measured with the phase spectrum method and the amplitude spectrum method, and the velocity difference between two methods was less than 20m/s.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1998.05b
• /
• pp.204-209
• /
• 1998

핵연료 펠렛이 장입되어 있는 원전연료봉 피복관은 핵분열성 물질의 외부 유출에 대한 일차 방호벽 역할을 하므로 원전의 안전성을 위해서는 피복관의 구조건전성 확보가 매우 중요하다. 고온, 고압의 운전 조건 속에서 연료봉 피복관은 산화막이 생성 상장하여 연료봉을 취성 파괴시킬 가능성이 있으므로 이를 가동중에 비파괴적으로 측정할 수 있는 방법을 개발할 필요가 있다. 산화막이 존재하는 지르칼로이 피복관에 대한 음파의 공명산란을 이론적으로 모델링하고 수치해석을 수행하였다. 산화막이 피복된 원통형 쉘의 공명산란에서 공명 원주파의 전파 특성은 산화막의 존재 여부와 그 두께 증가에 따라 크게 변화한다. 수치 해석 결과 제 1차 반대칭 (A$_1$) 원주파의 특정 부분파의 경우에는 산화막의 존재에도 불구하고 위상속도가 일정한 특이성을 보였다. 이러한 위상속도 특성을 실험을 통하여 확인하였으며 이 현상을 이용하여 산화막의 두께를 측정할 수 있는 새로운 비파괴 평가 방법을 제안하였다.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.6 no.2
• /
• pp.180-190
• /
• 2001

In this paper, a method of reducing torque ripples caused by phase winding inductances in BLDCM(Brushless DC Motor) drives is presented. In order to compensate the inductive current delays, commutation angle is controlled by the value compensating angle varied in accordance with rotational speed. Using the microprocessor AVR 8515, the proposed compensator is implemented and experiments are done with a 4-pole 3-phase BLDCM. The results show the remarkable reduction of torque ripple at whole speed ranges.