• Journal of KIISE
• /
• v.42 no.5
• /
• pp.551-557
• /
• 2015

The technology using ARM TrustZone draws attention as a new embedded virtualization approach. The ARM TrustZone defines two virtual execution environment, the secure world and the normal world. In such an environment, the inter-world communication is important to extend function of software. However, the current monitor software does not sufficiently support the inter-world communication. This paper presents a new inter guestOS communication scheme, for each world, for the ARM TrustZone virtualization. The proposed communication scheme supports bidirectional inter-world communication for single core and multicore environment. In this paper, It is implemented on a NVIDIA Tegra3 processor based on the ARM Cortex-A9 MPCore and it showed a bandwidth of 30MB/s.

• The Transactions of the Korea Information Processing Society
• /
• v.1 no.3
• /
• pp.367-379
• /
• 1994

This paper describes scheduling algorithms of the UNIX operating system and shows an analytical approach to approximate the average conditional response time for a process in the UNIX operating system. The average conditional response time is the average time between the submittal of a process requiring a certain amount of the CPU time and the completion of the process. The process scheduling algorithms in thr UNIX system are based on the priority service disciplines. That is, the behavior of a process is governed by the UNIX process schuduling algorithms that (ⅰ) the time-shared computer usage is obtained by allotting each request a quantum until it completes its required CPU time, (ⅱ) the nonpreemptive switching in system mode and the preemptive switching in user mode are applied to determine the quantum, (ⅲ) the first-come-first-serve discipline is applied within the same priority level, and (ⅳ) after completing an allotted quantum the process is placed at the end of either the runnable queue corresponding to its priority or the disk queue where it sleeps. These process scheduling algorithms create the round-robin effect in user mode. Using the round-robin effect and the preemptive switching, we approximate a process delay in user mode. Using the nonpreemptive switching, we approximate a process delay in system mode. We also consider a process delay due to the disk input and output operations. The average conditional response time is then obtained by approximating the total process delay. The results show an excellent response time for the processes requiring system time at the expense of the processes requiring user time.

• Journal of Satellite, Information and Communications
• /
• v.11 no.3
• /
• pp.51-57
• /
• 2016

Many kinds of telemetry should be monitored to check the state of spacecraft and it leads the time consumption. However, it is very important to define the status of satellite in short time because the contact number and time of low earth orbit satellite is limited. Also, on-board fault management should be prepared for non-contact operation because of the sever space environment. In this paper, on-board and ground autonomous operation method for the safety enhancement is described. Immediate fault detection and response is possible in ground by explicit anomaly detection through satellite event and error information. Also, satellite operation assistant system is proposed for ground autonomy that collect event sequence in accordance with related telemetry and recommend or execute an appropriate action for abnormal state. Critical parameter monitoring method with checking rate, mode and threshold is developed for on-board autonomous fault management. If the value exceeds the limit, pre-defined command sequence is executed.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.23 no.12
• /
• pp.106-114
• /
• 2009

This paper addresses unit commitment for microgrid optimization including renewable energy sources, working under deregulated power market. As microgrid supplies both heat and electricity for consumer, operational optimization must be done to meet their demand economically. So renewable energy sources are considered to be negative load, and batteries are used as the load flattening device to raise possibly operational function. In the state of solution, the program is developed to solve out the maximum profit of microgrid using dynamic programming method. Finally, its validity is verified through case study in isolation mode and interconnected mode. The S/W will be used to operate microgrid economically after the market of microgrid is formed.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.47 no.4
• /
• pp.283-288
• /
• 2019

In this paper, there is summarized the validation of ground test results through the telemetry acquired during on-orbit initial activation on solar-array drive assembly(SDA) of GK2A launched at Dec-5, 2018. Especially, the decision logic of SDA initial position and the compensation logic are validated and confirmed. The SDA initial position is needed when GK2A enter to geostationary orbit from transfer orbit and the compensation logic is for the accumulated position error due to the open-loop control. Up to now, it is normal operating. Also the periodic offset between the geostationary orbit and Sun position is found that it is not checked on design phase, and then the proper threshold value is applied.

• Journal of Energy Engineering
• /
• v.25 no.3
• /
• pp.73-82
• /
• 2016

The energy consumption efficiency in a variety of operational test mode was considered for domestic gas boiler below 70 kW. The energy efficiency test carried out in the experimental conditions similar to the actual operation status was analyzed and compared with the current Korean efficiency test method. Four types of test modes for each boiler(Non-condensing and condensing boiler) were carried out in the condition of laboratory mode(full load, steady state) and actual operating mode. Futhermore divided into two operational status for each of these, it was applied by maximum gas consumption and consumer sales conditions. Test equipment has the function referred to gas boiler standards, such as KS or European standard EN. The equipment should be continuously measured and record the measuring factors which are the flow volume of gas and water, laboratory temperature, water flow volume for heating, return water volume after heating and quantity of the exhaust gases(CO, NO, $NO_2$). The experimental results were found that non-condensing boiler efficiency of laboratory mode is about 10% higher than that of actual mode. In case of condensing boiler, the efficiency of laboratory condition is about 20% higher than that of the actual using conditions. I suggest that the government will gradually take the efficiency test method considering the actual conditions.

• Proceedings of the KIEE Conference
• /
• 2008.04c
• /
• pp.205-207
• /
• 2008

본 논문에서는 권선형 유도기를 사용한 이중여자 유도형 풍력발전기용 제어기를 개발하였다. 제어기는 발전기의 회전속도와 발전량, 기리고 계통 전압 등의 조건에 따라서 발전기를 자동으로 제어한다. 발전이 가능한 조건에서는 발전기의 유효전력은 최적값이 되도록 제어된다. 또한, 풍력발전 시스템의 무효전력은 계통 운영자의 요구, 계통 전압, 그리고 발전량 등을 고려하여 무효전력 제어 모드를 스스로 결정하도록 하였다.

• Proceedings of the KIEE Conference
• /
• 2008.10c
• /
• pp.202-204
• /
• 2008

RCM(reliability Centered Maintenance) 적용 시 나타나는 장점으로 인해 이미 여러 산업 분야에 적용되고 있다. 설비의 안정성을 중요시하는 원자력발전 부문에서 처음으로 도입 후 전력산업분야 대부분에서 RCM을 적용하거나 적용연구가 진행되고 있다. 철도산업에서도 전력산업 분야와 같이 안정적 이면서 경제적인 전력을 공급하는 것이 중요하므로 정비업무의 중요성이 크다고 할 수 있다. 특히 철도 시스템 중 한전에서 154kV나 345kV를 수전 받아 철도 시스템에 전력을 공급하는 변전소의 역할은 매우 중요하다. 따라서 철도 변전소를 구성하고 있는 설비의 특성과 운영방식에 대한 연구를 통해 적절한 RCM적용 방안을 위한 고장모드 및 임계분석 (FMECA: Failure Mode, Effects and Criticality Analysis) 연구의 필요성이 대두된다. RCM과 FMECA는 적용 산업분야에 따라 적용 절차를 다르게 적용되어진다. 따라서 철도 변전소에 대한 고장데이터와 설비들의 특성 및 현재 운용방식 등을 종합적으로 고려하여 적절한 수립방법 연구가 필요하다.

• The Transactions of the Korea Information Processing Society
• /
• v.1 no.4
• /
• pp.438-451
• /
• 1994

A low complexity, fault detecting computer architecture for utilisation in programmable logic controllers is designed. The cyclic operating mode of PLCs and a specification level, graphical programming paradigm based on the interconnection of application oriented standard software function modules are architecturally supported. Thus, by design, there is no semantic gap between the programming and machine execution levels enabling the safety licensing of application software by an extremely simple, but rigorous method, viz, diverse back translation.

• Review of KIISC
• /
• v.3 no.4
• /
• pp.69-88
• /
• 1993

이 시리즈를 시작하면서 제3권 제2호(1993.6)에 sc27국제표준화 현황을 정리해 보고했었다. 필자와 산업연구원의 이경석 박사가 1993년 10월 파리에서 열린 SC27 국제표준 총회에 다녀와 새로 정리된 최신의 표준화현황은 11월 20일 개최되는 1993년도 한국통신정보보호학회 학술대회에서 특별보고회로 발표되며그 내용은 논문집에 포함되어 있으니 참고 바란다. 이번 호에는n비트의 입출력을 갖는 블럭암호화 알고리즘의 사용방법에 관해 1991년에 국제표준이 된 문서 IS 10116를 소개한다. 이보다 앞서 1987년 IS 8372로 거의 같은 내용의 국제표준이 n=64의 경우에 한정되어 만들어져 사용되어왔다. 1992년 정보보안 국제총회에서 IS 10116이 IS8372의 내용을 포함하며 IS 10116가 IS 8372보다 더 잘 서술되어 있으므로 IS 3872를 국제표준으로 놓아두자는 결론을 냈었다.