• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2011.11a
• /
• pp.750-755
• /
• 2011

The ignition characteristics of liquid rocket engine thrust chambers which have been developed by domestic technology were analyzed. Analysis results showed that low frequency fluctuation appeared in a partial ignition range according to different temperature profiles and vaporous state in the oxidizer manifold with startup sequences. This low frequency fluctuation wasn't developed as a malfunction factor, but this fluctuation is thought to be taken a continuous concern considering interfaces with engine system and launch vehicle.

• LP가스
• /
• s.87
• /
• pp.46-50
• /
• 2003

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2017.05a
• /
• pp.1084-1087
• /
• 2017

When a liquid rocket engine is started the oxidizer and fuel must be flowed into combustion chamber and gas generator with time differences. The wrong time difference between propellants or malfunction of ignition device can occur the explosion of combustion chamber due to detonation by energized premixed-propellants. Therefore it is important to observe the transient characteristic of propellants or to measure the inflow time of propellants into combustion chamber and gas generator. The measurement of static pressure is not enough to observe the propellants inflow time into combustion chamber and gas generator. By measuring dynamic pressure of main flow passage of propellants the accurate propellants inflow time could be investigated.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2011.11a
• /
• pp.379-382
• /
• 2011

Engine test as well as unload test of starting motor itself was performed to evaluate the braking characteristics of starting system used for initial spin-up of gas turbine for power generation. Through the experimental evaluation of the braking performance with the capacity of braking resistor of the starting motor, we have achieved quantitative data to secure robust braking characteristics in emergency during the starting period of the gas turbine. It is possible to establish a capacity selection criterion of braking resistor to ensure the starting reliability of the gas turbine.

• Proceedings of the KIPE Conference
• /
• 2008.10a
• /
• pp.184-186
• /
• 2008

리니어 발전기는 리니어 엔진의 시동에 필요한 연소조건을 만들기 위하여 전동기로 동작하다가 연소가 안정화되면 발전기로 동작을 하여 PCS(Power Conditioning System)를 통해서 전력을 계통으로 보내주게 된다. 리니어 엔진의 초기 시동을 하기 위하여 발전기는 운동주파수와 운동방향, 그리고 힘의 크기를 제어해야 하며, 발전 시에는 엔진의 동작에 맞도록 전력을 제어해야 한다. 이를 효율적으로 제어하기 위하여 MSC(Machine Side Converter)에서 상전류를 독립적으로 조절할 수 있는 H-bridge로 각 상을 구성하였다. LSI(Line Side Inverter)는 DC-Link 전압을 제어하여, MSC의 동력/발전 동작에 따라서 전력을 계통에서 받아오거나 전력을 계통으로 보내는 동작을 한다. 본 연구에서는 리니어 발전기 모델링를 통해서 PCS 제어 알고리즘을 확인하고 전체 시스템과 연동을 한 실제 운전특성에 대하여 살펴보았다.

• Journal of Aerospace System Engineering
• /
• v.17 no.6
• /
• pp.144-148
• /
• 2023

Aircraft battery is the core equipment of an aircraft that supplies engine starting power and emergency power, and it must be charged to ensure sufficient capacity at all times and maintain high reliability to ensure stable power supply. The battery of the T-50 series aircraft is designed to enable the engine to start up to two times in temperatures as low as -18℃ and above. However, intermittent failures in engine starting have been observed during winter. In this paper, we analyze the failure phenomena occurring during low-temperature charging of the battery and improve the charging algorithm based on the analysis and test. Additionally, the results of start simulation tests show that the battery charging defects at low temperatures are resolved, and an improvement in the charging performance is confirmed; thus, validating the effectiveness of the new algorithm.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.14 no.2
• /
• pp.10-18
• /
• 2010

Scramjet engine is one of the core parts of hypersonic vehicle of next generation and being investigated by many countries. Korea Aerospace Research Institute performed a ground test of the model scramjet engine S1 in 2007. And, S2 model which is improved from S1 model in engine startability and thrust was tested with HIEST (High Enthalpy Shock Tunnel) at Kakuda Space Center of JAXA. Design condition of S2 model was Mach 6.7, however, it was tested at Mach 7.7 as an off-design condition test. As a test result, flow separation was found at the inside of the intake, but the engine showed stable combustion pressure distribution. Furthermore, compared to other test models, S2 model showed a good performance value in thrust and specific impulse.

• Journal of IKEEE
• /
• v.17 no.1
• /
• pp.63-70
• /
• 2013

In this paper, we have implemented the performance evaluation system of the unified fuel heater for CRDI diesel engine. If the diesel engine be cold by low temperature in winter, then that makes the waxing materials like a paraffin and is the source of poor engine starting. The unified fuel heater is the barrow meter that estimate the start performance of diesel engine, and be tested by test chamber. The chamber perform the normal temperature, an extremely low temperature, an operating performance in an extremely high temperature, the resistance operation delay time and current operation delay time in setting up test resistance, the bimetal delay time test in temperature variation, the current and resistor test of the composited heater, a heating operation test.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2008.11a
• /
• pp.15-18
• /
• 2008

This study fulfilled analysis of startup characteristics of Turbo pump unit-Gas generator open loop test from the viewpoint of simulation. The test results were investigated and the calculated results were compared to test results. The curve for RPM developing predicted by simulation agreed well with test result. The slope of transient combustion pressure of gas generator correspond with test result.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2008.11a
• /
• pp.19-22
• /
• 2008

This study fulfilled analysis of startup characteristics of Turbo pump unit-Gas generator closed loop test from the viewpoint of simulation. The test results were investigated and the calculated results were compared to test results. The curve for RPM developing predicted by simulation agreed well with test result. The slope of transient combustion pressure of gas generator correspond with test result.