• Journal of Energy Engineering
• /
• v.23 no.3
• /
• pp.174-180
• /
• 2014

Experimental study of liquid nitrogen pool spread is carried out when it is continuously released. The liquid nitrogen spreads over a cement mortar plate with continuous release. Evaporation rate per unit area of the liquid nitrogen is measured using a digital balance, and a spreading distance of the liquid pool is measured by thermocouples. It is discovered that the evaporation rate per unit area of liquid nitrogen tends to decrease as the liquid pool spreads.

• Transactions of the Korean hydrogen and new energy society
• /
• v.29 no.5
• /
• pp.466-472
• /
• 2018

The investigation of cryogenic liquid pool spreading is an essential procedure to assess the hazard of cryogenic liquid usage. In this experimental study, to measure the evaporation velocity when the pool is spreading, liquid nitrogen was continuously released onto unconfined concrete ground. Almost all of the reported results are based on a non-spreading pool in which cryogenic liquid is instantaneously poured onto bounded ground for a very short period of time. A simultaneous measurement of the pool location using thermocouples and of the pool mass using a digital balance was carried out to measure the evaporation velocity and the pool radius. A greater release flow rate was found to result in a greater average evaporation velocity, and the evaporation velocity decreased with the spreading time and the pool radius.

• Transactions of the Korean hydrogen and new energy society
• /
• v.32 no.5
• /
• pp.365-373
• /
• 2021

In this study, evaporation of LN2 non-spreading pool on concrete plate was dealt with experimentally. The thermophysical properties of concrete, which is a composite material, were obtained by minimizing the difference between the numerical analysis results obtained from the assumed properties and the results from experiments. The thermal energy required for evaporation of the liquid pool is supplied from the concrete plate and the wall of the container. As a result of the measurement, the thermal energy flowing in from the wall was negligible compared to the one supplied from the concrete plate. It was found that the measured evaporation rate of the liquid pool by the heat energy supplied through the concrete plate agrees well with the PTC model except for the initial section of the experiment. The validity of the semi-infinite assumption and the one-dimensional assumption, which are the main conditions of the PTC model, was also verified through experiments. The evaporation rate model in the non-spreading pool discussed in this study can provide a basic frame for the one in the spreading pool, which is a meaningful result considering that the spreading pool is very realistic compared to the non-spreading pool.

• Transactions of the Korean hydrogen and new energy society
• /
• v.34 no.5
• /
• pp.526-534
• /
• 2023

To evaluate the risk of leakage when using liquid hydrogen, a leakage test was conducted using liquid nitrogen in an outdoor environment rather than a laboratory environment. To assume a real-scale continuous leak, liquid nitrogen was allowed to leak for 5 minutes through a pipe with a diameter of 25.4 mm at a design spill rate of 60 L/min. The measurement system consisted of devices for climate conditions, LN2 spread and vapor clouds. The main experimental results are the liquid pool radius and the concentration of vapor cloud, and the radius of the liquid pool was compared with the numerical analysis results.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.12
• /
• pp.1193-1199
• /
• 2012

A cup burner experiment was performed to investigate the effect of the oxidizer velocity and concentration on flame instability near extinction. Heptane was used as a fuel and air diluted by nitrogen and carbon dioxide was used in the oxidizer stream. Two types of flame instabilities at the flame base and at axial downstream were observed near extinction. The instability at the flame base could be characterized by cell, swing, and rotation modes, and the cell mode changed to the rotation mode through the swing mode as the oxidizer velocity increased. To assess the parameters for the flame instability, the initial mixture strengths, Lewis number, and adiabatic flame temperature were investigated under each condition. The Lewis number might be the most important among them, but it is impossible to generalize because of the insufficient number of cases. Furthermore, the axial periodic flickering motion disappeared at low and high oxidizer velocities near extinction. This resulted from the fact that low oxidizer velocity induced evaporated fuel velocity below the critical velocity and high velocity made the reacting fuel velocity comparable.

• Korean Journal of Plant Tissue Culture
• /
• v.27 no.3
• /
• pp.203-211
• /
• 2000

In this study to produce large-scale scopolamine we were examined in the tumor calli of Datura metel L. induced by Agrobacterium tumefaciens $Ery{101}$. The growth and scopolamine contents of tumor calli were higher under light condition than in dark. The optimum condition of growth and scopolamine production were fluence rate of 16 $\mu$mol $m^{-2}s^{-1}$, spectra of red light region and 16 hour light periods on 50 mL SH liquid medium in 4 weeks culture. To increase of the scopolamine contents in tumor calli, the optimum concentration of nitrogen source were 1.8 mM NH$_4$+ and 40 mM NO$_3$. The optimum elicitor concentration for production of scopolamine were 10 mg/L chitosan and 15 mg/L yeast extract. The effect of precursors were good at the concentration of 0.2 mM tropine and 0.3 mM tropic acid, respectively. In order to increase of growth and scopolamine contents. we induced mutant from Datura metel L. tumor callus. Mutants of tumor calli were obtained by 3 Krad, 4 Krad and 6 Krad of ${60}^Cor-ray$. Among them, 3 Krad tumor callus was excellent on the growth and teratoma induction. The 4 Krad tumor callus was negligible for both growth and teratoma induction. But the 6 Krad tumor callus was the best in growth and teratoma induction. The formation of the mutant calli can be enhanced through hormonal combination of 1 mg/L 2,4-dichlorophenoxyacetic acid and 0.5 mg/L benzyladenine. We carry out selection mutant tumor calli for high content tropane alkaloid and suspension cultures for scopolamine production.

• The Korean Journal of Mycology
• /
• v.32 no.2
• /
• pp.79-88
• /
• 2004

Cordyceps pruinosa grows upon dead pupae of Lepidoptera and produces one or $3{\sim}4$ club-shaped stromata per host. The stromata have distinct club-shaped head and long stalk. The length of stromata varies from $1{\sim}3\;cm$. Apical head consists of densely crowded semi-immersed perithecia, which are $360{\sim}400\;{\times}\;180{\sim}200\;{\mu}m$ in size. Asci are $150\;{\mu}m$ in length and $2.8{\sim}3\;{\mu}m$ in diameter. Ascospores, which are $124{\sim}141\;{\mu}m$ in length, have thin thread-like structures in the middle with part-spores attached on both sides. Each ascospore does not separate into part-spores after dispersal, but each part-spore germinates and together develops a colony. The imperfect form produces phialides of $15{\sim}24\;{\times}\;2{\sim}3\;{\mu}m$ size, with spherical or spindle shaped conidia of $4{\sim}6\;{\times}\;1.8{\sim}2.4\;{\mu}m$ size, The anamorph was identified as Mariannaea elegans Samson. YMA and SDAY agar media with pH 7 was produced abundant mycelial growth with high density. Best mycelial growth was observed when dextrin was used as a carbon source. Lactose, saccharose and sucrose also produced high mycelial growth. Peptone, yeast extract and tryptone produced abundant mycelial growth, when used as nitrogen sources. Highest mycelial growth and density was observed when C/N ratio was 1 : 1 at the concentration of 12.5 g/l each. $KH_2PO_4$ was the best mineral source for mycelial growth. Highest mycelial dry wt. was produced in YM and SDAY broths. Optimum inoculum for 100 ml of liquid broth was 6 mycelial discs. Similarly, optimum liquid culture period was 7 days.