• Journal of the Institute of Electronics and Information Engineers
• /
• v.54 no.7
• /
• pp.21-28
• /
• 2017

Practical models for FPGA architectures which include performance- and/or density-enhancing components such as carry chains, wide function multiplexers, and memory/multiplier blocks are being applied to academic FPGA placement tools which used to rely on simple imaginary models. Previously the techniques such as pre-packing and multi-layer density analysis are proposed to remedy issues related to such practical models, and the wire length is effectively minimized during initial analytic placement. Since timing should be optimized rather than wire length, most previous work takes into account the timing constraints. However, instead of the initial analytic placement, the timing-driven techniques are mostly applied to subsequent steps such as placement legalization and iterative improvement. This paper incorporates the timing driven techniques, which check if the placement meets the timing constraints given in the standard SDC format, and minimize the detected violations, with the existing analytic placer which implements pre-packing and multi-layer density analysis. First of all, a static timing analyzer has been used to check the timing of the wire-length minimized placement results. In order to minimize the detected violations, a function to minimize the largest arrival time at end points is added to the objective function of the analytic placer. Since each clock has a different period, the function is proposed to be evaluated for each clock, and added to the objective function. Since this function can unnecessarily reduce the unviolated paths, a new function which calculates and minimizes the largest negative slack at end points is also proposed, and compared. Since the existing legalization which is non-timing driven is used before the timing analysis, any improvement on timing is entirely due to the functions added to the objective function. The experiments on twelve industrial examples show that the minimum arrival time function improves the worst negative slack by 15% on average whereas the minimum worst negative slack function improves the negative slacks by additional 6% on average.

• Journal of Korea Society of Industrial Information Systems
• /
• v.19 no.4
• /
• pp.33-39
• /
• 2014

In this paper, a new on-chip aging sensing circuit based on flip-flops is proposed to detect a circuit failure of MOSFET digital circuits casued by aging phenomenon such as HCI and BTI. The proposed circuit uses timing windows to warn against a guardband violation of sequential circuits, and generates three warning bits right before circuit failures occur. The generated bits can apply to an adaptive self-tuning method for reliable system design as control signals. The aging sensor circuit has been implemented using 0.11um CMOS technology and evaluated by $4{\times}4$ multiplier with power gating structure.

• International Journal of Highway Engineering
• /
• v.9 no.4
• /
• pp.33-43
• /
• 2007

Because usually signal controllers on the crosswalks of mid-block provide pedestrian signals every cycle based on the fixed signal plan, pedestrian signals are provided even when there is no pedestrian demand. Consequently, signal is operated inefficiently and this may cause drivels to experience useless delay or violate the signal. Even though recently pushbuttons have been installed to improve the efficiency of pedestrian signal control in the crosswalks of mid-block and the pedestrian safety. they are not spread out national-wide in Korea because of the cost of the pushbutton equipments and the lack of an acknowledgement of the efficiency of the pushbutton. In this study, the effectiveness of the pushbutton on saving the vehicle delay was verified through before and after study in 4 study sites using a traffic micro-simulation model, VISSIM. To evaluate the viability of the pushbutton, a benefit/cost analysis was also performed for 4 study sites. It was found that B/C ratio of all of 4 study sites was greater than 1. The sensitivity analysis for the traffic volume and pedestrian volume were performed to identify the impact of the both volume on the operation of pushbutton. And, a benefit/cost analysis was performed for all scenarios. It was found that when the pedestrian volume is greater than 90ped/h, the pedestrian signal was operated same as the fixed signal plan. That is, there is no benefit of pushbutton at all once the pedestrian volume is greater than 90ped/h. When the pedestrian volume is equal to or less than 90ped/h and the traffic volume is greater than 2,500veh/h, B/C ratio is greater than 1. Also it was found that as traffic volume increases and pedestrian volume decreases, the benefit increases. In this study, the criteria for installation of pushbutton on the crosswalks of mid-block are developed through the sensitivity analysis and benefit/cost analysis. The results of this study may be used as a criteria for expansion of pushbutton system.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.6 no.1
• /
• pp.6-17
• /
• 2013

Recently, the color of vehicle license plate has been changed from green to white. Thus the vehicle plate recognition system used for parking management systems, speed and signal violation detection systems should be robust to the both colors. This paper presents a vehicle license plate recognition system, which works on both of green and white plate at the same time. In the proposed system, the image of license plate is taken from a captured vehicle image by using morphological information. In the next, each character region in the license plate image is extracted based on the vertical and horizontal projection of plate image and the relative position of individual characters. Finally, for the recognition process of extracted characters, PCA(Principal Component Analysis) and LDA(Linear Discriminant Analysis) are sequentially utilized. In the experiment, vehicle license plates of both green background and white background captured under irregular illumination conditions have been tested, and the relatively high extraction and recognition rates are observed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.5
• /
• pp.886-891
• /
• 2015

Recently, The World Health Organization announced that harms human health because of air pollution that are emerging as threats to human health worldwide. according to the, Seoul, 2011 According to a July 2014 - Public Facilities indoor air quality measurements, were examined to be in violation of indoor air pollution standards in most multi-use facility. Indoor air pollution resulting from this is present in the paper, and cause disease, such as pulmonary disease, asthma, bronchitis and to In this connection, the measurement of indoor air quality by using the environment sensor, analyzing the measured data to generate an actuator signal required for ventilation and improve indoor air quality by implementing a monitoring system with real-time measurement, autonomously managing the air quality in our lives so that it can be.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.20 no.4
• /
• pp.1-12
• /
• 2021

Emergence of the COVID 19 pandemic has resulted in a sharp increase in the number of two-wheeler vehicular traffic accidents, prompting the introduction of numerous efforts for their prevention. This study applied XGBoost to determine the factors that affect severity of two-wheeled vehicular traffic accidents, by examining data collected over the past 10 years and analyzing the influence of each factor. Among the total factors assessed, variables affecting the severity of traffic accidents were overwhelmingly high in cases of signal violations, followed by the age group of drivers (60s or older), factors pertaining only to the car, and cases of centerline infringement. Based on the research results, a reasonable legal reform plan was proposed to prevent serious traffic accidents and strengthen safety management of two-wheeled vehicles. Based on the research results, we propose a reasonable legal reform plan to prevent serious traffic accidents and strengthen safety management of two-wheeled vehicles.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.2
• /
• pp.219-228
• /
• 2022

One of the most pressing and demanding issues today in the conditions of widespread transformation and digitalization of spheres of human activity is information security and ensuring the integrity of data. The main research and development in the field of information security is aimed at improving efficiency and rationalization. One of the main means of data transmission and operation of information complexes are fiber-optic systems. To date, there have been incidents of illegal intrusion and theft of information, passing through this type of communication. Thus, today there is a problem associated with insufficient information security in fiber-optic data transmission systems. One of the most effective tools to counter acts of illegal interference in systems are artificial intelligence and cryptographic algorithms of information protection. It is the symbiosis of these two tools that can qualitatively improve the level of information security in fiber-optic data transmission systems. Thus, the authors of this article pursue the goal associated with the description of an innovative system for protecting information from violations in fiber-optic data transmission systems based on the integration of intelligent cryptographic algorithms.

• The Journal of the Korea Contents Association
• /
• v.13 no.3
• /
• pp.435-443
• /
• 2013

While rural highways carry on lower traffic volumes, the deviations of running speeds between vehicles appear to be higher on rural highways than urban highways. The speed characteristic of rural highways is adding to pedestrian-related accidents which occur on a crosswalk with poor sight distance due to the limits of car headlights and lighting. Specially, the aged was mostly occupied in nighttime-related accidents on crosswalks, and pedestrians crossing on the far side of approaching vehicles appear to have the probability of fatality higher than the near side. An alternative is needed to resolve the compounded accidents, and then this study is to establish a new approach to an optimum lighting environment on a crosswalk to improve pedestrian safety. This study was conducted by a survey and a field study on the lighting of existing crosswalks. The field study shows that the existing lighting has the problem of wasting energy and impeding walking due to glare. The survey shows that nighttime sight distance on a crosswalk is required to improve and that road users prefer to be brighter pedestrian waiting space together with the crosswalk. Thus, a lighting environment that is not too bright and illuminates the crosswalk and the pedestrian waiting space is needed to implement.

• Journal of Korean Society of Transportation
• /
• v.36 no.2
• /
• pp.112-128
• /
• 2018

We are implementing pedestrian priority zone policy to certain districts to reduce greenhouse gas and to develop eco-friendly city which has more focus on pedestrians' walking environment. This policy has contributed to citizens' satisfaction level with improved public transportation service as well as more spacious streets for walk. Despite highly positive influence of pedestrian priority zone policy to the walking environment, we need to anticipate the impact of this to traffic environment as it may have bad effect to the overall traffic flow around the zone where the policy is implemented. This research has analyzed the change of characteristics of traffic accidents around the eco-traffic area of Hang-Gung dong, Suwon city, to understand impact of the pedestrian priority zone policy to the traffic surroundings, with pre-post analysis methodology. As a result, number of accidents related to pedestrians showed decrease as pedestrian priority zone is designed operated with focus to pedestrians. But accidents related illegal U-turn and violation of the traffic signal showed (significant) increase as there was a restriction of turns and decrease of overall traffic speed. To prevent the accidents above, we need to notice drivers to pay special attention before the pedestrian priority zone event, and information from this research should be given to the drivers through safety signs and mobile application at the place near to the event.

• The Journal of the Korea Contents Association
• /
• v.13 no.8
• /
• pp.128-140
• /
• 2013

The cause of traffic accidents and driver behavior is affected by psychological factors, because the behavior of drivers and pedestrians, and to identify the psychological linkage analysis to explore improvements in service design approaches are becoming increasingly important. Service design is a service-oriented development methodology that make invisible and intangible elements into visible and higher-value. Accordingly, through design thinking to action for development of products and a pleasant road environment were studied for school zone by discovering underlying issues to resolve in terms of service design. First, survey of domestic road psychological and behavioral problems were derived through the analysis of the causes of traffic accidents and researched the concept of school zones by analyzing the ideas. To reduced the width of the lane manipulate the speed of the vehicle and to cross the crosswalk safely. In order to encourage the flow of vehicle traffic, new solutions are proposed by offering robot traffic lights, graphic design of crosswalk, space, and the fence and convergence public design and services.