• Journal of Internet Computing and Services
• /
• v.4 no.3
• /
• pp.47-55
• /
• 2003

Multicast protocols ore developed in order to support group communications efficiently, However. there still exist some issues to be solved for deploy multicast protocol in the public internet. This paper refers problem of existing Reliable Multicast Protocols and redesigns component function, and proposes enhanced reliable multicast transport protocol, This paper proposed a improved multicast transport scheme in NACK based reliable multicast. This scheme is much faster than by sender-initiated or receiver-initiated recovery and latency is smaller. Designed components are implemented in UNIX environment using C programming longuage. Then the protocol was evaluated performance through simulation. As the result, proposed protocol is better than existing protocols in both of transmission delay and packet loss. Especially, proposed protocol in this paper con be used in multicast services needed high reliability.

• Journal of Energy Engineering
• /
• v.18 no.3
• /
• pp.147-155
• /
• 2009

Demand for distributed source by new and renewable energy has been gradually increasing recently. For the characteristics of distributed generation, distributed source is located near the distribution system and customers' buildings and can be operated in standalone mode or in interface mode with distribution system. When the distributed sources are interfaced with distribution system, the standard for interfacing distributed source with existing distribution system and operation manual should be updated with revisions in order to manage the distributed source effectively and operate the distribution system stably because how to operate the interfaced system is different from that of existing distribution system. In this paper, the FEP(Front End Processor) using the international standard protocol IEC-60870 for interfacing with distributed resources was designed. The designed system was verified via the test result using main control system for distributed generation and RTU(Remote Terminal Unit) for interface with distributed power generating.

• Fire Science and Engineering
• /
• v.27 no.6
• /
• pp.83-88
• /
• 2013

Catastrophic disasters are sprouting out recently, i.e., the radiation leaks and the hydrofluoric acid gas leaks, etc. The restoration work for these kinds of disasters is very harmful and dangerous for human beings to handle themselves, thus allowing manless robots to fly the reconnaissance planes over to the disaster stricken areas and do the necessary work instead. For this endeavor and purpose, we created and tested an intelligent robot that can inspect those areas, using Mbed (ARM processor) technology temperature sensors and gas sensors aided by CAM (Computer-Aided Manufacturing) cameras. Also, HTTP Server, PC, androids and their combined efforts allow their remote controlled operation from far away with timing control. These intelligent robots can be on duty for 24 hours, minimizing the accidents and crimes and what not, and can respond more quickly when these misfortunes actually happen. We can anticipate the economic effects as well, derived from the reduced needs for hiring human resources.

• The KIPS Transactions:PartC
• /
• v.12C no.5 s.101
• /
• pp.679-686
• /
• 2005

Because EPON access network shares a medium and aggregates the traffic from EPON subscribers, scheduling media access control on EPON bandwidth allocation is very important. Furthermore DBA mechanism of EPON based on TDMA is out of specification and up to implementation. This paper deals with a DBA method to guarantee the QoS of the delay sensitive traffic on the base of best-effort service and delay priority queue management. The proposed method performs virtual scheduling algorithm for the integrated traffic. It uses the same MAC messages and tries to guarantee the QoS of higher priority traffic first with a simple DBA architecture. We evaluate the algorithm for traffic delay according to polling interval and traffic load of upstream and downstream. The results show that the proposed method can guarantee the QoS of the delay sensitive traffic with priority of the service classes.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.2
• /
• pp.196-205
• /
• 1991

This paper is a study on the isolated word recognition of speaker independent which proposes to newly improved MSVQ(multisection vector quantization) recognition system which improve the classical MSVQ recognition system. It is a difference that test pattern has on more section than reference pattern in recognition system 146 DDD area names are selected as recognition vocabulary. 12th LPC cepstral coefficients is used as feature parameter. and when codebook is generated, MINSUM and MINMAX are used in finding the centroid. According to the experiment result. it is proved that this method is better than VQ(vector quantization) recognition methods, DTW(dynamic time warping) pattern matching methods and classical MSVQ methods for recognition rate and recognition time.

• Journal of Biosystems Engineering
• /
• v.36 no.5
• /
• pp.355-360
• /
• 2011

This study was carried out to analyze the installation effect of an anti-wind net on reducing wind velocity which was used to protect orchards as well as single-span plastichouses. The pressure drop through three types of anti-wind net was measured in a subsonic wind tunnel. The wind reduction through the anti-wind facility for several sets in respect to three types of the net and heights of the facility ranging from 3 to 11 m was analyzed by using computational fluid dynamics (CFD). The measured data showed that the pressure drop increased as an equation of the second degree of the inlet wind velocity. Numerical computations exhibited that the effect of wind reduction definitely augmented as the net size became smaller and increased with the height of the facility being heightened to some extent. For the typical and widely used anti-wind facility with a height of 5 m and a net size of 4mm, the amount of wind reduction came up to 5.1 m/s for the inlet wind velocity of 20 m/s, and also 7.6 and 10.1 m/s for the inlet wind velocities of 30 and 40 m/s, respectively. In case for the orchard's longitudinal length to be within about 200 m, the appropriately effective height of the facility was predicted to be 5 m. Finally, the negative total pressure on the top face of the single-span plastichouse certainly reduced for all the cases with the anti-wind facility being installed. In particular, the reduction of the negative total pressure was more considerable as the inlet wind velocity increased.

• The Journal of the Korea Contents Association
• /
• v.9 no.7
• /
• pp.57-66
• /
• 2009

Zigbee is a universal communication standard used in USN and is utilized in various applications. Zigbee protocol provides an address within a single PAN network, and at this time, it uses DAA. This is a method that divides a 16-bit address area into blocks with a fixed size according to the depth to assign one to each node. However, this method is limited because it has to assign addresses in 16 bits. As the depth increases, the number of nodes also increases exponentially to the maximal number of routers provided to each depth. Therefore, it is difficult to construct a huge network with numerous routers and large depth as in the places which are wide or have many shadow areas. Besides, since all the operations are performed in a single PAN network, it is hard to make several PANs into a single network. This article suggests new addressing and routing methods that can construct several PAN networks into a single network and combine broad area with less limitation in the number of routers and depth by extending the Zigbee-based network. Moreover, this paper has tested its performance and has verified its usability through substantive tests.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.11 no.4
• /
• pp.52-58
• /
• 2007

The irregular fuel surface was observed by the visualization of hybrid rocket combustion. Even though the test condition maintained oxidizer rich environment, the irregular dark fuel surface was formed as the result of incomplete combustion. In order to investigate the correlation of the characteristics of oxidizer flow and the irregular fuel surface, various flow conditions were imposed such as swirl flow, induced swirl flow by helical fuel configuration and straight flow. Test results revealed no correlation was found between oxidizer flow condition and irregular fuel surface. And this can be a commonly observed phenomena in the tests with different fuel/oxidizer combination. Thus, the irregular fuel surface can be a result of the interaction of blowing flow of vaporized fuel and the boundary layer of oxidizer flow. A further study will be required to confirm the assumption for the formation of irregular fuel surface.

• Korean Journal of Medicinal Crop Science
• /
• v.13 no.4
• /
• pp.133-137
• /
• 2005

Experiments were conducted to find the optimal acclimatization conditions for Eleutherococcus senticosus plantlets regenerated from bioreactor cultured somatic embryos, various acclimatizing conditions were compared regarding both survival rate and growth of the plantlets. Among the various temperature and artificial soil tested, the highest survival rate (88%) was observed when plantlets were acclimatized in Klasmann bed soil at $10^{\circ}C$ When in vitro plantlets directly transplanted to field environment, shading treatment was necessary and 50% shading was more effective than 30% shading. Transplanting season were also important for successful acclimatization of in vitro cultured plantlets, transplanted on March 20 with 50% shading exhibited the best survival rate and further growth.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.12C
• /
• pp.240-248
• /
• 2001

This paper describes the design of a space-division switch which can support a self-healing operation of 2-fiber bidirectional line switched ring in 2.5Gb/s SDH-based transmission system. The switch having a 1.25Gb/s throughput has been designed and implemented with COMPASS tool and 0.87$\mu\textrm{m}$ CMOS gate-array. The proposed switch is suitable for the quickly self-healing operations when a failure occurs in a 2-fiber bidirectional switched ring composed of ADM transmission systems. The switch is composed of an add/drop control part, a cross-point switch, a frame-phase aligner, processor interface and an unequipped data framer. The test results of the switch adapted to 2.SGb/s SDH-based transmission system, show immediate restoration when a failure occurs.