• Journal of the Korea Organic Resources Recycling Association
• /
• v.30 no.3
• /
• pp.23-28
• /
• 2022

In order to investigate the degree of sewage sludge dewaterability using Fe(II)/Na₂S₂O₈, STTF, SCST, water content, TS, VS, TB-EPS as carbohydrate and Protein were measured. The dosage of Na₂S₂O₈ was varied from 0.4 to 0.7 mmol/gVS and molar ratio of Fe(II)/Na₂S₂O₈ was varied from 0.5 to 0.7 mol/mol. According to the increase of the dosage of Na₂S₂O₈ and Fe(II)/Na₂S₂O₈ molar ratio, STTF and SCST increased from 1.00 to 15.00 and 4.51, respectively. Water content decreased to 82.6%. TB-EPS as carbohydrate and protein decreasing rate also increased to 37.16% and 57.34%, respectively. Especially, Na₂S₂O₈ 0.6 mmol/gVS and Fe(II)/Na₂S₂O₈ 0.6 mol/mol condition, water content dercreased to 83.1%, STTF and SCST increased to 13.64 and 4.19 which showed the cost effective improvement of dewaterability. It is considered that SO₄^- radical generated by Fe(II)/Na₂S₂O₈ degraded EPS and converted bound water to free water.

• Journal of the Korean Applied Science and Technology
• /
• v.39 no.4
• /
• pp.552-559
• /
• 2022

Atopic dermatitis (AD) is a chronic inflammatory skin disease accompanied by severe itching, mainly before five. The aim of this study is to investigate the effects of 405 nm+850 nm LED light therapy on AD-like symptoms in NC/Nga mice. The mice were randomly placed in the normal (Vehicle), atopic dermatitis-induced (CON), and 405 nm + 850 nm LED light therapy (LED) groups. The LED experimental group conducted 405 nm+850 nm wavelength LED ray therapy for 10 minutes a day for seven days. LED light therapy research confirmed the improvement and improvement of Dermatics score and observed the reduction of epidermal tissue thickness caused by dermatitis. Based on the significant decrease of serum IL-1𝛽 and transdermal moisture loss and serum IgE concentration due to LED light therapy, LED light therapy can help restore normal skin conditions in mice that cause atopic dermatitis. This study showed the anti-atopic effect of infrared light and blue light. Light in mice with atopic dermatitis led to the simultaneous use of circular LEDs with two wavelengths.

• Journal of the Korea Society of Computer and Information
• /
• v.28 no.2
• /
• pp.181-190
• /
• 2023

This study examined that have excellent antioxidant effect and expand the base of consumption of lotus leaves. We added 1%, 3%, and 5% of lotus leaf powder to traditional gochujang. pH was the highest in the gochujang with lotus leaf powder 1%(p<0.001). The moisture was significantly lower as the addition of lotus leaf powder increased(p<0.01). The viscosity was the lowest with lotus leaf powder 5% was found to be 15.61 dPa·s(p<0.001). In chromaticity, the L value was the highest in the control, the viscosity of gochujang became darker and lessened(p<0.001). The a value and b value showed the highest in the control(p<0.001). The salinity was the lowest in the gochujang with lotus leaf powder 3%(p<0.001). The sugar content decreased as the more amount of lotus leaf. Total phenol and total flavonoid contents was the highest in the gochujang with lotus leaf powder 5%. The DPPH radical scavenging ability was higher as the more amount of lotus leaf. Reducing power and α-glucosidase inhibitory activity was the highest in the gochujang with lotus leaf powder 3%. The gochujang with lotus leaf powder can be expected to have higher antioxidant activities and to be a health functional food.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.49 no.3
• /
• pp.264-273
• /
• 2022

Due to the development of properties of adhesive materials currently used in dentistry, the bonding ability between the brackets and the tooth enamel has been greatly improved. In general, in situations where cooperation can be obtained, adhesion of the orthodontic bracket through the conventional three-step process can show excellent bonding strength. However, if it is difficult to expect patient cooperation, as in the pediatric dentistry area, or if moisture isolation is not properly performed, the binding strength that does not reach the expected effect. As a result, various products that simplify the process for adhesion are being developed. The aim of this study was to evaluate and compare the shear bonding strength between the conventional 3-step adhesion system, self-etching primer system and one-step adhesion system that reduces the priming process. A total of 60 human maxillary, mandibular premolars were prepared. Group I (control group) were followed conventional 3-step bonding process. Group II were conditioned with self-etching primer. Group III were etched with 37% phosphoric acid and brackets were bonded with self-priming adhesive. The resultant shear bond strength of each group was measured and an adhesive remnant index (ARI) was recorded. The mean shear bond strength of group I, II, III were 14.69 MPa, 11.21 MPa and 12.21 MPa respectively. Significant differences could only be found between group I, II and group I, III (p < 0.05). The ARI indicated no significant difference among all groups.

• Korean Chemical Engineering Research
• /
• v.60 no.3
• /
• pp.414-422
• /
• 2022

The objective of this work was to investigate the feasibility of acid-catalyzed hydrothermal fractionation for maximum solubilization of the hemicellulosic portion of two typical agricultural residues. The fractionation conditions converted into combined reaction severity (CS) in the range of 1.2-2.9 was used to establish a simple reaction criteria at glance. The hemicellulosic sugar yield of 56.6% was shown when rice straw was fractionated at the conditions at the conditions; 160 ℃ of temperature 0.75% (w/v) of H₂SO₄, 20 min of reaction time, 1:15 solid/liquid ratio. The hemicellulosic sugar yield of 83.0%, however, was achieved when barley straw was fractionated at the conditions at the conditions; 150 ℃ of temperature 0.75% (w/v) of H₂SO₄, and 15 min of reaction time, 1:10 solid/liquid ratio. For barley straw, acid-catalyzed hydrothermal fractionation could be effectively performed. After the fractionation process, the remaining fractionated solids were 48.5% and 57.5% from raw rice and barley straws, respectively. The XMG contents in the solid residues decreased from 17.3% and 17.6% to 6.0% and 2.6%, which corresponded to 16.7% and 8.5% on the basis of the raw straws, respectively. In another way, only 5.6% of cellulose and 8.5% of XMG were lost due to excessive decomposition during the acid-catalyzed hydrothermal fractionation of barley straw, compared to cellulose and XMG losses of 6.4% and 26.6% in rice straw. Hemicellulosic sugars from the rice straw were considered more over-decomposed due to the somewhat higher reaction severity at the acid-catalyzed hydrothermal fractionation.

• Journal of Navigation and Port Research
• /
• v.46 no.4
• /
• pp.297-302
• /
• 2022

An exothermic oil absorbent sheet with calcium chloride crystals can be fabricated, by dipping a clean polypropylene fabric in calcium carbonate and hydrochloric acid solution and drying it. The exothermic oil absorbent sheet applied to the seawater surface, releases heat by the dissociation of calcium chloride. The dissociation heat liquefies the solidified low-sulfur fuel oil at a low temperature, and converts it to a state at which it can be absorbed. The optimum mole concentrations of calcium carbonate and hydrochloric acid required for the exothermic oil absorbent sheet, are 0.25 M and 0.5 M, respectively. The oil absorption capacity of the exothermic oil absorbent sheet for low sulfur fuel oil depends on the seawater temperature. But, it is highly excellent at 4.5-7.08 g/g at 10℃, the average seawater temperature during the winter in Korea. The exothermic oil absorbent sheet is an excellent alternative in absorbing low-sulfur fuel oil in winter and removing it from seawater.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.27 no.3
• /
• pp.276-282
• /
• 1982

To estimate the responses of sesame plant in growth and yielding traits to different soil drainage conditions, a pot trial was conducted by using of sesame variety "Suweon-9" were introduced with 5 different mixing combinations of clay and sea-sand soils as 0:100, 25:75, 50:50, 75:25, and 100:0 percents in volumetric ratio. Also two irrigation methods as 20mm/6 days interval and 10mm/3 days interval were detected. As a result, water drainage was linearly decreased with increament of clay contents. And the excess drainage condition(such as pure sand soil) required more irrigation, however in crop growths, no significant differences among various soil drainage conditions except the pure sand were recognized. On the other hand, number of capsules per plant, among other yielding components, was most contributed factor to the yield, which was effectively given from the soil mixed with clay and sea-sand as 75% and 25%, respectively. Therefore, much similar responses were also detected from the seed yields per a sesame plant. However, the number of seeds per capsule and maturity function were more effectively composed under the soil mixed with clay and sea-sand as 25% and 75% respectively better than under the soil of 75% and 25%. As a conclusion, the yielding responses of sesame plant was advanced more effectively at the soil conditions of water conserved type (e.g. 25%/75% in clay/sand ratio) than of water-draining type (e.g. 75%/25% in clay/sand ratio).nd ratio).

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.29 no.1
• /
• pp.51-57
• /
• 2023

Because of the global pollution caused by plastic disposal, demand for eco-friendly transformation in the packaging industry is increased. As part of that, the utilization of polylactic acid (PLA) as a food packaging material is increased. However, it is necessary to improve the crystallinity of PLA by adding nucleating agents or to improve the modulus by adding fillers because of the excessive brittleness of the PLA matrix. Thus, the cellulose nanofiber (CNF) was fabricated and dried to obtain a powder form and applied to the CNF/PLA nanocomposite. The effect of CNF on the morphological, thermal, rheological, and dynamic mechanical properties of the composite was analyzed. We can confirm the impregnated CNF particle in the PLA matrix through the field emission scanning electron microscope (FE-SEM). Differential scanning calorimetry (DSC) analysis showed that the crystallinity of not annealed CNF/PLA nanocomposite was increased approximately 2 and 4 times in the 1st and 2nd cycle, respectively, with the shift to lower temperature of cold crystallization temperature (T_cc) in the 2nd cycle. Moreover, the crystallinity of annealed CNF/PLA nanocomposite increased by 13.4%, and shifted T_cc was confirmed.

• The Korean Journal of Mycology
• /
• v.50 no.4
• /
• pp.291-300
• /
• 2022

In this study, the physical properties of the medium and changes in the wood chemical composition of the sawdust were investigated during the cultivation of oak mushroom sawdust bags, and the following results were obtained. After inoculation, the weight of the medium decreased during the incubation period. It is determined that this is not due to evaporation of moisture containing the medium or decomposition of sawdust, but to decomposition of rice bran, a low molecular substance added to the medium. It was confirmed that the moisture content of the medium was steadily increased during incubation, and it was estimated that the organic substrates such as rice brane in the medium was decomposed by mycelium, and water, one of the decomposition products of organic substrates, caused an increase in the moisture content of the medium. Along with the increase in the harvest of oak mushrooms, the proportion of organic substances such as holocellulose and lignin, the main components of the wood cell wall of sawdust, steadily decreased. In particular, the degradation characteristics of the wood cell wall component of shiitake, which is a white rot fungi, were confirmed by higher lignin reduction rate than that of holocellulose. On the other hand, ash, which is an inorganic material, increased with an increase in the number of mushroom harvests. The increase in the amount of ash in the medium may have been due to the decrease in the organic matter content such as holocellulose and lignin.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.25 no.4
• /
• pp.245-257
• /
• 2023

The representative crop in the Republic of Korea, rice, is cultivated over extensive areas every year, which resulting in reduced resistance to pests and diseases. One of the major rice diseases, rice blast disease, can lead to a significant decrease in yields when it occurs on a large scale, necessitating early detection and effective control of rice blast disease. Drone-based crop monitoring techniques are valuable for detecting abnormal growth, but frequent image capture for potential rice blast disease occurrences can consume significant labor and resources. The purpose of this study is to early detect rice blast disease using remote sensing data, such as drone and satellite images, along with weather data. Satellite images was helpful in identifying rice cultivation fields. Effective detection of paddy fields was achieved by utilizing vegetation and water indices. Subsequently, air temperature, relative humidity, and number of rainy days were used to calculate the risk of rice blast disease occurrence. An increase in the risk of disease occurrence implies a higher likelihood of disease development, and drone measurements perform at this time. Spectral reflectance changes in the red and near-infrared wavelength regions were observed at the locations where rice blast disease occurred. Clusters with low vegetation index values were observed at locations where rice blast disease occurred, and the time series data for drone images allowed for tracking the spread of the disease from these points. Finally, drone images captured before harvesting was used to generate spatial information on the incidence of rice blast disease in each field.