• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.12
• /
• pp.1119-1125
• /
• 2010

Most of the sludge pre-treatment methods to improve the anaerobic digestibility of sludge are not practied in the fields with low economical efficiency. The venturi cavitation system (VCS) adopting hydrodynamic cavitation is simple and requires low energy. This research was conducted to investigate the optimum design and operating conditions of the VCS. The experimental results indicated that the optimum number of venturi in series was three, and the suction mode operation of the pump yielded 1.6 times higher pre-treatment efficiency per unit energy consumption than the discharge mode. The combination of venturies with different throat sizes did not affect the pre-treatment efficiency. Also, the parallel installation of the three in series venture unit yielded 30% higher pre-treatment efficiency per unit energy consumption than the single unit. Under parallel conditions, the solubilization efficiency was 5.6 mg ${\Delta}SCOD/g$ TS/kWh, which is higher than the previously reported value.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.19 no.1
• /
• pp.109-114
• /
• 2011

This study was conducted to investigate the effect of hydraulic retention time(HRT) on the power density in a horizontal flow microbial fuel cell(MFC) reactor. When HRTs were 15min, 30min, 60min and 180min, maximum power densities were $24.7mW/m^2$, $27.3mW/m^2$, $22.8mW/m^2$ and $17.2mW/m^2$, respectively. The highest power density was obtained at HRT of 30min. It was 59% improvement when compared to the power density at an HRT of 180min. When HRT was increased, COD removal rate increased whereas the coulombic efficiency remained constant. The result shows that the optimal performance of the horizontal flow MFC reactor could be achieved at HRT of 30min.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.7 no.3
• /
• pp.116-121
• /
• 2004

Treatability tests were conducted to study the feasibility of EMMC process as a recycling-water treatment system in high density seawater aquaculture farm. To study the effect of organic and ammonia nitrogen loading rate on system performance, hydraulic retention time was reduced gradually from 12hr to 10min. The conclusions are can be summarized as follows. When the system HRT was reduced from 12hr to 2hr gradually, there was little noticeable change(reduction) in ammonia nitrogen removal efficiencies. However, removal efficiencies were decreased dramatically when the system was operated under the HRT of less than 2hr. In case of organics(COD), there was no dramatic change in removal efficiencies depending on HRT reduction. COD removal efficiencies were maintained successfully higher than 9％ when the system was operated at tile HRT of 10 min. System performances depending on media packing ratio in the reactors were also evaluated. There were little differences in each reactor performances depending on media packing ratio in reactor when the reactors were operated under the HRT of longer than 1hr. However, differences in reactor performances were considerably evident when the reactors were operated under the HRT of shorter than 1hr. When comparing reactor performance among 25％, 50％,7 5％ packed reactor, it can be judged that media packing ratio more than 50％ plays no significant role in increasing reactor performance. For this reason, packing the media less than 50％ is more reasonable way in view of economic. Such a tendency shown in COD removal efficiencies well agreed with the variation of ammonia-nitrogen removal efficiencies according to the media packing ratio in reactors at each HRT. Difference in effluent ammonia-nitrogen concentration between 50％ media packing reactor and 75％ media packing reactor was negligible. When comparing with the results of 25％ packing reactor, difference was not so great.

• Journal of the Korean GEO-environmental Society
• /
• v.8 no.6
• /
• pp.21-28
• /
• 2007

The objective of this study was to investigate the effect of hydraulic retention time (HRT) on removal efficiencies of organic matter, nitrogen and phosphorus in MBR-RO process for treating synthetic sewage. In MBR process, turbidity was less than average 2 NTU and average removal efficiency showed more than 99% during the operation period(MBR 105 day). As a result of HRT variation, average removal efficiencies of $COD_{Cr}$ on HRT 6, 12, 18 and 24hour were about 72.4, 84, 88.6 and 92.5%, respectively. The $NH_4{^+}-N$ removal efficiency was about 60.2 85.5, 91.3 and 92.2%, respectively. T-N and T-P removal efficiencies increased from 53.7 and 56.8 to 82.5 and 86.4%, respectively as the HRT increased from 6 hour to 24 hour. In RO process, average removal efficiencies of color and $COD_{Cr}$ in RO permeate were about 99.9% and 96.8%, respectively. Also, removal efficiencies of T-N, $NH_4{^+}-N$, $NO_3{^-}-N$ and T-P were all above average 90%.

• Journal of Wetlands Research
• /
• v.12 no.2
• /
• pp.75-89
• /
• 2010

The purpose of this study is to examine the hydraulic stability of the vegetation mat method on high water revetment. Recently, the river is managed not only for the flood control also for the environmental friendliness. For improving the environmental function of the river, the ecological river restoration projects are being performed. To ensure the stability of flood control, instead of removal of concrete revetment, the vegetation mat method has been widely used on the recovery soil. However, the recovery soil method often failed to be stable against the flood, which has caused the economic loss. In this study, the rate of soil loss is evaluated by the hydraulic experiments. Also, the velocity distribution on high water revetment is analyzed by both the hydraulic and numerical experiments.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.18 no.1
• /
• pp.67-73
• /
• 2000

The water quality of inland stream is polluting with industrialization and urbanization, and with that water quality of lake also deteriorated, to manage water quality pollution problem of lake, new water quality management method is needed. As a pilot study of the method that manage water quality of lake using GSIS(Geo-Spatial Information System), we study the method which automatically extract the hydraulic characteristic informations of lake in GSIS environment. Also, as an example of practical use of the extracted hydraulic characteristic information of lake, we carry out the characteristic analysis of waterbody flow using finite different method. With the automation the extraction procedure of hydraulics characteristic information needed in characteristic analysis of waterbody flow, we carried out the analysis efficiently. Particularly, with the extraction of section information on lake not in layout form, in analyzable form, we make the analysis that section information of lake was indispenably required(e.g. stratification analysis) possible in GSIS environment.

• Water for future
• /
• v.29 no.1
• /
• pp.213-220
• /
• 1996

This paper presents an experimental study on the discharge head of Cherepnov water lifter that was continuously operated with the aid of the siphon. The energy used by the Cherepnov water lifter is derived from the potential energy ofthe water itself. The lifter consists of three interconnected tanks and five pipes, one of which is open and two others are hermetically sealed. The effects of varying operating parameters such as the tank and pipe size, the ratio between head of discharge and drop height were analyzed. As a result, factors that can maximize the efficiency and increase the average delivery rate were indentified. When the ratio between head of discharge and drop height is about 0.5, the efficiency of Cherepnov water lifter is maximized. In order to design the efficient Cherepnov water lifter, the discharge head of the Cherepnov water lifter should be assigned to be twice as much as the drop height. The effect of tank size on the efficiency is less than 5%, while the effect of the pipe size is not negligible. The larger the pipe size is, the more the efficiency increases.

• Journal of Wetlands Research
• /
• v.15 no.1
• /
• pp.79-90
• /
• 2013

Stormwater wetland targeted to treat the rainfall runoff from cow feeding-lot basin has been monitored from May 2010 to November 2011. Reduction efficiency estimated based on 20 rainfall event monitoring was 88%, 54%, 70%, 31%, and 64% for TSS, BOD, $COD_{Cr}$, TN, and TP, respectively. Theoretically, as rainfall depth increases, hydraulic exchange ratio has to be increased. When the exchange ratio approaches to 1 (usually design goal), TSS reduction efficiency was estimated about 55%. Uncertainty in reduction efficiency of the stormwater wetland is normally very high due to the continuous rainfall activity, its magnitude and intensity, antecedent dry days, and other natural variables which can not be controlled by experiment conductors. In this study, predominant affecting variables was found to be hydraulics caused by consecutive rainfall events having different intensity and algal growth during dry days.

• Applied Chemistry for Engineering
• /
• v.30 no.5
• /
• pp.627-632
• /
• 2019

In this study, Laminaria japonica was used as a substrate for a mixed aerobic microbial consortium. Laminaria japonica is well-known as a representative brown algal biomass possessing advantages of cheap cost, and high productivity and carbohydrate content. A biological saccharification system was established by inoculating and enriching the mixed aerobic microbial consortium. Production of the soluble carbohydrate and reducing sugar at different hydraulic retention times (HRT) was observed. The efficiency of saccharification increased according to the decrease of HRT. The maximum saccharification yield in a continuous biological pretreatment process was 17.96 and 4.30 g/L/day for the soluble carbohydrate and reducing sugar, respectively at the HRT of 1 day. In contrast, the staccharification yield decreased drastically at the HRT of 0.5 day. Experimental results indicate that Laminaria japonica is a promising material for the production of useful products, in particular for the saccharification through a biorefinery process. It can thus be concluded that a continuous biological pretreatment process using a mixed cultivation system can be successfully employed for the biorefinery technology.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2009.05a
• /
• pp.426-430
• /
• 2009

본 연구에서는 ADCP 측정자료를 효율적으로 활용할 수 있도록 ADCP 이동측정법 자료의 후처리 프로그램을 개발하였다. 먼저, 측정된 ensemble과 방위별 유속으로 표시되던 단면유속분포를 한 눈에 알아볼 수 있도록 좌표를 정리하고 주흐름방향 유속을 출력하는 등, Sontek과 RDI 자료 취득 소프트웨어의 ascii 파일을 사용자가 쉽게 알아보고 가공할 수 있도록 변형하였다. 또한, 기존 ADCP 사용과 관련하여 발표된 screening 및 smoothing 기법을 적용하여 유효한 유속자료를 선별하고 단면의 평균 흐름에 근접한 유속자료를 제공하도록 하였다. 멱함수를 이용한 외삽으로 측정불가역의 유속 및 유량을 추정하였으며, 총 53개 측정자료의 유량을 추정한 결과 ADCP 소프트웨어가 제공하는 유량과 평균 1.33 %의 오차를 보였다. 마지막으로, 정리된 ADCP 자료로부터 하천의 주요 수리학적 특성을 추정하도록 하여 하천단면을 횡단하는 간단한 ADCP 측정만으로도 많은 시간과 노력을 들여 측정하던 하천의 특성을 신속히 파악할 수 있도록 하였다.