• Journal of Advanced Navigation Technology
• /
• v.10 no.2
• /
• pp.167-172
• /
• 2006

In this paper, the 25W power amplifier for UHF band radio transceiver has been designed and realized. The power amplifier was composed of drive, power amplifier and control stages. Feedback topology and coaxial line baluns were used for wide band operation. The VDMOS, which has reliable performance for linearity and efficiency, was used for power device and designed to operate as push-pull amplification at Class AB Bias. The power amplifier designed in such a way was found to show stable AM modulation performance when voice signal was detected at the gate stage, with being designed and realized to meet output specifications of commercial air traffic control transmitter.

• Journal of Advanced Navigation Technology
• /
• v.24 no.6
• /
• pp.566-572
• /
• 2020

In a wireless power transmitter, the characteristics and effects of wireless power transmission between two induction coils are investigated, and a power converter circuit and a battery charger/discharger circuit using wireless power transmission technology are proposed. The advantage of wireless power transmitters and wireless chargers is that, instead of the existing plug-in-mounted wired charger (OBC; on-board charger), the user can wirelessly charge the battery without connecting the power source when charging power to the battery. There is. In addition, the advantage of wireless charging can bring about an energy efficiency improvement effect by using the secondary side rectifier circuit and the receiving coil, but the large-capacity long-distance wireless charging method has a limitation on the transmission distance, so many studies are currently being conducted. The purpose of the study is to study the transmitter circuit and receiver circuit of a wireless power transmission device using a primary coil, a secondary coil, and a half bridge series resonance converter, which can transmit power of a non-contact type power transmitter. As a result, a new topology was applied to improve the power transmission distance of the wireless charging system, and through an experiment according to each distance, the maximum efficiency (95.8%) was confirmed at an output of 3 kW at an 8 cm transmission distance.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.1
• /
• pp.15-22
• /
• 2006

In OFDMA system, even if the number of allocated sub-channel in mobile station varies from one to the whole sub-channel as in base station, while because of mobile station's transmit power is lower than that of base station, therefore full loading range(FLR) constraint occurs where whole sub-channel can be used and the conventional open-loop power control scheme can not be used beyond FLR. We propose a new scheme that limits the maximum sub-channel allocation number and uses power concentration gain(PCG) depending on location of mobile station, which is based on ranging in OFDMA system. Simulation results show that the proposed scheme provides solutions for optimum utilization of radio resource depending on the location of mobile station and enables open-loop power control beyond FLR without extra hardware complexity.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.2
• /
• pp.220-228
• /
• 2012

In this paper, we explained the design technique about Ka-band active limiter for protecting the receiver of a millimeter wave seeker. To implement low flat leakage power, we proposed the control circuit of active limiter to control limiter voltage with PRF(Pulse Repetition Frequency) signal and input power. This active limiter consisted of the conventional 2 stage passive limiter, a feedback circuit with a directional coupler, detector, non-inverting amplifier and over-current protection resistance. As the test result of the fabricated Ka-band limiter, it had 1 GHz bandwidth, 3.5 dB insertion loss at the small input power and -7.5 dBm flat leakage at the 4 W RF input power, respectively.

• Journal of Korea Multimedia Society
• /
• v.2 no.1
• /
• pp.47-58
• /
• 1999

In this paper, we design the radio interface protocols of wideband Wireless Local Loop(WLL) that uses wideband Code Division Multiple Access(CDMA), and propose the random access procedures on access channel and analyze the performance of the channel. The structure of radio interface protocols are designed by three modular parts to meet the requirements of IMT-2000 : radio resource controlling part that depends on the radio resources, connection controlling part that is independent of the radio resources, and application part that supports the interface between different parts and user terminals. In addition, we propose the random access procedures on access channel and analyze the performance of the channel. We assume that both near-far effect and shadow fading can be compensated by open loop power control. We observe that the number of access probes(delay) depend on the initial mobile transmission power and power increment, and the poor estimation of initial mobile transmission power might increase the average number of access probes.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.05a
• /
• pp.37-39
• /
• 2015

In this paper, we propose a distributed user scheduling with interference-aware power control (IAPC) to maximize signal to generating interference plus noise ratio (SGINR) in multi-cell uplink network. Assuming that the channel reciprocity time-division duplexing (TDD) system is used, the interference channel from users to other cell BSs is obtained at each user. In the proposed scheduling, each user reduces the transmit power if its generating interference to other BSs is larger than a predetermined threshold. Each BS selects the user with the largest SGINR among users. Simulation results show that the proposed technique significantly outperform the existing user scheduling algorithms.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.12
• /
• pp.39-44
• /
• 2010

In LTE-Advanced systems, every sector uses the entire range of the frequency resource, and when the UEs are located at a cell edge, user throughputs degrade due to the interferences from the adjacent cells. In this paper, we propose a combined scheme for inter-cell interference avoidance and power control. In the proposed algorithm, the sectors consist of the right edge, the left edge and the center for resource allocation and we control the transmission power to improve the user throughputs at the edge of each cell. Using a system level simulation, we analyze low 5th percentile and average user throughputs of the UEs who are located the cell, center and edge when the inter-cell interference avoidance and the power control are combined.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.5
• /
• pp.709-718
• /
• 2021

As regulations on environmental pollution of ships have been strengthened, interest in smart ships such as electric propulsion ships equipped with hybrid power systems is increasing. Since batteries used in electric propulsion ships have a larger capacity than batteries used in vehicles, the price is high and maintenance is considered important. The ship's battery is manufactured as an integral type and is managed by the battery management system, and the maintenance and repair of the battery is performed through the replacement of the battery. we design and implement a battery module and a control algorithm using pre-cell for easy battery management. In addition, a controller is designed to transmit the data necessary for the electric propulsion ship power system control to the power control system. When a battery to which the corresponding spare-cell is applied is used, the stability of the ship and the battery system is increased, and it can have an advantage in terms of maintenance and repair.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.8A
• /
• pp.1311-1321
• /
• 2001

본 논문에서는 매크로셀/마이크로셀 기반의 셀 구조의 순방향 얼랑 용량 및 outage 확률을 수학적으로 분석하였다. 각 계층 셀에는 음성 및 다양한 속도의 데이터 서비스 사용자가 균일하게 분포되어 있다고 가정하였으며 계층의 자원 분배 방법으로는 각 계층이 동일한 주파수 대역을 사용하는 대역 공유 방식을 적용하였다. 또한, 본 논문에서는 전력 제어의 불완전성에 의한 영향도 고려하였다. 대역 공유 계층셀 구조의 순방향 용량은 계층셀 기지국간 송신 전력비 및 매크로셀 내부에 위치한 마이크로셀의 상대적인 위치와 밀접한 관련이 있다는 결론을 내릴 수 있었으며 모의 실험 결과를 통해 증명하였다. 본 논문에서는 대역폭이 1.2288MHz인 1x 시스템과 광대역 3x 시스템의 순방향 얼랑 용량을 비교 분석하였으며 3x 시스템이 1x 시스템에 비해 3배 이상의 얼랑 용량 증대효과를 가진다는 것을 제시하였다.

• Proceedings of the Korean Information Science Society Conference
• /
• 2001.10c
• /
• pp.256-258
• /
• 2001

이동 환경에서의 서비스가 대중화 되면서 문제가 되고 있는 것이 바로 이동 호스트의 전력 제어 문제이다. 이동 호스트는 충분한 전력을 얻기 힘들기 때문에 데이터 전송을 받지 않는 경우에는 최소한의 정보만을 교환하는 상태로의 전의가 필수적이다. 현재 IETF의 Seamoby Working Group에서 논의되고 있는 IP 페이징 프로토콜의 경우에는 요구사항과 논리적인 구조만이 정의되어 있다. 현재 정의되어 있는 구조의 문제점은 유휴 (formant) 모드에 있는 이동 호스트에 데이터를 전송하기 위해서는 Dormant Monitoring Agent(DMA)로 전송된 데이터에 대하여 버퍼링이 수행되어야만 한다. 버퍼링의 목적은 이동 호스트의 유휴 모드에서 활성 (active) 모드로 전의 되는 시간 동안의 데이터의 손실을 방지하기 위함이다. 따라서, 하나의 DMA해서 관리해야 하는 이동 호스트가 많은 경우에는 대회의 양이 문제가 된다. 즉, 확장성 문제점이 존재하게 된다. 본 논문은 이러한 문제점을 줄이기 위하여 Domain Name Server(DNS)를 이용한 IP 페이징 제공 방안을 제안한다. 본 메커니즘은 송신자가 DNS에 호스트의 IP주소를 얻고자 하는 경우 IP 페이징 프로토콜을 먼저 이동 호스트의 페이징 에이전트에 전송함으로써 미리 이동 호스트를 활성 모드로 변경하게 함으로써 이전 메커니즘에서 적용되어야 하는 버퍼의 크기를 줄일 수 있는 메커니즘이다.