• Management & Information Systems Review
• /
• v.34 no.4
• /
• pp.1-13
• /
• 2015

This paper presents a mathematical formulation for container slot chartering model through strategic alliance between liner shipping companies. This paper develops a solution procedure to apply the model to real world problems and its applicability is demonstrated by a numerical example. The model presented in this paper has some important features which have never been considered in the previous researches. The model is linear model and pursuits profit maximization. And also it considers slot chartering capacity selection. This paper attempts to perform sensitivity analysis and compares slot chartering model with basic non-collaborating model in which there is no alliance and collaboration. As a result of sensitivity analysis, some interesting findings are obtained; Even though freight rate is more and more decreasing, the profit by slot chartering model is always higher than the basic model but the profit gaps become smaller. But The ratio of the profit gap to the profit of basic model is more increasing.

• Journal of the Korean GEO-environmental Society
• /
• v.17 no.10
• /
• pp.23-31
• /
• 2016

Grout is generally operated with low viscous material similar to water, but grout for micro crack with high viscous materials and high injection pressure is gradually increased under the development of underground and subsea space. In order to estimate grouting injection performance considering crack width, viscosity of grouting materials, and injection pressure, there should be a reliable standard laboratory testing method. In this paper, theoretical injection mechanisms of grouting materials are presented as radial and linear flows, and laboratory testing apparatus are introduced to simulate each flow case. Radial flow is simulated by using acrylic disk plates which are able to spread grouting material radially from the center of the disk plates, and linear flow is simulated by using stainless parallel plane plates which are able to spread grouting material linearly. Apparatus are consist of upper and lower plates and industrial films with different thickness are placed between plates in order to simulate various crack widths. Laboratory verification tests with these apparatus were conducted with tap water (1cP at $20^{\circ}C$) as an injection material. Through the laboratory testing results, the best laboratory testing method is recommended in order to estimate grouting injection performance.

• Explosives and Blasting
• /
• v.26 no.2
• /
• pp.38-44
• /
• 2008

Recently, planning road construction in South Korea is focused on upgrading of the existing road by rerouting or restructuring. For this, roads under current construction in Korea go for more straight in its alignments and routing. Straight routing makes it all the more required to construct many mountain tunnels and bridges in Korea where mountains are so widely spread. Some portal of mountain tunnel is not rarely planed at high steep slope of mountain valley where it is not easy to secure working space for tunnel excavation. Reverse excavation is an alternative measure for excavation of tunnel portal at high steep slope. Construction in reverse excavation method has three important points requiring careful consideration: 1)planning of pilot tunnel in proper width, height, and length etc., 2)measure against the effect of one-side earth pressure to the direction of tunnel portal, 3)securing tunnel safety against shallow ground condition at portal zone. This paper intends to suggest applicable range of pilot tunnel for reverse excavation at the portal zone located at high steep slope, and shows result of study on the appropriateness of a reverse excavation by means of 3D numerical analysis. Result of 3D numerical analysis for reverse excavation at high steep slope shows that pilot tunneling will be applicable to start from the point $20{\sim}25m$ before the portal from inside the tunnel.

• Journal of the Korean Society of Radiology
• /
• v.14 no.5
• /
• pp.517-522
• /
• 2020

Electron beam have many factors that affect dose distribution, so even if identical settings are used, they should be identified and used for radiation treatment, and the effects on the structures in the body are sensitive, making it difficult to investigate uniform dose distribution on tumors. In this study, a dosimeter was produced using PbI₂ which is a photoelectric material, and electrical characteristics were analyzed for 6, 9, and 12 MeV electronics in linear accelerators. The reproducibility test results showed that RSD were 1.1215%, 1.0160%, and 0.05137% respectively at 6, 9, and 12 MeV energies, indicating that the output signals were stable. The linearity evaluation results showed that the R² values of the reliability indicator for straight line trend lines were 0.9999, 0.9999, and 0.9994, respectively, at 6, 9, and 12 MeV, to confirm that the output signal was proportional to PbI₂ as dose increased. The PbI₂ dosimeter in this study is judged to be highly applicable to electromagnet measurement and is thought to be able to be used as a basic study of electron detector through photoelectric material.

• Journal of the Korean Society of Radiology
• /
• v.14 no.1
• /
• pp.1-6
• /
• 2020

In this study, it was intended to replace the existing plane parallel ionization chamber, which requires cross-calibration in electron beam treatment. The semiconductor compounds HgI₂ was fabricated as detector, and the characteristics of HgI₂ detector for the 6, 9 and 12 MeV electron beam was analyzed in the linear accelerator. It was also intended to evaluate the possibility of substitution with existing detectors and their applicability as electron beam dosimetry and to use them as a basic study of the development of electronic beam dosimeter. As a result of reproducibility, RSD was 0.4246%, 0.5054%, and 0.8640% at 6, 9, and 12 MeV energy, respectively, indicating that the output signal was stable. As a result of the linearity, the R² was 0.9999 at 6 MeV, 0.9996 at 9 MeV, and 0.9997 at 12 MeV showed that the output signal is proportional to HgI₂ as the dose is increased. The HgI₂ detector of this study is highly applicable to electron beam measurement, and it may be used as a basic research on electron beam detection.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.3
• /
• pp.169-173
• /
• 2015

This study is to predict the life exponent by measuring, over 7 years, the insulation resistance of high-voltage cables in 22 kV operation for 13 years. We found out the lifetime index in order to determine the time-dependent trend of deteriorating performance of power cables. The insulation resistances decreased according to elapsed time. We found that: the initial measurements of the cable systems were in agreement with the deterioration properties of the Arrhenius Law. By analyzing the life curve of the cable system, we also verified that the value of the life exponent (n) in the v-t characteristics defined by Weibull distribution has values from 10 to 11. When designing the cable system, the initial value of life exponent was chosen as 9 without any grounding. We have verified that the theoretical grounding based on the design safety of n=9 was actually the best one available. In the short term, we apply our research result to the diagnosis and evaluation of the power cables. In the long run, however, we plan to reduce the cost of the installation and management of cable systems in operation at power stations.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.8 no.6
• /
• pp.445-452
• /
• 2015

Software reliability in the software development process is an important issue. Software process improvement helps in finishing with reliable software product. Infinite failure NHPP software reliability models presented in the literature exhibit either constant, monotonic increasing or monotonic decreasing failure occurrence rates per fault. In this paper, proposes the reliability model with log and power intensity function (log linear, log power and exponential power), which made out efficiency application for software reliability. Algorithm to estimate the parameters used to maximum likelihood estimator and bisection method, model selection based on mean square error (MSE) and coefficient of determination($R^2$), for the sake of efficient model, was employed. Analysis of failure, using real data set for the sake of proposing log and power intensity function, was employed. This analysis of failure data compared with log and power intensity function. In order to insurance for the reliability of data, Laplace trend test was employed. In this study, the log type model is also efficient in terms of reliability because it (the coefficient of determination is 70% or more) in the field of the conventional model can be used as an alternative could be confirmed. From this paper, software developers have to consider the growth model by prior knowledge of the software to identify failure modes which can be able to help.

• Journal of Korea Water Resources Association
• /
• v.43 no.4
• /
• pp.409-419
• /
• 2010

In this study, for the purpose of analyzing the characteristics of Korean hydrologic weather parameters, 9 hydrologic weather parameters data such as annual precipitation, annual rainy days, annual average relative humidity, annual average temperature, annual duration of sunshine, annual evaporation, annual duration of precipitation, annual snowy days and annual new snowy days are collected from 63 domestic meteorological stations that has the hydrologic weather parameters records more than 30 years. And the basic characteristics of hydrologic weather parameters through basic statistics, moving average and linear regression analysis are perceived. Also trend using the statistical methods like Hotelling-Pabst test and Mann-Kendall test about hydrologic weather parameters is analyzed. Through results of basic analysis, moving average and linear regression analysis it is shown that precipitation is concentrated in summer and deviation of precipitation for each season showed significant difference in accordance with Korean climate characteristics, besides the increase in annual precipitation and annual average temperature, annual average relative humidity and annual duration of sunshine reduction and annual rainy days is said to increase or decrease. The results of statistical analysis of trend are summarized as trend commonly appeared in annual average relative humidity and annual average temperature. and annual precipitation, annual rainy days and annual duration of sunshine showed different results according to area.

• Journal of Platform Technology
• /
• v.11 no.4
• /
• pp.19-34
• /
• 2023

In order to identify the trends and insights of 'startups' in the global era, we conducted an in-depth trend analysis of the global startup ecosystem using Google Trends, a big data analysis platform. For the validity of the analysis, we verified the correlation between the keywords 'startup' and 'global' through BIGKinds. We also conducted a network analysis based on the data extracted using Google Trends to determine the frequency of searches for the keyword or term 'startup'. The results showed a strong positive linear relationship between the keywords, indicating a statistically significant correlation (correlation coefficient: +0.8906). When exploring global startup trends using Google Trends, we found a terribly similar linear pattern of increasing and decreasing interest in each country over time, as shown in Figure 4. In particular, startup interest was low in the range of 35 to 76 from mid-2020 due to the COVID-19 pandemic, but there was a noticeable upward trend in startup interest after March 2022. In addition, we found that the interest in startups in each country except South Korea is very similar, and the related topics are startup company, technology, investment, funding, and keyword search terms such as best startup, tech, business, invest, health, and fintech are highly correlated.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.6D
• /
• pp.711-717
• /
• 2009

This study develops model for analysis of relationship between major node (Interchange in expressway) and land price formation of apartments along with Seoul Belt Expressway by using CHAID analysis. The results show that first, regions(outer side: Gyeongido, inner side: Seoul) on the line of Seoul Belt Expressway are different and a graph generally show llinear relationships between land price and traffic node but it does not; second, CHAID analysis shows two different spatial distribution at the point of 2.6km in the outer side, but three different spatial distribution at the point of 1.4km and 3.8km in the inner side. In other words, traffic access does not necessarily guarantee high housing price since the graphs shows land price related to composite spatial distribution. This implies that residential environments (highway noise and regional discontinuity) and traffic accessibility cause mutual interaction to generate this phenomenon. Therefore, the highway IC landprice model will be beneficial for calculation of land price in New Town which constantly is being built along the highway.