• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.7 s.361
• /
• pp.17-22
• /
• 2007

OFDM (Orthogonal Frequency Division Multiplexing) is a special case of multicarrier transmission, where a single data stream is transmitted over a number of lower-rate subcarrier. One of the main reasons to use OFDM is to increase robustness against frequency-selective fading or narrowband interference. Unfortunately, an OFDM signal consists of a number of independently modulated subcarriers, which can give a large PAPR (Peak-to-Average Power Ratio) when added up coherently. In this paper, we investigate the performance of a simple PAPR reduction scheme, which requires no change of a receiver structure or no additional information transmission. The approach we employed is clipping in the time and frequency domains. The time-domain clipping is carried out with a predetermined clipping level while the frequency-domain clipping is done within EVM (Error Vector Magnitude). This approach is suboptimal with lower computational complexity compared to the optimal method. This evaluation is carried out on the OFDM system with an nonlinear amplifier. The simulation results demonstrated that the PAPR reduction algorithm is one of ways to reduce the effects of the nonlinear distortion of an HPA (High Power Amplifier).

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.12
• /
• pp.80-87
• /
• 2013

A novel instrumentation amplifier(IA) using positive polarity current-conveyor(CCII+) for electronic measurement systems with low cost, wideband, and gain control with wide range is designed. The IA consists of two CCII+, three resistor, and an operational amplifier(op-amp). The principal of the operating is that the difference of two input voltages applied into two CCII+ used voltage and current follower converts into same currents, and then these current drive resistor of (+) terminal and feedback resistor of op-amp to obtain output voltage. To verify operating principal of the IA, we designed the CCII+ and used commercial op-amp LF356. Simulation results show that voltage follower used CCII+ has offset voltage of 0.21mV at linear range of ${\pm}$4V. The IA had wide gain range from -20dB to 60dB by variation of only one resistor and -3dB frequency for the gain of 60dB was 400kHz. The IA also has merits without matching of external resistor and controllable offset voltage using the other resistor. The power dissipation of the IA is 130mW at supply voltage of ${\pm}$5V.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.6 s.97
• /
• pp.603-614
• /
• 2005

In this paper, digital ultra-narrowband Walky-Talky using direct conversion method for CQPSK modulation scheme is implemented with satisfying the requirements of APCO P25. RF transceiver design and implementation scheme that minimize the influence of DC-offset and AC-coupling at ultra-narrowband is proposed. This scheme also minimizes the influence of nonlinear characteristic at power amplifier fir CQPSK modulation method. Test results of full system including DSP module and direct conversion RF transceiver show that FCC emission mask at 36.8 dBm PEP meets the standard requirements. The characteristic of receiver AGC by PWM control signal is linear at 40 dB dynamic range and voice communication at input power level of -116 dBm is successful. Also it is verified that the performance of BER versus frequency offset and versus SNR meets the standard requirements.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.12
• /
• pp.2226-2234
• /
• 2016

Orthogonal Frequency Division Multiplexing (OFDM) technique uses multiple sub-carriers for the data transmission. Therefore, Inter Carrier Interference(ICI) is generated because of nonlinear high power amplifier and carrier frequency offset. Wireless OFDM transmission over Doppler fading channels also causes ICI. In OFDMA(Orthogonal Frequency Division Multiplexing Access), multiple sub-carriers are allocated to each user. Therefore, inter carrier interference causes interference to other users. I evaluate the BER performance of OFDMA systems in frequency selective fading channel, considering Multi-User Interference (MUI) owing to the carrier frequency offset, the nonlinear high power amplifier, and the Doppler fading. In the uplink OFDMA, multi-user interference introduces larger BER degradation than in the downlink. I explain the reason and obtain the required characteristics of the nonlinear amplifier and the value of frequency offset for good BER performance. And I also analyze the BER degradation upon Doppler fading channel.

• Journal of Advanced Marine Engineering and Technology
• /
• v.34 no.8
• /
• pp.1165-1171
• /
• 2010

The OFDM system has better characteristics in transmission rate, power efficiency, bandwidth efficiency, impulse-noise immunity, and narrow band interference immunity etc. in comparison with other conventional systems. However, high PAPR of an OFDM signals causes some serious non-linear processing of RF amplifier. And performance of the communication system gets worse. Therefore, various methods reducing PAPR of an OFDM skills such as the clipping method, block coding method, and phase rotation method etc. have been researched. In this paper, we propose a high-speed adaptive PTS method which eliminates high PAPR. And we compare the proposed method with other conventional methods. The proposed method has decreased quantity of calculation compare with an adaptive PTS method. Of course, The more its calculation amount is decreased, the more its BER characteristic is not better than an adaptive PTS method. However, keeping up satisfactory BER performance, we highly improved calculation amount of a PTS method.

• Proceedings of the Korea Contents Association Conference
• /
• 2005.05a
• /
• pp.458-463
• /
• 2005

OFDM communication system is effective for the high data rate transmission in the frequency selective fading channel. Since OFDM has high PAPR, OFDM signal may be distorted by the nonlinear HPA. In this paper, we propose an combined SLM and PTS method for reducing the PAPR in OFDM communication system. Proposed method increased some system complex in comparison with exiting method. But we made sure of high efficiency in the case of reducing the PAPR. As a result of using the 16-QAM modulation and increasing the carrier number in the SLM, PTS method and the SLM-PTS combined method, SLM-PTS combined method is more an effective method of reducing 3.5 dB PAPR than exiting OFDM system when this method is M, L=3, D=128, 256 in 10-3 BER.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.42 no.4
• /
• pp.739-746
• /
• 2017

Orthogonal frequency division multiplexing(OFDM) systems have many advantages. However, OFDM systems are much affected by a nonlinear distortion because those systems have a high peak to average power ratio(PAPR) value. A selected mapping technology was suggested to reduce a PAPR value. The technology does not have data loss but receivers need side information to know modified phase sequence. Therefore, side information causes decreased a transmission efficiency. In this paper, we suggest a blind SLM receiver using a cross correlation technology. This receiver does not require side information. The proposed blind SLM receiver calculates sums of cross-correlation between transmitted pilot signals multiplied by each phase sequence and received pilot signals. So, this receiver detects side information which has a maximum sum cross-correlation value. We compared our proposed SLM receiver to a conventional blind SLM receiver through bit error rate(BER) and side information error rate(SIER) performances. Simulation results show that the proposed SLM receiver has improved BER and SIER performances than the conventional SLM receiver.

• Journal of the Korea Society of Computer and Information
• /
• v.12 no.1 s.45
• /
• pp.155-160
• /
• 2007

Because output of multi-code CDMA system adapted high speed data transmission becoming multi-level system use linear amplifier in output stage and complex output signal. Therefore, Multi-Code CDMA system has shortcoming of high price, high complexity etc.. Binary CDMA technology that allow fetters in existing CDMA technology to supplement this shortcoming proposed. In binary CDMA system When correlator process high speed data, bottle-neck phenomenon is happened on synchronization acquisition process, it is very important parameter. Because existent correlator must there be advantage that power consumption is small but flow addition of several stages to receive correlation's value, the processing speed has disadvantage because the operation amount is much. Therefore in this paper, proposed correlator has characteristic such as data is able to high speed processing, chip area is independent and power consumption is constant in structure in binary CDMA system.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.3 no.3
• /
• pp.177-182
• /
• 2008

Because output of multi-code CDMA system adapted high speed data transmission becoming multi-level system use linear amplifier in output stage and complex output signal. Therefore, Multi-Code CDMA system has shortcoming of high price, high complexity etc. Binary CDMA technology that allow fetters in existing CDMA technology to supplement this shortcoming proposed. In binary CDMA system When correlator process high speed data, bottle-neck phenomenon is happened on synchronization acquisition process, it is very important parameter. Because existent correlator must there be advantage that power consumption is small but flow addition of several stages to receive correlation's value, the processing speed has disadvantage because the operation amount is much. Therefore in this paper, proposed correlator has characteristic such as data is able to high speed processing, chip area is independent and power consumption is constant in structure in binary CDMA system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.2 s.117
• /
• pp.183-190
• /
• 2007

This paper presents the design of 860 MHz band transmitter for improving power amplifier's linearity using Cartesian feedback method. For eliminating the effects of gain, phase mis-match, and DC offset, we estimate the property variations using ADS software. The implemented Cartesian feedback transmitter exhibits IMD3 of -54 dBc at an output power of 43 dBm and this result shows that the linearity is improved for 22.4 dB, compared with the test of the power amplifier without Cartesian feedback system. Thus, we verify that the proposed Cartesian feedback transmitter can be applied to narrow-band transmitter systems.