Abstract
A novel instrumentation amplifier(IA) using positive polarity current-conveyor(CCII+) for electronic measurement systems with low cost, wideband, and gain control with wide range is designed. The IA consists of two CCII+, three resistor, and an operational amplifier(op-amp). The principal of the operating is that the difference of two input voltages applied into two CCII+ used voltage and current follower converts into same currents, and then these current drive resistor of (+) terminal and feedback resistor of op-amp to obtain output voltage. To verify operating principal of the IA, we designed the CCII+ and used commercial op-amp LF356. Simulation results show that voltage follower used CCII+ has offset voltage of 0.21mV at linear range of ${\pm}$4V. The IA had wide gain range from -20dB to 60dB by variation of only one resistor and -3dB frequency for the gain of 60dB was 400kHz. The IA also has merits without matching of external resistor and controllable offset voltage using the other resistor. The power dissipation of the IA is 130mW at supply voltage of ${\pm}$5V.
저가, 광대역, 그리고 넓은 이득 제어 범위를 갖는 전자 계측 시스템을 실현하기 위한 정극성 전류 컨베이어(positive polarity current-conveyor : CCII+)를 사용한 새로운 계측 증폭기(instrumentation amplifier : IA)를 설계하였다. 이 IA는 두 개의 CCII+, 세 개의 저항 그리고 한 개의 연산 증폭기(operational amplifier : op-amp)로 구성된다. 동작 원리는 두 입력 전압의 차가 전압 및 전류 폴로워(follower) 사용되는 두 개의 CCII+에 의해 각각 동일한 전류로 변환되고 이 전류는 op-amp의 (+)단자의 저항기와 귀환 저항기를 통과시켜 출력 전압을 구하는 것이다. IA의 동작 원리를 확인하기 위해 AB급 CCII+를 설계하였고 상용 op-amp LF356을 사용하여 IA를 구현하였다. 시뮬레이션 결과 CCII+를 사용한 전압 폴로워는 ${\pm}$4V의 선형범위에서 0.21mV의 오프셋 전압을 갖고 있었다. IA는 1개의 저항기의 저항값 변화로 -20dB~+60dB의 이득을 갖고 있으며, 60dB에 대한 -3dB 주파수는 400kHz이였다. 제안한 IA의 외부의 저항기의 정합이 필요 없고 다른 저항기로 오프셋을 조절할 수 있는 장점을 갖고 있다. 소비전력은 ${\pm}$5V 공급전압에서 130mW이였다.