• The Transactions of the Korean Institute of Power Electronics
• /
• v.12 no.4
• /
• pp.277-284
• /
• 2007

This paper describes independent phase BLDC motor with a maximum torque among BLDC motor used for electric propulsion system Independent phase BLDC motor has characteristic that phases of stator we independent electrically. This paper is modeling two type of 3 phases BLDC motors, one has Y-connection type and the other has independent type, and it shows simulation of them, compares its characteristics. As a result of simulation, phase voltage of independent 3 phase BLDC motor is higher than Y-connection three phase BLDC motor. When the stator resistance and inductance are stable, high phase voltage causes an increase in maximum phase current and an increases in it serially causes an increase of maximum torque. It is also found that the current pulsation of independent phase BLDC motor was decreased by controlling phase current of independent BLDC motor.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.5 no.3
• /
• pp.261-268
• /
• 1995

In transforming $K_2Ti_4O_9$ whisker, synthesized by calcination and slow cooling method, into $K_2Ti_6O_{13}$ whisker with boiling water and hydrochrolic acid, the effect of their treatment time and concentration on phase transformation, surface state and scattering of whisker was examined. The result was that the surface state of whisker was improved and whisker with a small diameter and a considerable aspect ratio was obtained by inducing scattering of a bundle of whisker. The treatment by boiling water and hydrochrolic acid induced the phase transformation of $K_2Ti_4O_9$ into $K_2Ti_6O_{13}$ and the phase transformation proceeded by extration of $K^+$ ion.

• The Korean Journal of Pharmacology
• /
• v.26 no.1
• /
• pp.77-82
• /
• 1990

The effects of phenothiazine derivatives and calcium on the thermotropic phase transition of bilayers in dipalmitoyl phosphatidylcholine (DPPC) and dipalmitoyl phosphatidic acid (DPPA) liposomes were investigated with differential scanning calorimeter (DSC). Bilayers underwent an abrupt organizational changes at a characteristic temperature when heated. Such temperature-dependent transition was particularly striking and sharp in the bilayers prepared from pure phospholipids. The ability of phenothiazine derivatives to modify the phase transition of phospholipids liposomes was measured by a broadening of the phase transition profile, that transition began to appear at lower temperature than which occurs in untreated liposomes. Calcium ion caused a large upward shift in the transition temperature of DPPC:DPPA (34:66mol%) liposomes. When the liposomes were first incubated with calcium ion followed by phenothiazine derivatives, disappearance of the broad curve centering at $73^{\circ}C$ indicated displacement of calcium ion by phenothiazine derivatives at the anionic site. It is supposed that calcium ion and phenothiazine derivatives might compete with each other on the head group of acidic phospholipid.

• Applied Microscopy
• /
• v.33 no.1
• /
• pp.49-58
• /
• 2003

The ${\alpha}-{\beta}$ phase transition of titanium was investigated through in-situ EF-TEM heating experiments. Three different areas of a titanium foil were observed to minimize statistical errors. Systematic recording of diffraction patterns and images was carried out from $RT{\rightarrow}600^{\circ}C{\rightarrow}900^{\circ}C{\rightarrow}RT$ on each area. The following results were obtained: (1) Transition of titanium takes place very rapidly at $900^{\circ}C$. Two phases of titanium, ${\alpha}\;and\;{\beta}$, coexist at this temperature. (2) The transited ${\beta}$-phase appears in the form of twinned plates which are arranged in rotation relationship one another. (3) Analyses of electron diffraction patterns and EDS data indicate that the thermal oxidation layer is gradually formed on the surface of titanium above $900^{\circ}C$, which hinders the reversible ${\beta}{\rightarrow}{\alpha}$ phase transition upon cooling.

• Journal of the Korean Vacuum Society
• /
• v.17 no.2
• /
• pp.148-155
• /
• 2008

Dielectric and pyroelectric properties of relaxor ferroelectric in the PMN-PT solid solution series have been investigated. Features of the diffuse phase transition in PMN-PT system, typical relaxor ferroelectric materials, were studied as a function of temperature and frequency. The transition temperature of the ceramics with PT$\sim$0.325 did not depend on the measuring frequency. This can best realized in a relatively random environment that apparently is provided by PMN-rich complex perovskites, including those containing Pb. The composition with PT>0.35 show the characteristics of a normal single phase ferroelectric material. Thus the studies revealed that the morphotropic phase boundary in the PMN-PT system is in the vicinity of PT$\sim$0.3 and it has a small curvature and as a result the compositions near the morphotropic phase boundary show two phase transitions, rhombohedral$\rightarrow$tetragonal$\rightarrow$cubic, when the samples are heated up to higher temperature. The best optimum compositions are observed near the morphotropic phase boundary.

• Journal of the Korean Ceramic Society
• /
• v.39 no.12
• /
• pp.1149-1152
• /
• 2002

Indentation was used to analyze high pressure phases of silicon. Phase transformations on both loading time and loading rate were studied. Micro-raman spectroscopy was used to observe the indentation-induced transformations. As the loading time increased, Si-III and Si-XII disappeared and only a-Si was observed in (111) samples. As the loading time increased, the residual stress was removed by creation of cracks or dislocations. At 0.1 mm/min loading rate, pop-in . At 5 mm/min loading rate pop-in was observed in force/displacement curve of (111) sample, but pop-in was not observed in force/displacement curve of (100) sample. This result indicates that the loading rate affects the volume of phase transformation in silicon.

• Membrane Journal
• /
• v.22 no.3
• /
• pp.178-190
• /
• 2012

Flat sheet membranes were prepared with polysulfone (PSF) by an immersion precipitation phase inversion method. Membranes were prepared with PSF/N-methylpyrrolidone (NMP)/polyvinylpyrrolidone (PVP)/phosphoric acid casting solution and water coagulant. By using the successive process of the vapor-induced phase inversion (VIPS) followed by the nonsolvent-induced phase inversion (NIPS), the effect of phosphoric acid addition to casting solution on morphology and permeability of membrane was studied. The mean pore size, the porosity, and the water flux of membranes were increased by the addition of small amount of phosphoric acid. Furthermore, the morphology of the prepared membranes were changed from a dense sponge-like structure to highly enhanced asymmetric structure. PSF/NMP/PVP/phosphoric acid/2-butoxyethanol (BE) casting solution were prepared and cast the successive VIPS-NIPS process with same experimental condition. Due to the addition of BE to casting solution, the mean pore size and almost 0.1 ${\mu}m$ and the water flux increased about 10 to 12 $L/cm^2{\cdot}min{\cdot}bar$.

• Korean Journal of Materials Research
• /
• v.9 no.3
• /
• pp.240-243
• /
• 1999

Piezoelectric properties of O.9PMN-0.1PT relaxor ferroe1ectrics were investigated in the temperature range of $-40^{\circ}C~$100^{\circ}C$. After poled at $-40^{\circ}C$, electro-mechanical properties of the samples were measured by resonance antiresonance method. As the resonance behavior was shown in impedance spectrum obtained below $0^{\circ}C$, it can be c conduded that 0.9PMN-0.1PT is bona-fide ferroelectrics below the phase transition temperature. It is very noteworthy that electro-mechanical resonance occurs at the temperatures far above the phase transition temperature. It is coneluded that ferroelectricity in 0.9PMN-0.1PT relaxor were verified far above the phase transition temperature.

• Proceedings of the KIPE Conference
• /
• 2016.07a
• /
• pp.493-494
• /
• 2016

본 논문에서는 계통연계형 단상 인버터의 데드타임 영향을 보상하는 새로운 알고리즘을 제시한다. 데드타임은 전력용 반도체 스위치를 제어하기 위한 PWM 신호 출력시 인버터의 동일 레그에서 두 스위칭 소자가 동시에 턴-온 되는 경우 발생하는 단락을 방지하기 위해 삽입된다. 이러한 데드타임은 인버터 출력전압에 전원주파수의 기본파 및 홀수차 고조파를 야기하며 그로 인해 상전류 역시 왜곡이 발생된다. 본 논문에서는 H-bridge 인버터의 구조를 가지는 계통연계형 단상 인버터에서 데드타임에 의한 인버터 출력전압 및 상전류의 영향을 분석하고 계통측 상전류에 포함된 고조파 성분을 제거하기 위하여 SOGI(Second-order Generalized Integrator)를 활용한 새로운 보상 알고리즘을 제안한다. 시뮬레이션과 실험을 통해 제안하는 알고리즘의 효용성을 검증한다.

• Proceedings of the Korean Society for Emotion and Sensibility Conference
• /
• 2007.05a
• /
• pp.48-50
• /
• 2007

본 연구에서는 기능성 의류소재로서 나노캡슐화 상전이 물질 처리 직물의 적합성을 평가를 위한 기초자료를 제시하고자 직물의 역학적 특성과 촉감 감성과의 관계에 대해 분석하였다. 분석결과, 면직물과 폴리에스테르직물에 모두 영향을 미치는 요인으로는 최대 하중시의 신장성, 전단강성, 표면마찰계수, 인장선형성, 두께 총 5가지로 나타났다. 이를 바탕으로 역학적 특성이 면직물과 폴리에스테르직물의 촉감 감성을 예측할 수 있는지 확인하기 위한 회귀분석 결과 두 직물 모두 R2가 0.7이상으로 예측력이 높게 나타난 것을 확인할 수 있었다.