• Journal of Food Hygiene and Safety
• /
• v.38 no.3
• /
• pp.79-88
• /
• 2023

Trifludimoxazin is a triazinone herbicide that inhibits the synthesis of protoporphyrinogen oxidase (PPO). The lack of PPO damages the cell membranes, leading to plant cell death. An official analytical method for the safety management of trifludimoxazin is necessary because it is a newly registered herbicide in Korea. Therefore, this study aimed to develop a residual analysis method to detect trifludimoxazin in five representative agricultural products. The EN method was established as the final extraction method by comparing the recovery test and matrix effect with those of the QuEChERS method. Various sorbent agents were used to establish the clean-up method, and no differences were observed among them. MgSO₄ and PSA were selected as the final clean-up conditions. We used LC-MS/MS considering the selectivity and sensitivity of the target pesticide and analyzed the samples in the MRM mode. The recovery test results using the established analysis method and inter-laboratory validation showed a valid range of 73.5-100.7%, with a relative standard deviation and coefficient of variation less than 12.6% and 14.5%, respectively. Therefore, the presence of trifludimoxazin can be analyzed using a modified QuEChERS method, which is widely available in Korea to ensure the safety of residual insecticides.

• Journal of the Korean Geosynthetics Society
• /
• v.14 no.4
• /
• pp.45-58
• /
• 2015

Even though the plate bearing test (PBT) to evaluate the load baring capacity and the field density test to evaluate the relative density are mainly used for quality control of soil compaction in Korea, use of the dynamic cone penetrometer test (DCPT) and the dynamic plate bearing test (DPBT) considering economic feasibility, rapidity, and suitability for field conditions increase to use for quality control of soil compaction. In this study, bearing capacity and relative density of subgrade with thickness of 20 cm, 30 cm, and 40 cm are estimated using PBT, DCPT, DPBT and field density test in three field compaction tests, and the relationship among various compaction evaluation methods is analyzed and discussed.

• Clean Technology
• /
• v.14 no.2
• /
• pp.103-109
• /
• 2008

In this study, in order to develop evaluation method of the cleaning efficiency of residual flux which remains on the surface after soldering with solder paste, a specially designed metal tool is used to reduce spread uncertainty of flux while soldering. Using this tool, the measurement of cleaning efficiency of flux after soldering for some typical alternative semi-aqueous cleaners and 1,1,1-TCE by weighing method was conducted. As the test result of cleaning efficiency for each cleaner at several different cleaning times, the precision of the data is confirmed to within about 4% relative standard deviation (RSD) range. So, it is considered that this would be a good evaluation method for evaluating the cleaning efficiency of the residual flux which remains after solder paste soldering in the alternative cleaning. The results of this test method shows that the cleaning efficiency of ST 100SX and Neozal 750H in the cleaning of residual flux was better than other semi-aqueous cleaners, but its cleaning efficiency was clearly inferior to 1,1,1-TCE.

• Journal of Radiation Protection and Research
• /
• v.24 no.3
• /
• pp.131-142
• /
• 1999

By using the Korean demographic data and the modified relative risk projection model given in the Committee on the Biological Effect of Ionizing Radiation (BEIR) report-V under the U.S. National Academy of Science, the radiogenic excess risk in Korean population has been evaluated. On the basis of this risk, a safety goal for the safe operation of domestic nuclear power plants has been further derived in terms of personal dose. The baseline risk of death due to all causes in Korea and the trivial risk level, which the society considers safe, were estimated to be $5.2{\times}10^{-3}$ and $5.2{\times}10^{-6}$, respectively. The radiogenic excess cancer risk in Korea has been estimated to be $5.2{\times}10^{-3}$ for tie case of acute exposure to 0.1 Gy and $3.7{\times}10^{-3}$ for the case of chronic lifetime exposure to 1.0 mGy/y. On the basis of these risks estimate, the resulting safety goal for one year opeation of a reactor was 0.05 mSv, which is quite identical with the ALARA guideline prescribed by the USNRC in the Appendix I, 10CFR50.

• Fire Science and Engineering
• /
• v.33 no.6
• /
• pp.63-71
• /
• 2019

This study quantitatively analyzed the fire risk of buildings by use nationwide, fire occurrence, and the statistical data of buildings by use. Fire incidents and buildings' statistics from the past 10 years (2008-2017) were used and classified as "Building Laws" and "Enforcement Decree of the Act on the Installation, Maintenance, and Safety of Fire Facilities" to be used for the relative assessment under the Natural Breaks as a risk matrix. In addition, after conducting risk assessment using 2018 fire occurrence data, we compared and analyzed the same with past 10 years' data. The results showed that most facilities had similar risk grades, except for the results of reduced risk levels from IV to II in recreational facilities, confirming the past and present data correlations as valid. Hence, the classification method is deemed appropriate. Through the results, the fire risk assessment of buildings by use nationwide are presented as a reference for fire safety.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.20 no.1
• /
• pp.18-25
• /
• 2017

Damage of both life and property has been increased by natural disaster under the influence of climate change, thus many natural disaster vulnerability researches have been carried out to make adaptation policy and impact assessment of climate change recently. Their method for assessing vulnerability usually have used proxy variables for making vulnerability indices. However, because their results were too qualitative and relative it tends to be hard to make absolute comparison and establish standard of prevention or adaptation ability. Accordingly, this study aimed at quantifying natural disaster vulnerability using emergy through recognizing disaster as the relations between order and disorder by system approach. As a result, ordering energy (4.66E+22 sej/yr) and ordered structure (1.98E+22 sej) of Busan in 2003 and disordering energy (7.80E+18 sej), disordered parts (4.55E+20 sej) and rebuilding energy (3.87E+20 sej) by typhoon Maemi were analysed. And then, this was compared with Hurricane Andrew in Dade County. Through this comparison, if the prevention ability of Busan increases, disordered parts can be reduced against the more powerful disordering energy. Also, prevention for additional damages by disaster is needed to practical rebuilding action. In conclusion, it was able to figure out the impact of disaster quantitatively by natural systems and urban systems showing as common measure. Based on this study and further research to make effective prevention for how much prevention ability should be increased will contribute to producing the scientific data for disaster management policy in future.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.41 no.3
• /
• pp.209-218
• /
• 2015

Once powder base makeup products are applied to the skin, the products are formed a film and attached on the skin for 8 to 12 hours. The makeup film is deformed by secretions such as sweat and sebum secreted from the skin. Thus, durability of the film is an important quality factor in the makeup and its evaluation is also important. In this study, characteristics of the semi-finished powder products such as water absorption, oil absorption, water repellent and oil repellent were evaluated in a number of ways. Also, simple methods, which are not affected by evaluation conditions such as a difference between sweat and sebum secretion, temperature and humidity, were examined to predict the durability of the products. We measured water absorption, oil absorption, water repellent and oil-repellent properties of semifinished product by tablet, capillary and dipping method and then compared with the data of color difference meter and ROBO skin analyzer. Results showed that the durability of powder base makeup products was associated with more oil absorption and water-repellent characteristics than water absorption and oil-repellent. Oil absorption characteristics by tablet and capillary method and water-repellent characteristics by dipping method provides a simple and quick method to precdict the durability of the makeup products.

• Journal of Food Hygiene and Safety
• /
• v.34 no.3
• /
• pp.227-234
• /
• 2019

An analytical method was developed for the determination of oxytetracycline in agricultural products using the QuEChERS (Quick, Easy, Cheap, Effective, Rugged and Safe) method by liquid chromatography-tandem mass spectrometry (LC-MS/MS). After the samples were extracted with methanol, the extracts were adjusted to pH 4 by formic acid and sodium chloride was added to remove water. Dispersive solid phase extraction (d-SPE) cleanup was carried out using $MgSO_4$ (anhydrous magnesium sulfate), PSA (primary secondary amine), $C_{18}$ (octadecyl) and GCB (graphitized carbon black). The analytes were quantified and confirmed with LC-MS/MS using ESI (electrospray ionization) in positive ion MRM (multiple reaction monitoring) mode. The matrix-matched calibration curves were constructed using six levels ($0.001{\sim}0.25{\mu}g/mL$) and coefficient of determination ($r^2$) was above 0.99. Recovery results at three concentrations (LOQ, $10{\times}LOQ$, and $50{\times}LOQ$, n=5) were from 80.0 to 108.2% with relative standard deviations (RSDs) less than of 11.4%. For inter-laboratory validation, the average recovery was in the range of 83.5~103.2% and the coefficient of variation (CV) was below 14.1%. All results satisfied the criteria ranges requested in the Codex guidelines (CAC/GL 40-1993, 2003) and the Food Safety Evaluation Department guidelines (2016). The proposed analytical method was accurate, effective and sensitive for oxytetracycline determination in agricultural commodities. This study could be useful for safety management of oxytetracycline residues in agricultural products.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.12
• /
• pp.285-291
• /
• 2016

The purpose of this study was to evaluate the structural capacity of steel pipe pile specimens reinforced with hollow steel plate shear connectors by pull-out test. Compressive strength testing of concrete was conducted and yield forces, tensile strengths and elongation ratios of re-bars and hollow steel plate were investigated. A 2,000kN capacity UTM was used for the pull-out test with 0.01mm/sec velocity by displacement control method. Strain gauges were installed at the center of re-bars and hollow steel plates and LVDTs were also installed to measure the relative displacement between the loading plate and in-filled concrete pile specimens. The yield forces of the steel pipe pile specimens reinforced with hollow steel plate shear connectors were increased 1.44-fold and 1.53-fold compared to that of a control specimen, respectively. Limited state forces of steel pipe pile specimens reinforced with hollow steel plate shear connectors were increased 1.23-fold and 1.29-fold compared to that of a control specimen, respectively. Yield state displacement and limited state displacement of steel pipe pile specimens reinforced with hollow steel plate shear connector were decreased 0.61-fold and 0.42-fold compared to that of a control specimen, respectively.

• Economic and Environmental Geology
• /
• v.46 no.1
• /
• pp.1-9
• /
• 2013

We proposed the revised full-pattern-fitting method of illite polytype quantification with background correction and scale factor correction of WILDFIRE(C) simulated pattern, and R% value ((${\sum}$|simulated-measured|/simulated)/ $n{\times}100$) calculation, and then verified the reliability of this method by applying for the test sample ($2M_1$:1M$$\frac{._-}{.}$$1:1), and by comparing the result with Grathoff and Moore method (1996). We confirmed that the proposed method showed the error range of less than 3.6%, which is much lower than the previous full-pattern-fitting methods, in spite of the impurities of the test sample. In the comparison with Grathoff and Moore method for 2 tested samples, we obtained the relatively higher $2M_1$ contents using Grathoff and Moore method, whereas we obtained the reliable results with less than 10% of R% values.