• Journal of the Korean Institute of Landscape Architecture
• /
• v.47 no.4
• /
• pp.61-67
• /
• 2019

The purpose of this research is to evaluate the salt tolerance of the Miscanthus sinensis and to characterize the content of pigments in the leachate in relation to calcium chloride ($CaCl_2$) deicing salt. Miscanthus sinensis were cultured at five different concentrations of calcium chloride deicing salt, 0, 1, 2, 5, and $10g{\cdot}L^{-1}$ (referred to Cont. C1, C2, C5, and C10) for four months. The salt tolerance and leachate while growing Miscanthus sinensis on soil which was artificially contaminated by calcium chloride deicing salt. Soil chemical properties (pH, E.C., $Ca^{2+}$, $Na^+$, $K^+$, and $Mg^{2+}$) and plant growth parameters (plant height, leaf length, leaf width, number of leaves, shoot fresh weight, root fresh weight, shoot dry weight, an root dry weight) were evaluated. Soil pH decreased, while electrical conductivity significantly decreased ($p{\leq}0.05$) with a higher concentration of deicing salt $0g{\cdot}L^{-1}$ (Cont.). The increase in the concentration of chloride-based exchangeable cations, along with the increase in the deicing salt treatments, were observed in $Ca^{2+}$ > $Na^+$ > $K^+$ > $Mg^{2+}$. Notably the $Ca^{2+}$ exchangeable cations were 83~90% higher than the others. The growth of Miscanthus sinensis significantly increased ($p{\leq}0.05$) with the concentration of deicing salt higher than $1g{\cdot}L^{-1}$ (C1) when compared to 0 g/L (Cont.), except for the $10g{\cdot}L^{-1}$ (C10) treatment. The results determined that the contamination of soil by deicing salt could negatively impact the soil and Miscanthus sinensis was a tolerant species for the deicing salts. Further research will be focused on soil improvement additives and the stable stimulated plant growth of Miscanthus sinensis and a formulation on that basis for the soil-plant continuum.

• KSBB Journal
• /
• v.21 no.4
• /
• pp.255-259
• /
• 2006

The biodegradable hyaluronic acid(HA) membranes cross-linked with lactide using the crosslinking agent, 1-ethyl-3(3-dimethyl aminopropyl) carbodiimide(EDC) were prepared as a potential biocompatible material for tissue engineering. HA membranes having different mechanical properties were synthesised by varying degree of the mole ratio of lactide to HA, EDC concentration, and crosslinking temperature. HA membranes were degradable in water solution and the degradation became slower with the increasing mole ratio of lactide to HA. HA membranes were sterilized using ethylene oxide gas and extracted with cell culture medium for 24 h at $37^{\circ}C$ and 200 rpm. Cytotoxicity of the extract was tested using NIH/3T3 mouse embryo fibroblast as a model cell. Growth inhibition was not observed in the extracts of HA membranes with the mole ratios of lactide to HA, 5 or 10, and 10% EDC concentration, however 11% of growth inhibition was observed in the extract with the mole ratio of 13. Growth inhibition was not observed in the extracts of HA membranes prepared with 5% EDC or 10% EDC and the mole ratio of lactide to HA, 10, however 12% of growth inhibition was observed in the extract with 20% EDC. Cytotoxicity was not observed in the extracts of HA membranes prepared at varying crosslinking temperatures, $15^{\circ}C,\;25^{\circ}C,\;and\;28^{\circ}C$ with the mole ratio of lactide to HA, 10 and 10% EDC.

• Korean Journal of Food Science and Technology
• /
• v.42 no.4
• /
• pp.438-444
• /
• 2010

Fermented skate has a unique ammonia-like flavor. The flavor is preferred by a few lovers of skate muscle, while women and young people may be sensitive to the odor. Organic acids were used to reduce the ammonia-like odor in fermented skate and to investigate the physicochemical properties. Fermented skate muscles were sprayed with 20 mL of acetic acid or citric acid (3, 5, and 7%) for 30 seconds and stored at $4^{\circ}C$ for 15 days. The physicochemical properties of organic acid-treated fermented skate were investigated during storage. The control, which was treated with distilled water, showed a higher pH value than the samples treated with organic acids. The $L^*$ value increased with increasing organic acid concentration, while the $a^*$ and $b^*$ values were not significantly different among the samples. The trimethylamine (TMA) decreased with increasing in the organic acid concentration, but it was not significantly different after 9 days of storage. Ammonia-type nitrogen and ammonia-like flavoring, decreased with increasing in the organic acid concentration, whereas ammonia-type nitrogen increased with a storage period more than 6 days. In conclusion, fermented skate treated with 7% citric acid was the best treatment to reduce the ammonia-like odor.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.11 no.3
• /
• pp.87-95
• /
• 2003

Although extensive studies were conduced on hydrogen fermentation of organic wastewaters, little is known about biohydrogen production from organic solid wastes. The leaching-bed reactor treating food waste by heat-shocked anaerobic sludge was, therefore, operated at D of 2.1, 3.6, 4.5 and $5.5d^{-1}$ to find optimal D for hydrogen production. Successful operation of a reactor can be accomplished when it is operated at proper dilution rate (D). Operation at high D leads to the washout of biomass in the reactor while operation at low D leads to product inhibition due to the accumulation of excess VFA. These appear to limit the production of hydrogen to reach a higher level. All the reactors showed that, on day 1-3, hydrogen production was dominant and VFA concentration was higher than ethanol. Butyrate and acetate were major components of VFAs over the whole operation, though lactate was very high on day 1-2. Compared with other D values, D of $4.5d^{-1}$, resulted in higher butyrate/acetae (B/A) ratios during the fermentation. The trend of B/A ratios was similar to the hydrogen production, suggesting that butyrate formation favored hydrogen production. Ethanol increased significantly from day 4 when hydrogen Production stopped. It indicated that heat-shocked sludge was able to induce a metabolic flow from hydrogen-and acid-producing pathway to solvent-producing pathway. Operation at D of $4.5d^{-1}$ led to higher fermentation efficiency (58%) than those (51.5, 55.3 and 53.7%) at 2.1, 3.6 and $5.5d^{-1}$. The COD removed was convened to hydrogen (10.1%), VFA (30.9%), and ethanol (17.0%).

• Korean Journal of Environmental Agriculture
• /
• v.18 no.2
• /
• pp.109-115
• /
• 1999

Lead and cadmium were analyzed with different pretreatemnt methods. Paddy soil and wastewater sludge samples were used and the result was compared each other. Pretreatment method affected the concentration obtained from samples significantly. Large difference was illustrated between the results. The concentration by 0.1N HCl extraction method, an official analytical method for soil and solid wastes, was far lower than those by the EPA3050B and mixed-acid digestion methods. The reason might be that metals associated with organics and silicates are not easily extracted by 0.1N HCl, while digestion methods using strong acids and high temperature dissolved all the elements in the samples. It implies that pretreatment method should be specified in addition to concentration on the report of metal analysis for environmental samples. Acid digestion methods are not necessarily good because the concentration obtained does not represent the natural condition which is our concern in many cases. The 0.1N HCl extraction method does not fully represent the natural condition either. The metals associated with organics will be extracted eventually as organics decompose with time. Therefore, proper pretreatment and analytical methods should be developed for specific purpose, and their standardization is recommended.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.9 no.3
• /
• pp.141-148
• /
• 2011

It is clarified in the radioactive waste transfer regulation that the concentration of radioactive waste for the major radio nuclide has to be examined when radioactive waste is guided to the radioactive waste stores. In case of the low level radioactive waste sample, the analytical results of radioactive waste concentration frequently show a value lower than minimum detectable activity (MDA). Since the MDA value basically depends on the amount of a sample, background value, measurement time, counting efficiency, and etc, it would be necessary to increase a sample amount with a intention of minimizing MDA. In order to measure a concentration of $^{129}I$ in low and medium level radioactive waste, $^{129}I$ was collected by using a distillation technique after leaching the simulated radioactive waste sample with a non-volatile acid. The recovery of $^{129}I$ measured was compared with that measured with column elution technique which is a conventional method using an anion-exchange resin. The recovery of inactive iodide by using the distillation method and column elution were found as $86.5{\pm}0.9%$ and $87.3{\pm}2.7%$, respectively. The recovery and MDA value calculated for distillation technique when 100 g of extracted solution of $^{129}I$ was taken, were found to be $84.6{\pm}1.6%$ and $1.2{\times}10^{-4}Bq/g$, respectively. Consequently, the proposed technique with simplified process lowered the MDA value more than 10 times compared to the column elution technique that has a disadvantage of limited sampling amount.

• Korean Chemical Engineering Research
• /
• v.54 no.6
• /
• pp.806-811
• /
• 2016

Organosolv pretreatment is the process to frationation of lignocellulosic feedstocks to enhancement of enzymatic hydrolysis. This process has advantages that organic solvents are always easy to recover by distillation and recycled for pretreatment. The chemical recovery in organosolv pretreatment can isolate lignin as a solid material and carbohydrates as fermentable sugars. For the economic considerations, using of low-molecular-weight alcohols such as ethanol and methanol have been favored. When acid catalysts are added in organic solvent, the rate of delignification could be increased. Mineral acids (hydrochloric acid, sulfuric acid, and phosphoric acid) are good catalysts to accelerate delignification and xylan degradation. In this study, the biomass was pretreated using 40~50 wt% ethanol at $170{\sim}180^{\circ}C$ during 20~60 min. As a results, the enzymatic digestibility of 2-stage pretreatment of rigida using 50 wt% ethanol at $180^{\circ}C$ was 40.6% but that of 1-stage pretreatment was 55.4% on same conditions, therefore it is shown that the pretreatment using mixture of the organosolv and catalyst was effective than using them separately.

• Resources Recycling
• /
• v.25 no.2
• /
• pp.33-41
• /
• 2016

A scale up tests (380 kg/day) using a continuous solvent extraction and electro-winning system was carried out to separate and recover cobalt from a solution containing 1.91 g/L Co and 14.65 g/L Ni. The solution was obtained during a process including solvent extraction and precipitation stages for removal of Cu and Fe from a synthetic sulfuric acid solution of manganese nodule matte. The optimal condition for solvent extraction was : solvent concentration of 0.22M Na-Cyanex 272 (45% saponified with NaOH) and O:A phase ratios of 1:1.5, 10:1 and 1.5:1 used in extraction, scrubbing and stripping stages, respectively. The extraction and stripping efficiencies were found to be 99.8% and 99.88%, respectively. The stripped solution contained 40.27 g/L Co with 4 ppm Ni. Cobalt metal of 99.963% purity was yielded with current efficiency of 67% and current density of $0.563A/dm^2$ during the electro-winning process.

• Journal of Korea Soil Environment Society
• /
• v.3 no.1
• /
• pp.55-63
• /
• 1998

This study investigates the contamination mechanism of soil by drainages including acid rains around mining waste sites, and suggests the quantitative methods of prevention against soil contaminations and its alternatives. For these purposes, the dissolution of arsenic in soils, which is one of toxic heavy metals, has been examined experimentally using the artificial acidic solution. Also, in order to prevent dissolution of arsenic by acid rain, the effects of limestone for the neutrality method on the soil were investigated. The arsenic in soil specimen was dissolved by strong acidic solution below pH1.0. The maximum amount of dissolved arsenic increased with decreasing pH value. Furthermore, it was found very effective to use limestones for the neutrality method. The neutralization of limestones in acidic solution was found to follow the equation of chemical reaction-controlling formulation in unreacted-core models.

• Resources Recycling
• /
• v.28 no.3
• /
• pp.45-52
• /
• 2019

$TiO_2$ as a raw material for producing titanium can be produced by carbon reduction of natural ilmenite ores over 1823 K and acid leaching of the obtained titanium-rich slag. However, the conventional process can cause very high energy consumption and a large amount of leaching residues. In the present study, we proposed the sulfurization of $FeTiO_3$ with $Na_2SO_4$ at temperatures below 1573 K, which can separate Fe in $FeTiO_3$ as the FeS based sulfide phase and Ti as the $TiO_2-Na_2O$ based oxide phase. This study is a fundamental study for sulfurization of $FeTiO_3$ to investigate the influence of reducing atmosphere, reaction temperature and the sulfur/Fe ratio on the separability and distribution behaviors of of Fe, Ti, and Na between the oxide phase and the sulfurized phase. At 1573 K and carbon saturation condition, the Fe can be separated from $FeTiO_3$ as Fe-C-S metal and a part of FeS, and the concentration of Fe in oxide decreased to 4 mass% after sulfurization.