• Journal of the Korean Institute of Telematics and Electronics
• /
• v.11 no.3
• /
• pp.32-35
• /
• 1974

The SCR oscillator is ctaracterized by the second order differential equation which is consistent with both its equivalent circuit and its empirical formula. It is found that the wave form of the SCR oscillator contains the components of higher harmonics and that this oscillator is static since its representative point on the phase tragectory has the sense directed to the equilifrium point.

• Proceedings of the Optical Society of Korea Conference
• /
• 1991.06a
• /
• pp.65-65
• /
• 1991

레이저 분광학의 연구에 있어서 고출력이며 좁은 선폭인 레이저광이 요구된다. 특히 고리형 공진기 레이저는 이득물질에서 공간 홀 버닝 효과 (Spatial Hole Burning effect)를 줄이거나 없앨수 있으므로 정상파로 발진하는 레이저에 비하여 높은 출력의 단일모드 발진을 얻을 수 있다. 8자형 고리 공진기 레이저에서 외부 되반사경과 코팅되지않은 에탈론의 조합을 사용하여 높은 출력의 단일모드를 얻었다. 색소분자의 에너지 준위를 2준위 구조로 가정하여 고리형 색소레이저에 있어서의 단일모드 발진의 안정성(Stability)을 살펴보았으며 양방향으로 단일모드 발진을 하는 경우에 있어서의 쌍안정(Bistability) 상태를 확인하였다.

• Proceedings of the Optical Society of Korea Conference
• /
• 1995.06a
• /
• pp.149-153
• /
• 1995

세슘원자에 대한 레이저 쿨링용 광원으로 사용하기 위해 다이오드 레이저의 서폭을 축소하고 발진 주파수 및 출력을 동시에 안정화 시키는 연구를 수행하였다. 자유발진 상태에서 약 30 MHz 이고, 출력이 10mW인 다이오드 레이저에 유이창으로 Q 갑이 낮은 외부 공진기를 구성함으로써 발진선폭을 약 5MHz로 줄일수 있었다. 그리고 세슘원자의 포화흡수 스펙트럽의 교차공진 흡수선에 레이저 주파수를 안정시키기 위해 주입전류를 10kHz 로 변조하고, lock-in amp 의 출력단에서 나오는 주파수 오차신호를 전류공급장치와 유리창이 부착된 PZT로 동시에 피드백시켰다. 또한 오차신호를 레이저 다이오드의 온도 조절장치로 피드백 시킴으로써 주파수와 동시에 레이저 출력을 안정화시킬 수 있었다. 이 때의 출력의 변동폭은 약 0.03% 로서 온도로 피드백 시키지 않는 경우에 비해 약 260배 안정된 결과를 얻었다. 그리고 컴퓨터를 이용해서 흡수선의 peak 값을 매 10초마다 검색하고 이 값이 최대가 되도록 PZT 전압을 조절함으로써 레이저 주파수를 세슘원자의 흡수선의 봉우리에 1주일 이상 안정화시킬 수 있었다. 주파수 안정도 측정을 위해 Zeeman 이동된 포화흡수 스펙트로미터를 구성하였으며, 측정된 주파수 안정도 (Allan 분산의 제곱근)는 적분시간 1초 일 때 1.2x10-10 이었다.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.22 no.6
• /
• pp.11-18
• /
• 2018

A pulse detonation engine (PDE) requires high operating frequency greater than 100 Hz to get meaning thrust as a propulsion devise. Thus a PDE needs an ignition circuit operating precisely at high operating frequencies. In this paper AC(alternating current) and DC(direct current) types of ignition circuits were designed and compared. Each circuit was tested at operating frequencies from 16.66 to 100.00 Hz by measuring the input signal of each circuit and the voltage change in the primary coil of the transformer. Results show that the DC power circuit can attain a maximum error rate of 5.15% at higher operating frequencies, whereas the AC power circuit displays a negligible agreement with the operating signal at frequencies greater than 33.33 Hz. Therefore it is confirmed that DC-powered ignition circuit is preferable for the PDE operating at high frequencies.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.10 no.6
• /
• pp.45-55
• /
• 1973

This paper discusses the nonlinear time-invarient circuit composed of a tunnel diode. Prior to determine the solution of the nonlinear network which has negative resistance elements, the static characteristics of the nonlinear resistance elements need to be represented by function. Polynomial curve fitting is discussed to represent the static characteristies by least squares approximation. In order to solve the nonlinear network, the state equations for the networks are set up and solved by prediction corrector method. Finally, the limit cycle is plotted to discuss the stability of the nonlinear network and the oscillation condition.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.12
• /
• pp.68-74
• /
• 2010

A sub-${\mu}$W CMOS Wien-Bridge oscillator for ultra low power (ULP) radio applications is presented. The Wien-Bridge oscillator is based on an non-inverting opamp amplifier with a closed-loop gain $1+R_2/R_1$ as a means of providing necessary loop gain. An additional RC network provides appropriate phase shift for satisfying the Barkhausen oscillation condition at the given frequency of 1/($2{\pi}RC$). In this design, we propose a novel loop gain control method based on a variable capacitor network instead of a rather conventional variable resistor network. Implemented in $0.18{\mu}m$ CMOS, the oscillator consumes only 560 nA at the oscillation frequency of 22 kHz.

• Korean Journal of Optics and Photonics
• /
• v.21 no.5
• /
• pp.181-184
• /
• 2010

A simple technique for a flexibly tunable and switchable dual wavelength-switchable erbium-doped fiber (EDF) laser using fiber Bragg gratings is proposed and demonstrated by using both linear cavity loss controlling and homogeneous gain broadening of the EDF. The oscillating wavelength switching is successfully realized by using the modulation of the acousto-optic modulator driven by the RF signal. The wavelength spacing and lasing wavelength of the proposed wavelength-switchable laser can also be controlled by using the bending-induced tension or compression strain. The proposed tunable dual wavelength-switchable fiber laser has a lot of advantages, such as a high extinction ratio larger than 40dB and a high tunability of ~7.2 nm/$m^{-1}$.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.19 no.6
• /
• pp.67-79
• /
• 1982

The stability of general pulse-width modulation system with Gaussian random disturbance was discussed . General system is divided into nonlinear and linear elements using the conventional describing function method. The concept of the equivalent admittance was used to find the transfer characteristic of the nonlinear element of the system. In this paper the self-sustained oscillation condition in the autonomous system was derived and the results was analyzed with computer simulation.

• Korean Journal of Optics and Photonics
• /
• v.16 no.5
• /
• pp.450-455
• /
• 2005

We have studied on operational characteristics of the nitrogen laser with sliding discharge and longitudinal excitation. We could observe radiation of nitrogen laser excited by a sliding discharge along the surface of a dielectric. The shape of the beam was a ring type which had 2 mm or 4mm in diameter depending on the sliding discharge tube shape. In this experiment, We show the possibilities to make other shapes of laser beam, for example, rectangle, ellipse, and to excite another gas laser system like an excimer laser.

• Korean Journal of Optics and Photonics
• /
• v.21 no.5
• /
• pp.185-189
• /
• 2010

We demonstrate a single-frequency wavelength tunable erbium-doped fiber (EDF) ring laser. We used an unpumped-EDF as a saturable-absorber in order to obtain a stable single-frequency with a narrow-linewidth single-polarization mode in the ring cavity. The lasing wavelength was controlled by using bending-induced strain, such as tension and compression strain corresponding to the bending direction, applied to the fiber gratings. The fiber laser exhibited an output power of -1.85 dBm at a wavelength of 1540.72 nm for a pumping power of ~400 mW. An extinction ratio was measured to be more than 60 dB. The proposed tunable fiber laser maintains nearly the same output power while its lasing wavelength is controlled over in a wavelength range of 5 nm.