• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.1
• /
• pp.79-87
• /
• 2013

A new modulation technique - correlative encoded FSK (CEFSK) - for use in power and bandwidth limited digital communication system is proposed. CEFSK is free of ISI and generates output signals which have a smooth and continuous phase transition and a reduced envelope fluctuation by keeping correlation between amplitude and phases of two subsequent symbols. In comparison to conventional one-bit differential detected (1DD) GFSK, the performance of the 1DD-CEFSK in a non-linearly amplified (NLA) channel impaired by additive white Gaussian noise (AWGN), ISI and IM, is analyzed via computer simulation. The simulation result shows that, in an NLA single-channel, 1DD-CEFSK provides a signal-to-noise ratio (SNR) advantage of up to 1.2dB and 0.8dB at BER of $1{\times}10^{-4}$ when input back-off (IBO) of HPA is -1.0dB and -3.0dB, respectively. For the same channel environment with multi-channel, 1DD-CEFSK outperforms 1DD-GFSK by 1.1dB in SNR, regardless of the value of IBO.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.39 no.5
• /
• pp.1-7
• /
• 2002

In this paper, an extended type of a direct learning control(DLC) method is proposed for the effective control of systems which perform a given task repetitively. DLC methods have been suggested to overcome the defects of iterative learning control, the learning process should be resumed from the beginning even if a slight change occurs in the desired output pattern. If a given desired output trajectory is "proportional" to the output trajectories which are learned previously, we can obtain the desired control input directly without the iterative learning process by using the DLC. First, most existing DLC methods are shown to be applicable only to single-input single-output systems with the relative degree one and then, an extended type of DLC is proposed for a class of nonlinear systems having the relative degree more than or equal to one by using the known relative degree of a nonlinear system. By the simulation results for the arbitrary nonlinear system with the relative degree more than one, the validity and the performance of the proposed DLC method are examined.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.18 no.4 s.70
• /
• pp.335-345
• /
• 2005

This paper concentrates on the nonlinear analysis of prestressed concrete (PSC) containment structures. Unlike a commercialized program which adopts the perfect bond assumption between concrete and tendon in the analysis of PSC structures, a numerical algorithm to consider the slip effect, simultaneously with the use of commercialized programs such as DIANA and ABAQUS, is introduced in this paper For bonded tendons, the apparent yield stress of an embedded tendon is determined from the bond slip relationship. And for unbonded tendons, Correction for the strength and stiffness of unbonded internal tendons is achieved on the basis of an iteration scheme derived from the slip behavior of tendon along the entire length. Finally, the developed algorithm is applied to two PSC containment structures of PWR and CANDU to verify its efficiency and applicability in simulating the structural behavior of large complex structures, and the obtained result shows that both containment structures represent the ultimate pressure capacity larger than about 3 times of the design pressure.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.7 no.2
• /
• pp.69-77
• /
• 1987

A finite element method has been developed to study the material nonlinear analysis of reinforced concrte structures. Concrete behavior under the biaxial state of stress is represented by a nonlinear constitutive relationship which incorporates tensile cracking, tensile stiffening effect between cracks and the strain-softening phenomenon beyond the maximum compressive strength. The concrete model used is based upon nonlinear elasticity by assuming concrete to be an orthotropic material and modeled as equivalent uniaxial stress-strain constitutive relationship using equivalent uniaxial strain. The streel reinforcement is assumed to be in a uniaxial stress state and is modeled as a bilinear, elasto-plastic material with strain hardening approximating the Bauschinger effect. In plane stress state, R.C. beams is modeled as a quadratic element that has two degrees of freedom in each node. And this results of finite element analysis are compared with the experimential results of midspan deflection, stresses and strains.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.3
• /
• pp.211-217
• /
• 2014

This study analyzes the nonlinear interaction between two different vortex shedding frequencies from a cylinder with two diameters. In particular, two different vortex shedding frequencies are generated by preparing a cylinder having two diameters artificially. Flow velocity fluctuations behind the cylinder are measured three-dimensionally. Additionally, we fabricated a hole and placed a pressure transducer for measuring the pressure on the cylinder surface. The pressure signal from the pressure transducer is used as basic signal. A TSC(Trans Spectrum Coherence) is used for checking the strength of the nonlinear interaction between two different vortex shedding frequencies. As a result, the following are clarified: i) frequency distribution behind the cylinder, ii) three-dimensional flow state behind the cylinder through calculation of ensemble average, and iii) close relationship between the vertical vortex and change of low frequency by nonlinear interaction between two different vortex shedding frequencies from the cylinder with two diameters.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.11B
• /
• pp.709-717
• /
• 2007

Pricing a network service aims for congestion control of the network as well as economic efficiency. A monopolistic supplier providing users with a network service on a shared link needs a pricing schedule that maximizes revenue under the link's bandwidth constraint and guarantees the bandwidth purchased by the users. In that case, nonlinear pricing is an efficient scheme which meets both requirements. This study reviews how nonlinear pricing can be applied to the network service under the constraint and shows that the nonlinear pricing may result in a fixed unit price of bandwidth as linear pricing when demand characteristics of the users follow a power law. Also, the way how the provider with incomplete information on the demand distribution seeks for the optimal pricing from the degree of the network congestion is introduced and the relationship between the development direction of the Internet and internet pricing is considered based on the results of the study.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.27 no.3
• /
• pp.19-30
• /
• 1990

This note describes an application of Hamiton's principle to nonlinear free-surface flow problems. Two functionals are constructed based on classical Hamilton's principle with a modification due to the presence of a free surface. As an effort towards the development of an efficient numerical scheme for our problem, we present the following three test results: i) The bounding principles of the eigenvalues for the linear dispersion relation. ii) By assuming steady solitary waves, an approximate relation between the amplitudes and the speeds of solitary waves are derived from the two functionals constructed. Their numerical results are compared with those of Longuet-Higgins & Fenton(1974). iii) The shapes and charicteristics of solitary waves are computed from two sets of functionals by varying the number of total finite elements in the fluid domain.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.35 no.4
• /
• pp.84-94
• /
• 2023

The wave height and period regression curve is widely used to estimate the design wave period. In this study, the parameters of the curves are estimated, compared, and evaluated using the linear, robust linear, and nonlinear regression methods, respectively. The data used in the design wave height estimation are the annual maxima (AM) wave height and period data sets divided by typhoon and non-typhoon conditions, provided by the Ministry of Oceans and Fisheries (2019). The estimation parameters show significant differences in the local coastal waters and the estimation methods. The estimation parameters based on the Suh et al. (2008, 2010) method show the apparent bias, under-estimation in the intercept (scale) parameter, and over-estimation in the slope (exponent) parameter, respectively.

• Proceedings of the KIEE Conference
• /
• 2005.07d
• /
• pp.2558-2560
• /
• 2005

본 논문에서는 마찰력과 질량은 수직항력에 의해 관계하고, 시스템 입출력 관계에서도 도출할 수 있음에 착안하여, LuGre 모델을 기반으로 하는 수직항력 관측이 가능한 보상기 적용과 동시에 제어 입력과 시스템 출력 관계를 적응규칙을 통해 질량추정기를 설계하여 제어 입력의 스케일로 사용함으로써 그 성능을 더욱 향상시키고자 하였다.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 2004.10a
• /
• pp.467-470
• /
• 2004

퍼지모델은 주로 경험적 방법에 의해 추출되기 때문에 보다 구체적이고 체계적인 방법에 의한 동정 및 최적화 될 필요성이 요구된다. 일반적으로, 정보 granules는 근접성, 유사성 또는 기능성 등에 인하여 서로 결합되는 요소(특히, 수치 데이터)의 실체이다. 본 논문에서는 비선형 시스템의 퍼지모델을 위해 정보 granules에 의한 퍼지 관계 기반 퍼지 추론 시스템을 최적 설계한다. 제안된 퍼지 모델은 정보 데이터의 특성을 살리기 위해 HCtl 클러스터링 방법에 의한 중심값을 이용하여 모든 입력변수가 상호 관계한 전반부/후반부 구조 및 파라미터 동정을 시행한다. 두 가지 형태의 퍼지 추론 방법은 간략 추론과 선형추론에 의해 수행되고 삼각형 멤버쉽 함수를 사용한다. 구축된 정보 granule 기반 퍼지 모델은 유전자 알고리즘을 이용하여 전반부 파라미터를 최적으로 동정한다. 그리고 학습 및 테스트 데이터의 성능 결과의 상호균형을 얻기 위한 하중값을 가진 성능지수를 사용하여 근사화와 예측성능의 향상을 꾀하며, 기존 문헌과의 성능비교를 통해 제안된 퍼지 모델을 평가한다.