• Journal of the Korean Geotechnical Society
• /
• v.37 no.12
• /
• pp.107-116
• /
• 2021

In this study, a set of laboratory liquefaction test has been conducted using undisturbed samples collected from Songlim-park, Pohang where liquefaction phenomenon had been observed in 2017. Soil samples were frozen right after tube sampling to minimize the disturbances during transport, storage, and test preparation. Cyclic triaxial test has been carried out to evaluate the liquefaction resistance ratio of undisturbed soil samples. As a result, the liquefaction resistance ratio of samples collected from 8.0~8.8 m and 11.0~11.8 m were almost similar, and these values were approximately 0.04~0.07 larger than values estimated by simplified assessment method using field test results. It is expected that the application of undisturbed sample for the evaluation of liquefaction resistance could contribute to the economical design of geotechnical structures.

• Journal of the Korean Geotechnical Society
• /
• v.39 no.3
• /
• pp.17-27
• /
• 2023

In order to accurately determine soil characteristics, it is necessary to collect undisturbed samples, and it is important to collect these samples with minimal disturbance. In this study, a sampler that minimizes sample disturbance was developed by attaching a catcher to the tip, and its applicability was reviewed through in situ sampling, X-ray CT, and laboratory tests. Results confirmed that horizontal cracks are likely to occur when using the Shelby tube sampler, whereas these cracks can be suppressed when using the newly developed sampler. Moreover, consolidation and shear test results showed that the samples collected using the newly developed sampler showed higher maximum shear strength compared to those collected using the Shelby tube sampler.

• Journal of the Korean Geotechnical Society
• /
• v.40 no.3
• /
• pp.7-18
• /
• 2024

In this study, slope stability was evaluated in consideration of unsaturated soil behavior to predict landslides. Samples were collected from a landslide site due to heavy rainfall during Typhoon Hinnamnoh. Soil moisture characteristic tests were performed based on the evaporation method using a swelling undisturbed sample and a remolded sample. Based on the hydraulic-mechanical behavior, two-dimensional infiltration and stability analyses were performed. As a result, from the two sample types, it is found that both behaviors exhibited clear differences in the results, and the behavior of the swelling undisturbed sample was able to predict the actual slope failure appropriately.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.2
• /
• pp.55-66
• /
• 2006

The existing Highway LA-1 of US is required to be replaced for covering increasing regional demands of transportation such as Hurricane evacuation and oil industry. This 28 km crosses wetlands and is a sensitive environmental area. Huge amount of soil investigation and laboratory tests were performed with best efforts to overcome inherit errors of sampling, disturbance, and testing procedures for this project. The data scattering was corrected through using central tendency theory.

• 기술발표회
• /
• s.2006
• /
• pp.270-276
• /
• 2006

영산강 하구지역은 현재 신도시개발이 한창 진행되고 있으며, 연약한 해성퇴적층이 15~25cm로 존재하고 있다. 연약지반 개량설계는 불교란시료를 채취하고 각종 실내시험을 통하여 지반의 토질정수를 결정한다. 본 고찰은 압밀관련 지반정수인 선행압밀하중(Pc), 압축지수(Cc), 재압축지수(Cr)를 재해석하기 위해 침하계측 결과를 이용 실내시험의 압밀 곡선과 비교 분석하였다.

• The Journal of Engineering Geology
• /
• v.7 no.3
• /
• pp.217-227
• /
• 1997

The purpose of this study is to analyze the correlation of soil properties in coastal soft ground. For the purpose of this study, several coastal soft ground areas were selected. Many large scale construction works are being executed and will increase continuously in these soft ground areas. So, soil property in these areas is very important. The grounds forming coastal areas are affected by seawater movement. So, most of these areas consist of alluvium stratum. Therefore, soil properties of eastern and southern coastal areas are very complex. Many laboratory tests were executed with disturbed and undisturbed soil samples. Undisturbed samples were taken by using thin walled tubes and transported into the laboratory with caution, so as not to disturb the sample. The consistent rate of fine-grained content in these areas is over 90%. Also, these areas contain higher water content and clay content. Therefore, knowing these soil properties, it is possible to safely design fabrics and constructions.

• Geotechnical Engineering
• /
• v.14 no.1
• /
• pp.59-70
• /
• 1998

Samples of silty sands and hydraulic fill ground were investigated by dynamic triaxial teats in order to evaluate the liquefaction strengths. In the tests, (1) undisturbed and disturbed samples were prepared, (2) dynamic shear strengths were measured under isotropic and anisotropic condition, and (3) the test results were compared with the other results which were tested by domestic and foreign researchers. The liquefaction shear strengths under ismtropic test condition were presented in terms of the relative densities. The amount of silt under 30o hardly influenced on the liquefaction strength. In the test results of anisotropically consolidated samples the liquefaction strength was dependent on the magnitude of the effective consolidation ratio. These teat results show that the liquefaction strength of the silty sand in Korea went coast exists within the boundary of the values suggested by Seed and Peacock(1971).

• Journal of the Korean Geotechnical Society
• /
• v.20 no.7
• /
• pp.99-105
• /
• 2004

When a saturated clay is sampled from a borehole in an undisturbed manner, the exerted negative pore water pressure restricts the volume expansion. The vertical and horizontal stresses to which the clay was subjected in the ground are smaller and larger than this isotropically confining stress equivalent to the mean principal stress in the ground, respectively. Therefore the sample expands vertically and shrinks laterally under an undrained condition. In the ordinary consolidation test, the sample thus deformed is trimmed to fit the inside of the consolidometer ring. Thus, the specimen generates larger consolidation displacement due to confining larger horizontal stress when in-situ effective pressure is loaded. The specimen does not reproduce the in-situ consolidation behavior, In this paper, considering sample deformation, the test specimen is made to expand laterally to fit the inside of the ring in the undrained manner when the in-situ effective pressure is loaded. And applicability of this proposed test procedure was verified; results from the conventional consolidation test procedure are also discussed.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.3
• /
• pp.29-34
• /
• 2008

A large diameter sampler was developed to take undisturbed samples from not only soft ground but also sandy and weathered ground. The large diameter sampler which was developed in Korea Institute of Construction Technology(KICT-type large diameter sampler) was manufactured based on the principle of triple core barrel sampling. A specially designed cutting device was used to cut and contain various kinds of samples in the sampler during a sampling and retrieval procedure. By adjusting the stiffness of the spring located at the top of the sampler, the distance between the cutting shoe and auger can be controlled in accordance with the ground condition. In order to investigate the applicability of the developed sampler and compare the quality of the samples taken by the sampler with that by the traditional thin-walled tube sampler, samples were taken at various sites according to the ground condition. And a series of laboratory tests such as the unconfined compress ion test, triaxial compression test, oedometer test, large diameter Rowe cell consolidation test (D: 150 mm) were performed. The test results showed that the samples by the KICT-type large diameter sampler show higher quality than the samples by the thin-walled tube sampler. And the validity and applicability of the developed KICT-type large diameter sampler was confirmed accordingly.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.4
• /
• pp.153-160
• /
• 2001

딜라토메터를 이용한 현장 수평압밀계수 추정법의 국내 점토지반 및 실트질 지반에의 적용성을 평가하기 위해 국내 점토지반과 실트지반에 대하여 각각 딜라토메터 관입시험 및 소산시험을 수행하였다. 소산시험 결과로부터 DMT-C법 [p$_2$-log t법과 C-√t법]과 DMT-A법을 이용하여 수평압밀계수를 추정하여 상호 비교하였으며 다른 실험방법에서 얻어진 결과들과도 함께 비교하고 평가하였다. 비교대상으로는 동일지반의 현장 피에조콘 소산시험으로 얻어진 수평압밀계수 및 불교란시료에 대하여 수행된 로셀압밀실험 및 일차원 실내압밀실험 결과가 함께 이용되었다. 연구결과 C-√t법을 제외한 p$_2$-log t법과 DMT-A법은 국내 점토지반에 대하여 상호일치하는 결과를 줄 뿐 아니라 피에조콘 결과와도 비교적 잘 일치하는 수평 압밀계수를 측정하였으며 다른 결과와 비교할 때 신뢰성 있는 결과를 주었다. 그러나 실트질 지반에 대하여는 p$_2$-log t법만이 적용 가능할 것으로 판단된다.