• The Korean Journal of Pesticide Science
• /
• v.4 no.4
• /
• pp.19-25
• /
• 2000

The leaching behaviour of quinclorac was elucidated using soil columns. On top of each glass column packed with a rice paddy soil up to the 30 cm height were applied three different treatments of [$^{14}C$]quinclorac: quincloiac only (T-1), quinclorac adsorbed onto active carbon (T-2), and quinclorac adsorbed onto a mixture of active carbon and $Ca(OH)_{2}$ (T-3). Half of the columns were planted with rice plants for 17 weeks and half of them unplanted for comparison. Average amounts of $^{14}C$-activity percolated from tile soil columns without rice plants in T-1, T-2, and T-3 were 81.1%, 27.8% and 48.0%, respectively, of tile originally applied $^{14}C$, whereas those with rice plants grown were 36.8%, 9.6% and 11.0%, respectively, indicating that the leaching of [$^{14}C$]quinclorac was significantly affected by vegetation and by treatment with the adsorbents. The bioavailability of the herbicide to rice plants in T-1, T-2, and T-3 were 13.6%, 11.0% and 13.9%, respectively. The residue levels of quinclorac in the edible part of rice grains would be far less than the maximum residue limit (MRL, 0.5 ppm). After the leaching, the amounts of $^{14}C$ remaining in soil in with rice planting T-1, T-2, and T-3 were 36.3%, 73.7%, and 61.8%, whereas those without rice planting were 19.7%, 71.1%, and 52.3%, respectively. The balance sheets indicate that [$^{14}C$]quinclorac translocated to rice shoots would be lost by volatilization and/or in other ways in T-1 and T-3. The $^{14}C$-activity partitioned into the aqueous phase of the leachates collected from all treatments was less than 7% of the total, but it increased gradually with time in the case of rice growing, suggesting tile formation of some polar degradation products.

• Economic and Environmental Geology
• /
• v.53 no.1
• /
• pp.23-32
• /
• 2020

Geological CO₂ sequestration is a global warming response technology to limit atmospheric emissions by injecting CO₂ captured on a large scale into deep geological formations. The presented results concern mineralogical and hydrogeological investigations (FE-SEM, XRD, XRF, and MICP) of mudstone samples from drilling cores of the Pohang basin, which is the research area for the first demonstration-scale CO₂ storage project in Korea. They aim to identify the mineral properties of the mudstone constituting the caprock and to quantitatively evaluate the hydrogeologic sealing capacity that directly affects the stability and reliability of geological CO₂ storage. Mineralogical analysis showed that the mudstone samples are mainly composed of quartz, K-feldspar, plagioclase and a small amount of pyrite, calcite, clay minerals, etc. Mercury intrusion capillary pressure analysis also showed that the samples generally had uniform particle configurations and pore distribution and there was no distinct correlation between the estimated porosity and air permeability. The allowable CO₂ column heights based on the estimated pore-entry pressures and breakthrough pressures were found to be significantly higher than the thickness of the targeting CO₂ injection layer. These results showed that the mudstone layers in the Yeongil group, Pohang basin, Korea have sufficient sealing capacity to suppress the leakage of CO₂ injected during the demonstration-scale CO₂ storage project. It should be noticed, however, that the applicability of results and analyses in this study is limited by the lack of available samples. For rigorous assessment of the sealing efficiency for geological CO₂ storage operations, significant efforts on collection and multi-aspect evaluation for core samples over entire caprock formations should be accompanied.

• Korean Journal of Soil Science and Fertilizer
• /
• v.13 no.1
• /
• pp.13-19
• /
• 1980

1. Ginseng field and virgin soils, to which Yakto, washed Yakto, litters (deciduous and coniferous trees) and bone meal were applied, were incubated at 60% of field capacity of the soils to shed light on the production of $NH_4-N$ and $NO_3-N$ through mineralization of the organic materials being the nitrogen sources for Korean ginseng. 2. Total nitrogen content mineralized in the soils, to which the following organic materials were applied, was:bone meal>Yakto${\gg}$litter (deciduous trees)> washed Yakto, litter (coniferous trees). The content increased with incubation time in all the virgin and ginseng field soils excepting only the virgin soils applied with washed Yakto and litters of which the contents decreased. A large part of nitrogen mineralized in the virgin and ginseng field soils to which Yakto was applied was nitrate form, while a half ginseng field soils and a considerable part in the other virgin soils was ammonium form in the other treatments. 3. $NH_4-N$ content produced in the virgin and ginseng field soils applied with bone meal increased with the time, while it decreased in the other treatments. And the content in the soils applied with bone meal was very high. 4. $NO_3-N$ content showed a continuous increase during the incubation time in all treatments of ginseng field soils and only in the virgin soil to which Yakto was applied, wherease it showed almost no change in the other treatments of virgin soils. And the content in the soils applied with Yakto was very high. 5. Yakto was expected to supply nitrate enough to meet amounts of nitrogen required by ginseng with different ages and also expected to increase in soil fertility, while bone meal was expected only to supply much nitrogen of which a considerable part was ammonium form.

• Journal of the Korean Wood Science and Technology
• /
• v.46 no.1
• /
• pp.73-84
• /
• 2018

Recently, the importance of flame retardation treatment technology has been emphasized due to the increase in urban fire accidents and fire damage incidents caused by building exterior materials. Particularly, in the utilization of wood-based building materials, the flame retarding treatment technology is more importantly evaluated. An Intumescent system is one of the non-halogen flame retardant treatment technologies and is a system that realizes flame retardancy through foaming and carbonization layer formation. To apply the Intumescent system, composite material was prepared by using Ethylene vinyl acetate (EVA) as a matrix. To enhance the flame retardant properties of the Intumescent system, a nano-clay was applied together. Composite materials with Intumescent system and nano - clay technology were processed into sheet - like test specimens, and then a new structure of cross laminated timber with improved flame retardant properties was fabricated. In the evaluation of combustion characteristics of composite materials using Intumescent system, it was confirmed that the maximum heat emission was reduced efficiently. Depending on the structure attached to the surface, the CLT had two stages of combustion. Also, it was confirmed that the maximum calorific value decreased significantly during the deep burning process. These characteristics are expected to have a delayed combustion diffusion effect in the combustion process of CLT. In order to improve the performance, the flame retardation treatment technique for the surface veneer and the optimization technique of the application of the composite material are required. It is expected that it will be possible to develop a CLT structure with improved fire characteristics.

• Journal of the Society of Disaster Information
• /
• v.11 no.1
• /
• pp.135-147
• /
• 2015

Recent underground common utility tunnels are underground facilities for jointly accommodating more than 2 kinds of air-conditioning and heating facilities, vacuum dust collector, information processing cables as well as electricity, telecommunications, waterworks, city gas, sewerage system required when citizens live their daily lives and facilities responsible for the central function of the country but it is difficult to cope with fire accidents quickly and hard to enter into common utility tunnels to extinguish a fire due to toxic gases and smoke generated when various cables are burnt. Thus, in the event of a fire, not only the nerve center of the country is paralyzed such as significant property damage and loss of communication etc. but citizen inconveniences are caused. Therefore, noticing that most fires break out by a short circuit due to electrical works and degradation contact due to combustible cables as the main causes of fires in domestic and foreign common utility tunnels fire cases that have occurred so far, the purpose of this paper is to scientifically analyze the behavior of a fire by producing the model of actual common utility tunnels and reproducing the fire. A fire experiment was conducted in a state that line type fixed temperature detector, fire door, connection deluge set and ventilation equipment are installed in underground common utility tunnels and transmission power distribution cables are coated with fire proof paints in a certain section and heating pipes are fire proof covered. As a result, in the case of Type II, the maximum temperature was measured as $932^{\circ}C$ and line type fixed temperature detector displayed the fire location exactly in the receiver at a constant temperature. And transmission power distribution cables painted with fire proof paints in a certain section, the case of Type III, were found not to be fire resistant and fire proof covered heating pipes to be fire resistant for about 30 minutes. Also, fire simulation was carried out by entering fire load during a real fire test and as a result, the maximum temperature is $943^{\circ}C$, almost identical with $932^{\circ}C$ during a real fire test. Therefore, it is considered that fire behaviour can be predicted by conducting fire simulation only with common utility tunnels fire load and result values of heat release rate, height of the smoke layer, concentration of O2, CO, CO2 etc. obtained by simulation are determined to be applied as the values during a real fire experiment. In the future, it is expected that more reliable information on domestic underground common utility tunnels fire accidents can be provided and it will contribute to construction and maintenance repair effectively and systematically by analyzing and accumulating experimental data on domestic underground common utility tunnels fire accidents built in this study and fire cases continuously every year and complementing laws and regulations and administration manuals etc.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.5 s.347
• /
• pp.35-44
• /
• 2006

Reflective semiconductor optical amplifiers(R-SOAs) were designed with high gain, wide optical bandwidth, high thermal reliability and wide modulation bandwidth in TO-can package for the transmitter of wavelength division multiplexed-passive optical network(WDM-PON) application. Double trench structure and current block layer were introduced in designing the active layer of R-SOA to enable high speed modulation. The injection power requirement and the viable temperature range of WDM-PON system are experimentally analysed in based on Amplified Spontaneous Emission(ASE)-injected R-SOAs. The effect of the different injection spectrum in the gain-saturated R-SOA was experimentally characterized based on the measurements of excessive intensity noise, Q factor, and BER. The proposed spectral pre-composition method reduces the bandwidth of injection source below the AWG bandwidth and thereby avoids spectrum distortion impeding the intensity noise reduction originated from the amplitude squeezing.

• Journal of Radiation Protection and Research
• /
• v.9 no.1
• /
• pp.33-42
• /
• 1984

A great variety of nuclear gamma rays emitted from fission and activation products of spent nuclear fuel contains much information that can be elicited without affecting the integrity of the fuel elements. But the extraction of such information from the complex spectrum is difficult and requires computer codes. In the present work, a versatile code 'CAERI' was developed which locates peaks and calculates their areas for X-rays as well as gamma rays using elegant features of some widely used programs for gamma-ray peak fitting. 'CAERI' coded in FORTRAN used infinite series approximation more accurate than other workers various, simple, piecewise series approximations for evaluations of the Voigt function which represents the X-ray peak with non-negligible natural line width. 'CAERI' can handle even a complex multiplet consisting of peaks from X-rays and gamma rays in arbitrary mixture, which one often encounters in the isotopic analysis of heavy elements such as U and Pu. The results of the fitting performed on the test spectra of $^{177m}\;Lu\;{\gamma}-ray\;and\;^{235}U\;K_{\alpha}$X-ray show good agreement with those by previous workers.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.24 no.5
• /
• pp.476-486
• /
• 2004

This paper is the second part of the study on the development of a smart active layer (SAL) sensor, which consists of two parts. As mentioned in the first paper, structural health monitoring (SHM) is a new technology that is being increasingly applied at the industrial field as a potential approach to improve cost and convenience of structural inspection. Recently, the development of smart sensor is very active for real application. This study has focused on preparation and application study of SAL sensor which is described with regard to the theory and concept of the SAL sensor in the first paper. In order to detect elastic wave, smart piezoelectric sensor, SAL, is fabricated by using a piezoelectric element, shielding layer and protection layer. This protection layer plays an important role in a patched network of distributed piezoelectric sensor and shielding treatment. Four types of SAL sensor are designed/prepared/tested, and these details will be discussed in the paper In this study, SAL sensor ran be feasibly applied to perform structural health monitoring and to detect damage sources which result in elastic waves.

• KSBB Journal
• /
• v.19 no.4
• /
• pp.321-326
• /
• 2004

Microparticles of an inclusion complex between itraconazole and 2-hydroxypropyl-${\beta}$-cyclodextrin (HP-${\beta}$-CD) were prepared using an environmentally-benign supercritical anti-solvent (SAS) process. In order to evaluate the degree of complexation, the thermal behavior of solid micro particulate complexes was investigated using differential scanning calorimetry. The experimental results obatined for the solubility and dissolution rate of the microparticulate inclusion complexes in a buffer solution of pH 1.2 showed that the complexation of itraconazole with HP-${\beta}$-CD results in a significant increase in the solubility and dissolution rate of itraconazole. For the microparticulate itraconazole/Hp-${\beta}$-CD inclusion complexes prepared by the SAS process, about 80% of itraconazole was found to dissolve in the buffer solution. Our experimental results confirmed that the SAS process is a promising method for the preparation of microparticles of water-insoluble drug/cyclodextrin inclusion complexes.

• Korean Journal of Environmental Agriculture
• /
• v.19 no.4
• /
• pp.300-308
• /
• 2000

The degradation of herbicide $^{14}C-bifenox$ was studied in soils under anaerobic conditions. $^{14}C-bifenox$ was treated in silty loam and sandy loam soils, respectively at a rate of 2.1 mg/kg, and the soil was incubated under anaerobic conditions at $25^{\circ}C$ for 180 days. The mineralization, solvent extractable and non-extractable residues, degradation products of bifenox were investigated during the experiments. The relative amounts of $^{14}CO_2$ were 1.97 and 0.9% of applied $^{14}C$ in silty loam and sandy loam soils, respectively. The non-extractable residues of sandy loam soil increased dramatically up to 79.12% of applied $^{14}C$, and were higher than those of silt loam soil, suggesting physico-chemical properties and especially organic matter contributed to the difference of $^{14}C$ between two soils. The non-extractable residues were formed mainly humin fraction and increased with time. The major metabolites were nitrofen, 5-(2,4-dichlorophenoxy)-2-Nitrobenzoate, 2,4-dichlorophenoxy aniline and methyl 5-(2,4-dichlorophenoxy) anthranilate by GC/MS analysis. From the results of volatilization, mineralization and degradation of bifenox, bifenox was stable chemically and biologically in soil.