• Title/Summary/Keyword: 바렉터 다이오드

Search Result 22, Processing Time 0.024 seconds

A Design of a VCO for an Advance Warning System of the Vehicle′s Speed Limitation (차량 속도 제한 사전 경보기용 전압 제어 발진기 설꼐)

  • 김동현;최익권
    • The Journal of Korean Institute of Electromagnetic Engineering and Science
    • /
    • v.15 no.11
    • /
    • pp.1075-1081
    • /
    • 2004
  • In this paper, a VCO of a general advance warning system for vehicle's speed limitation in the X-band used in Japan is designed using a small signal scattering coefficient of PHEMT. A varactor diode that wide tuning range and series resistance 0 H is used for designing the VCO and -85 dBc/Hz of phase noise at 10 kHz of offset frequency is obtained by adjusting the reflection coefficient between the micro-strip line and the varactor device which determines transistor's operation voltage and resonant frequency, In addition +4.5 dBm of basic frequency signal output level and -25.6 dEc of the second harmonic constraint are acquired. Sample that produce in this paper could confirm that more excellent special quality appears than existing products in sensitivity.

Design and fabrication of voltage controlled dielectric resonator oscillate (Ku-band 전압제어 유전체 공진 발진기 설계 및 제작)

  • Nah I.J.;Kim Y.C.;Lee J.H.
    • 한국정보통신설비학회:학술대회논문집
    • /
    • 2002.08a
    • /
    • pp.31-34
    • /
    • 2002
  • 본 논문은 Ku-band(12.4-18 GHz) 위성통신 시스템 및 이동통신 중계기용 송수신부에 사용되는 고안정도 전압제어 유전체 공진기(Voltage Controlled Dieletric Resonator Oscillator)의 설계 및 제작에 대해 논하였다. 유전체 공진기(Dielectric Resonator)의 등가회로 모델을 이용하여 유전체 공진 발진기(Dielectric Resonator Oscillator)를 설계 알고리즘화 하였다. 유전체 공진 발진기와 바렉터 다이오드를 이용하여 13.4 GHz의 전압 제어 유전체 공진 발진기를 제작하였다. 이때의 출력 전력은 +12dBm이고 위상잡음은 offset 주파수 100kHz에서 -105 dBc/Hz로 측정되었다.

  • PDF

A Novel Varactor Diodeless Push-Push Voltage Controlled Oscilltor with Wide-Tuning Range (바렉터 다이오드를 이용하지 않은 광대역 Push-Push 전압제어 발진기)

  • Lee, Moon-Que;Moon, Seong-Mo;Min, Sang-Bo
    • Proceedings of the Korea Electromagnetic Engineering Society Conference
    • /
    • 2003.11a
    • /
    • pp.100-103
    • /
    • 2003
  • A Ku-band Push-push VCO for low cost applications is proposed. The proposed push-push oscillator achieves a wide tuning range in Ku-band by the collector bias tuning instead of extra varactor diodes. The measurement shows a wide tuning range of 900MHz, fundamental suppression of -30dBc and good phase noise of -115dBc@1MHz offset.

  • PDF

Voltage Controlled Injection-Locked Oscillator Design at 2.4 GHz Band for Wideband Applications (광대역 응용을 위한 2.4 GHz 대역 전압 제어 주입 동기 발진기 설계)

  • Yoon, Won-Sang;Lee, Hun-Sung;Lee, Hee-Jong;Pyo, Seong-Min;Kim, Young-Sik;Han, Sang-Min
    • The Journal of Korean Institute of Electromagnetic Engineering and Science
    • /
    • v.22 no.3
    • /
    • pp.292-298
    • /
    • 2011
  • In this paper, a voltage controlled injection-locked oscillator(VC-ILO) is proposed for wideband applications. From the control of the free-running frequency by a varactor diode, the wide frequency locking range can be obtained for low-level injected signals. The proposed VC-ILO is implemented on an FR-4 substrate with a thickness of 0.8 mm. The free-running frequencies of the oscillator is 2.39~2.52 GHz at the control voltage of 0~5 V. While the frequency locking range of over 50 MHz is presented for -10 dBm injected signal level at a fixed frequency, the locking range of over 90 MHz can be achieved for -30 dBm by controlling the free-running frequency.

A design of a circular phased-array antenna with microstrip slots (마이크로스트립 슬로트의 원형 위상배열 안테나 설계)

  • 임계재;고성선;윤현보
    • The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
    • /
    • v.2 no.1
    • /
    • pp.46-54
    • /
    • 1991
  • A noble phased-array antenna of the circular form with microstrip slots was designed for steering the radiation beam and increasing the directivity and gain. The directivity and gain could be controlled, varying the number of slots and the radius of a circle, but here, the 40 .deg. beam scanning antenna system was achieved by tangentially arranging 4 mi- crostrip slots on a circumference and the analog phase shifter was used to adjust phase difference in the adjacent elements. And such a system has a microstrip configuration taking the effects of the line dispersion and discontinuities into account at 10 Ghz. The experimental results were fairly agreed with theoretical values, and this circular phased array had an improved performance over the rectangular phased array with 64-microstrip patches in a view of the number of array elements.

  • PDF

High Efficient Phase Shifters Using Defected Ground Structures (결함 접지 구조를 이용한 고성능 위상 천이기)

  • Han Sang-Min;Kim Chul-Soo;Ahn Dal
    • The Journal of Korean Institute of Electromagnetic Engineering and Science
    • /
    • v.17 no.1 s.104
    • /
    • pp.1-7
    • /
    • 2006
  • New phase shifters with higher phase shift values are presented using defected ground structures(DGSs). The varactor diodes are mounted on DGSs of termination loads to control the large phase variation of the DGS at resonance. Two types of phase shifters are implemented with a branch-line and a coupled line hybrid. The experimental results of the proposed phase shifters show $135\%$ and $221\%$ increases in maximum phase shills, respectively, compared with those of conventional ones.

Design of Directional Coupler for TX/RX Isolation in UHF Band RFID Application (UHF 대역 RFID를 위한 송수신 분리 방향성 결합기 설계)

  • Na, Won;Kim, Wan-Kyu;Yu, Jong-Won;Lee, Moon-Que
    • The Journal of The Korea Institute of Intelligent Transport Systems
    • /
    • v.7 no.2
    • /
    • pp.43-49
    • /
    • 2008
  • In this paper, new directional couplers for T/R switch of UHF RFID applications are proposed to overcome TX-to-RX leakage problem. The proposed method can remove TX-to-RX leakage caused by both imperfect isolation characteristic of the conventional directional coupler and the mismatch of antenna impedance. Two directional couplers are implemented using distributed elements and lumped elements respectively for the verification. The varactor tuneable circuits for compensation of the antenna mismatch is also proposed. The measurement result shows excellent TX-to-RX leakage suppression, more than 45dB in 910MHz.

  • PDF

High Efficiency Frequency Tunable Inverse Class-E Amplifier (고효율 주파수 가변 역 E-급 증폭기)

  • Kim, Young
    • Journal of Advanced Navigation Technology
    • /
    • v.14 no.2
    • /
    • pp.176-182
    • /
    • 2010
  • This paper proposes that an inverse class-E amplifier is used a tunable parallel resonator at output port in order to maintain a high power-added efficiency(PAE) and output power with wide frequency ranges. A tunable circuit has a constant Q factor at operating frequency ranges and because of using varactor diode, the inductor and capacitor values of resonator can be changed. Also, the inductance value for zero-current switching (ZCS) is implemented a lumped element and the capacitance value is made a distributed element for phase compensation. The inverse class E amplifier using tunable parallel resonator is obtained to deliver 25dBm output power and achieve maximum power added efficiency(PAE) of 75% at 65-120MHz frequency ranges.

Tunable Bandstop Filter with Combined Right/Left-Handed Transmission Lines (Right/Left-Handed 전송 선로를 결합한 가변 대역 저지 필터)

  • Sung, Gyu-Je;Kim, Ell-Kou;Kim, Young;Yoon, Young-Chul
    • The Journal of Korean Institute of Electromagnetic Engineering and Science
    • /
    • v.19 no.10
    • /
    • pp.1122-1128
    • /
    • 2008
  • A novel tunable bandstop filter was proposed. It is composed of a right-handed transmission line, which has lowpass characteristics, and a left-handed transmission line which has highpass characteristics. Dispersion relations for the unit cells of RHTL and LHTL were derived by the method of ABCD parameter analysis. Varactor diodes and chip inductors were used to make the unit cells of RHTL and LHTL. A tunable bandstop filter was designed and fabricated by the parallel connection of RHTL and LHTL. The measured results of the proposed tunable bandstop filter are agreed well with the simulated results.

Design and Fabrication of A Doppler Radar for Motion Detector Using Frequency Tunable Hairpin Resonator (주파수 가변형 헤어핀공진기를 이용한 동작감지용 도플러 레이더센서의 제작 및 설계)

  • Kim, Eun-Su;Kim, Gue-Chol
    • The Journal of the Korea institute of electronic communication sciences
    • /
    • v.13 no.5
    • /
    • pp.931-936
    • /
    • 2018
  • We designed an x-band radar for motion detector using a frequency tunable hairpin ring resonator. The proposed doppler radar sensor can vary the oscillation frequency by applying a hairpin resonator using a varactor diode to the oscillator, and this can also reduce the size by transmitting and receiving a signal from Tx/Rx dual antenna. The fabricated doppler radar sensor was fabricated in $30{\times}24mm$, and it was confirmed that the pulse width difference occurred according to the distance from the object. The measurement results showed oscillation at 10.525GHz. We confirmed that it is enough to use as radar for motion detection from the measured results.