• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.38 no.3
• /
• pp.288-293
• /
• 2010

This paper presents to calculate the lethality of missile for the simulation test program and to verify the simulation results. In order to calculate a reliable lethality we need may data and experiments of fuse and warhead, but in reality it is hard to perform a task. Therefore, this paper obtained from the reference paper to analyze the lethality data for the calculation of the lethality. We form the 6 DOF simulation model using the MATLAB/SIMULINK. And formed the autopilot algorithm using the vertical and horizontal acceleration feedback and PNG (Proportional Navigation Guidance) command be used to the guidance algorithm. Finally, we evaluate the results about three cases, front launch, side launch and rear launch to simulate the simulation program, and the target is designed to have a constant speed and direction.

• Journal of the Korea Society for Simulation
• /
• v.29 no.1
• /
• pp.1-9
• /
• 2020

The ballistic missile threat continues to increase with the proliferation of missile technology. In response to this threat, many kinds of interceptors have been emphasized over the years. For development of interceptor, systematic flight tests are essential. Flight tests provide valuable data that can be used to verify performance and confirm the technological progress of ballistic missile defense system including interceptor. However, during flight tests, civilians near the test region could be risk due to a lot of intercept debris. For this reason, reliable estimate of safety area for the flight tests should be preceded. In this study, prediction of safety area is performed through modeling and simulation. Firstly, behaviors of ballistic missile and interceptor are simulated for those entire phase including interception to obtain the relative intercept velocity and the relative impact angle. By using obtained data of kinetic energy, the fragment ejection velocity is calculated and fragment trajectories are simulated by considering drag, gravity and wind effects. Based on the debris field formation and hazard evaluation of debris, final safety area is calculated.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.6
• /
• pp.544-550
• /
• 2009

To analyze the threat decision performance of MWR(Missile Warning Radar) give analysis on condition that we decide the effective threat using the POC(Probability of Over Countermeasure)/PUC(Probability of Under Countermeasure). Thus, we execute the simulation using the Monte-Carlo method to analyze effect, but the execution time of simulation took longer than we expected. In this paper, the effect analysis is proposed using the probability model to reduce the execution time of simulation. We present the setting method of parameter for probability model and the effect analysis result of MWR using the simulation. Also, we present the comparison result of simulation execution time for Monte-Carlo and probability model.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.25 no.5
• /
• pp.495-501
• /
• 2015

Abroad warships are confronted with various menaces. The most critical threat of the warship is an Anti-Ship Missile (ASM). The ASM is able to be launched at a variety of environments and platforms. The ASM can evades conventional naval radar systems and electronic countermeasure techniques for providing a fatal damage to the warship. To cope with the ASM, an active decoy is an effective method to minimize the direct damage to the warship. The active decoy increases survivability of the warship because the ASM can lure pursuit of the active decoy instead of the warship. In this paper, our proposed method verifies an available response time of the active decoy to deal with the ASM using the active decoy of the warship in marine environments. We defined models of the warship, the ASM, and the active decoy, and executed simulation by combining the models. By the simulation result, the proposed method demonstrated the superiority of the mobile active decoy of the response time decoy among various active decoys, and estimated a protection area to prevent the ASM according the response time of the mobile active decoy against the ASM.

• Journal of the Korea Society for Simulation
• /
• v.25 no.1
• /
• pp.1-9
• /
• 2016

This study focuses on the air to air missile control fin planform optimization for the minimizing hinge moment with the considering phenomena of fluid and structure simultaneously. The fluid-structure interaction method is applied for the fluid and structure phenomena simulation of the control fins. A transient-loosely coupled method is used for the fluid-structure interaction simulation because it is suited for using each fluid and structure dedicated simulation software. Searching global optimization point is required many re-calculation therefore in this study, a mathematical model is applied for rapidly calculation. The face centered central composite method is used for generating design points and the 2nd polynomial response surface is sued for generating mathematical model. Global optimization is performed by using the generic algorithm. An objective function is the minimizing travel distance of the center of pressure between Mach 0.7 and 2.0 condition. Finally, the objective function of optimized planform is reduced 7.5% than the baseline planform with satisfying constrained conditions.

• Journal of the Korea Society for Simulation
• /
• v.26 no.2
• /
• pp.31-39
• /
• 2017

This paper analyses the effectiveness of Kill Chain (KC) and Korea Air and Missile Defense (KAMD), also known as the K2 systems, using monte carlo simulation. It is assumed that the K2 systems are consisted with unitary KC and multi-layered (upper-tier and lower-tier) KAMD. And each system has two or three arbitrary weapon systems and its combination makes 12 scenarios. Measures of effectiveness (MOE) of the K2 systems were defined as ratio of eliminated ballistic missiles from total threats. And total cost was calculated by number of weapon launched and its unit cost. MOE and total cost of the K2 systems were estimated using monte carlo simulation with a thousand iteration for each scenario. Cost-effectiveness analysis was performed and the best candidate was selected using fixed effectiveness approach. As a result, the performances of KC are prime factor that affects both effectiveness and total cost of the K2 systems. It is also, acquired proper level of lower-tier KAMD to achieve desired defense effectiveness. For future work, it needs to be performed cost-effectiveness analysis based on practical specification and life cycle cost of weapon systems.

• Journal of the Korea Society for Simulation
• /
• v.19 no.4
• /
• pp.199-208
• /
• 2010

Positions of tactical objects are represented as Time, Space and Position Information(TSPI) in modeling and simulations(M&S). The format and required information record for TSPI is investigated by referring the TSPI object model of the Test and Training Enabling Architecture(TENA), which has been developed by the United States Department of Defense. The most sophisticated tactical data link, Link-16 has a Precise Participant Location and Information (PPLI) message. We study the data format for exchanging TSPI data based on the PPLI message. To evaluate and track positions of tactical objects, we consider the Kalman filter for linear systems, and the extended Kalman filter and the unscented Kalman filter for nonlinear systems. Based on motion equations of a ballistic missile, the tracking performance for the trajectory of the ballistic missile is simulated by the unscented Kalman filter.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.30 no.4
• /
• pp.92-98
• /
• 2002

In this study, maximum launch range and F-pole are evaluated and analyzed for the semi-active radar missile concerning various launch condition, performance limitation and target maneuvers. Furthermore, general evasion maneuvers are considered when shooter approaches to target with head-on conditions. A point-mass target, shooter and missile model is used including aircraft and missile dynamics. More realistic missile motion simulation is conducted using aerodynamic performance data, geometry, performance limitation, radar seeker performance and so on. Maximum launch range, which is the distance for intercept satisfying target and missile motion and performance, is evaluated using root finding method. F-pole, which is the distance between target and shooter when intercept is completed, is evaluated assuming that shooter maneuvers through pursuit guidance to target.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.2
• /
• pp.266-269
• /
• 2012

This paper introduces a signal processing technique for discrimination of ballistic missile's warhead. An interceptor missile to destroy the enemy's ballistic missile requires an information on the location of missile's warhead. In order to detect and locate the missile's warhead, a seeker radar in the interceptor missile makes use of chirp waveform to generate high resolution range profiles(HRRPs). We applied one of the well known spectral estimation technique called ESPRIT (Estimation of Signal Parameters by Rotational Invariance Technique) to these HRRPs to estimate scattering centers on the target. Using the information on the one-dimensional(1-D) scattering centers, we can find the location of the warhead by estimating the length of the missile, Simulation results show that the proposed signal processing technique is efficient in discriminating the warhead of an ballistic missile.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.12
• /
• pp.1333-1339
• /
• 2009

A MWR(Missile Warning Radar) of GVES(Ground Vehicle Equipment System) has to effectively decide the threat for a detected target. Linear Approximation Fitting(LAF) and Weighted Linear Approximation Fitting(WLAF) algorithm is proposed as algorithm for a threat decision method. The target is classified into a threat or non-threat using a boundary condition of the angular rate, and the boundary condition is determined using probability model simulation. This paper confirms the performance of proposed threat decision algorithm using measurement.