• Resources Recycling
• /
• v.23 no.6
• /
• pp.63-67
• /
• 2014

Gallium is an important material and is used by industry of oxide semi-conductor and LED chip. However, the most of the gallium-containing waste resources became outflow abroad and the most of which is imported from oversea by following technical problem and low circulation rate. In this research, the recovery of high purity Gallium metal from Gallium scrap, which containing about 30% of Gallium, was investigated by using hydro-metallurgical process. As pretreatment, the Gallium scrap was pulverized and leached by strong acid such as hydro chloric acid. At the leached solution, Indium was separated as an Indium sponge by substitution reaction and then Gallium and Zinc hydroxide separated and filtrated using strong alkaline solution such as sodium hydroxide by precipitation method. Also, Gallium metal and Zinc metal was recovered by electrowinning method. To make an electrolytic solution, Gallium and Zinc hydroxide was leached by strong alkaline solution. Finally, High purity Gallium metal was recovered by vacuum refining process to remove the Zinc impurity.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.5C
• /
• pp.171-185
• /
• 2011

Ready-mixed shotcrete that mixed with high quality aggregate and can improve construction quality is produced in a dry mortar plant and transported to construction sites. Because of using aggregate that produced in a special plant, Ready-mixed shotcrete has many advantages : good grain-size distribution, minimum stone powder, high quality and standardization material, etc. In this basic study different from the existing study that limited to additive and accelerator, the improvement of aggregate quality was tried to upgrade the shotcrete performance. The investigation about the construction conditions of shotcrete was performed and the result of an opinion poll was analyzed for a good grasp of the problems in domestic shotcrete quality. Pilot Plant Test was also performed to minimize the material segregation in plant manufacturing process. In additions, the field test was performed to find the optimum contents of synthetic fiber, appearing the same flexible toughness with that of steel fiber, and to find the optimum replacement ratio of blast furnace slag.

• Journal of the Korea Institute of Building Construction
• /
• v.17 no.3
• /
• pp.269-277
• /
• 2017

In this work, as a preliminary experimental works, which focuses on utilizing separated pastes from activated (or radioactive) concrete as solidifying agents for radioactive waste immobilization, were performed. It was found that density of hydrated cement paste, which was lower than that of ordinary portland cement, increased as temperature for heat treatment increased. Highest compressive strength was observed with the specimens that was heat treated at $600^{\circ}C$. However, heat treatment over $700^{\circ}C$ showed higher CaO content that caused higher heat of hydration after in contact with water, lows of workability, and lower strength. Based on experimental results, it is suggested that $600^{\circ}C$ heat treatment is more appropriate for waste cement paste to be used as a solidifying agent.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.13 no.3
• /
• pp.174-180
• /
• 2010

The inhomogeneous Helmholtz equation is introduced for variable water depth and potential function and separation of variables are introduced for the derivation. Only harmonic wave motions are considered. The governing equation composed of the potential function for irrotational flow is directly applied to the still water level, and the inhomogeneous Helmholtz equation for variable water depth is obtained. By introducing the wave amplitude and wave phase gradient the governing equation with complex potential function is transformed into two equations of real variables. The transformed equations are the first and second-order ordinary differential equations, respectively, and can be solved in a forward marching manner when proper boundary values are supplied, i.e. the wave amplitude, the wave amplitude gradient, and the wave phase gradient at a side boundary. Simple spatially-centered finite difference numerical schemes are adopted to solve the present set of equations. The equation set is applied to two test cases, Booij’ inclined plane slope profile, and Bragg’ wavy bed profile. The present equations set is satisfactorily verified against other theories including the full linear equation, Massel's modified mild-slope equation, and Berkhoff's mild-slope equation etc.

• Journal of the Korean Vacuum Society
• /
• v.10 no.3
• /
• pp.350-355
• /
• 2001

We have investigated characteristics of ZnSe epilayer grown by molecular beam epitaxy(MBE) on semi-insulating(SI) GaAs by using surface photovoltage(SPV). The measurements of SPV were performed with illumination intensity and modulation frequency. The bandgap energy of ZnSe epilayer was determined from derivative surface photovoltage (DSPV). The five states were observed at room temperature(RT), and those states relate to the impurity and defect formed hetero-interface of ZnSe and GaAs during the sample growth. The observed states represented as a tendency of typical extrinsic transition on the increasing illumination intensity. The 1s and 2s signals related to the excitonic absorption were not observed at RT, but those were presented with the splitted of two peaks in the SPV at 80 K. From the modulation frequency dependence, we obtained the junction conductance and capacitance of the sample.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.3
• /
• pp.575-583
• /
• 2000

Pulse oximetry is a well established non-invasive optical technique for monitoring the $SpO_2$ during anaesthesia, recovery and intensive care. Pulse oximeters determine the oxygen saturation level of blood by measuring the light absorption of arterial blood. In the measurement of the hemoglobin oxygen saturation, conventional method has required the technique of filtering of remove the noise, and of complex signal processing algorithm. So much time have been required to signal processing. In this research, we separate AC signal and DC signal in the stage of signal detection. Therefore we simplify the calculation algorithm for $SpO_2$. The implemented system have the high performance such an accuracy and a processing time than the traditional method.

• The Journal of the Korea Contents Association
• /
• v.12 no.3
• /
• pp.434-441
• /
• 2012

An analytic solution to the extended mild-slope equation was derived for waves propagating over an axi-symmetric pit. The water depth inside the pit was in proportion to a power of radial distance from the center of pit. The equation was transformed into the ordinary differential equation using the method of separation of variables. The coefficients of differential terms were expressed as an explicit form composing of the phase and group velocities. The bottom curvature and the square of bottom slope terms, which were added to the extended mild-slope equation, were expressed as power series. Finally, using the Frobenius series, the analytic solution to the extended mild-slope equation was derived. The present analytic solution was validated by comparing with the numerical solution obtained from FEM.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.11a
• /
• pp.681-684
• /
• 2008

In case of recycled fine aggregate, density and absorption ratio is lower than natural one, so it is used to lower value added products and it is limited its usage. It is reported that Compressive and tensile strength of recycled concrete is more deteriorate and shrinkage properties is very deteriorate because high absorption of recycled fine aggregate. Accordingly, in this study, it is develop that dry manufacturing system composed specific gravity separator of high-speed rotation impact type, reclaimer of minuteness fine aggregate and evaluate that shrinkage properties of recycled concrete using recycled fine aggregate at producing this system. Hereafter, it is present that fundamental data to practical use recycled fine aggregate.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.19 no.6
• /
• pp.743-748
• /
• 2009

In this paper, we propose an effective method to extract background components in automated vision inspection system for polarized film used in TFT LCD display panels. The test image signals are typically composed of three components such as ununiform background, random noises and target defect signals. It is important to analyze the background signal for accurate extraction of defect components. Two dimensional continuous wavelets with first derivative gaussian is used. This methods can be applied for reliable extraction of defect signal by elimination of the background signal from the original image. The proposed method outperforms over conventional FFT methods.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.4A
• /
• pp.375-382
• /
• 2010

This paper presents the extraction of natural frequencies and mode shapes of a cable-stayed bridge using data acquired from GNSS. The response signals of 6 GNSS measuring points installed at the Seohae cable-stayed bridge are used for analysis of dynamic characteristics. Using normalization process and a third order Butterworth filter for the measured signals, the related pass band's signals have been isolated. Then, the acceleration data by double differentiation for these signals are obtained. Total five natural frequencies have been extracted by the fast Fourier transform and compared to the results of different studies. For the acceleration obtained from GNSS signals, the mode shapes of the bridge have been successfully extracted by TDD technique.