• Journal of the Korean Society of Propulsion Engineers
• /
• v.22 no.3
• /
• pp.46-52
• /
• 2018

A simple Crocco's $n-{\tau}$ time delay model and linear analysis of fluid flow coupled with acoustics are combined to investigate the high frequency combustion instability in the combustion chamber of LOX/hydrocarbon engines. The partial differential equation of the velocity potential is separated into ordinary differential equations, and eigenvalues that correspond to tangential resonance modes in the cylindrical chamber are determined. A general solution is obtained by solving the differential equation in the axial direction, and boundary conditions at the injector face and nozzle entrance are applied in order to calculate the chamber admittance. Frequency analysis of the transfer function is used to evaluate the stability of system. Stability margin is determined from the system gain and phase angle for the desired frequency range of 1T mode. The chamber model with variable baffle length and configurations are also considered in order to enhance the 1T mode stability of the combustion chamber.

• Resources Recycling
• /
• v.18 no.3
• /
• pp.27-35
• /
• 2009

To solve resource exhaustion and waste management problems caused by mass consumption, there are many efforts to change from resource consumption system to recycling system. Specially, interests about management of construction waste have increased, but efficient recycling system of waste concrete is not established yet. In this study, high quality recycled aggregate processing circuit was developed to recycle waste concrete. From the waste concrete which is a hydrated compound with coarse aggregate, fine aggregate, and cement material, high quality recycled coarse aggregate for concrete making was produced by autogenous milling and heat pretreatment method. After then, refinement process was performed to separate fine aggregate and cement material from waste concrete fines by sink float separation and hindered-settling separation. As a result, high quality recycled aggregate was produced from waste concrete by developed processing circuit.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2009.05a
• /
• pp.796-800
• /
• 2009

토목구조물 및 사면의 붕괴는 집중호우가 내리는 경우 많이 발생하고 있으며, 특히 사면에서는 붕괴까지의 변형이 급속히 진행되어 이를 사전에 예방하기는 매우 어려운 현실이다. 침투 및 배수과정에서의 사면 붕괴는 강우침투로 인한 지반의 물리적 특성변화가 직접적으로 사면의 안전계수 변화에 영향을 주는 것으로 판단되며, 이때 발생하는 물리적 특성변화로는 침투시 사면 내 지반의 단위 중량은 증가하여 전단응력의 증가 및 전단강도 감소현상이 발생하며, 이와 반대로 사면 내 배수로 인하여 전단응력의 감소 및 전단강도의 증가현상이 발생한다. 따라서 본 연구에서는 강우침투로 발생하는 지반의 포화도 변화를 지반 내 투수계수의 함수로 설명하여 강우로 인한 지반의 침투 및 배수과정을 규명하고자 한다. 일반적으로 지반 내 지하수의 침투과정은 라플라스 공식을 적용한다. 그러나 라플라스 공식은 정상 상태(Steady State)일 경우에만 사용할 수 있고, 강우 등으로 인한 지하수의 수두 변화가 발생한 비정상 상태(Unsteady State)의 경우에는 부적합하므로 사면과 옹벽 등의 토질구조물에서는 안전성 변화를 계산할 수 없다. 이를 위해 사면 내 지반의 침투 및 배수과정을 투수계수의 함수로 나타내어, 강우의 침투과정을 Fourier Series, 변수분리법 및 섭동함수를 사용하여 식으로 유도함으로서 강우에 의한 지반의 침투 및 배수과정에 따른 사면 내 지하수의 분포를 예측한다. 침투과정 해석을 위하여 지표에서 포화대까지의 깊이 10m의 모델사면 및 지표부터 포화대까지의 포화도는 직선으로 비례한다는 가정을 적용한다. 먼저 푸리에 급수를 이용, 시간에 따른 온도를 열전달에 관하여 편미분하여 발생하는 열확산계수를 투수계수로 변환함에 따라 지하수의 시간과 수직방향거리에 대한 지반의 포화도를 산정한다. 변수분리법은 산정된 포화도에 지반의 초기조건과 경계조건를 고려하기 위해 적용하며, 변수분리법에 의해 산정된 지하수 분포를 섭동함수법으로 과도 및 정상상태로 분류한다. 본 연구의 수행으로 인해 얻어진 결과를 요약하면 다음과 같다. 첫째, Fourier Series와 변수분리법, 섭동함수를 이용하여 강우에 의한 지반의 포화도 변화를 수식적으로 나타낼 수 있으며 둘째, 지반에서의 강우침투과정을 식으로 표현함으로서, 깊이별 시간에 따른 포화도의 영역이 상부로부터 하부로 전이되는 과정을 알 수 있다. 셋째, 푸리에 급수를 이용한 지반의 침투계산으로 강우로 인한 지반의 포화영역 및 불포화영역을 명확히 구분할 수 있으며, 각 깊이별 포화도를 계산하여 각 구간에서 불포화구간의 전단강도에 대한 보다 정확한 계산이 가능하리라 판단된다.

• Journal of Korean Society of Transportation
• /
• v.33 no.2
• /
• pp.204-213
• /
• 2015

The congestion of pedestrians impedes the utilization efficiency of a subway station. Conflicts among pedestrians due to unseparated pedestrian flows not only increase the impedance of pedestrian mobility but also negatively affect on pedestrian safety. This paper analyzes the travel characteristics of bi-directional pedestrian flow based on microscopic movements, and evaluates the operation efficiency on separating the traffic line. The subway station was simulated in a 2-D grid structure by applying Discrete Element Method, and the movement is organized in each cell of the grid. As a result, the model explicates that separating the traffic line and encouraging the 'Keep right rule' would be mostly effective for the conflicting flows. Therefore, applying the 'Walking Guidance System' would be efficient to improve the pedestrian convenience and mobility.

• Journal of the Architectural Institute of Korea Structure & Construction
• /
• v.35 no.12
• /
• pp.165-172
• /
• 2019

The aim of the research is to evaluate the influence of various replacing ratios of supplementary cementitious materials(SCMs) such as fly ash(FA), blast furnace slag(BS), and both FA and BS on general properties including segregation resistance as a powder based high fluidity concrete of normal strength grade with water-to-cement ratio 0.40. Specifically, by replacing the SCMs with low density powders, it was assessed that the decreased segregation resistance due to the decreased viscosity by J-ring test. As a result of the experiment, from the general test, the mixtures with SCMs showed increased segregation resistance by increased viscosity as the references, while some segregation was shown from J-ring test due to the decreased density of fresh state mixture related with the capacity of delivering coarse aggregate.

• Journal of Advanced Navigation Technology
• /
• v.14 no.3
• /
• pp.426-431
• /
• 2010

68% of the manufacturing costs of solar cell wafer can be attributed to the slurry. The recycling of slurries is mandatory for reducing the costs of manufacturing wafering production, and the disposal of industrial waste, as well as for cutting down pollution levels. Slurries are currently being recycled using the centrifuge(decanter) method. However, this method is less than optimal as it does not completely remove the fine particles, leading to low quality. Also, be cause of the incomplete separation from the oil, it causes the impurities in the dried slurries. This study aims to develope a new recycling technology that overcomes the flaws of the centrifuge by utilizing chemicals. It will provide a total solution to the crucial process of recycling slurries in the making of solar cell wafer, by increasing the efficiency and renewable rate.

• Journal of the Korean Magnetics Society
• /
• v.4 no.2
• /
• pp.100-105
• /
• 1994

Ni-Fe thin films are deposited on the corning glass substrate by means of RF magnetron sputtering system In order to investigate the dependence of the prorerties of Ni-Fe thin films on the film thickness, ferromagnetic reson¬ance spectrum has been examined. The effective magnetization $M_{eff}$ is constant for all samples, while the exchange stiffness constant A increases with the film thickness. A tendency that spectroscopic splitting factor g increases with the sample thickness, we expect that the increase of the contribution of the orbital motion to the magnetic moment as a reason for it.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2006.05a
• /
• pp.111-114
• /
• 2006

Recently, it is increased on the concern for the reuse of waste concrete because of the shortage of natural aggregate and the increase of waste concrete. And recycled coarse aggregate is used variously, but the existing wet method producted recycled fine aggregate has problem like the high price facilities, the long time progress of the work and the poor of recycled fine aggregate. The aim of this study is to investigate outline and performance evaluation of the drying specific gravity separation method to product high duality recycled fine aggregate. Finally, this study is shown investigate process flowing of drying separation type with gravity manufacture, producte system and function of detail devices. The performance of the method of drying specific gravity separation is certificated as the qualities of recycled fine aggregate satisfied the KS

• Geophysics and Geophysical Exploration
• /
• v.18 no.2
• /
• pp.74-84
• /
• 2015

To yield physically meaningful images through elastic reverse-time migration, the wavefield separation which extracts P- and S-waves from reconstructed vector wavefields by using elastic wave equation is prerequisite. For expanding the application of the elastic reverse-time migration to anisotropic media, not only the anisotropic modelling algorithm but also the anisotropic wavefield separation is essential. The anisotropic wavefield separation which uses pseudo-derivative filters determined according to vertical velocities and anisotropic parameters of elastic media differs from the Helmholtz decomposition which is conventionally used for the isotropic wavefield separation. Since applying these pseudo-derivative filter consumes high computational costs, we have developed the efficient anisotropic wavefield separation algorithm which has capability of parallel computing by using GPUs (Graphic Processing Units). In addition, the highly efficient anisotropic elastic reverse-time migration algorithm using MPI (Message-Passing Interface) and incorporating the developed anisotropic wavefield separation algorithm with GPUs has been developed. To verify the efficiency and the validity of the developed anisotropic elastic reverse-time migration algorithm, a VTI elastic model based on Marmousi-II was built. A synthetic multicomponent seismic data set was created using this VTI elastic model. The computational speed of migration was dramatically enhanced by using GPUs and MPI and the accuracy of image was also improved because of the adoption of the anisotropic wavefield separation.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1999.10a
• /
• pp.199-202
• /
• 1999

Recently, the antiwahout underwater concrete with an natiwashout admixture has been increasingly used for underwater structures. However, the credibility of antiwahout underwater concrete was brought up as problems because it was seldom applied to fields. In this study, experiments were made on the basic properties of antiwashout underwater concrete replaced with GGBF Slag from 40% to 60% to improve its properties. Resultant to the test, we got the results as follows; the difference of U-type heght was decreased, and the slump flow was increased. Whereas the amount of suspended solids became high as to increasing the replacement ratio of GGBF Slag, pH value became low. Beacause the ratio of compressive strengths (in water compared to in air) at 28days was obtained over 90%, its value is satisfied with 70% of a criterion.