• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.11
• /
• pp.1225-1230
• /
• 2015

MAC protocol for WBAN performs CSMA/CA(:Carrier Sense Multiple Access with Collision Avoidance)algorithm that handles traffic which occurs in emergency with top priority in order to deal with variable data of sensor node for medicine. Emergency message that node sends undergoes collision and delay of transmission by retransmission of emergency message and waste of energy by retransmission. This paper suggests algorithm that minimizes loss of frame caused by collision and applies different backoff parameters by setting order of priority between MAC instruction frame and data frame in CSMA/CA algorithm case which applies order of priority queuing to improve aforementioned problem. According to performance evaluation, it has been found that using suggested MAC protocol showed lower collision probability, higher packet transmission processing ratio and lower packet loss compared with using IEEE 802.15.6.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.5
• /
• pp.486-496
• /
• 2013

Time synchronization in underwater environment is challenging due to high propagation delay and mobility of sensor nodes. Previous researches do not consider practical issues affecting on the accuracy of time synchronization such as high-channel access delay and relative position between sensor nodes. Also, those protocols using bidirectional message exchange shorten the network lifetime and decrease the network throughput because numerous transmission, reception and unnecessary overhearing can be occurred. Therefore, in our research, we suggest enhanced time synchronization based on features of underwater environment. It controls the instant of transmission by exploiting the feature of an oceanic movement and node deployment. Moreover, the protocol uses more accurate time information by removing channel access delay from the timestamp. The proposed scheme is also practical on the underwater sensor network requiring low-power consumption because the scheme conducts time-synchronization with smaller transmission and reception compared with previous works. Finally, simulation results show that the proposed protocol deceases time error by 2.5ms and 0.56ms compared with TSHL and MU-Sync respectively, reducing energy consumption by 68.4%.

• Journal of Institute of Control, Robotics and Systems
• /
• v.19 no.3
• /
• pp.268-274
• /
• 2013

In this paper, the performance analysis of optics-based sensor node localization using ToF (Time of Flight) scheme is conducted. Generally, the position of the sensor node is calculated on the base station. And the base station scans neighboring sensor nodes with a laser. The laser which is reflected from one sensor node, however, can be reached to the base station at different angles according to the scanning resolution. This means that the error of the reached angle can increase and one node may be recognized as different nodes. Also the power of laser can decrease because the laser signal spread. Thus the sensor node which is located at a long distance from the base station cannot be detected. In order to overcome these problems which can be occurred in localization using ToF, the beam spot, the scanning resolution, the size of reflector and the power of laser at the sensor node were analyzed. It can be expected that the consequence of analysis can be provided in acquisition of accurate position of sensor node and construction of optics-based sensor node localization system.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.8 no.12
• /
• pp.1803-1810
• /
• 2013

In a warehouse, because there exist frequent changes of stock status and the quality of some contents are influenced by the environment such as temperature, fast and accurate management of the warehouse's environment is very important for Warehouse Management Systems. However, due to the absence of a unified standard for the communication protocol between RFID nodes and centralized MAC schemes for RFID communications in previous studies have severe problems. Therefore, in this paper, we propose a WiMedia MAC based RFID cooperative relay transmission scheme for warehouse management system applications.

• Journal of Internet Computing and Services
• /
• v.9 no.5
• /
• pp.131-140
• /
• 2008

In this paper, we present a data dissemination protocol that guarantees energy-efficient data transmission and maximizes network lifetime. SPMS that outperforms the well-known protocol SPIN uses the shortest path to minimize the energy consumption. However, since it repeatedly uses the same path, maximizing the network lifetime is impossible. In this paper, we propose a protocol for data dissemination called the protocol Considering Between Energy and Distance (ConBED). It solves the network lifetime problem using the residual energy and the distance between nodes to determine a path for data dissemination. The simulation results show that ConBED guarantees energy-efficient transmission and increases the network lifetime by approximately 69% than that of SPMS.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.1925_1926
• /
• 2009

This paper describes a novel power management circuitry for reducing the sleeping mode power dissipation. Based on the proposed power management circuitry, the sensor module can be activated by RF wake-up signal, perform designated process and deactivate itself. There is absolutely no power dissipation at the sleeping mode which takes almost time of the operation. The temperature sensor module using solar cell as energy source has been fabricated and tested. Experimental results show that the sensor module with 3300 ${\mu}$F for storage capacitor can transmits RF temperature data to a receiver at a distance of 20 m every 15 second in a normal indoor light condition and keep the capacitor voltage over 9 V. And the sensor module can operate 100 times with a single charging, that means it is possible for the sensor module to transmit every 5 minute for 8 hours without light or any other power input during the night time.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37B no.9
• /
• pp.767-777
• /
• 2012

Topology control increases channel efficiency by controlling transmission power of a node, and as a result, network lifetime and throughput are increased. However, reducing transmission range causes a network connectivity problem, especially in mobile networks. When a network loses connectivity, the network topology should be re-configured. However, topology re-configuration consumes lots of energy because every node need to collect neighbor information. As a result, network lifetime may decrease, even though topology control is being used to prolong the network lifetime. Therefore, network connectivity time needs to be increased to expend network lifetime in mobile networks. In this paper, we propose an Adaptive-Redundant Transmission Range (A-RTR) algorithm to address this need. A-RTR uses a redundant transmission range considering a node status and flexibly changes a node's transmission range after a topology control is performed.

• Journal of Ocean Engineering and Technology
• /
• v.26 no.1
• /
• pp.27-33
• /
• 2012

This paper presents the effect of temperature on the impedance-based damage monitoring of steel-bolt connections using wireless impedance sensor nodes. In order to achieve the objective, the following approaches are implemented. First, a temperature-compensated damage monitoring scheme that includes a temperature compensation model and damage detection method is described. The temperature compensation model is designed by analyzing the linear regressions between the temperatures and impedance signatures. The correlation coefficient of the impedance signatures is selected as the damage index to monitor the damage occurrence in the target structures. Second, a wireless impedance sensor node is described for the design of the hardware components and embedded software. Finally, the performance of the temperature-compensated impedance-based damage monitoring scheme is evaluated for detecting a loose bolt in the steel-bolt connections on a lab-scale steel girder under various temperatures.

• Journal of Institute of Control, Robotics and Systems
• /
• v.13 no.7
• /
• pp.711-717
• /
• 2007

Location information will become increasingly important for future Pervasive Computing applications. Location tracking system of a moving device can be classified into two types of architectures: an active mobile architecture and a passive mobile architecture. In the former, a mobile device actively transmits signals for estimating distances to listeners. In the latter, a mobile device listens signals from beacons passively. Although the passive architecture such as Cricket location system is inexpensive, easy to set up, and safe, it is less precise than the active one. In this paper, we present a passive location system using Cricket Mote sensors which use RF and ultrasonic signals to estimate distances. In order to improve accuracy of the passive system, the transmission speed of ultrasound was compensated according to air temperature at the moment. Upper and lower bounds of a distance estimation were set up through measuring minimum and maximum distances that ultrasonic signal can reach to. Distance estimations beyond the upper and the lower bounds were filtered off as errors in our scheme. With collecting distance estimation data at various locations and comparing each distance estimation with real distance respectively, we proposed an equation to compensate the deviation at each point. Equations for proposed algorithm were derived to calculate relative coordinates of a moving device. At indoor and outdoor tests, average location error and average location tracking period were 3.5 cm and 0.5 second, respectively, which outperformed Cricket location system of MIT.

• Journal of Korea Multimedia Society
• /
• v.16 no.4
• /
• pp.464-471
• /
• 2013

With the advance of wireless sensor networks, WMSN(Wireless Multimedia Sensor Networks) researches to transfers multimedia data have been studied actively. First of all, three basic protocols, End-to-end, Hop-by-hop, and Unreliable transmission method, are compared to transfer multimedia data using simulations. This paper presents an efficient protocol to transfer multimedia data by overhearing messages of nodes and by transmitting next packets during the unused time interval. The proposed method is verified its performance by simulations and experiments. The results shows that the transmission rate of the proposed method 22% higher than that of End-to-end protocol with half of transmission time. Also the performance of the proposed method is compared with that of PIGAB(Packet Interval Gap based on Adaptive Backoff).