• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.21 no.5
• /
• pp.357-370
• /
• 2009

EFDC, ESCORT and MIKE21 models are applied at the Gomso Bay to investigate each models' facilities of tidal flat simulation. Comparisons with observation data show that all models simulate hydrodynamic phenomena and tidal flat well. CPU time and WCM are examined to evaluate the efficiency of the models, and the effects of flooding/drying depth and bottom friction are examined to analyze models' facilities of simulating tidal flat. The EFDC model is considered to be fairly good in accuracy, stability and applicability, it is, however, poor in efficiency and its complexity. While the ESCORT model is superior to the EFDC in simulation of tidal flat, it is inferior to the EFDC in CPU time and simulation of bottom friction. The MIKE21 model is excellent in efficiency, but some numerical noise would be detected at low water, not permitting correction of the model.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.4 no.3
• /
• pp.146-155
• /
• 1992

It has been conventional to treat the land boundary as a fixed one in numerical modeling of tidal flows, particularly in the finite element scheme. However conventional models using the fixed land boundary result in unrealistic tidal flows in inter-tidal zones which exist over wide coastal area in Korea. In this study, a 2-dimensional hydrodynamic model, using finite element method for moving boundary problems was developed. The performance of the model was tested in a rectangular channel with an open boundary at one end and a moving boundary at the other end. The model was applied to calculate the tidal currents in Maro Hae, located in the southwestern part of Korea where wide tidal flats develop. The behavior of tidal currents in the Udolmok and near the tidal flats in the study area was satisfactory when compared with the observed data. Variation of tidal currents due to the construction of Kochunam sea-dyke which barrages large area of tidal flat was presented. The results of this study confirm the efficiency of moving boundary treatment in coastal numerical models.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.14 no.3
• /
• pp.176-183
• /
• 2011

Applicabilities of two 3-D hydrodynamic models on Chungkye Bay in which tidal flats are well developed were examined. Both EFDC model and ESCORT model with the ${\sigma}$-coordinate showed fairly good results. However, their efficiencies were lowered especially on the tidal flats due to dense vertical grids. This inefficiency could be overcome by using the z-coordinate of the ESCORT model keeping similar accuracy.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.5 no.2
• /
• pp.99-106
• /
• 1993

A two-dimensional numerical analysis is performed for the simulation of intertidal-flat and analysis of hydraulic characteristics during seadike construction in Sae-Man-Keum tidal basin. The shallow water equations are selected as a mathematical model and the Leendertse's ADI scheme is used as the corresponding numerical model. The simulated results of tide and current by the present model agree welt with the experimenta1 results by the hydraulic Lab. or ADC (1989). In the application of the model, the possibility of rapidly varied flow analysis and the introduction of turbulence model required for more accurate hydraulic calculation at closing gap are described. The successive simulation of flooding/drying effects by a modification of the method by Stelling et al. (1986) can easily be used for the intertidal-flat analysis during tidal reclamation.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.3B
• /
• pp.335-343
• /
• 2008

A hydrodynamic numerical model, ESCORT, which enables wetting-and-drying simulation, is developed. The model is verified by applying it at the Mokpo coastal zone together with the MIKE21 model. This paper deals in only 2-dimensional aspects remaining 3-dimensional function for further research. To begin with, MIKE21 model is applied at the whole area where MIKE21 had been applied several times to produce boundary conditions for the main area. Unlike the whole area of uniform grid, main area adopts telescoping grid for ESCORT model and nested grid for MIKE21 model. The results of both model show not only good agreement for the values of water depth and tidal velocity between computed and observed ones, but also plausible wetting-and-drying simulation. However, ESCORT model needs some improvement of efficiency.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.15 no.2
• /
• pp.97-107
• /
• 2003

In order to evaluate the effect of dry-wet treatment on well developed tidal flats along the complex coastal line in the western part of Korean Peninsula, we adopted a finite element tidal hydrodynamic simulation model, ADCIRC incorporating newly suggested dry-wet option and applied it to Chonbuk coastal area and Keum river estuary. Model comparison with observed current data by RMS error in the Chonbuk area shows very good agreement within 1cm/sec of tidal velocity difference and 3％ of error to maximum tidal currents. However there is not seen any significant advantages in dry-wet treatment. For the tidal volume tests in the Keum river estuary, the differences are satisfied within 5％ nevertheless of dry-wet treatment but in a near cross section it marks over 20％. However both results are almost same in tidal residual tests. Thus it can be concluded that dry-wet option is not always necessary in the simulation of long-term dispersion analysis.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.8 no.1
• /
• pp.103-113
• /
• 1996

Two-dimensional finite element hydrodynamic models for long wave simulation usually adopt fixed land boundary. However moving boundary treatment is strongly required in the simulation of tidal flats for west and south coast of Korea. In this study very efficient and realistic moving boundary treatment is applied by considering incident long wave surface slope. Developed STEP-CM (Superior Two-step Explicit Program for Coastal Modeling) ,shows numerically stable results in comparative study for idealized one-dimensional channel. Real application of the model is done for Chonsu Bay where tidal flats are distributed along the coast. Nonlinear tidal current and tidal flat effects are easily simulated in STEP-CM and resulting circulations are detected around headland of Wonsan Island.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.8 no.3
• /
• pp.134-139
• /
• 2005

The purpose of this study is to quantify the penetration behavior of spilled weathered oil and dispersed oil and to evaluate the influence of the penetrated oils on seawater infiltration in tidal flat environment. The penetration depths of the spilled oils into the tidal flat sediments were gradually deeper according to increase the stranded oil volume. The penetration depth of stranded oil were abruptly dropped at first falling tide, but were not significantly fluctuated after that. Moreover, hydrocarbon concentration was most high within the upper 2 cm. Seawater infiltration was decreased in proportion to the stranded oil volume. Dispersed oil was easily permitted the seawater infiltration than weathered oil and crude oil. Therefore, quick cleaning actions fur penetrated oil will be required far recovery of seawater infiltration, because the seawater contains oxygen and nutrients required for the survival of benthic organisms in tidal flat.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.20 no.2
• /
• pp.247-258
• /
• 2014

To evaluate the influence of the external force components on the littoral currents in the Gusipo beach, Jeonbuk, West Coast of Korea where a wide tidal sand flat developed, a coupled hydrodynamic model considered real time tidal currents and wave-induced currents was constructed in which the EFDC for tides and tidal currents, the SWAN for waves and the SHORECIRC for wave-induced currents were used as the hindcasting models. A series of field observations for tides, tidal currents and incident waves were carried out and especially to observe the littoral currents in the tidal sand flat, the GPS mounted and light weight drogues were used. Also wind data were collected from the adjacent weather station. To analyze the littoral current components, the numerical drogue tracking results considered real time winds, tides and waves were compared with the field drogue data. The drift speed of numerical drogues was reproduced as the range of 68.0~105.2% compared with the field data and the velocity error of main direction component showed a good result as -16.7~10.0%. As a result, in the mild slope tidal flat including wide surf zone, the tides and winds were the major affection component of the littoral currents, on the other hand, the wave-induced currents seemed the minor component when the incident wave heights were relatively small.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.18 no.1
• /
• pp.63-68
• /
• 2006

Time series of waterline changes during a flood/ebb cycle can be utilized for supplementary data for measuring bottom topography. The waterlines extracted from consecutive images are substituted for depth contours using water level data. The distances between contours are quantified through a rectification image process. This technique is applied to the Keunpoolan beach in the Daeijak Island near Incheon. A camera monitoring technique supported by natural water level changes produces bottom topography with high precision. It is also less time consuming and more economical. The technique also can be utilized effectively to the physical modeling f3r measuring bottom changes in the three dimensional basin.