• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.12
• /
• pp.93-102
• /
• 1998

In noisy environments, human speech productions are influenced by noises(Lombard effect), and speech signals are contaminated. These distortions dramatically reduce the performance of speech recognition systems. This paper proposes a method of the Lombard effect compensation and noise suppression in order to improve speech recognition performance in noise environments. To estimate the intensity of the Lombard effect which is a nonlinear distortion depending on the ambient noise levels, speakers, and phonetic units, we formulate the measure of the Lombard effect level based on the acoustic speech signal, and the measure is used to compensate the Lombard effect. The distortions of speech under noisy environments are cancelled out as follows. First, spectral subtraction and band-pass filtering are used to cancel out noise. Second, energy nomalization is proposed to cancel out the variation of vocal intensity by the Lombard effect. Finally, the Lombard effect level controls the transform which converts Lombard speech cepstrum to clean speech cepstrum. The proposed method was validated on 50 korean word recognition. Average recognition rates were 82.6%, 95.7%, 97.6% with the proposed method, while 46.3%, 75.5%, 87.4% without any compensation at SNR 0, 10, 20 dB, respectively.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2000.11a
• /
• pp.125-129
• /
• 2000

In this paper, We designed and fabricated C-band bandpass filter using dielectric resonators. From waveguide cutoff frequency which applied the region between adjacent dielectric resonators, the height of cavity is determined. The cavity's diameter is determined to the twice of dielectric resonator's diameter considering the conductor loss. The resonant frequency of the DR-cavity is calculated with travelling wave mode analysis. Conventionally, circular cylindrical dielectric resonator is analysed by Cohn's model which use the evanescent mode in the region between dielectric resonator wall and circular cavity wall, which is an approximated method. The external quality factor, Q$_{ex}$ has found with simulation result using Ansoft's Maxwell simulation tool. The designed filter using dielectric resonators with dielectric constant of 45 has the passband center at 5.065GHz. The bandpass filter using dielectric resonators have about 1dB insertion loss. 20MHz bandwidth and more than 30dB attenuation at f$_{0}$$\pm$15MHz.z.z.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.39 no.5
• /
• pp.243-250
• /
• 2002

In the synthesis of the current source distribution function of an array antenna with the arbitrary radiation pattern, the Woodward-Lawson sampling method has been mainly used for the synthesis of an even function lobe pattern. In this paper, the method is extended to the synthesis of the odd function pattern and then the optimum synthesis method for the nonlinear source distribution function is proposed. The proposed method is applied to the design of nonuniform transmission lines with arbitrary reflection responses. The both dispersive impedance profiles of single and coupled nonuniform lines with arbitrary reflection responses are directly synthesized by the sampled values of a reflected spectral pattern which is optimally shaped by a perturbation of its complex null positions, hence removing the conventional step-by-step segmentation process and global optimization routines. The control problem in the case that all of port impedances are identical is also solved. The generality of the proposed method is verified by a filter design with the controlled arbitrary passband

• Korean Journal of Optics and Photonics
• /
• v.14 no.1
• /
• pp.97-102
• /
• 2003

Multi-channel images of 11-MUA(11-Mercaptoundecanoic acid) and 11-MUOH(11-Mercaptoundecanol) self-assembled monolayers were obtained by using two-dimensional surface plasmon resonance (SPR) absorption. The patterning process was simplified by exploiting direct photo-oxidation of thiol bonding (photolysis) instead of conventional photolithography. Sharper images were resolved by using a white light source in combination with a narrow bandpass filter in the visible region, minimizing the diffraction patterns on the images. The line profile calibration of the image contrast caused by different resonance conditions at each point on the sensor surface (at a fixed incident angle) enables us to discriminate the monolayer thickness in nanometer scale. Furthermore, there is no signal degradation such as photo bleaching or quenching, which are common in the detection methods based on fluorescence.

• Journal of Korean Society of Steel Construction
• /
• v.18 no.6
• /
• pp.769-782
• /
• 2006

As the ambient vibration test (AVT) of railway bridges has a limited range of speed, it has a limitation in examining the dynamic behavior of bridges accordingto speed. Thus, in order to analyze the correlation between the speed of a train passing over a bridge and the bridge's dynamic response, we conducted a speed-increasing experiment using a real diesel locomotive. To analyze the acceleration response characteristics, we attached seven vertical accelerometers at equal intervals throughout the entire section of the bridge except the supports, and one horizontal accelerometer to the middle span. Linear variable differential transformers (LVDT) were installed at the bridge's center in both vertical and horizontal directions to investigate the vertical and horizontal behaviors. The test train was statically loaded at the center and at the end of the bridge. And its speed was increased from 5 km/h to 90 km/h. With data obtained from the experiment, the vibration level was evaluated in each direction by the filtering frequency, and the level of horizontal vibration was examined in comparison with vertical vibration. The displacement and wheel load variation was analyzed by speed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.3
• /
• pp.445-453
• /
• 2000

In this paper, the method of designing an active inductor for MMIC is proposed. The proposed tunable active inductor is composed of a cascade FET with feedback capacitors and resistors. Because of a very low series resistance in the proposed inductor, a very high Q factor can be obtained. Also it has an excellent characteristics suitable for high frequency band. The inductance value can be changed by controlling feedback capacitors, resistors and a bias voltage respectively. When the feedback resistor and parallel resistor within circuits are varied, the inductance value is changed from 0.2 nH to 1.7 nH in the range 1 to 15 GHz. Also we designed bandpass filter using the proposed active inductor and it shows the insertion loss of 0.4 dB and return loss, 20 dB.

• Journal of the Korean Institute of Gas
• /
• v.15 no.4
• /
• pp.51-55
• /
• 2011

This paper describes the temperature compensation algorithm using thermopile detector for nondispersive infrared methane gas sensor. From the output voltage of thermistor that is attached onto the infrared detector, the ambient temperature was extracted. The effects of temperatures on the properties of sensor module (the characteristics of narrow bandpass filter, optical cavity and infrared lamp, and gas absorption coefficient times optical path length) have been introduced in order to implement the temperature compensation algorithm. Even though the measurement error of developed sensor module was in the range of $\pm$ 1,500 ppm, after programming the temperature compensation algorithm, the developed sensor module shows a high accuracy less than +180 ppm error within $20^{\circ}C$ temperature variation.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.17 no.5
• /
• pp.22-28
• /
• 2003

This paper describes the frequency dependence of the grounding impedance. In order to propose the evaluation method of the transient response of powered grounding systems, the grounding impedances were measured with varying the frequency of incoming currents by way of the variable frequency inverter and band pass filter. The magnitude and phase of the grounding impedance were analyzed in the frequency range of 20 [Hz]∼2.1[kHz]. The grounding impedance were increased with increasing the frequency of the test current. The grounding impedance at the frequency of 2[kHz] in the actual 22.9[kV] substation grounding system was approximately 3 times as large as the 60[Hz] grounding impedance. It was found that the frequency dependence of the grounding impedance is mainly subject to the inductive reactance of the grounding conductors. As a result, it is critical to determine the shape and size of grounding grid reducing the resultant inductance in grounding systems for lightning surge protection.

• Journal of The Korean Society of Integrative Medicine
• /
• v.8 no.2
• /
• pp.131-138
• /
• 2020

Purpose : The purpose of this study was to investigate the effects of the frequency band pass filter on the P300 event-related potential in the working memory. Methods : The subjects were 20 women in their 20s who applied for participation in the experiment. Event-related potentials (ERPs) were elicited using 3-back tasks for the working memory, and were recorded from Fz, Cz, and Pz scalp electrodes. The high-pass filters were set to 0.01, 0.1, and 0.3 Hz for analysis purposes, and the low-pass filters were set to 30 and 15 Hz. The 3-back task was presented for a total of 100 times, among which 30 times were designated for the target stimulation (a matched number) and 70 times for the non-target stimulation (an unmatched number). The temporal interval between each stimulation was set at 1 second, while each time duration was randomly presented between 2 to 4 seconds. ERP were analyzed for the P300 recorded from Fz, Pz and Cz scalp electrodes. Results : Latency and amplitude had no significant interaction effects in both the high- and low-pass filters. For the main effects, the latency and amplitude of the P300 event-related potential had no significant difference in the high-pass filters, but the latency had a significant difference in the low-pass filter of Fz, and the amplitude had a significant difference in the low-pass filter of Pz. Conclusion : The results of this study showed that the less than 0.3 Hz high filters had no effects on the differences between the latency and amplitude of the P300 event-related potential in the working memory. The 30Hz low-pass filter, however, was found to be useful for recording the P300 event-related potential in the working memory.

• Journal of the Korea Society of Computer and Information
• /
• v.15 no.2
• /
• pp.109-117
• /
• 2010

Digital watermarking has drawn extensive attention for protecting digital contents from unauthorized copying. This paper proposes a new watermarking scheme in frequency domain for copyright protection of digital audio. In our proposed watermarking system, the original audio is segmented into non-overlapping frames. Watermarks are then embedded into the selected prominent peaks in the magnitude spectrum of each frame. Watermarks are extracted by performing the inverse operation of watermark embedding process. Simulation results indicate that the proposed scheme is robust against various kinds of attacks such as noise addition, cropping, resampling, re-quantization, MP3 compression, and low pass filtering. Our proposed watermarking system outperforms Cox's method in terms of imperceptibility, while keeping comparable robustness with the Cox's method. Our proposed system achieves SNR (signal-to-noise ratio) values ranging from 20 dB to 28 dB. This is in contrast to Cox's method which achieves SNR values ranging from only 14 dB to 23 dB.