• Journal of Oral Medicine and Pain
• /
• v.38 no.3
• /
• pp.235-246
• /
• 2013

Age estimations by forensic odontology play a great role in personal identification. The purpose of this study was to analyze the characteristics of age estimation cases in Korea. Surveying clients who requested age estimation at the Department of Oral Medicine, Kyungpook National University Dental Hospital from March 2012 to March 2013. The results were as follows: 1. On gender distribution, females(57.14%) were more than males(42.86%). The elderly with 50's and over 60's were majorities(89.28%) of clients, and no clients were below 40's. Most of clients were equal to and lower than elementary school graduate(69.64%). 2. The most frequent reason for age discrepancy between registered age and alleged age was mistakes by family or relatives(80.36%). The purposes of age estimation were welfare(62.50%), social relationship problem(12.50%), to find right age(10.71%), and occupation(8.93%). 3. In order of route to visit at Department of Oral Medicine, they were via government office(48.21%), acquaintances(21.43%), mass media(14.29%), and clinic(10.71%). Clients had high degree of comprehension on age estimation with forensic odontology (scored 7.03 out of 10). The 2/3 of clients were satisfied with present fee for age estimation. 4. The percentage on the proximity of estimated age to alleged age was 69.81%. 4(11.43%) clients were approved on age correction by court.

• Particle and aerosol research
• /
• v.16 no.3
• /
• pp.65-72
• /
• 2020

In this study, the indoor fine dust concentration in an office of the Korea Knowledge Industry Center was measured for about 80 hours when the concentration of atmospheric PM_2.5 was very high. The effect of the operation of the air cleaner and the forced ventilation system on the indoor PM_2.5 was investigated, and the particle size distribution of the indoor and outdoor particles was analyzed. When forced ventilator and air purifiers were partially used, the indoor PM_2.5 concentrations were maintained between 27.7 ㎍/㎥ and 32.9 ㎍/㎥ when the atmospheric PM_2.5 was 127.7 ㎍/㎥ to 141.6 ㎍/㎥ during working hours. It is more effective to operate the air purifier without operating the forced ventilation system when the concentration of the PM_2.5 is high since the PM_2.5 penetrating the installed filter is continuously introduced indoor from the outside.

• Journal of Korean Society for Geospatial Information Science
• /
• v.20 no.2
• /
• pp.15-22
• /
• 2012

The variation in the wind speed with height above ground is called the wind shear profile. In the field of wind resource assessment, analysts typically use one of two mathematical relations to characterize the measured wind shear profile: the logarithmic profile (log law) and the power law profile (power law). The logarithmic law uses the surface roughness as a parameter, and the power law uses the power law exponent as a parameter. The shape of the wind shear profile typically depends on several factors, most notably the roughness of the surrounding terrain and the stability of the atmosphere. Since the atmospheric stability changes with season, time of day, and meteorological conditions, the surface roughness and the power law exponent also tends to change in time. For this study, Using the observed data from Met-mast, located in Pyeongdae, Handong in Jeju. we used the matlab and windograper to calculate roughness length and the law exponents. These calculations are similar to reference the data, but they have different ranges. In the ocean case, each reference data and calculated data was the same, but the crop area is higher than the earlier studies. In addition, the agricultural village is lower than the earlier studies.

• Asia-Pacific Journal of Business Venturing and Entrepreneurship
• /
• v.2 no.4
• /
• pp.19-41
• /
• 2007

This research has a goal which is suggesting the way of constructing 'Cluster' which mean scheming the commencement of an enterprise in an early stage. Now it is reorganized into a IT industry structure 'Time-to market growth' is burst as a big issue. in that point, this research analyze the core success factor which is drawing from the existing IT industrial complex, and then it will be used to draw up to the 'Idealistic growth-support Cluster' on the basis of it, we pulled out various issues about the Corporate in the early stage of its growth. Therefore, this research is focused on presenting the ideal network(net) by considering the Network that organizations and business in Cluster or the network including the factors linked organizations and business in Cluster. therefore, this research carried out three big analysis. from the case investigation we pulled out the core growth factor, and then we approached the analysis of net structure for making application to Network Analysis. and then we analyzed that the characteristics of the Network after measuring by on the basis of analyzing core growth factor. and especailly, this research carried out the Core analysis for recognition of Core- support-frame by base Centrality Test on the net which is composed of growth support organizations at each Business. Judging from this, we can help to make full use of resources for the network analysis in Cluster and establish the Network Strategy by Structure comparison between the structure of industry-Cluster and ideal Business-support networks on the basis of the analysis from the Core-success-factor

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.24 no.6
• /
• pp.662-669
• /
• 2018

Recently, the installation of submarine power cables is under consideration due to the increase of electric power usage and the development of the offshore wind farm in island areas, including Jeju. In order to protect power cables installed on the seabed, it is necessary to calculate the burial depth based on the characteristics of anchoring, dragging and fishing, etc. However, there is no design standard related to the size of target ships to protect the cables in Korea. In this study, we analyzed the design standards for the protection of domestic submarine pipelines similar to submarine cables, and developed the risk matrix based on the classification by emergency anchoring considering the installation environment, then designed the size of target ships according to the cumulative function scale by ship size sailing through the sea concerned. Also, we linked marine accident conditions, such as anchoring, dragging, etc. and the environmental conditions such as current, sea-area depth of installation etc. to the criteria of the protection of submarine cable, and examined the size of specific target ships by dividing the operating environment of ships into harbor, coastal and short sea. To confirm the adequacy and availability of the size of target ships, we verified this result by applying to No. 3 submarine power cables, which is to be installed in the section from Wando to Jeju Island. This result is expected to influence in the development of a protection system for submarine cables and pipelines as well as the selection of anchor weight according to the determination of burial depth.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.10
• /
• pp.188-198
• /
• 2013

Maximally flat (MAXFLAT) half-band filters usually have wider transition band than other filters. This is due to the fact that the maximum possible number of zeros at $z={\pm}1$ is imposed, which leaves no degree of freedom, and thus no independent parameters for direct control of the frequency response. This paper describes a novel method for the design of FIR halfband filters with an explicit control of the transition-band width. The proposed method is based on a generalized Lagrange halfband polynomial (g-LHBP) with coefficients parametizing a 0-th coefficient $h_0$, and allows the frequency response of this filter type to be controllable by adjusting $h_0$. Then, $h_0$ is modeled as a steepness parameter of the transition band and this is accomplished through theoretically analyzing a polynomial recurrence relation of the g-LHBP. This method also provides explicit formulas for direct computation of design parameters related to choosing a desired filter characteristic (by trade-off between the transition-band sharpness and passband & stopband flatness). The examples are shown to provide a complete and accurate solution for the design of such filters with relatively sharper transition-band steepness than MAXFLAT half-band filters.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.44 no.5
• /
• pp.62-70
• /
• 2007

In this paper, the boost Power Factor Correction(PFC) technique for Direct Torque Control(DTC) of brushless DC motor drive in the constant torque region is implemented on a TMS320F2812DSP. Unlike conventional six-step PWM current control, by properly selecting the inverter voltage space vectors of the two-phase conduction mode from a simple look-up table at a predefined sampling time, the desired quasi-square wave current is obtained, therefore a much faster torque response is achieved compared to conventional current control. Furthermore, to eliminate the low-frequency torque oscillations caused by the non-ideal trapezoidal shape of the actual back-EMF waveform of the BLDC motor, a pre-stored back-EMF versus position look-up table is designed. The duty cycle of the boost converter is determined by a control algorithm based on the input voltage, output voltage which is the dc-link of the BLDC motor drive, and inductor current using average current control method with input voltage feed-forward compensation during each sampling period of the drive system. With the emergence of high-speed digital signal processors(DSPs), both PFC and simple DTC algorithms can be executed during a single sampling period of the BLDC motor drive. In the proposed method, since no PWM algorithm is required for DTC or BLDC motor drive, only one PWM output for the boost converter with 80 kHz switching frequency is used in a TMS320F2812 DSP. The validity and effectiveness of the proposed DTC of BLDC motor drive scheme with PFC are verified through the experimental results. The test results verify that the proposed PFC for DTC of BLDC motor drive improves power factor considerably from 0.77 to as close as 0.9997 with and without load conditions.

• Journal of the Korea Society of Computer and Information
• /
• v.17 no.7
• /
• pp.33-43
• /
• 2012

In With increase of a demand on the spatial data, the need of spatial data model which can effectively store and manege spatial objects becomes more important in many GIS applications. There are many researches on the spatial data model. Several data models were proposed for some special functions, however, there are still many problems in the management and applications. Digital Map is one of spatial data model which is being used in Korea. The existing Digital Map is based on the Tiles. This approach needs more cost in its construction and management. Therefore, in this paper, we propose a feature-based seamless data model with Digital map 2.0 which is based on Tiles. This model can be easily constructed and managed in the large databases so that it is able to apply to any systems. The proposed model uses the relationships between features to correct updated data and the Unique Feature IDentifier(UFID) also makes system to search and manage the feature data more easily and efficiently.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.21 no.2
• /
• pp.65-75
• /
• 2018

This study analyzes the characteristics of the urban landscape changes as a result of the introduction of private parks among the long-term uncollected urban planning facilities and enables the analysis of the characteristics of the urban landscape changes as a result of the introduction of private parks, and applied to the private park projects. The DSM with its building was established for the quantitative landscape analysis to examine the view ratio using the stacked visible analysis. The analysis showed that Jikdong Park had a high frequency of view from downtown to green due to its location, and that the development project of a private park on park and town boundaries significantly lowered the view ratio. This implies a large degree of damage to the landscape by development projects provided protection of the view as a natural landscape is of value. Chudong Park also saw its view ratio of views from downtown to the hills green area of Chudong Park was much lower than that of Jikdong Park. And it was confirmed that the ratio of view changes due to development projects was small compared to that of Jikdong Park. In other words, although Jikdong Park and Chu-dong Park were developed in a similar scale in terms of the ratio of views, they were subject to significant damage due to their location characteristics. It is also meaningful to note that the degree of change in the landscape resulting from development projects that could not be found in the assessment or review of the existing Landscape Impact. As private parks are introduced in the urban green belt, apartment development is being pushed for at the edge of the green belt. This study is meaningful in that it is derived based on the calculation that the survey results are derived based on the changes in the views on green areas that urban residents may experience as the private park project is carried out, and it should be introduced based on the calculation of the private parks.

• Korean Journal of Ichthyology
• /
• v.25 no.3
• /
• pp.149-156
• /
• 2013

Phylogenetic relationships and DNA polymorphism among local populations of two Korean gobiidae species: Boleophthalmus pectinirostris and Scartelaos gigas were investigated based on 12S and 16S mitochondrial DNA and mitochondrial cytochrome b DNA sequences. DNA polymorphisms of B. pectinirostris between Suncheon and Gunsan populations were 100% identity from 434 bp segment of 12S rRNA gene and from 444 bp segment of mitochondrial cytochrome b genes, and 99.6% (2 bp different) identity from 484 bp segments of 16S rRNA genes. These results indicated the long period of geographic isolation between two populations of B. pectinirostris in Korea caused such high degrees of DNA polymorphisms. Based on the phylogenetic tree constructed from the two gobiid species in Korea, two genetically distinct groups of B. pectinirostris and S. gigas groups were recognized.