• The Bulletin of The Korean Astronomical Society
• /
• v.36 no.1
• /
• pp.67.1-67.1
• /
• 2011

태양으로부터 날아오는 고에너지 하전 입자들은 인공위성이나 지구의 통신장비에 심각한 고장을 일으킬 수 있다. 이런 사고를 방지하기 위해서는 사전에 태양풍의 물리량을 알아내는 것이 중요하다. 이를 위해 inter planetary scintillation 현상을 이용하여 태양풍의 운동을 예보하는 시스템을 전파연구소와 협력하여 개발할 예정이다. 그 첫 단계로 이 시스템보다 작은 규모의 시제품을 만들어 동작을 입증하고자 한다. 이 시제품은 각각 16개의 다이폴 안테나로 구성된 타일 3개로 이루어져 있다. 다이폴 안테나들의 중심주파수는 350MHz이고, 대역폭은 약10MHz이다. 48개의 다이폴 안테나들의 총 집광면적은 약 30m2이고, 타일 내의 다이폴 안테나들을 나선형으로 배열해 grating lobe의 크기를 감소시켰다. 각 안테나에서 나오는 신호는 저 잡음의 LNA를 이용해 증폭하여 beam former로 인가된다. Beam former는 안테나에서 나오는 신호의 위상을 조절하고 합쳐서 약 15도 크기의 빔을 만들고 전자적으로 천체를 추적한다. Beam former에서 나온 신호는 수신기에서 저주파의 신호로 변환되는데, 국부발진기를 조절하여 radio frequency interference에 능동적으로 대처할 수 있도록 하였다. 수신기에서 나오는 아날로그 신호는 digitizer를 최대 107sps의 빠르기로 2바이트의 디지털 신호로 전환된다. Labview 프로그램을 사용하여 3개의 타일에서 나온 신호를 합성해서 태양 근처의 전파원을 추적하도록 하였다.

• Journal of Satellite, Information and Communications
• /
• v.12 no.2
• /
• pp.61-64
• /
• 2017

A phase shifter is one of the key components that change the phase of an individual antenna in millimeter-wave phased array system. This paper presents a low-loss phase shifter design with two parallel 2-state amplifiers. To get the same gain of $0^{\circ}/180^{\circ}$ each state, delay lines are in the middle of each stage of the 2-Stage amplifiers. Normally, when adding AMPs in parallel, a power combiner/divider such as Wilkinson Power Combiner/Divider is added, but they are directly connected because it can cause added losses in silicon wafer. The measured data shows 12dB gain and 174-degree phase difference at 5GHz.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.10
• /
• pp.885-892
• /
• 2013

The main advantage of ESPAR antenna is that ESPAR antenna requires only a single RF chain for reduction of transceiver's hardware complexity, as compared to conventional MIMO system. In conventional MIMO system, each data symbol is mapped to each antenna. But, each data symbol is mapped to each orthogonal basis pattern in ESPAR antenna system. In this paper, we design beamspace MIMO system using ESPAR antenna with single RF chain for MIMO system of low-complexity and low power consumption. And then, we analyze performance of beamspace MIMO according to each PSK modulation. Performance of beamspace MIMO system is similar to performance of conventional MIMO system. As a result of analyzing the performance of beamspace MIMO system using higher-order PSK modulation. we can confirm that performance characteristic of beamspace MIMO system with low complexity and low power consumption is similar to digital communication of signal domain.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.21 no.1
• /
• pp.61-68
• /
• 2018

In this paper, we described about methods and results to verify the Tx/Rx beam characteristics of a planar active phased array antenna as using a near-field measurement. The near-field system can effectively measure multiple beams and predict the performance degradation due to the partial failure of individual elements. Also, it can accurately predict the EIRP relating to detection performance of the active phased array radar. We briefly described the near-field measurement method to verify the Tx/Rx beam characteristics, and then verified the effectiveness of measurement method by analyzing the measured results.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.10
• /
• pp.1188-1195
• /
• 2012

The trend for the development of radar is the active phased-array radar system. The trade-off between the processing speed and the number of the signal process board for the real time signal processing has to be optimized particularly in multichannel radar system. This paper introduces a transmission technique in order to transmit a large amount of received data from an Antenna Part to Signal Process Part. As a result, the number of the S/L board(COTS board) is reduced to one half, and the margin of the data transmission rate is about 2 times higher than the original method.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.5 s.108
• /
• pp.461-475
• /
• 2006

In this paper, it is described about the tri-band mobile antenna system design to provide broadband multimedia and direct broadcasting services using goo-stationary Koreasat 3, simultaneously operated in Ka/K/Ku band. The radiating part of the antenna system with a fan beam characteristic in the elevation plane is composed of the quasi-offset dual shaped reflector and the tri-band feeder. The tri-band feeder is also composed of the Ka/K dual band feeder with the protruding dielectric rod, the circular polarizer, the ortho-mode transducer and the circular-polarized Ku band feed array. Especially, the Ka/K dual band circular polarizer was realized firstly using the comb-type structure. For fast satellite-tracking on the movement, the Ku band feed array has the structure of the $2{\times}2$ active phased array which can make electrical beams. And, the circular-polarized characteristic in the feed array was improved by $90^{\circ}$ rotating arrangement of four radiating elements polarized circularly by a $90^{\circ}$ hybrid coupler, respectively. Four beam forming channels to make electrical beams at Ku band are divided into the main beam channel and the tracking beam channel in the output, and noise temperature characteristics of each channel were analyzed on the basis of the contributions of internal sub_units. From the fabricated antenna system, the output power at $P_{1dBc}$ of Ka_Tx channel was measured more than 34.1 dBm and the measured noise figures of K/Ku_Rx channels were less than 2.4 dB and 1.5 dB, respectively, over the operating band. The radiation patterns with co- and cross-polarization in the tri-band were measured using a near-field measurement in the anechoic chamber. Especially, Ku radiation patterns were measured after correcting each initial phase of active channels with partial radiation patterns obtained from the independent excitation of each channel. The antenna gains measured in Ka/K/Ku band of the antenna system were more than 39.6 dBi, 37.5 dBi, 29.6 dBi, respectively. And, the antenna system showed good system performances such as Ka_Tx EIRP more than 43.7 dBW and K/Ku_Rx G/T more than 13.2 dB/K and 7.12 dB/K, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.12
• /
• pp.1380-1393
• /
• 2010

This paper presents a design, fabrication and the test results of planar active electronically scanned array(AESA) radar prototype for airborne fighter applications using transmit/receive(T/R) module hybrid technology. LIG Nex1 developed a AESA radar prototype to obtain key technologies for airborne fighter's radar. The AESA radar prototype consists of a radiating array, T/R modules, a RF manifold, distributed power supplies, beam controllers, compact receivers with ADC(Analog-to-Digital Converter), a liquid-cooling unit, and an appropriate structure. The AESA antenna has a 590 mm-diameter, active-element area capable of containing 536 T/R modules. Each module is located to provide a triangle grid with $14.7\;mm{\times}19.5\;mm$ spacing among T/R modules. The array dissipates 1,554 watts, with a DC input of 2,310 watts when operated at the maximum transmit duty factor. The AESA radar prototype was tested on near-field chamber and the results become equal in expected beam pattern, providing the accurate and flexible control of antenna beam steering and beam shaping.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.9
• /
• pp.907-915
• /
• 2002

In this paper, a compact digital phase shifter to be used an active phased array antenna system for satellite communications was proposed. The even and odd mode analysis for a given reflection-type phase shifter, which uses a folded hybrid coupler as a base element, was performed and the design parameters were derived. Also, to verify experimentally the electrical performances of the proposed structure, X-band 4-bit digital phase shifter was designed and fabricated using Teflon soft substrate $({\varepsilon}_r; =\;2.17)$. Its circuit size was less than 3.5 cm $\times$ 3.0 cm, and it exhibited at least 50 % size reduction as compared with the conventional unfolded configuration. The experimental results of the fabricated phase shifter showed that the average insertion loss and insertion loss variation were less than 3.5 dB, $\pm$ 0.6 dB within the operating band, 7.9 ~ 8.4 GHz, respectively. And, input and output return loss were more than 10 dB, respectively. Also, the phase response of the phase shifter showed 4-bit operation with $\pm$3$^{\circ}$ rms phase error.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.2
• /
• pp.167-173
• /
• 2009

This paper proposes an electronically beam steering array antenna, consisting of single fed active element and 4 parasitic elements, operating in 5.8 GHz ISM band. Beam steering can be achieved by controlling the reactance of the variable reactance control circuit connected to the load of the parasitic elements without using the high cost phase shifters. The proposed antenna realizes ${\pm}30^{\circ}$ beam scanning of E-plane and H-plane with the below -10 dB return loss in ISM band. The gain of the $6.18{\sim}7.53\;dBi$ in E-plane and $7.022{\sim}7.779\;dBi$ in H-plane is shown in the scanning range.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.3
• /
• pp.175-181
• /
• 2004

In order to increase the coupling efficiency of the Power and Phase of the active Phase way antenna, we have fabricated the active phased-array antenna which is coupled by the transmission line, and investigated the relationship between the length of the coupling transmission line and coupling power and phase. The following three types of driving method -(1) giving the frequency difference between the two active antenna, (2) applying the input signal to the one side of the two antennas, and changing the eigen frequency of the other side antenna, (3) appling the different phase inputs to the active antennas was investigated. The experimental results showed that the interval of the antenna elements has not affected the power and the phase of the antenna.