• Environmental engineer
• /
• v.22 s.232
• /
• pp.76-77
• /
• 2005

공장내 황산출하장에서 황산저장탱크(7,500톤)에서 로딩탱크로 황산을 이송작업을 하던 중 황산이 로딩탱크 상부로 흘러넘쳐 방유제 내부로 누출되어 다음날 방유제 내부로 누출된 황산을 다시 로딩탱크로 이송하기 위해 이동용 펌프로 이송하던 중 호스연결부위에서 황산이 비산되면서 화상을 입고 사망한 재해임

• Journal of the Korea Concrete Institute
• /
• v.27 no.4
• /
• pp.443-450
• /
• 2015

This paper presents an investigation of the mechanical and microstructural properties of Class F fly ash based geopolymer containing sodium sulfate as an additive. Sodium sulfate was used as an chemical additive at the dosage levels of 0, 2, 4, and 6wt% of fly ash. Sodium hydroxide and sodium silicate solutions were used to activate fly ash. The compressive strengths of geopolymer pastes were measured at the age of 28 days. The microstructures of the geopolymer pastes were examined using XRD, MIP and SEM tests. The additions of 2wt% and 4wt% sodium sulfate produced geopolymers with high strength, while increasing the dosage of levels to 6% resulted in almost no changes in strength, comparing with the control geopolymer. The optimum increase in strength was obtained with the addition of 4wt% sodium sulfate. As the amount of sodium sulfate is increased, no additional crystalline phase was detected and no change of amorphous phase indicated despite the change in the strength development. The increase in the strength was due to the change of pore size distribution in samples. As addition of sodium sulfate altered the morphologies of reactive productions and Si/Al ratios of the reaction products, the strengths were thus affected. It was found that the strengths of geopolymer were larger for lower Si/Al ratios of reaction products formed in samples. The optimal amount of sodium sulfate in the fly ash based geopolymer helps to improve mechanical properties of the geopolymer, on the other hand, the high percentage of sodium sulfate could exist as an impurity in the geopolymer and hinder the geopolymer reaction.

• Korean Journal of Environmental Agriculture
• /
• v.17 no.1
• /
• pp.11-15
• /
• 1998

Carbofuran was incubated for four weeks in five types of paddy soil samples at $25^{\circ}C$. The soil samples prepared in the study were as follows : control soil, sterilized soil, 10% cellulose added soil, 10% cellulose and 1% ferrous sulfate added soil, and 10% cellulose and 1% magnesium sulfate added soil. The degradation rate of carbofuran was significantly decreased(p<0.05) in sterilized soil.The degradation rate of carbofuran was significantly decreased by addition of cellulose(p<0.05) in femous sulfate added soil and magnesium sulfate added soil(p<0.01).

• Journal of Bio-Environment Control
• /
• v.7 no.1
• /
• pp.55-61
• /
• 1998

This experiment was conducted to evaluate the effects of sulfate ion concentration in nutrient solution on the growth and qualify of Mongolian wormwood (Artemisia mongolica var. tenuifolia). Sulfate ion concentration was treated 0, 0.5, 1, 2 and 3mM using the modified nutrient solution composition for herb plants developed by European Vegetable R & D Center in Belgium. The growth of Mongolian wormwood was good at 3mM treatment and dry weight was best at 3mM treatment, Chlorophyll content increased with sulfate ion concentration. Mineral content did not show any significant difference among treatments. But Ca content in tissue markedly decreased at 3mM treatment. Sulfate ion uptake increased in proportion to sulfate ion concentration in nutreint solution, the higher sulfate ion concentration, the more uptake of sulfate ion by plant. At 1mM sulfate ion treatment, essential oil content was best, but the higher sulfate ion concentration resulted in decrease of essential oil content.

• Applied Chemistry for Engineering
• /
• v.9 no.4
• /
• pp.463-468
• /
• 1998

When sulfuric acid was added in HCl etching solution, corrosion of aluminum metal was inhibited by the chemical adsorption of sulfate ions. In the presence of $SO_4^{-2}$, cyclic voltammetry showed that the protective oxide film was formed on the inner surfaces of etch pits and, pit density was increased by nucleation on both the aluminum surface and the pits inside. Structure and distribution of etch pits found in AC etching of aluminum were strongly influenced by the concentration of $SO_4^{-2}$ and the amount of cathodic pulse charging. Below $0.8mC/cm^2$ of cathodic pulse charging, oxide films formed inside actively dissolving pits indicated the higher resistance to pit nucleation as the concentration of $SO_4^{-2}$ increases. However, the structural change of oxide films occurred above the $0.8mC/cm^2$ charging and the effect of $SO_4^{-2}$ was minimized, and it resulted in the rapid formation of etch pits.

• Proceedings of the Korean Society of Fisheries Technology Conference
• /
• 2001.10a
• /
• pp.165-166
• /
• 2001

콘드로이틴황산은 생물체내의 결합조직에 널리 분포되어 있으며 뮤코다당류의 일종으로 생체내에서는 단백질과 결합하여 chondromucoprotein으로 존재한다. 또한, 황산기의 결합위치에 따라 A, B, C, D, E, K의 6종류가 보고되어져 있으며, 이 중 연골에는 A와 C가, 피부에는 B가 함유되어져 있다. 콘드로이틴황산은 퇴행성관절염 예방 및 치료와 노화방지, 항종양등의 기능성이 밝혀져 식품첨가물 및 의약품으로써 이용되고 있다. (중략)

• Economic and Environmental Geology
• /
• v.42 no.5
• /
• pp.445-455
• /
• 2009

Microbiological sulfate reduction is the transformation of sulfate to sulfide catalyzed by the activity of sulfate-reducing bacteria using sulfate as an electron acceptor. Low solubility of metal sulfides leads to precipitation of the sulfides in solution. The effects of microbiological sulfate reduction on in-situ precipitation of arsenic and copper were investigated for the heavy metal-contaminated soil around the Songcheon Au-Ag mine site. Total concentrations of As, Cu, and Pb were 1,311 mg/kg, 146 mg/kg, and 294 mg/kg, respectively, after aqua regia digestion. In batch-type experiments, indigenous sulfate-reducing bacteria rapidly decreased sulfate concentration and redox potential and led to substantial removal of dissolved As and Cu from solution. Optimal concentrations of carbon source and sulfate for effective microbial sulfate reduction were 0.2~0.5% (w/v) and 100~200 mg/L, respectively. More than 98% of injected As and Cu were removed in the effluents from both microbial and chemical columns designed for metal sulfides to be precipitated. However, after the injection of oxygen-rich solution, the microbial column showed the enhanced long-term stability of in-situ precipitated metals when compared with the chemical column which showed immediate increase in dissolved As and Cu due to oxidative dissolution of the sulfides. Black precipitates formed in the microbial column during the experiments and were identified as iron sulfide and copper sulfide. Arsenic was observed to be adsorbed on surface of iron sulfide precipitate.

• Korean Journal of Agricultural Science
• /
• v.27 no.2
• /
• pp.135-140
• /
• 2000

The mobility of sulfate in soils defends on several factors including redox potential, soil mineralogy, pH, and the presence of other anions that compete for sorption sites with sulfate. The proposed model of adsorption mechanism for sulfate postulated that reaction is between anions in solution and charged surfaces of soil particles. With appropriate choice of parameters obtained from the adsorption-desorption experiments, the equation of transport model adapt an empirical approach, capable of handling most general equilibrium adsorption isotherms, suitable for multispecies systems.

• Journal of the Mineralogical Society of Korea
• /
• v.23 no.4
• /
• pp.395-402
• /
• 2010

Mineralogical characterization was performed for the mineral assemblages precipitated at the boundary between limestone bedrock and bat guano deposits in the Gossi Cave, Korea. Francoanellite, taranakite, ardealite, brushite and monetite are observed as phosphate minerals and gypsum and a small amount of barite as sulfate minerals in the guano deposits. With the increase of depth, phosphates are changed as following sequence: taranakite ${\rightarrow}$ francoanellite ${\rightarrow}$ ardealite ${\rightarrow}$ brushite ${\rightarrow}$ monetite. This sequence indicates that the major parameters controlling the physico-chemical conditions under which these mineral assemblages were deposited are pH and relative humidity.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.06a
• /
• pp.373-376
• /
• 2006

본 연구의 목적은 동해 울릉분지의 제4기 후기 퇴적물 내의 유기물, 공극수와 메탄의 특징 및 상호작용을 규명하는데 있다. 연구지역에서 채취한 코어퇴적물을 원소 분석한 결과 C/N 및 C/S 비(wt. %)는 퇴적물 내 유기물이 주로 해양조류 기원을 가지고, 일반적인 해양 또는 정체 환경에서 퇴적되어Tdam을 지시한다. 그러나 Rock-Eval 열분석 결과는 유기물 기원이 육상식물(Type III)이고, 열적 성숙단계가 미성숙단계임을 보여준다. 이러한 원소분석과 열분석간의 상반된 결과는 유기물이 침강하는 동안 또는 퇴적 후 이루어진 강한 산화작용에 기인한 것으로 추정된다. 퇴적물 내 공극수의 황산염 농도가 퇴적물의 심도가 증가할수록 감소하며, 감소하는 경향은 크게 두 가지 (적선성, concave down)로 나누어진다. 이는 모든 코어에서 황산엽 환원작용이 일어나고 있음을 지시한다. 또한 직선선의 황산엽농도 구배는 무산소 메탄 산화작용(AMO)의 전형적인 특징이다. 황산염 농도의 수직적 구배를 이용하여 SMI(sulfate-methane interface) 심도를 계산하면, 남부울릉분지의 코어 (03GHP-01, 03GHP-02; <3.5mbsf)가 북부울릉분지 코어(01GHP-05, 01GHP-07, 03GHP-03, 03GHP-04, 03GHP-05; > 6mbsf)보다 낮은 값을 갖는다. 위와 같은 SMI 심도차는 메탄의 상부 분산량과 밀접한 관련있는 것으로 추정된다. 메탄가스의 탄소 안정동위원소 $({\delta}^{13}C)$ 분석값들은 -83.5%o에서 -69.5%o의 범위를 가지고 있고, 이산화탄소 환원작용($CO)_2$ reduction)에 의한 생물 (biogenic) 기원임을 지시한다.