• Korean Journal of Construction Engineering and Management
• /
• v.20 no.2
• /
• pp.28-36
• /
• 2019

The APR1400 (Advanced Power Reactor 1400MW) nuclear power plant is a large-scale national infrastructure facility with a total project cost of 8.6 trillion won and a project period of 10 years or more. The total project area is about 2.17 million square meters and consists of more than 20 buildings and structures. And the total number of drawings required for construction is about 65,000. In order to design such a large facility, it is important to establish a design standard that reflects the design intent and can increase conformity between documents (drawings). To this end, a design bases document (DBD) reflecting the design bases that extracted in regulatory requirements (e.g. 10CFR50, Korean Law, etc.) is created. However, although the design bases are important concepts that are a big framework for the whole design of the nuclear power plant, they are managed in 2-dimensional by the experts in each field fragmentarily. Therefore, in order to improve the usability of building information, we developed BIM(Building Information Model) based 3-dimensional design bases management system. For this purpose, the concept of design bases information layer (DBIL) was introduced. Through the simulation of developed system, design bases attribute and element data extraction for each DBIL was confirmed, and walls, floors, doors, and penetrations with DBIL were successfully extracted.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.17 no.1
• /
• pp.37-46
• /
• 2019

As candidates for accident-tolerant fuels, ceramic microcell fuels, which are distinguished by their peculiar microstructures, are being developed; these fuels have $UO_2$ grains surrounded by cell walls. They contribute to nuclear fuel safety by retention of fission products within the $UO_2$ pellet, reducing rod pressure and incidence of SCC failure. Cesium, a hazardous fission product in terms of amount and radioactivity, can be captured by chemical reactions with ceramic cell materials. The capture-ability of cesium therefore depends on the thermodynamics of the capturing reaction. Conversely, compositional design of cell materials should be based on thermodynamic predictions. This study proposes thermodynamic calculations to evaluate the cesium capture-ability of three ceramic microcell compositions: Si-Ti-O, Si-Cr-O and Si-Al-O. Prior to the calculations, the chemical and physical states of the cesium and the cell materials were defined. Then, the reactivity was evaluated by calculating the cesium potential (${\Delta}G_{Cs}$) and oxygen potential (${\Delta}G_{O_2}$) under simulated LWR circumstances of normal operation. Based on the results, cesium capture is expected to be spontaneous in all cell compositions, providing a basis for the compositional design of ceramic microcell fuels as well as a facile way for evaluating cesium capture.

• Journal of the Korea Society of Computer and Information
• /
• v.27 no.5
• /
• pp.1-9
• /
• 2022

Localization systems can be used with various circumstances like measuring population movement and rescue technology, even in security technology (like infiltration detection system). Vision sensors such as camera often used for localization is susceptible with light and temperature, and can cause invasion of privacy. In this paper, we used ultra-wideband radar technology (which is not limited by aforementioned problems) and machine learning techniques to measure the number and location of occupants in other indoor spaces behind the wall. We used four different algorithms and compared their results, including extremely randomized tree for four different situations; detect the number of occupants in a classroom, split the classroom into 28 locations and check the position of occupant, select one out of the 28 locations, divide it into 16 fine-grained locations, and check the position of occupant, and checking the positions of two occupants (existing in different locations). Overall, four algorithms showed good results and we verified that detecting the number and location of occupants are possible with high accuracy using machine learning. Also we have considered the possibility of service expansion using the oneM2M standard platform and expect to develop more service and products if this technology is used in various fields.

• Journal of the Korean Wood Science and Technology
• /
• v.32 no.1
• /
• pp.35-44
• /
• 2004

The water soluble fractions(WSF) from Japanese larch wood were isolated, purified by anion exchange resin and Sephadex gel filtration and identified its chemical structure by means of periodate oxidation and methylation reactions. Its major components are arabinose and galactose (1 : 3.4). Based on the results of periodate oxidation, methylation and gas chromatographic analysis of purified WSF, main chain is composed of β-1,3-glycosidic linkage among D-galactopyranoses, and two different side chains; β-1,6-glycosidic linkage among 2-3 units of D-galactopyranoses and β-1,6-glycosidic linkage between 1-2 units of D-galactopyranose and L-arabinopyranose. Addition of WSF to culture media of oak mushroom (Lentinula edodes) accelerated the mycelial growth. In the case of PDA cultures, 2 percent addition of WSF in Sanlim No. 6 strain and 4 percent of WSF in Mok-H strain mostly enhanced the mycelial growth of the mushroom. In the case of sawdust cultures, 4 percent addition of WSF in two strains showed the best mycelial growth. High percentages addition of WSF inhibited mycelial growth of the mushroom. Mushroom production was increased with addition of WSF. By the addition of WSF, ergosterol contents in the media were quite high at the colonized stage and rapidly increased at the fruiting stage. Therefore the ergosterol content could be utilized as an indicator to evaluate the culture maturity for the mushroom fruiting.

• Conservation Science in Museum
• /
• v.28
• /
• pp.35-50
• /
• 2022

This study explores the results of the research and conservation treatment conducted on two-peony paintings in the collection of the National Museum of Korea. The Jang-ji(障子) resembles a folding screen, but differs in size, shape, and use. A thick sheet of paper was used to attach the paintings to a wall, and traces of the lattice frame and red pigments, which was mainly used for building structures, remain on the back of the paper. It is confirmed that the paper was used as Jang-ji(障子) attached to adorn the walls or doors of a building and specifically decorated the interior of Seonwonjeon Hall in Gyeongbokgung Palace, which was removed in 1867. The paper also indicates that the mounting was made in the 19^th-century Joseon Dynasty, as the peony painting was finished in a different color from Jang-ji(障子) used for the Seonwonjeon Hall in Changdeokgung Palace. Based on the analysis of pigments and literature research, this study attempts to take a new approach to the colored pigments used in royal peony paintings, and it is believed that the conservation treatment used in this study highlights the necessity of continuous research on wallpaper as reference materials for royal paintings of the Joseon Dynasty.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.8
• /
• pp.119-127
• /
• 2006

Granulated Blast Furnace Slag (GBFS) is produced in the manufacture process of pig-iron and shows a similar particle formation to that of natural sea sand and also shows light weight, high shear strength, well permeability, and especially has a latent hydraulic property by which GBFS is solidified with time. Therefore, when GBFS is used as a backfill material of quay or retaining walls, the increase of shear strength induced by the hardening is presumed to reduce the earth pressure and consequently the construction cost of harbor structures decreases. In this study, using the model sand box (50 cm$\times$50 cm$\times$100 cm), the model wall tests were carried out on GBFS and Toyoura standard sand, in which the resultant earth pressure, a wall friction and the earth pressure distribution at the movable wall surface were measured. In the tests, the relative density was set as Dr=25, 55 and 70% and the wall was rotated at the bottom to the active earth pressure side and followed by the passive side. The maximum horizontal displacement at the top of the wall was set as ${\pm}2mm$. By these model test results, it is clarified that the resultant earth pressure obtained by using GBFS is smaller than that of Toyoura sand, especially in the active-earth pressure.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.11 no.2
• /
• pp.130-137
• /
• 2023

This study analyzed the effect of mixing order on the flowability, compressive strength, and flexural strength of cement composites reinforced with polyvinyl alcohol(PVA) fibers and multi-walled carbon nanotubes(MWCNTs). The experimental results showed that the addition of CNTs significantly reduced the flowability, and the flowability was considerably affected by the mixing order when CNTs were added. The compressive strength was most effectively improved when water and CNTs solution were mixed first before adding PVA fibers, and the flexural strength was highest when water and CNTs solution were mixed with PVA fibers after dry mixing. However, there was no clear correlation between the flexural toughness and the mixing order. In addition, scanning electron microscopy(SEM) image analysis was conducted to analyze the microstructure. The SEM images showed that CNTs were randomly dispersed through the specimens and contributed to the strength improvement, but the effect of the mixing order was not clearly observed. The main results of this study are expected to be useful for evaluations of workability and material performance of PVA fiber-reinforced cement composites with CNTs.

• Korean Journal of Plant Taxonomy
• /
• v.31 no.3
• /
• pp.267-282
• /
• 2001

To examine the leaf epidermal microstructure of three genera (Scopolia s.s., Anisodus, AtroPanthe, including Przewalskia as an outgroup) in the genera Scopolia Jacq. s.l., leaves of 10 species (37 specimens) were investigated by the light microscopy (LM) and scanning electron microscopy (SEM). The stomata of studied taxa were 'amphistomatic type' and the size (guard cell) range was $18-64{\times}11-48{\mu}m$. The size of stomata is slightly differed from between the taxa; the smallest size of stomata were found in the monotypic genus, Przewalskia ($24-27{\times}16-17{\mu}m$), on the other hand the largest one was found in Anisodus carniolicoides ($62-64{\times}43-48{\mu}m$). The stomatal complex was mostly anomocytic (in Scopolia s.s., Anisodus taxa : A. luridus, A. carniolicoides, A. acutangulus) and sometimes anisocytic (in Anisodus tanguticus, Przewalskia, Atropanthe). The stomata is mostly crescent in shape, but rarely circular, especially in Przewalskia tangutica. The shapes of epidermal cells are similar in both adaxial and abaxial sides, and mostly undulate/sinuate polygonal anticlinal wall, but rarely arched in Przewalskia tangutica. The epicuticular wax was not well developed in most studied taxa, except Anisodus tanguticus which is well developed cuticular striae around the stomatal complex. The elongate-headed glandular trichomes were found in Scopolia s.s. and Przewalskia. While the taxa of Anisodus and Atropanthe have not any trichomes (i. e., glabrous), except Anisodus luridus, which has simple or sometimes branched (dendritic- type) non-glandular trichome. Finally, the systematic and ecological significance of the leaf micromorphological features (stomata complex, trichome, etc.) in identification and elucidation of Scopolia s.l. including Przewalskia, especially between or within the genera including among the species is also discussed.

• Investigative Magnetic Resonance Imaging
• /
• v.15 no.2
• /
• pp.146-153
• /
• 2011

Purpose : To describe normal anatomy and compare the differences of external genital organs and urethra on MR imaging in pre- and postmenopausal women. Materials and Methods : A total of 19 pre- and 18 postmenopausal healthy women underwent pelvis MR imaging at 1.5 T. Two radiologists retrospectively scored and compared the image quality of female external genitalia and urethra on axial T2-weighted images (T2WI) and axial fat-suppressed contrast-enhanced T1-weighted images (FSCE-T1WI) by using Wilcoxon signed ranks test. The radiologists compared the wall thickness or size of external genital organs and urethra on FSCE-T1WI between two groups by using Student t test. Results : Image quality was better with FSCE-T1WI than with T2WI in all subjects (p < 0.05). The vestibular bulb, clitoris and labium minor were more clearly visualized on FSCE-T1WI in premenopausal subjects rather than in postmenopausal subjects (p < 0.05). The urethra had a target-like appearance with three layers in premenopausal and postmenopausal subjects. Postmenopausal subjects were observed to have significantly smaller vaginal wall thickness, urethral wall thickness and vestibular bulb width than premenopausal subjects (p < 0.05). Conclusion : The anatomy and morphologic changes of female external genital organs and urethra were well discernible on FSCE-T1WI.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.30 no.4 s.48
• /
• pp.533-541
• /
• 2004

Atopic dermatitis, also called congenital fever, is a allergic eczema of chronic itching disease. It is a recurrent and familial disease and appears on a wide age group from infant to adult. It is very common, and the ratio of occurrence is about $9{\~}l2\%$ of a child. However. it is showing trend of continuous increase by social and natural environment, food culture, and life style, recently. The human skin plays a barrier role against a physical and chemical stimulus from external environment. According to the latest study, the decreased amount of ceramide in horny layer impairs the bier function and moisture-maintaining function of skin in atopic dematitis patient. Ceramide is a kind of the sphingolipid in which a fatty acid is connected to sphingosin. Ceramide constitutes about $40\%$ of total lipid between keratinocytes and has the function of defense wall and building regular structure to suppress moisture vaporization in horny layer. In horny layer of skin a comified cell is composed of multi-layer structure of a brick shape, and, as for this cornified cell, it is strongly connected by ceramide, cholesterol, and free fatty acid. Here, we described the effects of a cream containing ceramide on the recovery of skin harrier function of atopic dermatitis patient. The safety and efficacy of latex and liquid formula were evaluated as cosmetics for atopic dermatitis. The latex products was composed of intercellular lipid components-ceramide, cholesterol, and free fatty acid-to restore skin barrier function in atopic dermatitis patients. The liquid one contained beta-glucan, magnolia extracts, and licolice extracts, which have skin immunomodulatory and anti-inflammatory effects. It is also confirmed that their possibility on new cosmetic market of atopic dermatitis.