• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.5A
• /
• pp.317-325
• /
• 2012

In this study, to evaluate the shrinkage behavior of ultra high performance fiber reinforced concrete (UHPFRC) under restrained condition, restrained shrinkage test was performed according to ring-test mostly used at home and abroad. Ring-test was performed with the various thicknesses and radii of inner steel ring to give different degree of restraint. Free shrinkage and tensile tests were carried out simultaneously to estimate the degree of restraint, stress relaxation, and shrinkage cracking potential. Test results indicated that the average steel strain and residual tensile stress were reduced as the thicker inner steel ring was used, whereas degree of restraint was increased. The steel strain, residual tensile stress and degree of restraint were hardly affected by the size of radius of inner ring. In the case of all ring specimens, shrinkage crack did not occur because the residual tensile stress was lower than the tensile strength. About 39~65% of the elastic shrinkage stress was relaxed by the sustained interface pressure, and the maximum relaxed stress was increased as the thicker inner ring was applied. Finally, the degree of restraint with age was predicted by performing non-linear regression analysis, and it was in good agreement with the test results.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.11a
• /
• pp.581-584
• /
• 2008

In this study, it is willing to present that fundamental data for proposing quantitatively shrinkage cracking evaluation method such as plat-ring type restrained test method. To examine suitable size of specimen of plat-ring type restrained test method, Evaluated concrete about restrained shrinkage crack properties of numerical analysis of 3D solid element using the MIDAS program, drying shrinkage deformation, restrained shrinkage stress, crack area and crack point with inside ring diameter of specimen in 100mm, 150mm, 200mm and high of Specimen in 30mm, 50mm after curing in condition of constant temperature and usual habit of temperature 20${\pm}$3$^{\circ}$C, humidity 60${\pm}$5%. As a result, it was available about suitable estimation with inside ring diameter of specimen in more than 150mm and high of Specimen in 50mm. Hereafter, it is considered that the study concerning environmental condition and mixing factor in plat-ring type restrained test method is need.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2009.05a
• /
• pp.349-352
• /
• 2009

최근 유비쿼터스 헬스케어가 부각됨에 따라 심장의 활동상태를 보다 편리하게 측정하기 위하여 이동성 및 휴대성을 강조한 심전도 계측 시스템 및 스트레스 상태를 분석하기 위한 연구들이 수행되고 있다. 하지만 기존 심전도 계측은 전극의 부착 및 계측시스템과의 연결을 위한 리드선의 사용으로 인해 활동의 불편함을 유발한다. 본 연구에서는 기 연구 수행된 가정 또는 사무실에서 무구속적인(unconstrained) 방법으로 지속적인 심장의 활동상태의 모니터링이 가능한 무구속 의자형 심탄도 계측 시스템을 구현하였다. 무구속적인 방법으로 심탄도 신호를 계측하고 심탄도신호로부터 심박동변이율을 추출함으로써 일상생활 중 스트레스를 모니터링 하고자 하였다. 구현된 시스템을 통한 스트레스 모니터링의 가능성을 평가하기위하여 안정상태의 심박동변이율과 인위적인 신체적 스트레스인 Valsalva 조작를 유도한 후 심박동 변이율을 비교평가 하였다. 건강한 대학생 10명을 대상으로 비교분석을 수행한 결과 안정 상태와 육체적 스트레스 인가 후 심박동 변이율의 변화 양상을 관찰할 수 있었으며, 무구속적인 방법에 의해 스트레스의 모니터링이 가능함을 확인 할 수 있었다.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.821-824
• /
• 2008

In this study, it is willing to present that fundamental data for proposing quantitatively shrinkage cracking evaluation method such as plat-ring type restrained test method. It is possible to decide that specimen diameter is s 150mm with evaluating restrained shrinkage crack properties of concrete according to change of ring diameter in specimen. Also, effectiveness of test method according to mixing of PVA fiber is evaluated as part of a repeatability verification experiment of plat-ring type restrained test method using ring which diameter is 150mm. As a result, it is possible to measure the crack due to the plastic shrinkage which was occurred within 48hours at early age with plat-ring type restrained test method. Hereafter, it is considered that the study concerning environmental condition and mixing factor in plat-ring type restrained test method is need.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.5
• /
• pp.39-52
• /
• 2013

The shear stress characteristics of landslide materials can be affected by various factors. We examined the shear stress characteristics of two different soils using ring-shear apparatus, in which saturation-consolidation-shearing speed can be easily controlled. This paper presents (i) shear stress-time characteristics, (ii) shear stress depending on normal stress and shear speed and (iii) shear stress as a function of shearing speed. Materials used in this paper were the Nakdong River sand and muds taken from Jinhae coastal area in Korea. Samples were prepared in three types: Sand (upper)-Sand (lower), Clay (upper)-Clay (lower) and Sand (upper)-Clay (lower). The upper and lower indicate the samples placed in upper and lower ring shear boxes, respectively. For given normal stresses (50 and 100 kPa) and shearing speed (0.1 mm/sec), we performed ring shear tests. Then the failure lines were determined in the second test. Last, we determined the shear stress characteristics depending on different shearing speeds, such as 0.01, 0.1, 1, 10, 100 mm/sec. As a result, we found that shear stress characteristics are strongly dependent on above three factors. The shear stress of Sand (upper)-Clay (lower) is smaller than that of Sand (upper)-Sand (lower), but slightly larger than that of Clay (upper)-Clay (lower). The shear stress is also characterized by grain crushing and wetting process at slip surface.

• Journal of the Institute of Convergence Signal Processing
• /
• v.16 no.2
• /
• pp.56-62
• /
• 2015

In this study, we implemented an unconstraint ECG monitoring system on a chair. Nowadays, modern people spend most of their time sitting on the chair. Therefore, it is necessary to have an unconstraint ECG monitoring system that can be used for a long time. The implemented system can perform measurement even with clothes on and it has great advantage on motion artifacts. A pair of unconstraint electrodes are placed on the back of the chair. Amplifier and filters are designed to remove motion artifacts, The baseline noise and power line noise are filtered and very low level of bio-signal is amplified to give a final measurement. Control unit and wireless transmission unit are implemented. Analog signal is converted into digital signal and transmits biological signal to the PC and the smart phone. Therefore continuous ECG monitoring in daily life is made possible. A comparison experiment between Ag / AgCl electrode and unconstraint electrode is conducted to evaluate the performance of the implemented system. As a result, we confirm our unconstraint system can be used for daily life ECG monitoring.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.10a
• /
• pp.872-875
• /
• 2016

본 연구에서는 무구속적으로 사용자의 활동상태를 모니터링하고 이를 기반으로 산만도를 추정하기 위한 연구를 수행하였다. 사용자의 활동상태 모니터링을 위해서는 키넥트 센서를 활용하여 머리에서의 관절정보와 어깨관절정보를 검출하고, 각 검출지점의 시간당 좌표변화를 인덱스화하여 움직임 변화정도를 측정하였다. 이러한 움직임정보로부터 산만도의 추정을 위하여 움직임의 빈도와 움직임의 강도를 분석하고 이로부터 산만도를 추정하기위한 인덱스를 개발하였다. 실제 사용자의 활동상태로부터 추출된 움직임정보 및 산만도 추정인덱스의 모니터링을 위하여 PC기반의 모니터링 및 스마트폰기반의 어플리케이션을 구현하였다. 구현된 시스템의 성능평가를 위하여 키넥트를 이용한 산만도 추정 어플리케이션과 동시에 비디오 계측을 통해 움직임의 정도에 따른 산만도 추정식의 결과를 비교분석한 결과 개발된 산만도 추정시스템과 비디오분석결과의 상관관계가 높음을 실험으로 확인하였다.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2006.10a
• /
• pp.17-17
• /
• 2006

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.16 no.2
• /
• pp.81-87
• /
• 2017

The pipe connection process using a clamping ring is used for joining small pipes in the refrigerator and air-conditioner industries instead of the brazing process, which induces inevitable thermal deformation in the pipes. However, few studies have been carried out on the process to select optimal parameters in joining pipes, and studies on the relation between the process parameters of the connection and connecting force of the joint have not been conducted. In this study, the connection process of pipes with the clamping ring was modeled using the finite element method (FEM) and analyzed to obtain the contact stress distribution between the pipes with which the connecting force of the joint was estimated. Considering the characteristics of pipe connection, the process was modeled and simulated in a two-dimensional axisymmetric solution domain. With the numerical model, the effect of ring shape on the connection was studied by adding a projection to the end of a ring or changing the length of a ring. The results of the analyses revealed that the contact stress distribution could be predicted with the suggested model. The effect of the ring shape was also presented. The effect of any combination of process parameters could be easily estimated through the related analyses.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2010.05a
• /
• pp.148-151
• /
• 2010

심장관련 질환은 현대사회에서 업무 과중과 스트레스에 의해 발병 가능성이 높아지고 있으며, 일상생활 중 건강상태를 지속적으로 모니터링하여 심장질환 관련 응급상황에 대처하기위한 많은 연구들이 수행되고 있다. 본 연구에서는 가정 또는 사무실에서 무구속적인 방법으로 지속적인 심장 활동상태의 모니터링이 가능한 무구속 의자형 심탄도 계측 시스템을 구현하였다. 구현된 시스템에서 계측된 심탄도 신호로부터 건강모니터링을 위한 특징성분을 검출하기위해 웨이브렛 변환과 템플릿 매칭을 혼합한 신호처리방법을 제안하였다. 또한 적응 문턱치를 통해 심탄도 신호에서 심박동을 검출하였으며 심박동의 간격으로부터 HRV(heart rate variabillity)를 계산하였다. 구현된 시스템의 성능평가를 위하여 심전도와 동시에 심탄도를 측정하였으며, 두 신호로부터 심박동 검출 성능을 비교하여 구현된 무구속 의자형 심탄도 계측 시스템의 유용성 및 무자각 건강모니터링의 가능성을 확인하였다. 또한 스트레스에 따른 HRV의 변화를 관찰하기 위하여 피실험자로부터 인위적으로 숨을 참고 강제호기를 통해 흉강내압을 증가시켜 인위적인 육체적 스트레스를 가하는 발살바를 유도하였으며, HRV의 시간 및 주파수 영역에서 도출되는 파라미터들을 평가하여 심탄도 모니터링을 통해 안정 상태와 스트레스 상태의 판별 및 무구속 건강모니터링의 가능성을 평가하였다.