• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.9
• /
• pp.6254-6259
• /
• 2015

On the optical system and the system itself of the noise of the noise from the outside always present. This noise is to function as reducing performance of the optical system. Therefore, the probability of error, thereby changing the system. In this paper, the error probability of the optical system due to changes in various values by introducing the characteristic variable the value of the optical system was calculated using the ${\kappa}$-square method. Was confirmed also in accordance with the calculation result is an error probability of the optical system changes, it was confirmed that when the value of the holding case for holding the standard about 400 Lux on the probability of the optical system. This case was found to be an optical system using a light source with a low output, so that means the smaller output is no problem to maintain the error probability value of the optical system is large. This means that more effective and less expensive to implement because it means that the optical system does not require the use of pre-amplifier for amplifying the signal at the receiving end of an optical system using a light source with a low output when the normal case.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.1
• /
• pp.677-682
• /
• 2015

In this paper, we investigated the effect of light on the performance of the receiver system noise and external noise added from the ever-present influence in general optical system. And calculated the reception sensitivity of the receiver at the time of off-keying transmission - from the optical transmission system in consideration of the case that the photo detector has a quantum yield of less than one-one. Not less than 50 it was confirmed that it is possible to configure the low power system is calculated and compared with the case where less than 300 the receiver sensitivity of the optical system to maintain the standard error probability. However, even if these values were considered, and the preamplifier in the receiver, considering a case of using a low-output light source, so that a heavy burden in the value less than the actual system installation, using the light source having less than the output, as shown in Figure 3, the results that were obtained also may be used.

• The Optical Journal
• /
• s.123
• /
• pp.22-25
• /
• 2009

III-V족 화합물반도체 태양전지중 다접합 구조 태양전지와 집광형 태양전지는 제 3세대 태양전지로서 주목받고 있다. 현재 가장 간단하고 저렴한 원가를 갖는 구조가 프레넬 렌즈 1장을 사용한 구조로서 현재의 광학시설과 인프라만으로도 많은 부분을 개선할 수 있을 것이라 확신한다. 렌즈를 활용하여 집광한 빛을 한곳으로 모으로 이를 셀에 균일한 강도로 손실 없이 전송하기 위한 기하광학적 설계기술이 필요하며 이러한 설계와 조명설계를 결합하여 광시스템을 구축하는 것이 무엇보다 중요하다. 현재 나라마다의 다양하고 적극적인 개발노력으로 인하여 수년 안에 기존보다도 훨씬 효율성 높고 실용적인 태양집광시스템이 개발되리라 기대한다.

• 제어로봇시스템학회:학술대회논문집
• /
• 1988.10a
• /
• pp.683-687
• /
• 1988

Digitalization of processor and increase of control information need the fiber optic data network which has excellent noise immunity and high-quality, widebaudwidth information transfer capability. It is aimed to offer a fiber optic dataway system for measuring and control the power plant, that has high reliability, high data transmission rate and small cable duct with large transmission capacity.

• Proceedings of the Optical Society of Korea Conference
• /
• 2000.08a
• /
• pp.10-11
• /
• 2000

광섬유 격자는 WDM 광시스템의 필터뿐만 아니라 센서로도 많은 연구가 되고 있다. 이 경우 필수적인 것이 유효굴절률에 대한 해석이다. 유효굴절률은 광섬유의 코어와 클래딩의 굴절률과 반지름에 따른 수치해석을 통해서도 구할 수 있다. 수치해석과정에서 필수적인 것이 파장에 따른 굴절률을 계산할 수 있는 Sellmeier식이다$^{(1)}$ . 본 연구에서는 광섬유격자 쌍을 이용하여 광섬유의 유효굴절률을 클래딩 모드수에 따라 측정할 수 있는 새로운 방법을 제시한다. (중략)

• Journal of Advanced Marine Engineering and Technology
• /
• v.19 no.1
• /
• pp.71-81
• /
• 1995

In this paper, a new speed control scheme for induction motor drives that regular sampled PWM and harmonic elimination switching pattern over the full range of output speed is presented. The proposed scheme(hybrid scheme) provides three mode and guarantees smooth voltage boost. A detailed description of the scheme, along with the relalization aspect, is described. Moreover, methods of compensating for dead time and optical transmission system of drive signal are proposed and investigated. Finally, experimental investigation of hybrid scheme is presented.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.9
• /
• pp.4462-4466
• /
• 2013

In optical system, the signal and additive noise for statistical properties of a variety of ways to evaluate the performance of the system is essential for the optimization. In this paper, performance analysis of spectrum-sliced optical system in the optical pre-amplifier in the receiver the received signal by including the error limits for the bit that is, the bit error rate (BER: Bit Error Rate) required to maintain the average optical power represents the number of photons per bit is included in this paper to digital form, noticeable signal the receiver to calculate the sensitivity of the method for the calculation was performed. The general strength of the transmission of the modulated signal and digital signal transmission was required for the comparison of optical power. As shown in Figure 3, the general strength of the digital signal transmission system for transmitting a modulated signal compared with the case is improved by at least 10dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.12B
• /
• pp.1703-1711
• /
• 2001

광시스템에서 발생할 수 있는 비선형 현상 중 하나인 유도 브릴루앙 산란은 낮은 입력 파워 레벨에서도 발생할 수 있기 때문에 광전송 시스템에 큰 영향을 주는 현상이다. 그러므로 고출력의 신호를 광섬유에 입사시켜 광전송 시스템의 전송 거리를 길게 하기 위해서는 광섬유에서 발생하는 유도 브릴루앙 산란에 대한 고려가 필요하다. 특히 현재 광통신에 사용되고 있는 파장 분할 다중방식(WDM) 광전송 시스템에서는 채널 간격이 좁으므로 유도 브릴루앙 산란의 영향을 고려해야만 한다. 브릴루앙 이득 스펙트럼은 브릴루앙 주파수 천이, 부릴루앙 선폭과 이득계수에 대한 정보뿐만 아니라 브릴루앙 임계값에 대한 정보를 포함한다. 이러한 유도 브릴루앙 산란 신호를 1550nm 파장대에서 실험적으로 확인하였으며 실험으로 관측한 SBS 신호를 이론적으로 계산된 값과 비교하였다. 실험으로 구한 신호 주파수는 10.8825GHz로서 이론상의 값 10.9GHz와 일치하였으며 브릴루앙 이득 스펙트럼을 측정한 결과 1.5436 $\times$ $10^{-ll}$m/w의 브릴루앙 이득 계수 $g_{0}$을 얻었다.다.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.3 no.4
• /
• pp.70-75
• /
• 2010

In this paper, was designed Algorithm Brent. this Algorithm can be used in the medical optical system. Optical signals are transmitted using optical fibers and integrated Optic. Developed Algorithm finds the maximum of the transmitted signal intensity. Optical system is made for Laser-Diode, HeNe-Laseer, controller for stepping motor, glass fiber and integrated Optic, etc. In this paper, two algorithms were investigated.

• Journal of IKEEE
• /
• v.22 no.4
• /
• pp.959-964
• /
• 2018

In this study, a study is conducted on a monitoring system that can control the environment of plants using sensors in conjunction with the LED light system and the plant growth control system. To verify the performance of the developed plant growth system, an experiment was conducted on the characteristics of energy efficiency, data transmission rate, and light volume control. The experiment resulted in a satisfactory result by controlling more than 80% energy efficiency, 1Mb/sec wireless communication speed, and 5 levels of optical control. The proposed system can be applied to LED plant facilities and will contribute to the automation of agriculture by organizing an automated system for production efficiency and labor cost reduction for future commercialization.