• Journal of the Korea Society of Computer and Information
• /
• v.12 no.1 s.45
• /
• pp.137-144
• /
• 2007

Advances in networking technology digital media, and codecs have made it possible for the Internet evolves into a Broadband convergence Network (BcN) and provides various services including Voice over Internet Protocol (VoIP) and IPTV over their high-speed IP networks. In order for the Internet to make a profit as traditional Public Switched Telephone Network (PSTN), it must provide high qualify VoIP services. Therefore, real time qualify measurement framework is the most important requisite to provide VoIP service. For this, IETF (Internet Engineering Task Force) defined RTCP-Extended Reports (RTCP-XR) that extend RTCP (Real-Time Transport Protocol Control Protocol). However, procedure and method tot actually VoIP qualify measurement did not recommended nothing but defined item to measure voice quality. Our objective in this paper is to describes a practical measuring framework for end-to-end QoS of switched voice packet in an IP environment. It includes concepts as well as step-by-step procedures for measuring packetized voice streams. It also proposes new formats that extend RTCP-XR's concept.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.9
• /
• pp.1248-1256
• /
• 1993

The propagation and delay properties in opical fiber are particularly attractive because digital signal processing and conventional analog signal processing techniques such as those using surface acoustic wave devices are limited In their usefulness for signal bandwidth exceeding one or two GHz, although they are very effective at lower frequencies. Since an accurate, low loss and short time delay elements can be obtained by using such an optical fiber, optical signal precessing has attracted much attention for high speed and broad-band signal precessing in particular channel separation filtering for optical FDM signals. In this paper, we consider a coherent optical lattice filter, which uses coherent light sources and consists of directional couplers and optical fiber delay elemnts. The optical fiber fitters are more restricted than the usual digital filters. The reasons are as follows. 1) the coupling coefficients of directional couplers are restricted to the number between 0 and 1. 2) optical signal E(complex amplitude) is divided into J If-$\boxUl$ and J L/7$\div$$\boxUl$ at the directional coupler. Considering these restrictions and in this case all the coupling coefficients of summing and branching elements are set to be equal, we have given design formulae for optical lattice filter, which make the best use of optical signal energy.

• Journal of the Society of Disaster Information
• /
• v.11 no.1
• /
• pp.73-88
• /
• 2015

Due to the cases of recent global warming and unusual weather etc., large-scale natural disasters such as typhoons, floods, snow damage occur frequently across the continents such as Southeast Asia and North America, South America etc. and risks of earthquakes and tsunami are also increasing gradually in Korea which has been regarded as a safe zone and disaster types are also being diversified such as typhoons, floods, heat waves, heavy snow and damage scale is also enlarged. In addition, due to geographical characteristics or lack of infrastructure, disasters tended to occur intensively around a specific region or city in the past but disasters occur throughout the country in recent years so preparation for disaster prevention has emerged as an urgent challenge issue. Therefore, considering that the plan of obtaining the effective feedback function of disaster Information is very important in the proactive and software aspects for disaster reduction, this paper analyzed this three aspects of contents, procedural and contextual aspects and proposed the plan. First, in the content aspect, building disaster prevention information communication Infrastructure, building urban and regional disaster prevention system, obtaining concurrency and sharing of information and second, in the procedural aspect, active utilization of ICT(Information and Communication Technology) of the prevention stage, disaster prevention information collection and analysis reinforcement of the preparation stage, improvement of decision-making structure and field command system of the response stage, recovery system related information promotion of the recovery stage were proposed as alternatives and finally, in the contextual aspect, if disaster prevention information is effectively managed through maintenance of disaster prevention information related systems, obtaining domainality by disaster prevention work, improvement of the ability to judge the situation, obtaining comprehensive and feedback function etc, it is considered to significantly contribute to reducing natural disasters.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.2B
• /
• pp.100-107
• /
• 2007

Recently, a study of BcN(Broadband convergence Network) is progressing continuously, and it is important to improve the quality of the service according to subscribers because a scale of network is about to be larger. It is more important to manage QoS(Quality of Service) of all subscribers in layer 2 than layer 3 network since managing it in layer 3 network cost both additional processes and large hardware. Moreover, QoS based on Best-Effort service has been developed because tots of subscribers should use limited resource in BcN. However, they want to be supplied with different service even though they pay more charge. Therefore, it is essential to assign the different bandwidth to subscribers depending on their level of charge. The method of current Rate Limiter limits the bandwidth of each port that does not offer fair service to subscribers. The Rate Limiter proposed in this paper limits bandwidth according to each subscriber. Therefore, subscribers can get fair service regardless of switch structure. This new Rate Limiter controls the bandwidth of subscribers according to the information of learning subscriber and manages maximum performance of Ethernet switch and QoS.

• Journal of the Korea Society of Computer and Information
• /
• v.14 no.3
• /
• pp.121-131
• /
• 2009

BcN provides a wide variety of high-quality multimedia services such as broadcasting and communication convergence services. But the quality degeneration is observed in BcN when we use broadcasting and communication convergence service via more than one network of different internet service providers. In this paper, a QoS management system which is able to measure and maintain objectively the quality-related information in overall networks is proposed. The proposed QoS management system is tested on the pilot networks of BcN consortiums by measuring the quality of voice and video experienced by the actual users of the commercial video phone services. The result of the experiment shows that it is possible to figure out service qualify between a user and a service provider by analyzing the information from agents. The per-service traffic information collected by probes is proved to be useful to pinpoint the party responsible for the loss of the service qualify in case of the services including different service providers. As the result of the experiment, it is shown that the proposed QoS management system would play a key role of resolving the quality dispute, which is one of the important issues of QoS-guaranteed BcN.

• Journal of Intelligence and Information Systems
• /
• v.22 no.1
• /
• pp.107-118
• /
• 2016

The advent of 5G mobile communications, which is expected in 2020, will provide many services such as Internet of Things (IoT) and vehicle-to-infra/vehicle/nomadic (V2X) communication. There are many requirements to realizing these services: reduced latency, high data rate and reliability, and real-time service. In particular, a high level of reliability and delay sensitivity with an increased data rate are very important for M2M, IoT, and Factory 4.0. Around the world, 5G standardization organizations have considered these services and grouped them to finally derive the technical requirements and service scenarios. The first scenario is broadcast services that use a high data rate for multiple cases of sporting events or emergencies. The second scenario is as support for e-Health, car reliability, etc.; the third scenario is related to VR games with delay sensitivity and real-time techniques. Recently, these groups have been forming agreements on the requirements for such scenarios and the target level. Various techniques are being studied to satisfy such requirements and are being discussed in the context of software-defined networking (SDN) as the next-generation network architecture. SDN is being used to standardize ONF and basically refers to a structure that separates signals for the control plane from the packets for the data plane. One of the best examples for low latency and high reliability is an intelligent traffic system (ITS) using V2X. Because a car passes a small cell of the 5G network very rapidly, the messages to be delivered in the event of an emergency have to be transported in a very short time. This is a typical example requiring high delay sensitivity. 5G has to support a high reliability and delay sensitivity requirements for V2X in the field of traffic control. For these reasons, V2X is a major application of critical delay. V2X (vehicle-to-infra/vehicle/nomadic) represents all types of communication methods applicable to road and vehicles. It refers to a connected or networked vehicle. V2X can be divided into three kinds of communications. First is the communication between a vehicle and infrastructure (vehicle-to-infrastructure; V2I). Second is the communication between a vehicle and another vehicle (vehicle-to-vehicle; V2V). Third is the communication between a vehicle and mobile equipment (vehicle-to-nomadic devices; V2N). This will be added in the future in various fields. Because the SDN structure is under consideration as the next-generation network architecture, the SDN architecture is significant. However, the centralized architecture of SDN can be considered as an unfavorable structure for delay-sensitive services because a centralized architecture is needed to communicate with many nodes and provide processing power. Therefore, in the case of emergency V2X communications, delay-related control functions require a tree supporting structure. For such a scenario, the architecture of the network processing the vehicle information is a major variable affecting delay. Because it is difficult to meet the desired level of delay sensitivity with a typical fully centralized SDN structure, research on the optimal size of an SDN for processing information is needed. This study examined the SDN architecture considering the V2X emergency delay requirements of a 5G network in the worst-case scenario and performed a system-level simulation on the speed of the car, radius, and cell tier to derive a range of cells for information transfer in SDN network. In the simulation, because 5G provides a sufficiently high data rate, the information for neighboring vehicle support to the car was assumed to be without errors. Furthermore, the 5G small cell was assumed to have a cell radius of 50-100 m, and the maximum speed of the vehicle was considered to be 30-200 km/h in order to examine the network architecture to minimize the delay.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.5 s.108
• /
• pp.461-475
• /
• 2006

In this paper, it is described about the tri-band mobile antenna system design to provide broadband multimedia and direct broadcasting services using goo-stationary Koreasat 3, simultaneously operated in Ka/K/Ku band. The radiating part of the antenna system with a fan beam characteristic in the elevation plane is composed of the quasi-offset dual shaped reflector and the tri-band feeder. The tri-band feeder is also composed of the Ka/K dual band feeder with the protruding dielectric rod, the circular polarizer, the ortho-mode transducer and the circular-polarized Ku band feed array. Especially, the Ka/K dual band circular polarizer was realized firstly using the comb-type structure. For fast satellite-tracking on the movement, the Ku band feed array has the structure of the $2{\times}2$ active phased array which can make electrical beams. And, the circular-polarized characteristic in the feed array was improved by $90^{\circ}$ rotating arrangement of four radiating elements polarized circularly by a $90^{\circ}$ hybrid coupler, respectively. Four beam forming channels to make electrical beams at Ku band are divided into the main beam channel and the tracking beam channel in the output, and noise temperature characteristics of each channel were analyzed on the basis of the contributions of internal sub_units. From the fabricated antenna system, the output power at $P_{1dBc}$ of Ka_Tx channel was measured more than 34.1 dBm and the measured noise figures of K/Ku_Rx channels were less than 2.4 dB and 1.5 dB, respectively, over the operating band. The radiation patterns with co- and cross-polarization in the tri-band were measured using a near-field measurement in the anechoic chamber. Especially, Ku radiation patterns were measured after correcting each initial phase of active channels with partial radiation patterns obtained from the independent excitation of each channel. The antenna gains measured in Ka/K/Ku band of the antenna system were more than 39.6 dBi, 37.5 dBi, 29.6 dBi, respectively. And, the antenna system showed good system performances such as Ka_Tx EIRP more than 43.7 dBW and K/Ku_Rx G/T more than 13.2 dB/K and 7.12 dB/K, respectively.