• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.2C
• /
• pp.83-94
• /
• 2008

In this study an effective stress analysis was performed to evaluate liquefaction potential and ground settlement for reclaimed sites. The effective stress model can simulate the stiffness degradation due to excess pore pressure and resulting ground deformation. It is applicable to a wide range of strain. An equivalent linear analysis suitable for low strain levels was also carried out to compare the effective stress analysis. Shear stress ratio calculated from an equivalent linear analysis was used to determine SPT blow count to prevent liquefaction. Depending on the magnitude of potential earthquake and fine contents, the SPT blow count was converted into an equivalent cone tip resistance. It was compared with the measured cone tip resistance. The measured elastic shear wave velocity and cone tip resistance from two reclaimed sites in Incheon were used to perform liquefaction analyses. Two liquefaction evaluation methods showed similar liquefaction potential which was evaluated continuously. The predicted excess pore pressure ratio of upper 20 m was between 40% and 70%. The calculated post-shaking settlement caused by excess pore pressure dissipation was less than 10 cm.

• Journal of the Korean Geographical Society
• /
• v.35 no.4
• /
• pp.641-647
• /
• 2000

한반도 중부지방의 사면형성과정을 검토하기 위하여 이 지역에 광범위하게 분포하는 쥬라기의 화강암과 선캄브리아기의 편마암으로 구성된 산지 소유역에서 수문관측을 실시하였다. 화강암 유역의 면적은 0.0546$\textrm{km}^2$이며, 기복비는 0.35이다. 편마암 유역은 다소 넓어 면적은 0.0754$\textrm{km}^2$이나 기복비는 0.36으로 거의 같다. 두 유역의 사면은 모두 사림으로 피복되어 있다. 관입시험 결과에 의하면 화강암유역 토층의 층후는 20cm 이하로 얇고 도처에 기반암이 보출된다. 반면에 편마암 유역의 층후는 50cm 이상으로 상대적으로 두껍게 나타난다. 관측은 1999년 5월부터 시작하였으며, 현재도 계속되고 있다. 강우에 대한 유출방응은 편마암 유역이 화강암 유역에 비하여 신속하게 나타난다. 첨두유량과 기저유량 모두 화강암유역보다는 편마암유역에 전반적으로 높게 관측되어 편마암 유역 사면에서의 저류량이 큰 것으로 생각된다. 또한 편마암사면에서 우수의 체류시간을 반영하여 전기전도도는 편마암 유역이 화강암유역보다 2배 정도 높게 관측된다.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.4
• /
• pp.259-267
• /
• 2001

실내시험으로 구한 점토의 공학적 성질은 샘플링, 운반, 저장, 그리고 성형과정 동안에 발생하는 시료의 교란으로 인해 원지반의 성질과 다르게 측정된다. 본 연구에서는 양산점토에 대한 삼축압축시험($CK_{o}$ UC) 결과를 이용하여 샘플링 방법에 따른 교란의 정도를 평가하였다. 실험에 사용된 시료는 76mm 튜브샘플러, 76mm 피스톤샘플러, 블록샘플러로 채취되었으며, 시료의 교란정도를 평가하기 위해 각 시료에서 측정된 체적변형률, 비배수 전단강도, Secant Youngs modulus, 그리고 파괴시 간극수압계수를 비교하였다. 시료의 교란정도를 평가하는 것 이외에도 SHANSEP 방법을 이용하여 수행한 $CK_{o}$ U 삼축압축시험 결과를 이용하여 양산점토에 대한 정규화 전단강도($C_{u}$ /$\sigma$$_{vc}$ )와 OCR 관계를 규명하였다. 또, 피에조콘 관입시험, 딜라토메타 시험, 그리고 현장 베인시험결과를 이용하여 구한 양산점토의 비배수 전단강도를 삼축압축시험 결과와 비교하였다.

• The Journal of the Korea Contents Association
• /
• v.20 no.11
• /
• pp.669-675
• /
• 2020

This research has focused on comparing the capacity predicted by the theoretical formula with the one measured by field load tests to examine characteristics of the bearing capacity of a helical pile. The helical pile is featured by a central shaft with one or more helical-shaped bearing plates. Being established by a small rotary attached to an excavator that applies toque, the helical piles can be readily constructed at narrow sites, especially in an urban area with relatively less noise than the others requiring driving and excavation. Although many cases of the helical pile constructions can be recently found, the bearing capacity of the pile has been limitedly studied. To this end, this contribution analyzes and presents comprehensive results of the ten field loading tests with an application of different parameters depending on joint condition and specification of the helical piles, and types of tests and grouting.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.15 no.4
• /
• pp.136-145
• /
• 2011

For a massive project related to building national industrial complexes on a soft ground applied to PVD after dredging and hydraulic fill, laboratory tests were carried out using undisturbed sample taken from various depth. Piezocone penetration and dissipation tests were carried out to assess horizontal coefficient of consolidation and initial stress in field. The ground consists of upper dredged fill and lower original clay layer having both similar marine clays. It should be, however, considered as multi-layered soft ground having different initial void ratio, initial water content, initial effective stress, and permeability and compressibility with directions. To assess initial stress of those soft layers in which have different stress history related to consolidation, CPTu test results, especially excess pore water pressure, were analyzed. It allows to find out distribution of excess pore water pressure and initial stress inner original clay layer.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.12
• /
• pp.13-23
• /
• 2007

Weathered soils appear from the rock and its weathering result. In accordance with the degree of weathering the roch may become soft rock, weathered rock and residual soil. In general, classification method for determining the degree of weathering are performed by chemical method and N-value. But these method have some problems. So, this research is to suggest an appropriate physical method to determine the degree of weathering of weathered soils. A new classification method for determining the degree of weathering is suggested, based upon the results from fall cone test. According to the proposed physical method using fall cone apparatus, the measured values of the samples from the same area show distinctive difference of weathering. For the checking, we selected two areas. As a result, the relationship between CWI and water content according to penetration is expressed as an equation in Ilsan and Incheon area. And it proved to be a good method to determine the degree of weathering.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.6
• /
• pp.73-81
• /
• 2002

Various CPT-based prediction models far profiling stress history of marine clay at the southern part of the Korean peninsula were investigated by using both statistical analysis and case history study. Preconsolidation pressures($\sigma'$p) and overconsolidation ratio(OCR) estimated by empirical correlations and cone penetration tests were compared with those of laboratory odometer test results. Stress history of marine clay determined by odometer test results was in general overconsolidated at below 10m depth from the mudline, whereas marine clay at below l0m depth from the mudline which has an around 0.3 overconsolidation ratio showed variable stresses and unstable states. Preconsolidation pressures were computed by both empirical methods of the Chen and Mayne(1996) and theoretical method of Konrad and Law(1987). It is estimated that Chen and Mayne(1996)'s prediction method based on pore water pressure is more reliable than any other prediction methods, and their method proved to be the most reliable for overconsolidation ratio estimation. However, it is recommended that Mayne & Holtz(1988) and Mayne & Bachus(1988) methods are more suitable than any other methods for predicting the overconsolidation ratio at an underconsolidated (OCR<1) clay. For these reasons, rather than making use of existing prediction models, development of site specific empirical correlations which considers local characteristics and site conditions may be required due to different local stress history and variable soil properties.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.9
• /
• pp.25-32
• /
• 2004

Some amount of cements can be added into the soil with high water content to improve the engineering properties. In such a case, it is difficult to predict and figure out the phase changes of the soil-cement mixture which is closely associated with workability of the soil-cement mixture. Changes in heat of hydration and hardness of the cement pastes are known to provide the useful information about the phase changes of the soil-cement mixtures. In this study, heat of hydration and cone penetration depth were measured from the specimens of cement paste and 3 soil-cement mixtures. From the experimental results, it was found that the phase changes of the soil-cement mixtures are the same as those of cement paste, and that shear strength of the mixtures abruptly increases when the heat of hydration is minimum. Initial setting time of the mixtures coincides with the state when fall cone penetration depth was 1.0 mm and it is defined as plastic limit of the mixtures. Initial setting time of the mixtures is retarded as soil/cement ratio is increased. Measurements of heat of hydration and fall cone apparatus could be the useful tools to predict the phase changes of tile soil-cement mixtures.

• Journal of the Korean Geotechnical Society
• /
• v.15 no.2
• /
• pp.165-180
• /
• 1999

Static load tests were performed for open-ended piles, closed-ended piles, piles with grouted toe, and base-grouted piles by using calibration chamber. Then vertical bearing capacities determined from load tests were compared with each other. The stability of base-grouted pile during a simulated seaquake was investigated by changing the penetration depth. Also, static load tests and seaquake tests for 2-piles and 4-piles group were performed. The bearing capacity of the pile grouted inside the toe was 11.2~30.8% less than that of open-ended pile because of reduction of base resistance due to disturbance of base soil under pile toe. The bearing capacity of a base-grouted pile was 23.8~33.9% more than that of an open-ended pile and was similar to that of a closed-ended pile. The bearing capacity of base-grouted group pile was increased ; the bearing capacity of base-grouted 2-piles group increased 14.6~31.8% compared to that of open-ended 2-piles group, and that of base-grouted 4-piles group increased 15.3~22.4% compared to that of open-ended 4-piles group. During the simulated seaquake in deep sea, stability of base-grouted pile was found to be dependent on the pile penetration depth. During seaquake motion, single long base-grouted pile longer than 20m was stable and short base-grouted pile shorter than 12m failed. But relatively long base-grouted pile longer than 12m kept mobility state. Bearing capacity of base-grouted group pile with penetration depth less than 7m was degraded a little bit ; so, base-grouted group pile could maintain mobility condition.

• Journal of the Korea Concrete Institute
• /
• v.26 no.6
• /
• pp.731-739
• /
• 2014

This paper describes the evaluation of the impact performance of steel fiber-reinforced concrete based on high-velocity impact experiments using hard spherical balls. In this experimental study, panel specimens with panel thickness to ball diameter (h/d) ratios of 3.5 or less were tested with variables of steel fiber volume fraction, panel thickness, impact velocity, and aggregate size. Test results were compared with each other to evaluate the impact resistance. The results showed that the percentage of weight and surface loss decreased as the steel volume fraction increased. However, the penetration depth increased with up to steel fiber volume fraction of 1.5%. Particularly the results of specimens with 20 mm aggregates showed poorer performance than those with 8 mm aggregates. The results also confirmed that the impact performance prediction formulas are conservative with (h/d) ratios of 3.5 or less. Despite the conservative predictions, the modified NDRC formula and ACE formula predict the impact performance more consistently than the Hughes formula.